Soft tissue measurement of arsenic and selenium in an animal model using portable X-ray fluorescence

Lead content in soil, plants, rodents, and amphibians in the vicinity of a heating plant's ash waste

This study supplements previous research focused on environmental condition in the vicinity of waste ash material. The main aim of our study was the comparative analysis of lead levels in soil, plant, and animal organisms in the area of the tailings pond and surroundings, using x-ray. Findings confirm that the level of Pb in the top layer of soil is in the range of 20-135 ppm. Lead content in Calamagrostis plant tissues was confirmed only at the tailings pond area, with the highest lead concentrations measured in above-ground components; stems with blooms followed by roots and ground floor sheats. The livers, kidneys, and hearts of Apodemus flavicollis were examined, with findings of higher values in the tailings pond area than in the reference site, and average values of 14.5 ppm for livers, 16.0 ppm for kidneys, and 16.6 ppm for hearts. No significant differences were discovered based on sex and body length/body weight of A. flavicollis individuals. Values for Bombina variegata liver tissue reached an average of 12.3 ppm for individuals caught in a water reservoir without ash sediments, versus 15.7 ppm in those trapped by the edge of then tailings pond area. Females had lower concentrations of lead than males, but with no statistically significant differences found. Despite lower lead levels in soil and ash than expected, concentrations in mammalian and amphibian organs suggest a possible transition of this element into the food chain, and therefore further research in this area is recommended.

Relationship between heavy metal accumulation and histological alterations in voles from alpine and forest habitats of the West Carpathians

The interaction between toxic heavy metals and bio-elements in internal organs and femoral bones and their potential impacts on bone structural properties and renal histopathological changes in bank voles and snow voles were investigated. Our results reveal that heavy metals Hg and Pb accumulate more in femoral bones of alpine habitats than forests. In snow voles, the parameters of the primary osteons' vascular canals (length, average perimeter and area) simultaneously decreased with an increase of Pb and Sr. Wider primary osteons' vascular canals of snow voles contained decreased levels of K, but increased Ba. In bank voles, the number of primary osteons increased in alpine habitats along with K, Hg, and Pb accumulation. In the kidneys of bank voles, rising levels of Rb, Hg, and Zn were detected in alpine habitats. Hg increases the most in kidney tissue from alpine habitats in both vole species, and Hg levels (mean value 0.25 μg/g, max. value 0.55 μg/g) in the renal tissues of bank voles from alpine localities are similar to Hg levels from Hg-polluted industrial areas in other studies. This reflects that alpine areas of the Tatra Mountains are highly contaminated with Hg. The intensity of renal hemosiderosis relates significantly to Zn, Fe, and Cu levels in snow voles, with Fe and Zn levels in bank voles from forest habitats, and with Rb in bank voles from alpine habitats. The intensity of tubule necrosis in renal tissues of bank voles from alpine habitats was negatively related to Se content. In bank voles from forest habitats, significant positive correlations were found between the intensity of glomerular hyperplasia and amounts of Zn. The interactions of the detected element's association with bone tissue and internal organs are discussed.

Assessment of alternative methods for analyzing X-ray fluorescence spectra

When analyzing characteristic peaks in X-ray fluorescence (XRF) spectra, the peak area is the value most often used to quantify peak size. However, some studies have reported the amplitude of the peak instead of the area. When the width of the peak is allowed to vary from trial to trial in order to provide the best possible fit to the data, these two alternative methods can yield slightly different results. In the current study, these two approaches to peak analysis are compared for data obtained from bone reference materials having certified lead concentrations of 1.09 ± 0.03 μg/g, 16.1 ± 0.3 μg/g, 13.2 ± 0.3 μg/g, and 31.5 ± 0.7 μg/g. Measurements were made with an Olympus Innov-X Delta Premium portable XRF system. Using both the area and amplitude methods, lines of best fit were constructed for the lead Lα and lead Lβ signals as a function of lead concentration. Additionally, coefficients of variation were calculated for each reference material and condition of analysis. To assess possible variations over time, the procedure was performed at two points separated by about one year. The amplitude and area methods were found to produce results which were consistent and proportional. Using either method, lead XRF signal plotted as a function of known lead concentration produced adjusted r² values of ∼0.99. The amplitude method provided slightly higher adjusted r² values overall. Coefficients of variation were generally very similar between the two methods, although more pronounced differences emerged from measurements of the lowest concentration reference material.

Feasibility of measuring zinc in human nails using portable x-ray fluorescence

A variety of adverse health effects have been identified as resulting from zinc deficiency. Zinc supplementation may therefore be indicated for certain individuals or populations. A rapid and straightforward means of assessing zinc status in humans would be of considerable medical benefit. In this study, the feasibility of measuring zinc levels in human fingernails or toenails using a portable x-ray fluorescence technique was assessed. Whole nail models (or phantoms) were constructed from resin, and dosed with various concentrations of zinc. These different concentration "nails" were cut into small slices of 4.4 ± 0.2 mm width. The combination of these various slices into different arrangements allowed the modeling of different time-dependent zinc exposure scenarios. A portable x-ray fluorescence device was tested using an "open beam" configuration having a beam diameter of ∼9 mm, and using a "weld mask" configuration with the beam width reduced to 2.9 mm. Minimum detection limits were determined to be 0.15 ± 0.01 ppm for the open beam, and 1.13 ± 0.08 ppm when using the weld mask. By scanning across the length of the model nails, it was demonstrated that differences in zinc levels deposited over time could be detected, and that the weld mask configuration was better suited to resolving spatial changes. The x-ray fluorescence approach was found to be highly sensitive for detecting zinc in nail, and capable of differentiating patterns of zinc uptake over time.

Selenium-mediated arsenic excretion in mammals: a synchrotron-based study of whole-body distribution and tissue-specific chemistry

Arsenicosis, a syndrome caused by ingestion of arsenic contaminated drinking water, currently affects millions of people in South-East Asia and elsewhere. Previous animal studies revealed that the toxicity of arsenite essentially can be abolished if selenium is co-administered as selenite. Although subsequent studies have provided some insight into the biomolecular basis of this striking antagonism, many details of the biochemical pathways that ultimately result in the detoxification and excretion of arsenic using selenium supplements have yet to be thoroughly studied. To this end and in conjunction with the recent Phase III clinical trial "Selenium in the Treatment of Arsenic Toxicity and Cancers", we have applied synchrotron X-ray techniques to elucidate the mechanisms of this arsenic-selenium antagonism at the tissue and organ levels using an animal model. X-ray fluorescence imaging (XFI) of cryo-dried whole-body sections of laboratory hamsters that had been injected with arsenite, selenite, or both chemical species, provided insight into the distribution of both metalloids 30 minutes after treatment. Co-treated animals showed strong co-localization of arsenic and selenium in the liver, gall bladder and small intestine. X-ray absorption spectroscopy (XAS) of freshly frozen organs of co-treated animals revealed the presence in liver tissues of the seleno bis-(S-glutathionyl) arsinium ion, which was rapidly excreted via bile into the intestinal tract. These results firmly support the previously postulated hepatobiliary excretion of the seleno bis-(S-glutathionyl) arsinium ion by providing the first data pertaining to organs of whole animals.

Selenium Speciation in the Fountain Creek Watershed (Colorado, USA) Correlates with Water Hardness, Ca and Mg Levels

The environmental levels of selenium (Se) are regulated and strictly enforced by the Environmental Protection Agency (EPA) because of the toxicity that Se can exert at high levels. However, speciation plays an important role in the overall toxicity of Se, and only when speciation analysis has been conducted will a detailed understanding of the system be possible. In the following, we carried out the speciation analysis of the creek waters in three of the main tributaries—Upper Fountain Creek, Monument Creek and Lower Fountain Creek—located in the Fountain Creek Watershed (Colorado, USA). There are statistically significant differences between the Se, Ca and Mg, levels in each of the tributaries and seasonal swings in Se, Ca and Mg levels have been observed. There are also statistically significant differences between the Se levels when grouped by Pierre Shale type. These factors are considered when determining the forms of Se present and analyzing their chemistry using the reported thermodynamic relationships considering Ca²⁺, Mg²⁺, SeO₄²⁻, SeO₃²⁻ and carbonates. This analysis demonstrated that the correlation between Se and water hardness can be explained in terms of formation of soluble CaSeO₄. The speciation analysis demonstrated that for the Fountain Creek waters, the Ca²⁺ ion may be mainly responsible for the observed correlation with the Se level. Considering that the Mg²⁺ level is also correlating linearly with the Se levels it is important to recognize that without Mg²⁺ the Ca²⁺ would be significantly reduced. The major role of Mg²⁺ is thus to raise the Ca²⁺ levels despite the equilibria with carbonate and other anions that would otherwise decrease Ca²⁺ levels.