Insulin-Loaded Barium Salt Particles Facilitate Oral Delivery of Insulin in Diabetic Rats

Oral delivery is considered as the most preferred and yet most challenging mode of drug administration; especially a fragile and sensitive peptide like insulin that shows extremely low bioavailability through the gastro-intestinal (GIT) route. To address this problem, we have designed a novel drug delivery system (DDS) using precipitation-induced Barium (Ba) salt particles. The DDS can load insulin molecules and transport them through the GIT route. There were several in vitro simulation tests carried out to prove the efficiency of Ba salt particles as oral delivery candidates. All three Ba salt particles (BaSO₄, BaSO_3, and BaCO₃) showed very good loading of insulin (>70% in all formulations) and a degree of resistance throughout a wide range of pHs from basic to acidic conditions when assessed by spectrophotometry. Particles and insulin-associated particles were morphologically assessed and characterized using FE-SEM and FT-IR. A set of tests were designed and carried out with mucin to predict whether the particles are potentially capable of overcoming one of the barriers for crossing intestinal epithelium. The mucin binding experiment demonstrated 60–100% of mucin adhesion to the three different particles. FT-IR identifies the characteristic peaks for mucin protein, particles, and particle-mucin complex re-confirming mucin adhesion to the particles. Finally, the effectiveness of nano-insulin was tested on streptozotocin (STZ) induced diabetic rats. A short acting human insulin analog, insulin aspart, was loaded into Ba salt particles at a dose of 100 IU/Kg prior to oral administration. Among the three formulations, insulin aspart-loaded BaSO₄ and BaCO₃ particles dramatically reduced the existing hyperglycemia. BaSO₄ with loaded Insulin showed an onset of glucose-lowering action within 1 hr, with blood glucose level measured significantly lower compared to the 2nd and 3rd h (p < 0.05). Insulin-loaded BaCO₃ particles showed a significant decrease in blood glucose level at 1–2 h, although the glucose level started to show a slight rise at 3rd h and by 4th h, it was back to baseline level. However, although BaSO₃ particles with loaded insulin showed a trend of reduction in blood glucose level, the reduction was not found to be significant (p < 0.05) at any point in time. Therefore, oral formulations of insulin/BaSO₄ and insulin/BaCO₃ particles were observed as effective as native insulin aspart subcutaneous formulation in terms of onset and duration of action. Further investigation will be needed to reveal bioavailability and mechanism of action of this novel Nano-Insulin formulations.

Barium isotope fractionation during the experimental transformation of aragonite to witherite and of gypsum to barite, and the effect of ion (de)solvation

In this study, we present the experimental results for stable barium (Ba) isotope fractionation (¹³⁷Ba/¹³⁴Ba) during the transformation of aragonite (CaCO₃) and gypsum (CaSO₄·2H₂O) in Ba-bearing aqueous solution to witherite (BaCO₃) and barite (BaSO₄), respectively. The process was studied at three temperatures between 4 and 60 °C. In all cases, the transformation leads to a relative enrichment of the lighter ¹³⁴Ba isotope in the solid compared to the aqueous solution, with ^137/134Ba enrichment factors between -0.11 and -0.17 ‰ for BaCO₃, and -0.21 and -0.26 ‰ for BaSO₄. The corresponding mass-dependent ^138/134Ba enrichment factors are -0.15 to -0.23 ‰ for BaCO₃, and -0.28 to -0.35 ‰ for BaSO₄. The magnitude of isotope fractionation is within the range of recent reports for witherite and barite formation, as well as trace Ba incorporation into orthorhombic aragonite, and no substantial impact of temperature can be found between 4 and 80 °C. In previous studies, ion (de)solvation has been suggested to impact both the crystallization process of Ba-bearing solids and associated Ba isotope fractionation. Precipitation experiments of BaSO₄ and BaCO₃ using an methanol-containing aqueous solution indicate only a minor effect of ion and crystal surface (de)solvation on the overall Ba isotope fractionation process.

Multi-Step Crystallization of Barium Carbonate: Rapid Interconversion of Amorphous and Crystalline Precursors

The direct observation of amorphous barium carbonate (ABC), which transforms into a previously unknown barium carbonate hydrate (herewith named gortatowskite) within a few hundred milliseconds of formation, is described. In situ X-ray scattering, cryo-, and low-dose electron microscopy were used to capture the transformation of nanoparticulate ABC into gortatowskite crystals, highly anisotropic sheets that are up to 1 μm in width, yet only about 10 nm in thickness. Recrystallization of gortatowskite to witherite starts within 30 seconds. We describe a bulk synthesis and report a first assessment of the composition, vibrational spectra, and structure of gortatowskite. Our findings indicate that transient amorphous and crystalline precursors can play a role in aqueous precipitation pathways that may often be overlooked owing to their extremely short lifetimes and small dimensions. However, such transient precursors may be integral to the formation of more stable phases.

Mono- and bimetallic Rh and Pt NSR-catalysts prepared by controlled deposition of noble metals on support or storage component

Mono- and bimetallic Rh and Pt based NOx storage-reduction (NSR) catalysts, where the noble metals were deposited on the Al2O3 support or BaCO3 storage component, have been prepared using a twin flame spray pyrolysis setup. The catalysts were characterized by nitrogen adsorption, CO chemisorption combined with diffuse reflectance infrared Fourier transform spectroscopy, X-ray diffraction, and scanning transmission electron microscopy combined with energy dispersive X-ray spectroscopy. The NSR performance of the catalysts was investigated by fuel lean/rich cycling in the absence and presence of SO2 (25 ppm) as well as after H2 desulfation at 750 °C. The performance increased when Rh was located on BaCO3 enabling good catalyst regeneration during the fuel rich phase. Best performance was observed for bimetallic catalysts where the noble metals were separated, with Pt on Al2O3 and Rh on BaCO3. The Rh-containing catalysts generally showed much higher tolerance to SO2 during fuel rich conditions and lost only little activity during thermal aging at 750 °C.