Multiplication in Serratia of a bacteriophage originating from Escherichia coli: Lysogenization and host-controlled variation

Functions involved in bacteriophage P2-induced host cell lysis and identification of a new tail gene

Successful completion of the bacteriophage P2 lytic cycle requires phage-induced lysis of its Escherichia coli host, a process that is poorly understood. Genetic analysis of lysis-deficient mutants defined a single locus, gene K, which lies within the largest late transcription unit of P2 and maps between head gene L and tail gene R. We determined and analyzed the DNA sequence of a ca. 2.1-kb EcoRV fragment that spans the entire region from L to R, thus completing the sequence of this operon. This region contains all of the functions necessary for host cell lysis. Sequence analysis revealed five open reading frames, initially designated orf19 through orf23. All of the existing lysis mutants--ts60, am12, am76, and am218--were located in orf21, which must therefore correspond to gene K. The K gene product has extensive amino acid sequence similarity to the product of gene R of bacteriophage lambda, and its exhibits endolysin function. Site-directed mutagenesis and reverse genetics were used to create P2 amber mutants in each of the four other newly identified open reading frames. Both orf19 (gene X) and orf20 (gene Y) encode essential functions, whereas orf22 (lysA) and orf23 (lysB) are nonessential. Gene Y encodes a polypeptide with striking similarities to the family of holin proteins exemplified by gpS of phage lambda, and the Yam mutant displayed the expected properties of a holin mutant. The gene products of lysA and lysB, although nonessential, appear to play a role in the correct timing of lysis, since a lysA amber mutant caused slightly accelerated lysis and a lysB amber mutant slightly delayed lysis of nonpermissive strains. Gene X must encode a tail protein, since lysates from nonpermissive cells infected with the X amber mutant were complemented in vitro by similar lysates of cells infected with P2 head mutants but not with tail mutants.

Characterization of phage 18, an unstable coliphage

Phage 18, a noninducible coliphage, is quite unstable and therefore difficult to study. Newly developed very gentle lysis and mounting techniques yielded isolated virions for examination by electron microscopy. The phage has a contractile tail with a length of 130 nm and an isometric head with a capsid diameter of 50 nm. Phage 18 is similar in morphology to phage P2 but is heteroimmune to it. DNA extracted from a clear-plaque mutant of phage 18 was subjected to BamHI restriction endonuclease digestion and was found to be easily distinguishable from the published restriction patterns for P2, phage 299, or phage 186 DNA. The genome size was calculated to be 33.5 kb. Using the DNA melting point, phage 18 DNA (G+C) content was determined to be 55.0% and its buoyant density was determined to be 1.715.

Deletions in bacteriophage P2. Circularity of the genetic map and its orientation relative to the DNA denaturation map

Several types of viable chromosomal deletions of bacteriophage P2 were isolated. One type gives the immunity insensitive phenotype and may extend to the genes for the immunity repressor (C) and for integrative recombination (int). Two other types delete genes (old and fun) known to be active in the lysogenic state. For such deletion mutants the relationship between particle density and DNA length was established. The deletions were located in respect to previously mapped genes and the results were compared with electron microscopical studies (by Inman and collaborators) of the P2 chromosome. It is concluded that the best representation of the genetic map of P2 is circular. The cohesive ends of the linear P2 DNA molecule are most likely formed between genes old and Q. Except for the neighborhood of gene old, the previously published, linear genetic map of P2 (Lindahl) is colinear with the melting map of the P2 chromosome (Inman). Preliminary evidence for some specific recombination event often accompanying integrative recombination between phage chromosomes is presented.

Isolation of a polyvalent bacteriophage for Escherichia coli, Klebsiella pneumoniae, and Aerobacter aerogenes

A lytic bacteriophage isolated from sewage was found to attack strains of Aerobacter aerogenes, Escherichia coli, and Klebsiella pneumoniae, but not members of the genera Salmonella, Proteus, and Serratia. The phage, designated phimp, contained deoxyribonucleic acid with a 50% guanine plus cytosine ratio and a molecular weight of 23.1 x 10(6) daltons. Single-step growth experiments of phimp plated at 37 C on A. aerogenes A2 gave a mean latent period of 20 min, an average burst size of 103 plaque-forming units/infected cell, and an average adsorption rate constant of 3 x 10(-10) ml/min. Electron microscopy of phimp revealed a phage with a flexible tail (165 nm long and 6 nm wide). The phage head had a hexagonal outline (62 nm in diameter).

A simple technique for the identification of chain termination suppressor mutants in species of Salmonella

Chain-termination suppressors which are almost certainly amber suppressors have been isolated inSalmonella anatumby a technique involving the use of amber mutants of bacteriophage 01. The same technique could be used in any species ofSalmonella(and many strains of Arizona) and analogous techniques are suggested for use in other genera of bacteria and in higher plants.