Raman imaging spectroscopic characterization of modified poly(dimethylsiloxane) for micro total analysis systems applications

Identification and assessment of pulmonary Cryptococcus neoformans infection by blood serum surface-enhanced Raman spectroscopy

Cryptococcus neoformans (C. neoformans) is a causative agent for acute pulmonary infection, which can further develop to lethal meningoencephalitis if untreated. The meningoencephalitis infection can be prevented, if timely treatment on pulmonary cryptococcal infection can be implemented based on its early diagnosis and accurate assessment. In this study, blood serum surface-enhanced Raman spectroscopy (SERS) method was investigated on identification and assessment of pulmonary C. neoformans infection. The serum SERS measurements were collected from the mice infected with C. neoformans and the healthy mice, in which the infected mice were further divided into four subgroups according to the duration of infection. Based on those SRES measurements, biochemical differences were analyzed among those different groups to investigate the potential biomarkers for identifying and assessing the pulmonary C. neoformans infection. Furthermore, partial least square (PLS) analysis followed by linear discriminant analysis (LDA) model was employed to identify pulmonary cryptococcal infection and to assess the degrees of infection with the accuracies of 96.7% and 85.3%, respectively. Therefore, our study has demonstrated the great clinical potential of using serum SERS technique for an accurate identification and assessment of pulmonary cryptococcal infection.

A SERS aptasensor for simultaneous multiple pathogens detection using gold decorated PDMS substrate

An aptamer-based sensitive method was developed here for detection of multiple foodborne pathogens in food matrix by surface-enhanced Raman scattering (SERS) technology. Polydimethylsiloxane (PDMS) film was first prepared and then coated with gold nanoparticles (AuNP) to act as an active substrate for the enhancement of Raman scattering. The as-prepared Au-PDMS film was functionalized with specific pathogen aptamers (Apt) to capture the targets. In addition, aptamers functionalized AuNP integrated with Raman reporters (4-Mercaptobenzoic acid (4-MBA)/Nile blue A (NBA)) were fabricated as pathogen-specific SERS probes. In this scheme, pathogens were first captured by Apt-Au-PDMS film and then bind with SERS probes to allow the formation of a sandwich assay to complete the sensor module for the detection of multiple pathogens. With Vibrio parahaemolyticus and Salmonella typhimurium as model targets, this protocol can selectively detect 18 cfu/mL and 27 cfu/mL, respectively. Furthermore, this platform can be successfully applied to detect pathogens in seafood samples with recoveries ranging from 82.9% to 95.1%.

Highly sensitive and selective determination of Hg(II) based on microfluidic chip with on-line fluorescent derivatization

In this study, a convenient, sensitive, rapid and simple method was developed on microfluidic chip which was integrated with on-line complexing and laser-induced fluorescence detection. A rhodamine derivative (RD) was developed as a fluorescent chemosensor for Hg(II). It exhibited high selective recognition toward Hg(II) over other examined metal ions in water samples. Under the optimized conditions, the response was linearly proportional to the concentration of Hg(II) in the range of 0-70 μM with a detection limit of 0.031 μM. Satisfactory repeatability and reproducibility were achieved, with a relative standard deviation (RSD) of 6.62%. The established method was successfully applied for the determination of Hg(II) in environmental water samples (surface water, tap water, and waste water). Recoveries obtained for the determination of Hg(II) in spiking samples ranged from 85% to 103%.

Formulation of a covalently bonded hydroxyapatite and poly(ether ether ketone) composite

Spinal fusion devices can be fabricated from composites based on combining hydroxyapatite and poly(ether ether ketone) phases. These implants serve as load-bearing scaffolds for the formation of new bone tissue between adjacent vertebrae. In this work, we report a novel approach to covalently bond hydroxyapatite and poly(ether ether ketone) to produce a novel composite formulation with enhanced interfacial adhesion between phases. Compared to non-linked composites (HA_PEEK), covalently linked composites (HA_L_PEEK), loaded with 1.25 vol% hydroxyapatite, possessed a greater mean flexural strength (170 ± 5.4 vs 171.7 ± 14.8 MPa (mean ± SD)) and modulus (4.8 ± 0.2 vs 5.0 ± 0.3 GPa (mean ± SD)). Although the mechanical properties were not found to be significantly different (p > 0.05), PEEK_L_HA contained substantially larger hydroxyapatite inclusions (100-1000 µm) compared to HA_PEEK (50-200 µm), due to the inherently agglomerative nature of the covalently bonded hydroxyapatite and poly(ether ether ketone) additive. Larger inclusions would expectedly weaken the HA_L_PEEK composite; however, there is no significant difference between the flexural modulus of poly(ether ether ketone) with respect to HA_L_PEEK (p = 0.13). In addition, the flexural modulus of HA_PEEK is significantly lower compared to poly(ether ether ketone) (p = 0.03). Ultimately, covalent linking reduces hydroxyapatite particulate de-bonding from the polymeric matrix and inhibits micro-crack development, culminating in enhanced transfer of stiffness between hydroxyapatite and poly(ether ether ketone) under loading.

Surface modification of PDMS microchips with poly(ethylene glycol) derivatives for μTAS applications

In this work is presented a method for the modification of native PDMS surface in order to improve its applicability as a substrate for microfluidic devices, especially in the analysis of nonpolar analytes. Therefore, poly(ethylene glycol) divinyl ether modified PDMS substrate was obtained by surface modification of native PDMS. The modified substrate was characterized by attenuated total reflectance infrared spectroscopy, water contact angle measurements, and by evaluating the adsorption of rhodamine B and the magnitude of the EOF mobility. The reaction was confirmed by the spectroscopic evaluation. The formation of a well-spread water film over the surface immediately after the modification was an indicative of the modified surface hydrophilicity. This characteristic was maintained for approximately ten days, with a gradual return to a hydrophobic state. Fluorescence assays showed that the nonpolar adsorption property of PDMS was significantly decreased. The EOF mobility obtained was 3.6 × 10(-4) cm(2) V(-1) s(-1) , higher than the typical values found for native PDMS. Due to the better wettability promoted by the modification, the filling of the microchannels with aqueous solutions was facilitated and trapping of air bubbles was not observed.