Cellulose Nanofiber-Based Triboelectric Nanogenerators for Efficient Air Filtration in Harsh Environments

Advanced portable healthcare devices with high efficiencies, small pressure drops, and high-temperature resistance are urgently desired in harsh environments with high temperatures, high humidities, and high levels of atmospheric pollution. Triboelectric nanogenerators (TENGs), which serve as energy converters in a revolutionary self-powered sensor device, present a sustainable solution for meeting these requirements. In this work, we developed a porous negative triboelectric material by synthesizing ZIF-8 on the surface of a cellulose/graphene oxide aerogel, grafting it with trimethoxy(1H,1H,2H,2H-heptadecafluorodecyl)silane, and adding a negative corona treatment, and it was combined with a positive triboelectric material to create a cellulose nanofiber-based TENG self-powered filter. The devices achieved a balance between a small pressure drop (53 Pa) and high filtration efficiency (98.97%, 99.65%, and 99.93% for PM0.3, PM0.5, and PM1, respectively), demonstrating robust filtration properties at high temperatures and high humidities. Our work provides a new approach for developing self-powered wearable healthcare devices with excellent air filtration properties.

Effect of Nanoparticles on Rheological Properties of Water-Based Drilling Fluid

Nano-water-based drilling fluids (NWBDFs) are prepared using nano-copper oxide (CuO) and multiwalled carbon nanotubes (MWCNTs) as modification materials. The effects of the temperature and concentration of the nanoparticles (NPs) on the rheological properties are studied using a rotational rheometer and viscometer. Also, the influence of two NPs on the filtration properties is studied using a low-pressure and low-temperature filtration apparatus, as well as a scanning electron microscope (SEM). It is found that MWCNTs with a concentration of 0.05 w/v% have the most obvious influence on the NWBDFs, which improve the stability of the gel structure against temperature and also decrease the filtration rate. Finally, a theoretical model predicating the yield point (YP) and the plastic viscosity (PV) as a function of the temperature considering the influence of the NPs is developed based on DLVO theory.

Fabrication and Characterization of Single Phase α-Alumina Membranes with Tunable Pore Diameters

Nanoporous and single phase α-alumina membranes with pore diameters tunable over a wide range of approximately 60-350 nm were successfully fabricated by optimizing the conditions for anodizing, subsequent detachment, and heat treatment. The pore diameter increased and the cell diameter shrunk upon crystallization to α-alumina by approximately 20% and 3%, respectively, in accordance with the 23% volume shrinkage resulting from the change in density associated with the transformation from the amorphous state to α-alumina. Nevertheless, flat α-alumina membranes, each with a diameter of 25 mm and a thickness of 50 μm, were obtained without thermal deformation. The α-alumina membranes exhibited high chemical resistance in various concentrated acidic and alkaline solutions as well as when exposed to high temperature steam under pressure. The Young's modulus and hardness of the single phase α-alumina membranes formed by heat treatment at 1250 °C were notably decreased compared to the corresponding amorphous membranes, presumably because of the nodular crystallite structure of the cell walls and the substantial increase in porosity. Furthermore, when used for filtration, the α-alumina membrane exhibited a level of flux higher than that of the commercial ceramic membrane.