High-Throughput Experimental Study of Wurtzite Mn1-x Zn x O Alloys for Water Splitting Applications

We used high-throughput experimental screening methods to unveil the physical and chemical properties of Mn_1-x Zn _x O wurtzite alloys and identify their appropriate composition for effective water splitting application. The Mn_1-x Zn _x O thin films were synthesized using combinatorial pulsed laser deposition, permitting for characterization of a wide range of compositions with x varying from 0 to 1. The solubility limit of ZnO in MnO was determined using the disappearing phase method from X-ray diffraction and X-ray fluorescence data and found to increase with decreasing substrate temperature due to kinetic limitations of the thin-film growth at relatively low temperature. Optical measurements indicate the strong reduction of the optical band gap down to 2.1 eV at x = 0.5 associated with the rock salt-to-wurtzite structural transition in Mn_1-x Zn _x O alloys. Transmission electron microscopy results show evidence of a homogeneous wurtzite alloy system for a broad range of Mn_1-x Zn _x O compositions above x = 0.4. The wurtzite Mn_1-x Zn_xO samples with the 0.4 < x < 0.6 range were studied as anodes for photoelectrochemical water splitting, with a maximum current density of 340 μA cm^-2 for 673 nm-thick films. These Mn_1-x Zn _x O films were stable in pH = 10, showing no evidence of photocorrosion or degradation after 24 h under water oxidation conditions. Doping Mn_1-x Zn _x O materials with Ga dramatically increases the electrical conductivity of Mn_1-x Zn _x O up to ∼1.9 S/cm for x = 0.48, but these doped samples are not active in water splitting. Mott-Schottky and UPS/XPS measurements show that the presence of dopant atoms reduces the space charge region and increases the number of mid-gap surface states. Overall, this study demonstrates that Mn_1-x Zn _x O alloys hold promise for photoelectrochemical water splitting, which could be enhanced with further tailoring of their electronic properties.

Comparative study on Ti-Nb binary alloys fabricated through spark plasma sintering and conventional P/M routes for biomedical application

The main purpose of this work is to obtain homogenous, single β phase in binary Ti-xNb (x = 18.75, 25, and 31.25 at.%) alloys by simple mixing of pure elemental powders using different sintering techniques such as spark plasma sintering (pressure-assisted sintering) and conventional powder metallurgy (pressure-less sintering). Synthesis parameters such as sintering temperature and holding time etc. are optimized in both techniques in order to get homogenous microstructure. In spark plasma sintering (SPS), complete homogeneous β phase is achieved in Ti25at.%Nb using 1300 °C sintering temperature with 60 min holding time under 50 MPa pressure. On the other hand, complete β phase is obtained in Ti25at.%Nb through conventional powder metallurgy (P/M) route using sintering temperature of 1400 °C for 120 min holding time which are adopted from the dilatometry studies. Nano-indentation is carried out for mechanical properties such as Young's modulus and nano-hardness. Elastic properties of binary Ti-xNb compositions are fallen within the range of 80-90 GPa. Cytotoxicity as well as cell adhesion studies carried out using MG63, osteoblast-like cells showed excellent biocompatibility of thus developed Ti25at.%Nb surface irrespective of fabrication route.

9-cis Retinoic acid inhibits cumulus cell apoptosis during the maturation of bovine cumulus-oocyte-complexes

Cumulus cell (CC) apoptosis is inversely correlated with embryonic development in vitro. Therefore, inhibition of CC apoptosis is important for proper embryonic development and quality. Retinoic acids (all-transRA and 9-cisRA) are natural components of retinoids, and 9-cisRA is the physiologically active metabolite of retinoic acid in vitro. During in vitro maturation, 9-cisRA enhances oocyte competence through multiple mechanisms affecting the oocyte and preimplantation embryo; however, the effect of 9-cisRA on CC apoptosis has yet to be elucidated. The aim of the present study was to evaluate the effect of 9-cisRA on CC apoptosis and to identify the molecular mechanism underlying that effect. Bovine slaughterhouse cumulus-oocyte complexes (COC) were matured in vitro in the absence or presence of 5 nM 9-cisRA. Cumulus cells were collected from immature and matured COC for the detection of apoptosis and gene expression analysis. Results showed that 9-cisRA reduced the number of apoptotic CC by about 2.7 fold (P < 0.023), compared with control. However, apoptosis is rare in CC of immature COC (0.01% ± 0.001). Transcripts involved in the caspase cascade were down-regulated upon exposure to 9-cisRA, including tumor necrosis factor alpha (TNF-α, 11.1 fold, P < 0.001), tumor necrosis factor alpha receptor 1 (TNFR1, 2.3 fold, P < 0.01), caspase 9 (CASP9, 2.0 fold, P < 0.031), caspase 8 (CASP8, 2.2 fold, P < 0.012), and caspase 3 (CASP3, 2.1 fold, P < 0.006), while antiapoptotic B-cell lymphoma 2 (BCL2) transcript was increased (3.1 fold, P < 0.004), compared with control. In addition, 9-cisRA inhibited mitogen activated protein kinase mRNA expression in CC, including extracellular signal-regulated kinase 1/2 (ERK1, 2.7 fold, P < 0.02; ERK2, 2.7 fold, P < 0.03), and c-Jun N-terminal kinase (JNK, 1.6 fold, P < 0.044), as well as the activator protein-1 (AP1) family members c-jun (1.6 fold, P < 0.041) and c-fos (2.0 fold, P < 0.06). The transcript abundances of TNF-α, TNFR1, CASP9, CASP8, CASP3, ERK1, ERK1, JNK, and BCL2 were increased, while c-fos and c-jun mRNA expression was decreased in the matured CC. On the basis of the data, we suggest that 9-cisRA inhibits CC apoptosis during in vitro maturation of bovine COC.

Coculturing denuded oocytes during the in vitro maturation of bovine cumulus oocyte complexes exerts a synergistic effect on embryo development

The present study examined the effect of coculturing cumulus oocyte complexes (COCs) and denuded oocytes (DOs) during in vitro maturation (IVM) on nuclear and cytoplasmic maturation, zona pellucida (ZP) hardening, the pattern of fertilization and glutathione peroxidase 1 (GPX1) gene expression in the oocyte. Furthermore, the rate of embryonic development and the quality of blastocysts were examined for both COCs and DOs. Three IVM conditions were studied: 1) the coculture of 12 COCs and 60 DOs, 2) COC control with 12 COCs, and 3) DO control with 60 DOs. The IVM was performed in a 120-μl droplet of TCM199-based IVM medium. Following IVM, in vitro fertilization (IVF) and in vitro culture (IVC) were conducted separately for the COCs and DOs (DO coculture) from the IVM coculture group. Coculturing COCs and DOs increased the percentage of oocytes reaching the blastocyst stage and the total number of cells per blastocyst in both the COC coculture (44.4 ± 8.6 vs 26.7 ± 9.7%, P < 0.01, and 137.9 ± 24.9 vs 121.7 ± 21.1, P < 0.05) and the DO coculture (20.5 ± 5.0 vs 11.1 ± 2.5%, P < 0.01, and 121.9 ± 27.5 vs 112.3 ± 33.2, P < 0.05) compared to their respective control groups. The synergistic effects of coculturing were detected as increased nuclear and cytoplasmic maturation, the prevention of ZP hardening, increased monospermic fertilization and increased expression of GPX1 in the oocytes in response to endogenous oocyte-secreted factors. In conclusion, coculturing COCs and DOs may be an effective culture system for both intact COCs and immature DOs.

Determination of parent orientation maps in advanced titanium-based alloys

In the past few years, reconstruction methods have been developed and applied successfully to restore the beta microtexture in titanium alloys. This contribution shows how these methods are extended to other transformations often encountered in advanced titanium alloys: the alpha (hcp)-->gamma (tetragonal) and the beta (bcc)-->O (orthorhombic) transformation. The efficiency of the restitution depends on specific crystallographic features of the investigated phase transformations. Therefore, the paper outlines these crystallographic specificities for some advanced titanium alloys. To illustrate the capability of the method to reconstruct the parent phase, different restored parent microtextures of these alloys are presented. The results show that the reconstruction methods are an efficient tool to study the microstructure and texture modifications induced by these phase transformations.