Determination of butyltin compounds in marine biological samples by enzymatic hydrolysis and HG-GC-QFAAS detection

Optimization of an analytical method for determining organotin compounds in fish tissue by base-hydrolysis pretreatment and simultaneous ethylation–extraction procedures

To determine butyl- and phenyl-tins in fish muscle, a method including base digestion pretreatment, followed by a simultaneous ethylation-extraction procedure and gas chromatograph-flame photometric detector (GC-FPD) analysis is outlined. Key parameters that influence analyte recovery were investigated and optimized. A solution of 3% (w/v) potassium hydroxide (KOH) and 1 h digestion time at 60 degrees C were chosen in the base digestion step, to ensure complete solubilization of fish muscle and the decomposition of organotins was found to be insignificant. We found that the ratio of fish muscle/reaction solution should not exceed 0.2 g (dry weight) per 100 mL in order to avoid the matrix effect caused by the binding of hydrolyzed fish tissue with organotin ions. Ethylation of organotins were conducted at pH 6-7 with a 1% (w/v) sodium tetraethylborate (NaBEt(4)) solution for 1 h. This simple and timesaving procedure should be able to be applied to the routine analysis of organotins in other bio-tissues.

Physico-chemical approach to study organotin sorption-desorption during solid-phase microextraction

Solid-phase microextraction (SPME) has become a real alternative to liquid-liquid extraction in the field of speciation of organometallic compounds. Despite the high performance of this preconcentration technique, matrix effects in natural samples can affect the analytical precision. In order to understand the origin of these disturbances and control the extraction step as best as possible, the sorption-desorption behaviour of organotins was studied. In the first part, this paper discusses the analytical problems encountered in the daily use of SPME due to the particular problems observed for phenyltins. The sorption profile of these compounds was modelled using experimental design methodology to confirm the first-order kinetics. Desorption of the compounds was also observed after a given time and could not be attributed to competition between organotin compounds. In the same way, butyl- and phenyltins were studied in the presence of humic substances, which acted as representatives of organic matter found in natural samples. These substances drastically decrease the extraction yields, but do not affect the sorption profile of butyl- and phenyltins.

Sample treatment in chromatography-based speciation of organometallic pollutants

Speciation analysis is nowadays performed routinely in many laboratories to control the quality of the environment, food and health. Chemical speciation analyses generally include the study of different oxidation state of elements or individual organometallic compounds. The determination of the different chemical forms of elements is still an analytical challenge, since they are often unstable and concentrations in different matrices of interest are in the microg l(-1) or even in the ng l(-1) range (e.g., estuarine waters) or ng g(-1) in sediments and biological tissues. For this reason, sensitive and selective analytical atomic techniques are being used as available detectors for speciation, generally coupled with chromatography for the time-resolved introduction of analytes into the atomic spectrometer. The complexity of these instrumental couplings has a straightforward consequence on the duration of the analysis, but sample preparation to separate and transfer the chemical species present in the sample into a solution to be accepted readily by a chromatographic column is the more critical step of total analysis, and demands considerable operator skills and time cost. Traditionally, liquid-liquid extraction has been employed for sample treatment with serious disadvantages, such as consumption, disposal and long-term exposure to organic solvent. In addition, they are usually cumbersome and time-consuming. Therefore, the introduction of new reagents such as sodium tetraethylborate for the simultaneous derivatization of several elements has been proposed. Other possibilities are based in the implementation of techniques for efficient and accelerated isolation of species from the sample matrix. This is the case for microwave-assisted extraction, solid-phase extraction and microextraction, supercritical fluid extraction or pressurized liquid extraction, which offer new possibilities in species treatment, and the advantages of a drastic reduction of the extraction time and the embodiment into on-line flow analysis systems. This new generation of treatment techniques constitutes a good choice as fast extraction methods for feasible species-selective analysis of organometallic compounds under the picogram level, that can be used for national regulatory agencies, governmental and industrial quality control laboratories, and consequently, for manufacturers of analytical instrumentation.

Liquid chromatography with fluorimetric detection of triorganotin compounds in marine biological materials

Several extraction methods have been evaluated for marine biological materials with regard to tributyltin and triphenyltin determination by liquid chromatography with post-column fluorimetric detection using fisetin as a fluorogenic reagent. Extraction with ethyl acetate in a hydrochloric acid medium has been shown to be the most appropriate extraction method and it has been successfully applied to fish (sea bass) reference material from the National Institute for Environmental Studies (NIES-11) and to a candidate reference material.