Skin-friction drag analysis from the forced convection modeling in simplified underwater swimming

Steady hydrodynamic interaction between human swimmers

This study focuses on the hydrodynamic interaction between two or three human swimmers in competitive swimming. Although the swimming performance of a single swimmer has been widely examined, studies on the interaction between multiple competitive swimmers are very rare. Experiments showed evidence that the drag of a swimmer could be modified by the existence of the other adjacent competitors (Chatard & Wilson. 2003 Med. Sci. Sports Exerc. 35, 1176–1181. (doi:10.1249/01.MSS.0000074564.06106.1F)). The following questions arise: (1) what mechanism determines the interaction; (2) which position experiences drag reduction or drag increase; (3) how much can drag be reduced or increased in a formation? According to the authors' knowledge, such questions have not been addressed by any published literature. Therefore, the main purpose of this study is to find the mechanism of the hydrodynamic interaction between human swimmers and to quantify this interactive effect by using a steady potential flow solver. The free-surface effect was fully taken into account in our calculations. We firstly calculated the wave drag of a swimmer swimming solely in an open swimming pool. Then we calculated the wave drag of the same swimmer when he/she swam in the wake region of one or two leading swimmers. The results showed that the hydrodynamic interaction made a significant contribution to the drafter's wave drag. By following a leading swimmer, a drafter at wave-riding positions could save up to 63% of their wave drag at speed of 2.0 m s⁻¹ and lateral separation of 2.0 m. Particularly, when a drafter is following two side-by-side leaders, the drag reduction could even be doubled. To the authors' knowledge, this study is the first to demonstrate that the hydrodynamic interaction between human swimmers can best be described and explained in terms of wave interference effect on the free water surface. When the wave cancellation effect is observed, the wave drag of a drafter could be minimized, and this wave cancellation effect can be achieved only when the drafter is in a wave-riding position.

Unsteady computational fluid dynamics in front crawl swimming

The development of codes and power calculations currently allows the simulation of increasingly complex flows, especially in the turbulent regime. Swimming research should benefit from these technological advances to try to better understand the dynamic mechanisms involved in swimming. An unsteady Computational Fluid Dynamics (CFD) study is conducted in crawl, in order to analyse the propulsive forces generated by the hand and forearm. The k-ω SST turbulence model and an overset grid method have been used. The main objectives are to analyse the evolution of the hand-forearm propulsive forces and to explain this relative to the arm kinematics parameters. In order to validate our simulation model, the calculated forces and pressures were compared with several other experimental and numerical studies. A good agreement is found between our results and those of other studies. The hand is the segment that generates the most propulsive forces during the aquatic stroke. As the pressure component is the main source of force, the orientation of the hand-forearm in the absolute coordinate system is an important kinematic parameter in the swimming performance. The propulsive forces are biggest when the angles of attack are high. CFD appears as a very valuable tool to better analyze the mechanisms of swimming performance and offers some promising developments, especially for optimizing the performance from a parametric study.

Effect of The Swimmer's Head Position on Passive Drag

The aim of this study was to investigate the effect of the head position on passive drag with a towing-line experiment in a swimming pool. The tests were performed on ten male swimmers with regional level swimming skills and at least 10 years of competitive swimming experience. They were towed underwater (at a depth of 60 cm) at three speeds (1.5, 1.7 and 1.9 m/s) and in two body positions (arms above the swimmer's head and arms alongside the body). These two body positions were repeated while the swimmer's head was positioned in three different ways: head-up, head-middle and head-down in relation to the body's horizontal alignment. The results showed a reduction of 4-5.2% in the average passive drag at all speeds when the head was down or aligned to the swimmer's arms alongside the body, in comparison to the head-up position. A major significant decrease of 10.4-10.9% (p < 0.05) was shown when the head was down or aligned at the swimmer's arms above the swimmer's head. The passive drag tended to decrease significantly by a mean of 17.6% (p < 0.001) for all speeds examined with the arms alongside the body position rather than with the arms above the head position. The swimmer's head location may play an important role in reducing hydrodynamic resistance during passive underwater gliding.

The Hydrodynamic Study of the Swimming Gliding: a Two-Dimensional Computational Fluid Dynamics (CFD) Analysis

Nowadays the underwater gliding after the starts and the turns plays a major role in the overall swimming performance. Hence, minimizing hydrodynamic drag during the underwater phases should be a main aim during swimming. Indeed, there are several postures that swimmers can assume during the underwater gliding, although experimental results were not conclusive concerning the best body position to accomplish this aim. Therefore, the purpose of this study was to analyse the effect in hydrodynamic drag forces of using different body positions during gliding through computational fluid dynamics (CFD) methodology. For this purpose, two-dimensional models of the human body in steady flow conditions were studied. Two-dimensional virtual models had been created: (i) a prone position with the arms extended at the front of the body; (ii) a prone position with the arms placed alongside the trunk; (iii) a lateral position with the arms extended at the front and; (iv) a dorsal position with the arms extended at the front. The drag forces were computed between speeds of 1.6 m/s and 2 m/s in a two-dimensional Fluent^® analysis. The positions with the arms extended at the front presented lower drag values than the position with the arms aside the trunk. The lateral position was the one in which the drag was lower and seems to be the one that should be adopted during the gliding after starts and turns.

Turbulence model choice for the calculation of drag forces when using the CFD method

The aim of this work is to specify which model of turbulence is the most adapted in order to predict the drag forces that a swimmer encounters during his movement in the fluid environment. For this, a Computational Fluid Dynamics (CFD) analysis has been undertaken with a commercial CFD code (Fluent). The problem was modelled as 3D and in steady hydrodynamic state. The 3D geometry of the swimmer was created by means of a complete laser scanning of the swimmer's body contour. Two turbulence models were tested, namely the standard k-epsilon model with a specific treatment of the fluid flow area near the swimmer's body contour, and the standard k-omega model. The comparison of numerical results with experimental measurements of drag forces shows that the standard k-omega model accurately predicts the drag forces while the standard k-epsilon model underestimates their values. The standard k-omega model also enabled to capture the vortex structures developing at the swimmer's back and buttocks in underwater swimming; the same vortices had been visualized by flow visualization experiments carried out at the INSEP (National Institute for Sport and Physical Education in Paris) with the French national swimming team.