Compact Tissue-equivalent Proportional Counter for Deep Space Human Missions

Effects on human health from the complex radiation environment in deep space have not been measured and can only be simulated here on Earth using experimental systems and beams of radiations produced by accelerators, usually one beam at a time. This makes it particularly important to develop instruments that can be used on deep-space missions to measure quantities that are known to be relatable to the biological effectiveness of space radiation. Tissue-equivalent proportional counters (TEPCs) are such instruments. Unfortunately, present TEPCs are too large and power intensive to be used beyond low Earth orbit (LEO). Here, the authors describe a prototype of a compact TEPC designed for deep space applications with the capability to detect both ambient galactic cosmic rays and intense solar particle event radiation. The device employs an approach that permits real-time determination of yD (and thus quality factor) using a single detector. This was accomplished by assigning sequential sampling intervals as detectors “1” and “2” and requiring the intervals to be brief compared to the change in dose rate. Tests with g rays show that the prototype instrument maintains linear response over the wide dose-rate range expected in space with an accuracy of better than 5% for dose rates above 3 mGy h(-1). Measurements of yD for 200 MeV n(-1) carbon ions were better than 10%. Limited tests with fission spectrum neutrons show absorbed dose-rate accuracy better than 15%.

Measurement of CP-violating asymmetries in B0 decays to CP eigenstates

We present measurements of time-dependent CP-violating asymmetries in neutral B decays to several CP eigenstates. The measurement uses a data sample of 23x10(6) Upsilon(4S)-->BbarB decays collected by the BABAR detector at the PEP-II asymmetric B Factory at SLAC. In this sample, we find events in which one neutral B meson is fully reconstructed in a CP eigenstate containing charmonium and the flavor of the other neutral B meson is determined from its decay products. The amplitude of the CP-violating asymmetry, which in the standard model is proportional to sin2beta, is derived from the decay time distributions in such events. The result is sin2beta = 0.34+/-0.20 (stat)+/-0.05 (syst).

Analysis of interlaboratory performance in the determination of total selenium in water

This study explored the performance of experienced laboratories in the analysis for total selenium in water by a variety of analytical methods. The goal of the study was to examine intra- and interlaboratory variability. Replicates (n = 7) of 7 sample types that included a reference material of known Se concentration, natural waters, and treated wastewaters were submitted to 7 laboratories with prequalified Se analytical experience. Results of the study indicated wide ranges in minimum and maximum results, distinct differences in laboratory precision, and routine reporting of numerical results below statistical limits of quantitation. Hydride generation as a sample introduction technique demonstrated superior performance. In general, the study supports a caution advisory about using low-level Se data, especially results lower than about 10 micrograms Se/L, without quantitating the statistical uncertainty of the data. Because this study used data from samples that were submitted in bulk to participating laboratories prequalified for Se analytical expertise and experience, it can be considered a best-case demonstration of performance.

The correlation between serum selenium and blood selenium in cattle

The selenium (Se) concentration of paired blood and serum samples from cattle was determined by 2 methods: 1) atomic absorption spectroscopy using hydride generation (HG-AAS), and 2) inductively coupled argon plasma emission spectroscopy using hydride generation (ICP). Samples from 327 cattle were analyzed by HG-AAS, and samples from 344 cattle were analyzed by ICP. The data were examined by linear regression analysis, and the technique of inverse prediction was utilized to determine prediction intervals for estimating blood Se concentration from known serum Se concentration. The correlation coefficients, by simple linear regression of serum Se on blood Se, were 0.79 (r2 = 0.62) and 0.88 (r2 = 0.77) for the HG-AAS data and the ICP data, respectively. For the HG-AAS data, the inverse prediction formula for estimating blood Se when serum Se is known, at the 95% prediction interval, was [formula; see text]. For the ICP data, the inverse prediction formula for estimating blood Se when serum Se is known, at the 95% prediction interval, was [formula; see text]. The prediction intervals were quite wide, and the accuracy of estimating blood Se from a known serum Se was not useful for diagnostic purposes. The use of serum Se concentration to assess nutritional status of cattle with respect to Se does not appear to be appropriate.

Unstable injectable selenium treatments that may be toxic to cattle

High or toxic tissue levels of selenium resulted from administration of the aqueous layer of an unstable injectable oil emulsion of selenium and vitamins A and D. Since selenium partitioned from hydrophobic to aqueous media in the poorly mixed product, the aqueous portions constituted a significant threat to health.

Reliable, inexpensive microcomputer interface for the optical multichannel analyzer (OMA)

A microprocessor system and interface for the optical multichannel analyzer (OMA) is described. The interface hardware and software are very simple and easy to implement. The microcomputer is used in conjunction with the OMA in the 2-d (two-dimensional) mode as the data acquisition, analysis and storage system for a 8-ps-resolution transient absorption spectrometer. However, the microcomputer and interface hardware and software are of general use in any application where rapid transfer, processing and storage of spectroscopic information from the OMA are required.