Flow injection catalytic spectrophotometric simultaneous determination of nitrite and nitrate

Cell Wall Polysaccharide Composition of Grafted 'Liberty' Watermelon With Reduced Incidence of Hollow Heart Defect

Grafting watermelon scions to interspecific squash hybrids has been found to increase fruit firmness. Triploid (seedless) watermelon are prone to hollow heart (HH), an internal fruit disorder characterized by a crack in the placental tissue expanding to a cavity. Although watermelon with lower tissue firmness tend to have a higher HH incidence, associated differences in cell wall polysaccharide composition are unknown. Grafting "Liberty" watermelon to "Carnivor" (interspecific hybrid rootstock, C. moschata × C. maxima) reduced HH 39% and increased tissue firmness by 3 N. Fruit with and without severe HH from both grafted and non-grafted plants were analyzed to determine differences in cell wall polysaccharides associated with grafting and HH. Alcohol insoluble residues (AIR) were sequentially extracted from placental tissue to yield water soluble (WSF), carbonate soluble (CSF), alkali soluble (ASF), or unextractable (UNX) pectic fractions. The CSF was lower in fruit with HH (24.5%) compared to those without HH (27.1%). AIRs were also reduced, hydrolyzed, and acetylated for GC-MS analysis of monosaccharide composition, and a portion of each AIR was methylated prior to hydrolysis and acetylation to produce partially methylated alditol acetates for polysaccharide linkage assembly. No differences in degree of methylation or galacturonic and glucuronic acid concentrations were found. Glucose and galactose were in highest abundance at 75.9 and 82.4 μg⋅mg^-1 AIR, respectively, followed by xylose and arabinose (29.3 and 22.0 μg⋅mg^-1). Mannose was higher in fruit with HH (p < 0.05) and xylose was highest in fruit from grafted plants (p < 0.05). Mannose is primarily found in heteromannan and rhamnogalacturonan I side chains, while xylose is found in xylogalacturonan or heteroxylan. In watermelon, 34 carbohydrate linkages were identified with galactose, glucose, and arabinose linkages in highest abundance. This represents the most comprehensive polysaccharide linkage analysis to date for watermelon, including the identification of several new linkages. However, total pectin and cell wall composition data could not explain the increased tissue firmness observed in fruit from grafted plants. Nonetheless, grafting onto the interspecific hybrid rootstock decreased the incidence of HH and can be a useful method for growers using HH susceptible cultivars.

A novel and simple spectrophotometric method for detection of nitrite in water

A novel and simple spectrophotometric method is developed for the determination of nitrite in water by using the self-coupling diazotization reagent 2-amino-6-chlorobenzoic acid and UV light illumination. The method only involves one reagent and one step, which can be easily applied to the determination of nitrite and tolerates many foreign anions' effects under acidic conditions.

A review on spectroscopic methods for determination of nitrite and nitrate in environmental samples

Nitrate is an important pollutant found in environmental samples. Nitrate and nitrite pose various environmental as well as health hazards. Different methods of determining nitrate in various environmental samples developed during previous years include spectrophotometric, chemiluminescence, electrochemical detection, chromatographic, capillary electrophoretic, spectrofluorimetric methods. Out of these, methods based on spectroscopic detection of nitrate have been discussed in this review article due to their easy availability, high sensitivity, low detection limit, economical and facile nature. Methods based on spectrophotometry, Raman Spectroscopy, IR and FTIR Spectroscopy, atomic absorption spectroscopy (AAS), fluorescence spectroscopy, chemiluminescence, mass spectroscopy, molecular emission cavity analysis (MECA), electron paramagnetic resonance spectrometry (EPR) and nuclear magnetic resonance spectroscopy (NMR) have been reviewed. The basic principle, detection limits, detection range, RSD%, sample throughput/h, advantages and disadvantages have been discussed.

Methods for the detection and determination of nitrite and nitrate: A review

Various techniques for the determination of nitrite and/or nitrate developed during the past 15 years were reviewed in this article. 169 references were covered. The detection principles and analytical parameters such as matrix, detection limits and detection range of each method were tabulated. The advantages and disadvantages of various methods were evaluated. In comparison to other methods, spectrofluorimetric methods have become more attractive due to its facility availability, high sensitivity and selectivity, low limits of detection and low-cost.

Development of a cloud point extraction and spectrophotometry-based microplate method for the determination of nitrite in human urine and blood

A novel and simple method for the sensitive determination of trace amounts of nitrite in human urine and blood has been developed by combination of cloud point extraction (CPE) and microplate assay. The method is based on the Griess reaction and the reaction product is extracted into nonionic surfactant Triton-X114 using CPE technique. In this study, decolorization treatment of urine and blood was applied to overcome the interference of matrix and enhance the sensitivity of nitrite detection. Multi-sample can be simultaneously detected thanks to a 96-well microplate technique. The effects of different operating parameters such as type of decolorizing agent, concentration of surfactant (Triton X-114), addition of (NH4)2SO4, extraction temperature and time, interfering elements were studied and optimum conditions were obtained. Under the optimum conditions, a linear calibration graph was obtained in the range of 10-400 ng mL(-1) of nitrite with limit of detection (LOD) of 2.5 ng mL(-1). The relative standard deviation (RSD) for determination of 100 ng mL(-1) of nitrite was 2.80%. The proposed method was successfully applied for the determination of nitrite in the urine and blood samples with recoveries of 92.6-101.2%.

The Determination of Nitrate and Nitrite in Human Urine and Blood by High-Performance Liquid Chromatography and Cloud-Point Extraction

A simple efficient and practical separation/preconcentration coupled with HPLC method for the determination nitrate and low concentrations of nitrite in human urine and blood was investigated. The method is based on precolumn derivatization using the Griess reaction and cloud-point extraction (CPE) of nitrite anion and direct determination of nitrate using its UV absorbance by ion-pair HPLC. The chromatographic process with detection at two wavelengths (510 and 220 nm) allows the determination of nitrite and nitrate. Decolorization and protein precipitation of urine and blood was applied to overcome the interference of matrix and enhance the sensitivity. The method was validated for linearity, accuracy and precision. Under the optimum conditions, the linear range of nitrite from 10 to 1,000 ng/mL and nitrate from 0.1 to 10 µg/mL. Product recoveries ranged from 92.4 to 99.9%. The limits of detection were 1 ng/mL and 0.1 µg/mL for nitrite and nitrate, respectively. Therefore, the technique was simple and reliable, with potential application in biological sample analysis of nitrate and nitrite.

A new catalytic-spectrophotometric method for quantification of trace amounts of nitrite in fruit juice samples

A new kinetic method has been developed for the determination of nitrite in fruit juice samples. The method is based on the catalytic effect of nitrite with the oxidation of Nile Blue A (NBA) by KBrO(3) in the sulfuric acid medium. The optimum conditions obtained are 1.2 mM sulfuric acid, 0.034 mM of NBA, 2.8 × 10(-3) M KBrO(3), reaction temperature of 20 °C, and reaction time of 100 s at 595.5 nm. Under the optimized conditions, the method allowed the quantification of nitrite in a range of 0.2-800 μg/mL with a detection limit of 0.02 μg/mL. The method was applied to the determination of nitrite in 15 brands of fruit juice samples.

Spectrofluorimetric determination of trace nitrite with o-phenylenediamine enhanced by hydroxypropyl-β-cyclodextrin

A simple and sensitive spectrofluorimetric method was developed for the determination of nitrite in environmental and food samples. The method was based on the selective reaction of o-phenylenediamine with nitrite in acidic medium to form benzotriazole, which exhibited strong fluorescence at 568 nm with excitation at 420 nm in alkaline medium. The detection limit and sensitivity of the proposed method were improved by hydroxypropyl-β-cyclodextrin through complexation. The linear calibration range for nitrite was 0.04-0.8 μg mL(-1) with a detection limit of 13.6 ng mL(-1) (S/N=3.29). The relative standard deviation for ten determinations of 0.1 and 0.4 μg mL(-1) nitrite were 1.38% and 2.01%, respectively. Twenty-eight coexistent ions were examined, and no serious interference for most of ions was observed. The proposed method was successfully applied for the determination of nitrite in the water, sausage and soil samples with recoveries of 95.5-108.5%. The results were in good agreement with the recommended AOAC method.

A simple and sensitive spectrophotometric method for the determination of trace amounts of nitrite in environmental and biological samples using 4-amino-5-hydroxynaphthalene-2,7-disulphonic acid monosodium salt

A very simple, sensitive, fairly selective and rapid spectrophotometric method for the determination of trace amounts of nitrite has been described. This method is based on the diazotized intramolecular coupling of electrophilic diazonium cation with the phenolic group of 4-amino-5-hydroxynaphthalene-2,7-disulphonic acid monosodium salt (AHNDMS) in a phosphate buffer solution of pH 7.5. The cyclic product has a purple color with maximum absorbance at 560nm and is stable for 6h. Optimum reaction conditions and other important analytical parameters for the maximum color development were established. Beer's law was found to obey for nitrite in the concentration range of 0.1-1.6microgml(-1) with molar absorptivity of 2.6x10(4)lmol(-1)cm(-1) and Sandell's sensitivity of 0.0075microgml(-1). The effect of interfering ions on the determination is described. The recommended method was applied for the determination of nitrite in different water, soil and human saliva samples. The performance of the recommended method was evaluated in terms of Student's t-test and variance ratio F-test, which indicated the significance of proposed method over the reference method.

Determination of trace amounts of oxalate in vegetable and water samples using a new kinetic-catalytic reaction system

This paper describes a new, simple, sensitive, and selective catalytic-kinetic-spectrophotometric method for the determination of trace amounts of oxalate in vegetable and water samples. The method is based upon the catalytic effect of oxalate on the oxidation of crystal violet (CV) by dichromate in sulfuric acid media. The reaction was followed by measuring the decrease in absorbance of CV at 630 nm (lambdamax of CV). The dependence of sensitivity on the reaction variables was studied and discussed. Under the optimum conditions, a fixed time procedure was used to obtain a linear calibration curve in the oxalate concentration ranges of 0.20-5.5 microg mL(-1) of oxalate. The calculated detection limit was 0.050 microg mL(-1). The relative standard deviations for ten replicate determinations of 0.40, 1.8, and 2.5 microg mL(-1) of oxalate were 6.0%, 2.5%, and 1.8%, respectively. The effect of the presence of various species commonly associated with real samples was also investigated. The proposed method was successfully applied for the determination of oxalate in vegetable and spiked water samples.

Determination of low level nitrite and nitrate in biological, food and environmental samples by gas chromatography-mass spectrometry and liquid chromatography with fluorescence detection

Gas chromatography-mass spectrometry (GC-MS) and liquid chromatography with fluorescence detection (LC-FL) methods have been proposed for the determination of low level nitrite and nitrate in biological, food and environmental samples. The methods include derivatization of aqueous nitrite with 2,3-diaminonaphthalene (DAN), enzymatic reduction of nitrate to nitrite, extraction with toluene and chromatographic analyses of highly fluorescent 2,3-naphthotriazole (NAT) derivative of nitrite by using GC-MS in selected-ion-monitoring (SIM) mode and LC-FL. Nitrite and nitrate ions in solid samples were extracted with 0.5M aqueous NaOH by sonication. The recoveries of nitrite and nitrate ions based on GC-MS and LC-FL results were 98.40% and 98.10% and the precision of these methods, as indicated by the relative standard deviations (RSDs) were 1.00% for nitrite and 1.20% for nitrate, respectively. The limits of detection of the GC-MS in SIM mode and LC-FL methods based on S/N=3 were 0.02 and 0.29 pg/ml for nitrite and 0.03 and 0.30 pg/ml for nitrate, respectively.

A simple and rapid spectrophotometric method for the determination of nitrite by its decolorizing effect on peroxovanadate complex

A rapid, simple, and most economical spectrophotometric method was proposed for the determination of nitrite in various water samples, soil samples, and roots of leguminous plants. The method is based on decolorizing effect of nitrite on complex formed between hydrogen peroxide and vanadate in acidic medium. The decolorization of that complex by nitrite was exploited to monitor the reaction spectrophotometrically at 470 nm. The method was optimized for effect of concentrations of ammonium metavanadate, hydrogen peroxide, various acids, concentrations of sulphuric acid, order of reagents addition and color stability. The color of the complex was found to be stable for about 2 days, and the stability constant of the complex was also calculated by modified Job's method. The linearity range of the calibration graph was over 6.67-66.7 microg ml(-1) of nitrite with molar absorptivity, 0.276 x 10(3) mol(-1) l cm(-1) and Sandell's sensitivity, 0.1667 microg cm(-2). The method was applied successfully for the determination of nitrite in soil samples, various wastewater samples and roots of leguminous plants.

A Simple Flow Injection Spectrophotometric Determination of Nitrite Based on Its Reaction with Thiourea

A simple flow injection spectrophotometric method for the determination of nitrite is described. Nitrite injected into the flow system reacts with thiourea in acidic medium and the generated thiocyanate ion reacts with Fe(III) in the reagent solution to produce a highly colored product. The influences of chemical and physical parameters including reagent concentrations, sample volume injected, flow rates of the carrier and reagent solutions, reaction coil length and reaction temperature, were studied and optimum values of these parameters were established. Under the optimum conditions, the calibration curve for nitrite was linear over the concentration range 0.36 - 90 microg ml(-1) without preconcentration and over the range 3.8 - 500 ng ml(-1) with a simple online preconcentration step using an anion exchange column. The corresponding detection limits were 0.36 micro ml(-1) and 3.8 ng ml(-1), respectively. Up to 25 samples can be analyzed per hour, with an average relative standard deviation of < or = 1.2%. Interferences by various foreign ions were studied and the method was applied to the determination of nitrite in water and spiked water samples.