Hydrophobicity enhancement of polyurethanes by attaching fluorinated end blocks via ATRP and correlation between surface properties and self-assembly nature

Stearic acid esterified pectin: Preparation, characterization, and application in edible hydrophobic pectin/chitosan composite films

This work investigated the modification of low-methoxy pectin with stearic anhydride through microwave action with 4-dimethylaminopyridine as catalyst. Fourier transform infrared spectroscopy (FTIR) and X-ray photoelectron spectroscopy (XPS) analyses indicated that stearic acid was grafted on the pectin through esterification reaction, with the maximum stearic acid grafting ratio (SGR) of 10.7% for the modified pectin. The introduction of stearic acid was shown to significantly improve the emulsifying activity and stability of pectin. Composite films were prepared by blending the modified pectins and chitosan, and compared with the contact angle of 65.3° for the film with native low-methoxy pectin (PC0), the films with modified pectins showed a significant angle increase, with the highest contact angle reaching 101.9°, indicating a hydrophobic surface. Moreover, an appropriate amount of aliphatic chains could improve the tensile strength and elongation at break of the composite films due to the "anchoring effect".

Functionalization of triblock copolymer elastomers by cross-linking the end blocks via trans-N-alkylation-based exchangeable bonds

Functionalization of ABA triblock copolymer-based materials is achieved by incorporating dynamic covalent bonded cross-links via trans-N-alkylation in glassy A block domains.

Effect of Nano Alumina on the Properties of Fluorinated Polyurethane

This article selects studies on the preparation of fluorinated polyurethane-nano-alumina composite coating materials, and analyzes the anti-wear, water resistantance, and surface microstructure. Attenuated total reflection-Fourier transform infrared spectroscopy (ATR-FTIR) shows that the polyurethane synthesized in this study does not contain hydrophilic -CH2OH groups. The cavitation wear test depicts that the actual cavitation amount C of the Al2O3-FPU (4) (fluorinated polyurethane) coating is 0.9035 × 10-3 kg, and the anti-wear ability increases by 61.9% compared with FPU-0.5. The water-resistant test shows that the contact angle of water droplets on the surface of the coating increase from 95.3° of FPU-0.5 to 123.1° of Al2O3-FPU (4), and the water absorption decreases from 2.52% to 1.04%. Scanning electron microscopy (SEM) observation confirms that alumina particles can protrude on the coating surface and resist strong wear, while the C-F chain with high bond energy at the near-surface exhibits high strength and water resistance, which prevents wear from spreading deep into the coating. Differential scanning calorimetry (DSC) results show that the Tg(HS) value of the hard segment phase decreases with higher external force. Notably, when the coating is subjected to erosion, which enhances the crystallinity of the hard segment phase, the tensile strength of the hard segment phase of the coating surface is improved, which supports the wear resistance. Herein, we show that the addition of nano-alumina to fluorinated polyurethanes can control high water and abrasion resistance.