Statistical groupings of mental and social health measurements correlate with musculoskeletal capability - A cross sectional study

OBJECTIVE

A better understanding of the degree to which social health factors contribute uniquely to statistical clusters associated with variation in levels of capability might inform targeted whole person care strategies for more comprehensive management of musculoskeletal health. Therefore, we asked: (1) What are the statistical groupings of social and mental health measurements in patients seeking specialty care for musculoskeletal conditions? (2) Do identified psychosocial groupings correspond with different mean magnitudes of incapability accounting for demographic and clinical factors?

METHODS

We included 158 patients seeking musculoskeletal specialty care and collected measures of magnitude of incapability, unhelpful thoughts and distress regarding symptoms, symptoms of depression, symptoms of anxiety, and social health. A k-means clustering algorithm was fit to the data and a linear regression model compared mean PROMIS-PF CAT scores for grouping.

RESULTS

A quantitative social health measure contributed to 4 statistical clusters as follows: 1) relatively low levels of all mental health measures and high social health; 2) greater unhelpful thoughts and distress regarding symptoms, average symptoms of general anxiety and depression, and average social health; 3) higher levels of all mental health measures and severely compromised social health; and 4) severely compromised mental health and lower social health. Magnitude of incapability was significantly greater for groups with worse mental and social health.

CONCLUSION

The finding of a relatively independent association of social and mental health factors with greater incapability supports the importance of introducing comprehensive health strategies in musculoskeletal specialty care. Strategies may include mindset training and case management of social unmet needs.

LEVEL OF EVIDENCE

Level III; Cross-sectional study.

Comparison of proactive and conventional treatment of anastomotic leakage in rectal cancer surgery: a multicentre retrospective cohort series

PURPOSE

Comparative studies on efficacy of treatment strategies for anastomotic leakage (AL) after low anterior resection (LAR) are almost non-existent. This study aimed to compare different proactive and conservative treatment approaches for AL after LAR.

METHODS

This retrospective cohort study included all patients with AL after LAR in three university hospitals. Different treatment approaches were compared, including a pairwise comparison of conventional treatment and endoscopic vacuum-assisted surgical closure (EVASC). Primary outcomes were healed and functional anastomosis rates at end of follow-up.

RESULTS

Overall, 103 patients were included, of which 59 underwent conventional treatment and 23 EVASC. Median number of reinterventions was 1 after conventional treatment, compared to 7 after EVASC (p < 0.01). Median follow-up was 39 and 25 months, respectively. Healed anastomosis rate was 61% after conventional treatment, compared to 78% after EVASC (p = 0.139). Functional anastomosis rate was higher after EVASC, compared to conventional treatment (78% vs. 54%, p = 0.045). Early initiation of EVASC in the first week after primary surgery resulted in better functional anastomosis rate compared to later initiation (100% vs. 55%, p = 0.008).

CONCLUSION

Proactive treatment of AL consisting of EVASC resulted in improved healed and functional anastomosis rates for AL after LAR for rectal cancer, compared to conventional treatment. If EVASC was initiated within the first week after index surgery, a 100% functional anastomosis rate was achievable.

The InSight HP3 Penetrator (Mole) on Mars: Soil Properties Derived from the Penetration Attempts and Related Activities

The NASA InSight Lander on Mars includes the Heat Flow and Physical Properties Package HP³ to measure the surface heat flow of the planet. The package uses temperature sensors that would have been brought to the target depth of 3-5 m by a small penetrator, nicknamed the mole. The mole requiring friction on its hull to balance remaining recoil from its hammer mechanism did not penetrate to the targeted depth. Instead, by precessing about a point midway along its hull, it carved a 7 cm deep and 5-6 cm wide pit and reached a depth of initially 31 cm. The root cause of the failure - as was determined through an extensive, almost two years long campaign - was a lack of friction in an unexpectedly thick cohesive duricrust. During the campaign - described in detail in this paper - the mole penetrated further aided by friction applied using the scoop at the end of the robotic Instrument Deployment Arm and by direct support by the latter. The mole tip finally reached a depth of about 37 cm, bringing the mole back-end 1-2 cm below the surface. It reversed its downward motion twice during attempts to provide friction through pressure on the regolith instead of directly with the scoop to the mole hull. The penetration record of the mole was used to infer mechanical soil parameters such as the penetration resistance of the duricrust of 0.3-0.7 MPa and a penetration resistance of a deeper layer ( > 30 cm depth) of 4.9 ± 0.4 MPa . Using the mole's thermal sensors, thermal conductivity and diffusivity were measured. Applying cone penetration theory, the resistance of the duricrust was used to estimate a cohesion of the latter of 2-15 kPa depending on the internal friction angle of the duricrust. Pushing the scoop with its blade into the surface and chopping off a piece of duricrust provided another estimate of the cohesion of 5.8 kPa. The hammerings of the mole were recorded by the seismometer SEIS and the signals were used to derive P-wave and S-wave velocities representative of the topmost tens of cm of the regolith. Together with the density provided by a thermal conductivity and diffusivity measurement using the mole's thermal sensors, the elastic moduli were calculated from the seismic velocities. Using empirical correlations from terrestrial soil studies between the shear modulus and cohesion, the previous cohesion estimates were found to be consistent with the elastic moduli. The combined data were used to derive a model of the regolith that has an about 20 cm thick duricrust underneath a 1 cm thick unconsolidated layer of sand mixed with dust and above another 10 cm of unconsolidated sand. Underneath the latter, a layer more resistant to penetration and possibly containing debris from a small impact crater is inferred. The thermal conductivity increases from 14 mW/m K to 34 mW/m K through the 1 cm sand/dust layer, keeps the latter value in the duricrust and the sand layer underneath and then increases to 64 mW/m K in the sand/gravel layer below.

SUPPLEMENTARY INFORMATION

The online version contains supplementary material available at 10.1007/s11214-022-00941-z.

High incidence of HCV in HIV-negative men who have sex with men using pre-exposure prophylaxis

BACKGROUND & AIMS

HCV has emerged as a sexually transmitted infection (STI) among HIV-positive men who have sex with men (MSM). We evaluated HCV incidence and its risk factors among HIV-negative MSM using HIV pre-exposure prophylaxis (PrEP).

METHODS

Participants of the Amsterdam PrEP project were tested for HCV antibodies or HCV-RNA every 6 months. Participants used daily or event-driven PrEP and could switch regimens during follow-up. We calculated incidence rates (IRs) for overall HCV infection and separately for primary and re-infection. A univariable Bayesian exponential survival model was used to identify risk factors associated with incident HCV infection. The HCV NS5B gene fragment (709 bp) was sequenced and compared to HCV isolates from HIV-positive MSM and other risk groups (n = 419) using phylogenetic analysis.

RESULTS

Among 350 participants contributing 653.6 person-years (PYs), we detected 15 HCV infections in 14 participants (IR = 2.30/100PY). There were 8 primary infections (IR = 1.27/100PY) and 7 re-infections (IR = 27.8/100PY). IR was 2.71/100PY in daily and 1.15/100PY in event-driven PrEP users. Factors associated with incident HCV infection were higher number of receptive condomless anal sex acts with casual partners (posterior hazard ratio [HR] 1.57 per ln increase; 95% credibility interval [CrI] 1.09-2.20), anal STI (posterior HR 2.93; 95% CrI 1.24-7.13), injecting drug use (posterior HR 4.69; 95% CrI 1.61-12.09) and sharing straws when snorting drugs (posterior HR 2.62; 95% CrI 1.09-6.02). We identified robust MSM-specific HCV clusters of subtypes 1a, 4d, 2b and 3a, which included MSM with and without HIV.

CONCLUSIONS

HIV-negative MSM using PrEP are at risk of incident HCV infection, while identified risk factors are similar to those in HIV-positive MSM. Regular HCV testing is needed, especially for those with a previous HCV infection and those reporting risk factors.

LAY SUMMARY

We report that hepatitis C virus infections are frequently acquired among HIV-negative men who have sex with men (MSM) using pre-exposure prophylaxis to prevent HIV infection. New infections occurred more frequently in those reporting receptive anal sex without using condoms, having an anal sexually transmitted infection, injecting drugs, and sharing straws when snorting drugs. The viruses found in HIV-negative men using pre-exposure prophylaxis are genetically similar to those in HIV-positive men, but not in other hepatitis C risk groups, suggesting that (sexual) transmission is occurring between HIV-positive MSM and HIV-negative MSM using pre-exposure prophylaxis.

CLINICAL TRIAL NUMBER

Dutch trial registration number NTR5411.