Surface Enhanced Raman Scattering in Graphene Quantum Dots Grown via Electrochemical Process

Graphene Quantum dots (GQDs) are used as a surface-enhanced Raman substrate for detecting target molecules with large specific surface areas and more accessible edges to enhance the signal of target molecules. The electrochemical process is used to synthesize GQDs in the solution-based process from which the SERS signals were obtained from GQDs Raman spectra. In this work, GQDs were grown via the electrochemical process with citric acid and potassium chloride (KCl) electrolyte solution to obtain GQDs in a colloidal solution-based format. Then, GQDs were characterized by transmission electron microscope (TEM), Fourier-transform infrared spectroscopy (FTIR), and Raman spectroscopy, respectively. From the results, SERS signals had observed via GQDs spectra through the Raman spectra at D (1326 cm^-1) and G (1584 cm^-1), in which D intensity is defined as the presence of defects on GQDs and G is the sp² orbital of carbon signal. The increasing concentration of KCl in the electrolyte solution for 0.15M to 0.60M demonstrated the increment of Raman intensity at the D peak of GQDs up to 100 over the D peak of graphite. This result reveals the potential feasibility of GQDs as SERS applications compared to graphite signals.

Ultrathin Bismuth Film on High-Temperature Cuprate Superconductor Bi2Sr2CaCu2O8+δ as a Candidate of a Topological Superconductor

One of the key challenges in condensed-matter physics is to establish a topological superconductor that hosts exotic Majorana fermions. Although various heterostructures consisting of conventional BCS (Bardeen-Cooper-Schrieffer) superconductors as well as doped topological insulators were intensively investigated, no conclusive evidence for Majorana fermions has been provided. This is mainly because of their very low superconducting transition temperatures ( T_c) and small superconducting-gap magnitude. Here, we report a possible realization of topological superconductivity at very high temperatures in a hybrid of Bi(110) ultrathin film and copper oxide superconductor Bi₂Sr₂CaCu₂O_8+δ (Bi2212). Using angle-resolved photoemission spectroscopy and scanning tunneling microscopy, we found that three-bilayer-thick Bi(110) on Bi2212 exhibits a proximity-effect-induced s-wave energy gap as large as 7.5 meV which persists up to T_c of Bi2212 (85 K). The small Fermi energy and strong spin-orbit coupling of Bi(110), together with the large pairing gap and high T_c, make this system a prime candidate for exploring stable Majorana fermions at very high temperatures.

Effect of Annealing Temperature on ECD Grown Hexagonal-Plane Zinc Oxide

Zinc oxide (ZnO) offers a great potential in several applications from sensors to Photovoltaic cells thanks to the material's dependency, to its optical and electrical properties and crystalline structure architypes. Typically, ZnO powder tends to be grown in the form of a wurtzite structure allowing versatility in the phase of material growths; albeit, whereas in this work we introduce an alternative in scalable yet relatively simple 2D hexagonal planed ZnO nanoflakes via the electrochemical deposition of commercially purchased Zn(NO₃)₂ and KCl salts in an electrochemical process. The resulting grown materials were analyzed and characterized via a series of techniques prior to thermal annealing to increase the grain size and improve the crystal quality. Through observation via scanning electron microscope (SEM) images, we have analyzed the statistics of the grown flakes' hexagonal plane's size showing a non-monotonal strong dependency of the average flake's hexagonal flakes' on the annealing temperature, whereas at 300 °C annealing temperature, average flake size was found to be in the order of 300 μm². The flakes were further analyzed via transmission electron microscopy (TEM) to confirm its hexagonal planes and spectroscopy techniques, such as Raman Spectroscopy and photo luminescence were applied to analyze and confirm the ZnO crystal signatures. The grown materials also underwent further characterization to gain insights on the material, electrical, and optical properties and, hence, verify the quality of the material for Photovoltaic cells' electron collection layer application. The role of KCl in aiding the growth of the less preferable (0001) ZnO is also investigated via various prospects discussed in our work. Our method offers a relatively simple and mass-producible method for synthesizing a high quality 2D form of ZnO that is, otherwise, technically difficult to grow or control.

Tuning Rashba Spin-Orbit Coupling in Gated Multilayer InSe

Manipulating the electron spin with the aid of spin-orbit coupling (SOC) is an indispensable element of spintronics. Electrostatically gating a material with strong SOC results in an effective magnetic field which can in turn be used to govern the electron spin. In this work, we report the existence and electrostatic tunability of Rashba SOC in multilayer InSe. We observed a gate-voltage-tuned crossover from weak localization (WL) to weak antilocalization (WAL) effect in quantum transport studies of InSe, which suggests an increasing SOC strength. Quantitative analyses of magneto-transport studies and energy band diagram calculations provide strong evidence for the predominance of Rashba SOC in electrostatically gated InSe. Furthermore, we attribute the tendency of the SOC strength to saturate at high gate voltages to the increased electronic density of states-induced saturation of the electric field experienced by the electrons in the InSe layer. This explanation of nonlinear gate voltage control of Rashba SOC can be generalized to other electrostatically gated semiconductor nanomaterials in which a similar tendency of spin-orbit length saturation was observed (e.g., nanowire field effect transistors), and is thus of broad implications in spintronics. Identifying and controlling the Rashba SOC in InSe may serve pivotally in devising III-VI semiconductor-based spintronic devices in the future.

V2O5: A 2D van der Waals Oxide with Strong In-Plane Electrical and Optical Anisotropy

V₂O₅ with a layered van der Waals (vdW) structure has been widely studied because of the material's potential in applications such as battery electrodes. In this work, microelectronic devices were fabricated to study the electrical and optical properties of mechanically exfoliated multilayered V₂O₅ flakes. Raman spectroscopy was used to determine the crystal structure axes of the nanoflakes and revealed that the intensities of the Raman modes depend strongly on the relative orientation between the crystal axes and the polarization directions of incident/scattered light. Angular dependence of four-probe resistance measured in the van der Pauw (vdP) configuration revealed an in-plane anisotropic resistance ratio of ∼100 between the a and b crystal axes, the largest in-plane transport anisotropy effect experimentally reported for two-dimensional (2D) materials to date. This very large resistance anisotropic ratio is explained by the nonuniform current flow in the vdP measurement and an intrinsic mobility anisotropy ratio of 10 between the a and b crystal axes. Room-temperature electron Hall mobility up to 7 cm²/(V s) along the high-mobility direction was obtained. This work demonstrates V₂O₅ as a layered 2D vdW oxide material with strongly anisotropic optical and electronic properties for novel applications.

Imaging the Long Transport Lengths of Photo-generated Carriers in Oriented Perovskite Films

Organometal halide perovskite has emerged as a promising material for solar cells and optoelectronics. Although the long diffusion length of photogenerated carriers is believed to be a critical factor responsible for the material's high efficiency in solar cells, a direct study of carrier transport over long distances in organometal halide perovskites is still lacking. We fabricated highly oriented crystalline CH₃NH₃PbI₃ (MAPbI₃) thin-film lateral transport devices with long channel length (∼120 μm). By performing spatially scanned photocurrent imaging measurements with local illumination, we directly show that the perovskite films prepared here have very long transport lengths for photogenerated carriers, with a minority carrier (electron) diffusion length on the order of 10 μm. Our approach of applying scanning photocurrent microscopy to organometal halide perovskites may be further used to elucidate the carrier transport processes and the vastly different carrier diffusion lengths (∼100 nm to 100 μm) in different types of organometal halide perovskites.

Screening limited switching performance of multilayer 2D semiconductor FETs: the case for SnS

Gate tunable p-type multilayer tin mono-sulfide (SnS) field-effect transistor (FET) devices with SnS thickness between 50 and 100 nm were fabricated and studied to understand their performance. The devices showed anisotropic inplane conductance and room temperature field effect mobilities ∼5-10 cm² V^-1 s^-1. However, the devices showed an ON-OFF ratio ∼10 at room temperature due to appreciable OFF state conductance. The weak gate tuning behavior and finite OFF state conductance in the depletion regime of SnS devices are explained by the finite carrier screening length effect which causes the existence of a conductive surface layer from defect induced holes in SnS. Through etching and n-type surface doping by Cs₂CO₃ to reduce/compensate the not-gatable holes near the SnS flake's top surface, the devices exhibited an order of magnitude improvement in the ON-OFF ratio, and a hole Hall mobility of ∼100 cm² V^-1 s^-1 at room temperature is observed. This work suggests that in order to obtain effective switching and low OFF state power consumption, two-dimensional (2D) semiconductor based depletion mode FETs should limit their thickness to within the Debye screening length of the carriers in the semiconductor.

Intrinsic Electron Mobility Exceeding 10³ cm²/(V s) in Multilayer InSe FETs

Graphene-like two-dimensional (2D) materials not only are interesting for their exotic electronic structure and fundamental electronic transport or optical properties but also hold promises for device miniaturization down to atomic thickness. As one material belonging to this category, InSe, a III-VI semiconductor, not only is a promising candidate for optoelectronic devices but also has potential for ultrathin field effect transistor (FET) with high mobility transport. In this work, various substrates such as PMMA, bare silicon oxide, passivated silicon oxide, and silicon nitride were used to fabricate multilayer InSe FET devices. Through back gating and Hall measurement in four-probe configuration, the device's field effect mobility and intrinsic Hall mobility were extracted at various temperatures to study the material's intrinsic transport behavior and the effect of dielectric substrate. The sample's field effect and Hall mobilities over the range of 20-300 K fall in the range of 0.1-2.0 × 10(3) cm(2)/(V s), which are comparable or better than the state of the art FETs made of widely studied 2D transition metal dichalcogenides.