Treatment of anaerobically digested pig manure by applying membrane processes for nutrient recovery and antibiotics removal

A combination of membrane processes was applied to treat the digestate produced after the anaerobic treatment of pig manure in a biogas plant, aiming towards the recovery of nutrients and effective water treatment for potential reuse. Initially, coarse filtration (sieving and microfiltration) was used to remove particles larger than 1 µm, followed by ultrafiltration, to reduce the suspended solids concentrations below 1 g/L. Subsequently, selective electrodialysis is employed to recover the main nutrient ions, primarily ammonium and potassium. The ion-depleted digestate is then fed to a reverse osmosis unit, where clean water was recovered, yielding a by-product (concentrate) stream enriched in phosphates and organics content. The presence of antibiotics and the concentrations of heavy metals were monitored during all treatment stages to assess their behavior/removal in the various membrane processes. The results indicate that almost 51% of the digestate could be recovered as water free from ions and antibiotics, suitable for reuse in the biogas plant for process needs and irrigation purposes. The selective electrodialysis process can recover 51% of initial NH4+ content (corresponding to 96% of the electrodialysis feed), while the remainder largely ended up in the ultrafiltration concentrate. A similar behavior was observed for the case of K+, while approximately 68% of the phosphates content was retained by the coarse filtration process, with another 24% remaining in the ultrafiltration concentrate and the remaining 8% in the reverse osmosis concentrate. Most of the antibiotics and heavy metals were retained by the coarse and ultrafiltration steps, with smaller amounts detected in the reverse osmosis concentrate.

Recent advances on micro/nanoplastic pollution and membrane fouling during water treatment: A review

Effluent from sewage treatment plant, as an important source of microplastics (MPs) in receiving water, has attracted extensive attention. Membrane separation process shows good microplastic removal performance in the existing tertiary water treatment process. Problematically, membrane fouling and insufficient removal of small organic molecules are still the key obstacles to its further extensive application. Dissolved organics, extracellular polymers and suspended particles in the influent are deposited on the membrane surface and internal structure, reducing the number and pore diameter of effective membrane aperture, and increasing the resistance of membrane filtration. Exploring the mechanism and approach of membrane fouling caused by micro/nanoplastics is the key to alleviate fouling and allow membranes to operate longer. In this paper, removal performance of micro/nanoplastics by current membrane filtration and the contribution to membrane fouling during water treatment are thoroughly reviewed. The coupling mechanisms between micro/nanoplastics and other pollutants and mechanism of membrane fouling caused by composite micro/nanoplastics are discussed. Additionally, on this basis, the prospect of combined process for micro/nanoplastic removal and membrane fouling prevention is also proposed and discussed, which provides a valuable reference for the preferential removal of micro/nanoplastics and development of antifouling membrane.

Strong coupling of super-hydrophilic and vacancy-rich g-C3N4 and LDH heterostructure for wastewater purification: Adsorption-driven oxidation

Adsorption and wettability are crucial components of catalytic oxidation. To increase the reactive oxygen species (ROS) generation/utilization efficiency of peroxymonosulfate (PMS) activators, defect engineering and 2D nanosheet characteristics were used to regulate electronic structures and expose more active sites. Two-dimensional (2D) super-hydrophilic heterostructure by connecting cobalt species modified nitrogen vacancy-rich g-C₃N₄ (V_n-CN) and LDH (V_n-CN/Co/LDH) with high-density active sites and multi-vacancies, as well as high conductivity and adsorbability, to expedite ROS generation. The degradation rate constant of ofloxacin (OFX) was 0.441 min^-1 via the V_n-CN/Co/LDH/PMS system, which was 1-2 orders greater than in the previous studies. Confirmation of the contribution ratios of various reactive oxygen species (ROS), SO₄^·- and ¹O₂ in bulk solution, O₂^·- on the catalyst surface was the most abundant ROS. The catalytic membrane was constructed utilizing Vn-CN/Co/LDH as the assembly element. The 2D membrane achieved the continuous effective discharge of OFX in the simulated water after 80 h/4 cycles of continuous flowing-through filtration-catalysis. This study provides fresh insights into designing a PMS activator for environmental remediation activated on demand.

Modifications of microplastics in urban environmental management systems: A review

Microplastics (MPs) are a worldwide environmental pollution issue. Besides the natural environmental stresses, various treatments in urban environmental management systems induce modifications on MPs, further affecting their environmental behavior. Investigating these modifications and inherent mechanisms is crucial for assessing the environmental impact and risk of MPs. In this review, up-to-date knowledge regarding the modifications of MPs in urban environmental management systems was summarized. Variations of morphology, chemical composition, hydrophilicity and specific surface area of MPs were generalized. The aging and degradation of MPs during drinking water treatment, wastewater treatment, sewage sludge treatment and solid waste treatment were investigated. A high abundance of MPs occurred in sewage sludge and aging solid waste, while digestion and composting contributed to significant decomposition and reduction of MPs. These treatments have become converters for MPs before entering the environment. Several novel technologies for MPs removal were listed; However, no appropriate methods can be put into actual application by now, except the membrane separation. The corresponding effects of degradation on the behaviors of MPs, including adsorption, sinking and contaminant leakage, were discussed. Finally, three priorities for research were proposed. This critical review provides viewpoints and references for risk evaluation of MPs after treatments in urban environmental management systems.

The effect of pre-treatment methods on membrane flux, COD, and total phenol removal efficiencies for membrane treatment of pistachio wastewater

In this study, the effect of pre-treatment methods was investigated for membrane treatment of pistachio processing wastewater (PPW). Chemical coagulation, electrocoagulation, and electrooxidation processes were tested as the pretreatment methods to understand the effect of pretreatment on membrane performance. Alum (Al₂(SO₄)₃·18H₂O), iron (III) chloride (FeCl₃·6H₂O) and iron(II) sulfate (Fe(SO₄)·7H₂O) were used as coagulant and anionic polyelectrolyte was used as flocculant. Al-Al and Fe-Fe electrode pairs were used in the electrocoagulation experiments while platinum (Pt), boron doped diamond (BDD), and graphite were used in the electrooxidation experiments. UP150, NF270, and NF90 were used as the membranes. Chemical oxygen demand (COD) and total phenol removal efficiencies from wastewater were determined by considering membrane flux. For chemical coagulation experiments, the highest COD removal efficiency was determined as 44.9% for Al₂(SO₄)₃.18H₂O at 1000 mg/L when the wastewater pH value was 8.0. However, the highest total phenol removal efficiencies were obtined as 62.5% at 4000 mg/L for FeCl₃.6H₂O at pH 8. For electrocoagulation experiments, the highest COD and total phenol removal efficiencies were determined as 63.9% at pH 4.0 and 74.2% at pH 7.0, respectively, for 100 A/m² current density when aluminum electrode pairs were used. For electrooxidation experiments, the highest COD and total phenol removal efficiencies were determined as 61.2% at pH 4.0 and 83.1% at pH 10, respectively, for 200 A/m² current density when BDD-Pt electrode pairs were used. Raw PPW and pre-treated PPW with chemical coagulation, electrocoagulation, and electrooxidation processes were progressively further treated with ultrafiltration (UP150) and nanofiltration (NF270, NF90) membranes to improve COD and total phenol removal efficiencies. The results showed that the permeate of NF90 membrane supplied the highest COD (96.0%) and total phenol removal (97.5%) efficiencies for the raw wastewater. However, COD and total phenol removal efficiencies were determined as 98.6% and 100% for electrocoagulation + NF90, 97.9% and 100% for electrooxidation + NF90, 96.6% and 100% for chemical coagulation + NF90, respectively. The steady-state fluxes for NF90 membranes were 2.9, 7.0, and 8.6 L/m²h after chemical coagulation, electrooxidation, and electrocoagulation, respectively. The results depicted that electrocoagulation and electrooxidation were the most suitable pre-treatment methods for water recovery using NF90 membrane.

Monitoring the decolourisation efficacy of advanced membrane fabricated phytosilica nanoparticles in textile effluent water treatment

Silica nanoparticles are generally mesoporous that are predominant in the sand and rocks. Silica nanoparticles have a wide range of applications in various fields such as medicine, waste management, effluent treatment and electronics. The present work has explored the synthesis of silica nanoparticles through acid and alkaline leaching method from Pedalium murex which is a common weed that is found in southern parts of Tamil Nadu. Silica nanoparticles (SiNps) and its functional groups were confirmed by EDX and FTIR analysis with their respective energy dispersion levels and wavenumbers. Size, shape and morphological features of SiNps were analysed by PSA, TEM and SAED analysis. Synthesised and characterized nanosilica was crosslinked over nylon-66 and cellulose nitrate membranes and were confirmed by FTIR analysis for their crosslinking with SiNps. Water retention activity of the crosslinked and non crosslinked membranes was analysed by contact angle measurement to ensure the receptability of the membranes to remove contaminants by the adsorption. The decolourisation efficiency of the crosslinked nylon 66 membrane was found as a potential source for the treatment with 65.5% colour reduction when compared with other membranes. A slight reduction of solid profiles and COD ranges were achieved for crosslinked membranes than non crosslinked membranes.

Investigation of the treatability of molasses and industrial oily wastewater mixture by an anaerobic membrane hybrid system

In this study, the anaerobic treatability of automotive industry wastewater and its treatment in the subsequent membrane system were examined by using molasses, which is a waste of the sugar industry, as a co-substrate. Organic loadings of 3-3, 5-4, and 5gCOD/L/day were applied to a UASB reactor made of steel with a working volume of 7 L. The hydraulic retention time (HRT) was kept constant at 2 days. Temperature, pH, COD, alkalinity, Volatile Fatty acid (VFA) and biogas were monitored. The best COD removal was achieved at the value of 4 gCOD/L/day. The average COD removal rate was 77%. The effluent from the UASB reactor was transferred to the membrane system. The flux reductions of the PW10 kDa UF membrane at different concentrations were 1.717 gCOD/L, 1.934 gCOD/L, 2.257 gCOD/L, 4 gCOD/L, and 8 gCOD/L, and they were 90.78%, 42.69%, 45.88%, 51.00%, and 56.60%, respectively, at the input concentrations. The flux reductions of the UE50 100 kDa UF membrane at the input concentrations of 4 gCOD/L and 8 gCOD/L were 76.00% and 66.25%, respectively. It was determined that the UE50 100 kDa membrane caused more fouling compared to the PW 10 kDa UF membrane. Pore fouling models were determined for the flux reduction in the membranes and the mechanism behind it. Heavy metal and organic matter removals were examined in the effluent obtained from the membrane experiments.

Exposure of composite tannery effluent on snail, Pila globosa: A comparative assessment of toxic impacts of the untreated and membrane treated effluents

Effluent from tannery industries can significantly affect the aquatic environment due to the presence of a variety of recalcitrant components. The present study focuses on a comparative assessment of the toxic impacts of an untreated tannery effluent and membrane treated effluents using snail, Pila globosa as an aquatic model. Composite tannery effluent collected from a common effluent treatment plant was selected as the untreated effluent. To investigate the effect of treated effluents on the aquatic organism the effluent was treated by two ways, viz. a single stage microfiltration (MF) using ceramic membrane and a two-step process involving MF followed by reverse osmosis (RO). The whole body tissue, gonad and mantle of P. globosa were subjected to enzyme assays like superoxide dismutase (SOD), catalase (CAT), glutathione reductase (GR), glutathione peroxidase (GSH-GPx), glutathione S- transferase (GST), etc. for assessing toxic impact. Changes in the biochemical parameters like protein, carbohydrate and amino acid were observed including histological studies of gonad and mantle tissue upon treatment with tannery effluents. To examine potential DNA damage due to the exposure of the effluent, comet assay was conducted. The study revealed that with an exposure to the untreated effluent, activity of the antioxidant enzymes increased significantly while the protein and carbohydrate content reduced largely in the whole body tissue, gonad as well as mantle tissues of P. globosa. Histological study indicated considerable damage in the gonad and mantle tissues following exposure to the untreated effluent. Comet assay using hemolymph of P. globosa following exposure to tannery effluent, showed significant genotoxicity. Interestingly, compared to the untreated effluent, damaging effect was reduced in molluscs tissues when exposed to MF treated effluent and even lesser when exposed to MF+RO treated effluent. Apart from the reduced activities of oxidative stress enzymes, the protein, amino acid and carbohydrate content of molluscs exposed to both of the treated effluent were found close to that of control. Comet assay revealed no damage in the DNA for MF and MF+RO treated effluent indicating that the membrane based treatment procedure restores environmental condition to control level.