Filler particle leachability of experimental dental composites

We studied the effect of matrix selection, filler composition, and filler silanization on filler leachability after storage in distilled water or artificial saliva. We evaluated 2 matrix systems, 2 filler systems and 2 silane treatment procedures, combined into 8 different dental composite materials. A total of 128 batches were made, and 2 specimens per batch were prepared. Of these 2 specimens per batch, one was stored in distilled water and the other in artificial saliva, both at 37 degrees C. We transferred the specimens each 30th day during a 3-yr period to new vials containing either freshly distilled water or newly mixed artificial saliva and analyzed the solutions the specimens had been stored in regarding Si, Ba and Al concentrations. The analyses revealed that storage solution, filler composition, and total time in the storage solution had strong effects on leachability. The average monthly leakage of the three elements was linear with time and higher in the artificial saliva. The Ba-containing filler leached Si faster in artificial saliva than in distilled water, and roughly twice as much as the quartz filler. The storage effect approached an order of magnitude, while the filler effect was roughly a factor of two. Filler leaching was linear over time.

Calcium leaching from dentin and shear bond strength after etching with phosphoric acid of different concentrations

Based on the H2O-P2O5-CaO phase diagram, we hypothesize that a phosphoric acid concentration around 27 wt% leaches most calcium from dentin. We also hypothesize that bond strength is affected by resin infiltration, and that resin infiltration becomes incomplete when calcium leakage exceeds a certain value. Dentin disks were cut from human molars. Eight phosphoric acid concentrations were prepared (15.7-51.2 wt%). For each acid group, there were four etch time subgroups (15, 30, 60 and 120 s). The dentin disks were etched in acid and rinsed in water for times corresponding to 15 s, 30 s, 60 s and 120 s. The calcium concentrations were analyzed using atomic absorption spectroscopy. Composite cylinders were bonded to the remaining parts of the teeth using the same etching protocol, and shear bond strength was determined. The 29.2 wt% group demonstrated the highest and the 15.7 wt% group the lowest calcium leaching value. Even though there were trends towards lower bond strength for longer etch times, a statistically significant difference was only found between 30 and 120 s. There was no significant correlation between calcium leaching and bond strength. The results support the tested hypothesis that the highest leaching value would be around 27 wt% phosphoric acid.