A comprehensive review of coconut-based porous materials for wastewater treatment and CO2 capture

Insight into the wheat residues-derived adsorbents for the remediation of organic and inorganic aquatic contaminants: A review

Wheat is a major grain crop of the world that provides a stable food for human consumption. Large amounts of by-products/waste materials are produced after the harvesting and processing of wheat crop. Such materials can cause an environmental issue if not disposed of properly. Several studies have shown that wheat residues can be efficient precursors for adsorbents because of their availability, renewability, lignocellulosic composition, and surface active groups enriched structure. In the literature, there are few review articles that address wheat residues-based adsorbents. However, these reviews were specific in terms of adsorbate or adsorbent and did not provide detailed information about the modification, properties, and regeneration of these adsorbents. This article extensively reviews the utilization of wheat biomass/waste including straw, bran, husk, and stalk as precursors for raw or untreated, chemically treated, carbonaceous, and composite adsorbents against various environmental pollutants. The influences of inlet pollutant amount, adsorbent dose, pH, temperature, and time on the performance of adsorbents against pollutants were considered. The maximum uptakes, equilibrium time, and adsorption nature were identified from isotherms, kinetic, and thermodynamic studies. The highest adsorbed amounts of most tested contaminants were 448.20, 322.58, and 578.13 mg/g for lead, chromium, and copper, 1374.6 and 1449.4 mg/g for methylene blue and malachite green, and 854.75, 179.21, and 107.77 mg/g for tetracycline, phosphate, and nitrate, respectively. For the studied adsorbate/adsorbent systems the adsorption mechanism and regeneration were also discussed. Significant results and future directions are finally presented.

Effects of calcium-to-silicon ratio on the properties of fly ash-based tobermorite and its removal performance of Zn2+ and Mn2

The effects of calcium-to-silicon ratio on the properties of fly ash (FA)-based tobermorite and its removal performance of Zn2+ and Mn2+ were studied. The calcium-to-silicon ratio had a significant effect on the structural properties of the tobermorite samples. The specific surface area, pore volume, and average pore size of mesoporous tobermorite samples with different calcium-to-silicon ratios (0.8TOB, 1.2TOB, and 1.6TOB) were much larger than those of FA, and those of 1.2TOB were the largest, which were 53.29 m2/g, 0.448 cm3/g, and 30.50 nm, respectively. The removal efficiencies of Zn2+ and Mn2+ by 1.2TOB were 84.19% and 47.67%, respectively, which were much higher than those of 0.8TOB (60.62% and 42.41%), 1.6TOB (46.69% and 24.31%), and FA (4.13% and 6.95%). The adsorption of Zn2+ and Mn2+ by 0.8TOB, 1.2TOB, and 1.6TOB was corresponding to the pseudo-second-order kinetic model and Langmuir isotherm model. Particularly, 1.2 TOB showed the highest maximum adsorption capacities of Zn2+ and Mn2+ calculated from the Langmuir model, which were 129.70 mg/g and 82.09 mg/g, respectively. Moreover, the adsorption mechanisms might be due to the combination with -OH and the interlayer adsorption of the samples. This research provides new insight into the fly ash-based adsorbents towards Zn2+ and Mn2+ in wastewater.

Recent progress on tobacco wastes-derived adsorbents for the remediation of aquatic pollutants: A review

Tobacco (Nicotiana tabacum L.) is a significant crop widely planted worldwide. Its leaves have a special economical value as raw materials for the cigarette industry. During tobacco harvesting and cigarette production, a large amount of wastes that could not be used in the cigarette industry are generated such as tobacco stems, stalks, and low-grade leaves. The utilization of such agro-industrial wastes in raw or carbonaceous form as adsorbents for wastewater treatment is an economic and eco-friendly step for elimination of such waste. Tobacco waste can be directly applied as adsorbents for aquatic pollutants owing to its favorable lignocellulosic composition and functional groups enriched structure. Moreover, this waste has high volatile matters and thus can be an efficient precursor for high surface area carbonaceous adsorbents including biochar and activated carbon with high removal performance. This article is a recent and comprehensive review about the preparation of adsorbents (raw, biochar and activated carbon) from different tobacco wastes (stems, stalks, leaves, etc.) along with its characterization and regeneration. The adsorption behavior of different aquatic adsorbates on these adsorbents under specific conditions along with the isotherm, kinetic, thermodynamic, and mechanism studies is also considered. The highest uptakes for most tested pollutants were 399.0, 195.2, and 173.0 mg/g for lead, chromium, and cadmium, 517.5 mg/g for methylene blue, and 210.66 and 1.602 mg/g for phosphate and chlorpyrifos. Significant findings and future ideas for the studied adsorbate/adsorbent systems are finally given.

Coal fly ash and bottom ash low-cost feedstocks for CO2 reduction using the adsorption and catalysis processes

Combustion of fossil fuels, industry and agriculture sectors are considered as the largest emitters of carbon dioxide. In fact, the emission of CO2 greenhouse gas has been considerably intensified during the last two decades, resulting in global warming and inducing variety of adverse health effects on human and environment. Calling for effective and green feedstocks to remove CO2, low-cost materials such as coal ashes "wastes-to-materials", have been considered among the interesting candidates of CO2 capture technologies. On the other hand, several techniques employing coal ashes as inorganic supports (e.g., catalytic reduction, photocatalysis, gas conversion, ceramic filter, gas scrubbing, adsorption, etc.) have been widely applied to reduce CO2. These processes are among the most efficient solutions utilized by industrialists and scientists to produce clean energy from CO2 and limit its continuous emission into the atmosphere. Herein, we review the recent trends and advancements in the applications of coal ashes including coal fly ash and bottom ash as low-cost wastes to reduce CO2 concentration through adsorption and catalysis processes. The chemical routes of structural modification and characterization of coal ash-based feedstocks are discussed in details. The adsorption and catalytic performance of the coal ashes derivatives towards CO2 selective reduction to CH4 are also described. The main objective of this review is to highlight the excellent capacity of coal fly ash and bottom ash to capture and selective conversion of CO2 to methane, with the aim of minimizing coal ashes disposal and their storage costs. From a practical view of point, the needs of developing new advanced technologies and recycling strategies might be urgent in the near future to efficient make use of coal ashes as new cleaner materials for CO2 remediation purposes, which favourably affects the rate of global warming.

Surface-modified graphene oxide-based composites for advanced sequestration of basic blue 41 from aqueous solution

Advanced materials for the efficient treatment of textile wastewater need to be developed for the sustainable growth of the textile industry. In this study, graphene oxide (GO) was modified by the incorporation of natural clay (bentonite) and mixed metal oxide (copper-cobalt oxide) to produce GO-based binary and ternary composites. Two binary composites, GO/bentonite and GO/Cu-Co Ox (oxide), and one ternary composite, GO/bentonite/Cu-Co Ox, were characterized by Fourier transform-infrared spectroscopy (FTIR), scanning electron microscope (SEM), energy dispersive spectrometer (EDS) and Brunauer-Emmett-Teller (BET) analysis. The adsorption efficiency of these composites was evaluated against a cationic dye, Basic Blue 41 (BB41). The composites had several surface functional groups, and the ternary composite had tubular porous structures formed by the cross-linking of the bentonite and GO planes. The BET surface area of the ternary composite was 50% higher than that of the GO. The BB41 removals were 92, 89, 80, and 69% for GO/bentonite/Cu-Co oxide, GO/bentonite, GO and GO/Cu-Co oxide, respectively. The pseudo-2nd-order and intraparticle diffusion models best describe the kinetics results, indicating chemisorption and slow pore diffusion-controlled adsorption processes. The Langmuir isotherm-derived adsorption capacity of GO/bentonite/Cu-Co oxide was 351.1 mg/g, which was very close to the measured value. After five consecutive cycles, the ternary composite retained 90% BB41 removal efficiency compared to its 1st cycle. Electrostatic interaction and pore diffusion were predicted to be the controlling mechanisms for the adsorption of the BB41. The GO-based ternary composite can be a feasible and scalable adsorbent for BB41 in wastewater treatment.

Assessing the suitability of municipal sewage sludge and coconut bran as breeding medium for Oryza sativa L. seedlings and developing a standardized substrate

The utilization of organic solid waste (OSW) for preparing standardized seedling substrates is a main challenge due to its temporal and spatial variability. This study aims to form models based on data from the literature and validate them through experiments to explore a standardized seedling substrate. The typical OSW in Hainan Province, including municipal sewage sludge (MSS), coconut bran (CB), seaweed mud (SM), and municipal sewage sludge biochar (MSSB), was used as raw material. A series of six mixing ratios was tested, namely: T1 (0% MSS: 90% CB), T2 (10% MSS: 80% CB), T3 (30% MSS: 60% CB), T4 (50% MSS: 40% CB), T5 (70% MSS: 20% CB), and T6 (90% MSS: 0% CB). SM and MSSB were added as amendment materials at 5% (w/w) for each treatment. The physicochemical properties of substrates, agronomic traits of rice seedlings and microbial diversity were analyzed. The results showed that the four kinds of OSW played an active role in providing rich sources of nutrients. The dry weight of the above-ground part was 2.98 times greater in T3 than that of the commercial substrate. Furthermore, the microbial analysis showed a higher abundance of Actinobacteria in T3, representing the stability of the composted products. Finally, the successful fitting of the results with the linear regression models could establish relationship equations between the physicochemical properties of the substrate and the growth characteristics of seedlings. The relevant parameters suitable for the growth of rice seedlings were as follows: pH (6.46-7.01), EC (less than 2.12 mS cm-1), DD (0.13-0.16 g cm-3), and TPS (65.68-82.73%). This study proposed relevant parameters and models for standardization of seedling substrate, which would contribute to ensuring the quality of seedlings and OSW resource utilization.

Biochar/layered double hydroxides composites as catalysts for treatment of organic wastewater by advanced oxidation processes: A review

Heterogeneous advanced oxidation process has been widely studied as an effective method for removing organic pollutants in wastewater, but the development of efficient catalysts is still challenging. This review summaries the present status of researches on biochar/layered double hydroxides composites (BLDHCs) as catalysts for treatment of organic wastewater. The synthesis methods of layered double hydroxides, the characterizations of BLDHCs, the impacts of process factors influencing catalytic performance, and research advances in various advanced oxidation processes are discussed in this work. The integration of layered double hydroxides and biochar provides synthetic effects for improving pollutant removal. The enhanced pollutant degradation in heterogeneous Fenton, sulfate radical-based, sono-assisted, and photo-assisted processes using BLDHCs have been verified. Pollutant degradation in heterogeneous advanced oxidation processes using BLDHCs is influenced by process factors such as catalyst dosage, oxidant addition, solution pH, reaction time, temperature, and co-existing substances. BLDHCs are promising catalysts due to the unique features including easy preparation, distinct structure, adjustable metal ions, and high stability. Currently, catalytic degradation of organic pollutants using BLDHCs is still in its infancy. More researches should be conducted on the controllable synthesis of BLDHCs, the in-depth understanding of catalytic mechanism, the improvement of catalytic performance, and large-scale application of treating real wastewater.