Determination of gas–liquid partition coefficients by gas chromatography

IGC investigation of the effect of the length of the n-alkyl substituent in 5-alkylsubstituted norbornenes on solute retention

Polymerization of 5-n-alkyl-substituted 2-norbornenes synthesized a series of polymers having the same structure of the main polymer chain, but differing in the length of the alkyl substituent (up to 14 methylene units). The obtained polymers were studied by the capillary IGC method as a stationary phase during separation of a mixture of normal hydrocarbons C6-C10. Retention data in the form of a logarithm of the retention factor lnk were correlated with the size of the sorbate (via the carbon number of the alkane ZS) and with the size of the n-alkyl substituent in the polymer chain (via the carbon number of the polymer ZP). Correlation of lnk vs. ZS turned out to be linear for all polymers, but the angle of the slope of linear dependence dlnk/dZS increases with a decrease in the carbon number of the polymer ZP. Dependency of dlnk/dZS vs. ZP is not linear and indicates an increase in the retention of sorbates by the stationary phase with a decrease in the length of the alkyl substituent in the polymer chain. The correlation of the retention of lnk analytes with the carbon number of the polymer ZP is not linear and indicates an increase in the sorbate/sorbent interaction with a decrease in the length of the alkyl substituent. Inflection points were found at both correlations with ZP in the region of ZP = 8, which indicates a possible change in the sorption mechanism or a change in the phase state of the polymer. In polymer chemistry, the phase state of a polymer is characterized by the glass transition temperature Tg, the dependence of which vs. ZP turned out to be nonlinear with an inflection point at ZP ∼11. Thus, a decrease in the length of the alkyl substituent leads to the transition of the polymer from a rubbery state to a glassy one at ZP ∼ 11, which in turn, with a further decrease in the carbon number of the polymer to ZP ∼ 8, causes a change in the sorption mechanism from bulk sorption to surface sorption. The change in the sorption mechanism is accompanied by an increase in the interaction of the sorbate with the stationary phase, which manifests itself both in an increase in the retention time of analytes and in an increase in the enthalpy and entropy of sorption. The reason for this increase can be seen in the formation of a microporous structure in 5-alkyl-substituted polynorbornenes in a glassy state.

Determination of gas-polydimethylsiloxane distribution constants of major Cannabis terpenes and terpenoids by capillary gas-liquid chromatography

Terpenes and terpenoids are the principal responsible for the aroma of Cannabis, playing an important role in the interaction with the environment. Analytical determination of these compounds can be done by headspace coupled to solid phase micro-extraction (HS-SPME) and then injected in a gas chromatograph. In the present study, we determined distribution constants between gas and polydimetylsiloxane (PDMS), a conventional SPME liquid phase, at three temperatures between 303.15 and 343.15 K for major Cannabis terpenes and terpenoids employing a method based in gas chromatography using four capillary columns for monoterpenes and five columns for sesquiterpenes. In addition, van't Hoff regressions (logK_fg vs T^-1) were obtained in order to estimate logK_fg at 298.15 K aiming to compare with bibliographic values (experimental or estimated ones). An excellent agreement was found between them. The method, based on chromatographic theory is robust and relatively simple. It is expected that the herein obtained data could be useful for selecting SPME fiber type and dimensions, estimating extraction efficiencies, as well as to develop prediction models and validate them.

VOCs absorption from gas streams using deep eutectic solvents - A review

Volatile organic compounds (VOCs) are one of the most severe atmospheric pollutants. They are mainly emitted into the atmosphere from anthropogenic sources such as automobile exhaust, incomplete fuel combustion, and various industrial processes. VOCs not only cause hazards to human health or the environment but also adversely affect industrial installation components due to their specific properties, i.e., corrosive and reactivity. Therefore, much attention is being paid to developing new methods for capturing VOCs from gaseous streams, i.e., air, process streams, waste streams, or gaseous fuels. Among the available technologies, absorption based on deep eutectic solvents (DES) is widely studied as a green alternative to other commercial processes. This literature review presents a critical summary of the achievements in capturing individual VOCs using DES. The types of used DES and their physicochemical properties affecting absorption efficiency, available methods for evaluating the effectiveness of new technologies, and the possibility of regeneration of DES are described. In addition, critical comments on the new gas purification methods and future perspectives are included.

Inverse gas chromatographic evaluation of polysiloxanes containing phenolic and fluorophenolic functional groups for use in gas sensors

The paper presents the results of inverse gas chromatographic (IGC) research on two novel polysiloxanes: poly{dimethylsiloxane-co -[4-(2,3-difluoro-4-hydroxyphenoxy)butyl]methylsiloxane} and poly{dimethylsiloxane-co -[4-(4-hydroxyphenoxy)butyl]methylsiloxane}, dubbed PMFOS and PMOS respectively, designed for use as chemosensitive coatings for acoustoelectronic sensors. These materials contain phenolic functional substituents that differ by the presence of fluorine atoms. The materials' solvation properties were identified by IGC with application of an LSER solvation model at temperatures ranging from 40 to 120 °C. In the case of both polysiloxanes, the research revealed that the dominant type of intermolecular interaction was the formation of acidic hydrogen bonds. The material with fluorine-activated hydroxyl groups, PMFOS, is much more acidic and less basic than the other one and thus more interesting. According to LSER, PMFOS exhibits high affinity and selectivity to hydrogen bond bases. In addition, the material retains its properties even at a temperature of 120 °C.

Determination of physicochemical properties of ionic liquids by gas chromatography

Over the years room temperature ionic liquids have gained attention as solvents with favorable environmental and technical features. Both chromatographic and conventional methods afford suitable tools for the study of their physicochemical properties. Use of gas chromatography compared to conventional methods for the measurement of physicochemical properties of ionic liquids have several advantages; very low sample concentrations, high accuracy, faster measurements, use of wider temperature range and the possibility to determine physicochemical properties of impure samples. Also, general purpose gas chromatography instruments are widely available in most laboratories thus alleviating the need to purchase more specific instruments for less common physiochemical measurements. Some of the main types of physicochemical properties of ionic liquids accessible using gas chromatography include gas-liquid partition constants, infinite dilution activity coefficients, partial molar quantities, solubility parameters, system constants of the solvation parameter model, thermal stability, transport properties, and catalytic and other surface properties.

Measurements of relative distribution constants of vaporized hydrocarbons between air and polydimethylsiloxane via capillary columns for the calculation of headspace hydrocarbon compositions

This study focused on the measurements and validity of relative distribution constants of vaporized hydrocarbons between air and polydimethylsiloxane (PDMS) using commercially available capillary columns. Capillary column gas chromatography (CCGC) measurements, using two columns containing a PDMS stationary phase with different film thicknesses, were conducted to determine the relative distribution constants of n-heptane, toluene, n-octane, p-xylene, n-nonane, and 1,2,4-trimethylbenzene between air and PDMS at 90 and 120 °C. To validate the accuracy of the relative distribution constants via CCGC, the compositions of three headspace samples containing different amounts of hydrocarbons were calculated using the relative distribution constants via CCGC and extracted amounts via PDMS solid phase microextraction (SPME) at 90 and 120 °C. It was found that calculated hydrocarbon compositions of headspace samples were comparable to true headspace hydrocarbon compositions via direct vapor analysis, with an average absolute relative error of 3.2%. Our results indicate that CCGC is an alternative method that can provide a reliable and convenient method to determine the relative distribution constants of various hydrocarbons between air and PDMS for quantitative chemical analysis of headspace.

Thiocyanate hydrolase, the primary enzyme initiating thiocyanate degradation in the novel obligately chemolithoautotrophic halophilic sulfur-oxidizing bacterium Thiohalophilus thiocyanoxidans

Thiohalophilus thiocyanoxidans is a first halophilic sulfur-oxidizing chemolithoautotrophic bacterium capable of growth with thiocyanate as an electron donor at salinity up to 4 M NaCl. The cells, grown with thiocyanate, but not with thiosulfate, contained an enzyme complex hydrolyzing thiocyanate to sulfide and ammonia under anaerobic conditions with carbonyl sulfide as an intermediate. Despite the fact of utilization of the <<COS pathway>>, high cyanase activity was also detected in thiocyanate-induced cells. Three-stage column chromotography resulted in a highly purified thiocyanate-hydrolyzing protein with an apparent molecular mass of 140 kDa that consists of three subunits with masses 17, 19 and 29 kDa. The enzyme is a Co,Fe-containing protein resembling on its function and subunit composition the enzyme thiocyanate hydrolase from the Betaproteobacterium Thiobacillus thioparus. Cyanase, copurified with thiocyanate hydrolase, is a bisubstrate multisubunit enzyme with an apparent subunit molecular mass of 14 kDa. A possible role of cyanase in thiocyanate degradation by T. thiocyanoxidans is discussed.

An accurate and easy procedure to obtain isothermal Kováts retention indices in gas chromatography

Isothermal Kováts retention indices may be used in GC for identification purposes, but they are also useful in characterisation of stationary phases and for studying structural and physico-chemical properties of both the analyte and the stationary phase. They are currently reported as whole numbers with an accuracy of one index unit for non-polar stationary phases. The method recommended for their calculation uses a linear regression model, although non-linear models have also been applied with good results. In both cases, a computer programme and the retention times of a series of n-alkanes that elute correctly and resolved from the other compounds are needed, conditions which cannot always be fulfilled. However, it is possible to calculate retention indices with an accuracy of 0.1 retention index units (0.2 units for packed columns) with the help of only three n-alkanes using just a pocket calculator or a computer spreadsheet. The main requirement is that at least one of the n-alkanes has a retention index differing by no more than one hundred retention index units from that of the analyte being investigated. Examples are given for different stationary phases.