A sustainable one-pot method to transform seashell waste calcium carbonate to osteoinductive hydroxyapatite micro-nanoparticles

We have developed a straightforward, one-pot, low-temperature hydrothermal method to transform oyster shell waste particles (bCCP) from the species Crassostrea gigas (Mg-calcite, 5 wt% Mg) into hydroxyapatite (HA) micro/nanoparticles. The influence of the P reagents (H3PO4, KH2PO4, and K2HPO4), P/bCCP molar ratios (0.24, 0.6, and 0.96), digestion temperatures (25-200 °C), and digestion times (1 week-2 months) on the transformation process was thoroughly investigated. At 1 week, the minimum temperature to yield the full transformation significantly reduced from 160 °C to 120 °C when using K2HPO4 instead of KH2PO4 at a P/bCCP ratio of 0.6, and even to 80 °C at a P/bCCP ratio of 0.96. The transformation took place via a dissolution-reprecipitation mechanism driven by the favorable balance between HA precipitation and bCCP dissolution, due to the lower solubility product of HA than that of calcite at any of the tested temperatures. Both the bCCP and the derived HA particles were cytocompatible for MG-63 human osteosarcoma cells and m17.ASC murine mesenchymal stem cells, and additionally, they promoted the osteogenic differentiation of m17.ASC, especially the HA particles. Because of their physicochemical features and biological compatibility, both particles could be useful osteoinductive platforms for translational applications in bone tissue engineering.

Calcium sulphate biomineralisation: Artefact of sample preparation?

Calcium biomineralisation is widely documented in plants. However, crystallisation of Ca-sulphate-containing minerals is closely related to water content, and sample processing, such as drying, alters the water balance of plant tissues. We hypothesised that common sample processing practices may favour the formation of crystals, leading to spurious crystallisation not observed in unaltered plant tissues. We selected three species (Ononis tridentata, Helianthemum squamatum and Gypsophila struthium) with reported gypsum biomineralisation. We used x-ray diffractometry on fresh intact or sliced leaves, and on the same leaves processed by subsequent drying, to address whether sample processing alters crystal formation. Ca-sulphate crystals were detected in dry samples of all species but not in fresh intact samples. Ca-sulphate crystallisation occurred in some cut fresh samples, although the accumulation greatly increased after drying. In addition, G. struthium exhibited Ca-oxalate crystals in both fresh and dry treatments, with a tendency for greater accumulation in dry treatments. Our results demonstrate that the Ca-sulphate crystals observed by x-ray diffractometry in these species are artefacts caused by common sample processing practices, such as excessive drying and slicing samples. We encourage future studies on the biomineral potential of plants to avoid the use of procedures that alter the water balance of tissues.

Rational Coformer Selection in the Development of 6-Propyl-2-thiouracil Pharmaceutical Cocrystals

Pharmaceutical multicomponent solids have proved to efficiently modulate the physicochemical properties of active pharmaceutical ingredients. In this context, polyphenols are interesting coformers for designing pharmaceutical cocrystals due to their wide safety profile and interesting antioxidant properties. The novel 6-propyl-2-thiouracil multicomponent solids have been obtained by mechanochemical synthesis and fully characterized by powder and single-crystal X-ray diffraction methods. The analysis of supramolecular synthons has been further performed with computational methods, with both results revealing a robust supramolecular organization influenced by the different positions of the hydroxyl groups within the polyphenolic coformers. All novel 6-propyl-2-thiouracil cocrystals show an enhanced solubility profile, but unfortunately, their thermodynamic stability in aqueous media is limited to 24 h.

Metformin-NSAIDs Molecular Salts: A Path towards Enhanced Oral Bioavailability and Stability

According to the World Health Organization, more than 422 million people worldwide have diabetes. The most common oral treatment for type 2 diabetes is the drug metformin (MTF), which is usually formulated as a hydrochloride to achieve higher water solubility. However, this drug is also highly hygroscopic, thus showing stability problems. Another kind of worldwide prescribed drug is the non-steroidal anti-inflammatory drug (NSAID). These latter, on the contrary, show a low solubility profile; therefore, they must be administered at high doses, which increases the probability of secondary effects. In this work, novel drug-drug pharmaceutical solids combining MTF-NSAIDs have been synthesized in solution or by mechanochemical methods. The aim of this concomitant treatment is to improve the physicochemical properties of the parent active pharmaceutical ingredients. After a careful solid-state characterization along with solubility and stability studies, it can be concluded that the new molecular salt formulations enhance not only the stability of MTF but also the solubility of NSAIDs, thus giving promising results regarding the development of these novel pharmaceutical multicomponent solids.

Mechanisms shaping the gypsum stromatolite-like structures in the Salar de Llamara (Atacama Desert, Chile)

The explanation of the origin of microbialites and specifically stromatolitic structures is a problem of high relevance for decoding past sedimentary environments and deciphering the biogenicity of the oldest plausible remnants of life. We have investigated the morphogenesis of gypsum stromatolite-like structures currently growing in shallow ponds (puquíos) in the Salar de Llamara (Atacama Desert, Northern Chile). The crystal size, aspect ratio, and orientation distributions of gypsum crystals within the structures have been quantified and show indications for episodic nucleation and competitive growth of millimetric to centimetric selenite crystals into a radial, branched, and loosely cemented aggregate. The morphogenetical process is explained by the existence of a stable vertical salinity gradient in the ponds. Due to the non-linear dependency of gypsum solubility as a function of sodium chloride concentration, the salinity gradient produces undersaturated solutions, which dissolve gypsum crystals. This dissolution happens at a certain depth, narrowing the lower part of the structures, and producing their stromatolite-like morphology. We have tested this novel mechanism experimentally, simulating the effective dissolution of gypsum crystals in stratified ponds, thus providing a purely abiotic mechanism for these stromatolite-like structures.

A Comprehensive Methodology for Monitoring Evaporitic Mineral Precipitation and Hydrochemical Evolution of Saline Lakes: The Case of Lake Magadi Soda Brine (East African Rift Valley, Kenya)

Lake Magadi, East African Rift Valley, is a hyperalkaline and saline soda lake highly enriched in Na⁺, K⁺, CO₃ ^2-, Cl^-, HCO₃ ^-, and SiO₂ and depleted in Ca²⁺ and Mg²⁺, where thick evaporite deposits and siliceous sediments have been forming for 100 000 years. The hydrogeochemistry and the evaporite deposits of soda lakes are subjects of growing interest in paleoclimatology, astrobiology, and planetary sciences. In Lake Magadi, different hydrates of sodium carbonate/bicarbonate and other saline minerals precipitate. The precipitation sequence of these minerals is a key for understanding the hydrochemical evolution, the paleoenvironmental conditions of ancient evaporite deposits, and industrial crystallization. However, accurate determination of the precipitation sequence of these minerals was challenging due to the dependency of the different hydrates on temperature, water activity, pH and pCO₂, which could induce phase transformation and secondary mineral precipitation during sample handling. Here, we report a comprehensive methodology applied for monitoring the evaporitic mineral precipitation and hydrochemical evolution of Lake Magadi. Evaporation and mineral precipitations were monitored by using in situ video microscopy and synchrotron X-ray diffraction of acoustically levitated droplets. The mineral patterns were characterized by ex situ Raman spectroscopy, X-ray diffraction, and scanning electron microscopy. Experiments were coupled with thermodynamic models to understand the evaporation and precipitation-driven hydrochemical evolution of brines. Our results closely reproduced the mineral assemblages, patterns, and textural relations observed in the natural setting. Alkaline earth carbonates and fluorite were predicted to precipitate first followed by siliceous sediments. Among the salts, dendritic and acicular trona precipitate first via fractional crystallization-reminiscent of grasslike trona layers of Lake Magadi. Halite/villiaumite, thermonatrite, and sylvite precipitate sequentially after trona from residual brines depleted in HCO₃ ^-. The precipitation of these minerals between trona crystals resembles the precipitation process observed in the interstitial brines of the trona layers. Thermonatrite precipitation began after trona equilibrated with the residual brines due to the absence of excess CO₂ input. We have shown that evaporation and mineral precipitation are the major drivers for the formation of hyperalkaline, saline, and SiO₂-rich brines. The discrepancy between predicted and actual sulfate and phosphate ion concentrations implies the biological cycling of these ions. The combination of different in situ and ex situ methods and modeling is key to understanding the mineral phases, precipitation sequences, and textural relations of modern and ancient evaporite deposits. The synergy of these methods could be applicable in industrial crystallization and natural brines to reconstruct the hydrogeochemical and hydroclimatic conditions of soda lakes, evaporite settings, and potentially soda oceans of early Earth and extraterrestrial planets.

Production of Cross-Linked Lipase Crystals at a Preparative Scale

The autoimmobilization of enzymes via cross-linked enzyme crystals (CLECs) has regained interest in recent years, boosted by the extensive knowledge gained in protein crystallization, the decrease of cost and laboriousness of the process, and the development of potential applications. In this work, we present the crystallization and preparative-scale production of reinforced cross-linked lipase crystals (RCLLCs) using a commercial detergent additive as a raw material. Bulk crystallization was carried out in 500 mL of agarose media using the batch technique. Agarose facilitates the homogeneous production of crystals, their cross-linking treatment, and their extraction. RCLLCs were active in an aqueous solution and in hexane, as shown by the hydrolysis of p-nitrophenol butyrate and α-methylbenzyl acetate, respectively. RCLLCs presented both high thermal and robust operational stability, allowing the preparation of a packed-bed chromatographic column to work in a continuous flow. Finally, we determined the three-dimensional (3D) models of this commercial lipase crystallized with and without phosphate at 2.0 and 1.7 Å resolutions, respectively.

Crystallization, Luminescence and Cytocompatibility of Hexagonal Calcium Doped Terbium Phosphate Hydrate Nanoparticles

Luminescent lanthanide-containing biocompatible nanosystems represent promising candidates as nanoplatforms for bioimaging applications. Herein, citrate-functionalized calcium-doped terbium phosphate hydrate nanophosphors of the rhabdophane type were prepared at different synthesis times and different Ca2+/Tb3+ ratios by a bioinspired crystallization method consisting of thermal decomplexing of Ca2+/Tb3+/citrate/phosphate/carbonate solutions. Nanoparticles were characterized by XRD, TEM, SEM, HR-TEM, FTIR, Raman, Thermogravimetry, inductively coupled plasma spectroscopy, thermoanalysis, dynamic light scattering, electrophoretic mobility, and fluorescence spectroscopy. They displayed ill-defined isometric morphologies with sizes ≤50 nm, hydration number n ~ 0.9, tailored Ca2+ content (0.42-8.11 wt%), and long luminescent lifetimes (800-2600 µs). Their relative luminescence intensities in solid state are neither affected by Ca2+, citrate content, nor by maturation time for Ca2+ doping concentration in solution below 0.07 M Ca2+. Only at this doping concentration does the maturation time strongly affect this property, decreasing it. In aqueous suspensions, neither pH nor ionic strength nor temperature affect their luminescence properties. All the nanoparticles displayed high cytocompatibility on two human carcinoma cell lines and cell viability correlated positively with the amount of doping Ca2+. Thus, these nanocrystals represent promising new luminescent nanoprobes for potential biomedical applications and, if coupled with targeting and therapeutic moieties, they could be effective tools for theranostics.

Luminescent biomimetic citrate-coated europium-doped carbonated apatite nanoparticles for use in bioimaging: physico-chemistry and cytocompatibility

Nanomedicine covers the application of nanotechnologies in medicine. Of particular interest is the setup of highly-cytocompatible nanoparticles for use as drug carriers and/or for medical imaging. In this context, luminescent nanoparticles are appealing nanodevices with great potential for imaging of tumor or other targetable cells, and several strategies are under investigation. Biomimetic apatite nanoparticles represent candidates of choice in nanomedicine due to their high intrinsic biocompatibility and to the highly accommodative properties of the apatite structure, allowing many ionic substitutions. In this work, the preparation of biomimetic (bone-like) citrate-coated carbonated apatite nanoparticles doped with europium ions is explored using the citrate-based thermal decomplexing approach. The technique allows the preparation of the single apatitic phase with nanosized dimensions only at Eu³⁺ doping concentrations ≤0.01 M at some timepoints. The presence of the citrate coating on the particle surface (as found in bone nanoapatites) and Eu³⁺ substituting Ca²⁺ is beneficial for the preparation of stable suspensions at physiological pH, as witnessed by the ζ-potential versus pH characterizations. The sensitized luminescence features of the solid particles, as a function of the Eu³⁺ doping concentrations and the maturation times, have been thoroughly investigated, while those of particles in suspensions have been investigated at different pHs, ionic strengths and temperatures. Their cytocompatibility is illustrated in vitro on two selected cell types, the GTL-16 human carcinoma cells and the m17.ASC murine mesenchymal stem cells. This contribution shows the potentiality of the thermal decomplexing method for the setup of luminescent biomimetic apatite nanoprobes with controlled features for use in bioimaging.

Biomimetic citrate-coated europium doped carbonated apatite nanoparticles show a high luminescence intensity and cytocompatibility for uses in cell/tissue imaging.

Novel solid forms of the analgesic drug ethenzamide

The interest in multicomponent solid forms has increased in the last years within the pharmaceutical industry and also the solid-state community due to the possibility of obtaining materials with new properties [1]. Crystallization strategies, supported by solvent- and solid-based techniques, have also received attention in the search and development of methodologies for the screening of multicomponent crystals. In this work, ethenzamide, an anti-inflammatory and analgesic drug, was selected as a model drug to develop cocrystals on the basis of the synthon types using a series of phenolic coformers. Ethenzamide cocrystals and cocrystal solvates have been reported recently [2,3]. Liquid Assisted Grinding (LAG) and solution methods were used as synthetic tools. Attempts to produce cocrystals by LAG and Reaction Crystallization led to the formation of polycrystalline material. The solids obtained were then characterized by powder X-ray diffraction (PXRD), FT-IR and Raman spectroscopy. Recrystallization by slow solvent evaporation was carried out when the above-referred techniques strongly suggest the formation of a new solid form. The structure of five new multicomponent solids has been determined by single crystal X-ray diffraction. Additional stability studies have been performed at controlled relative humidity conditions and followed by PXRD.