Smart Removal of Dye Pollutants via Dark Adsorption and Light Desorption at Recyclable Bi2O2CO3 Nanosheets Interface

Dynamic ion exchange engineering bismuth ferrite-derived Bi2O2CO3 for rapid piezo-photocatalytic degradation of tetracycline

Piezoelectric materials can generate the built-in electric field under ultrasound assistance, which is beneficial to the separation of the photogenerated electron-hole pairs in photocatalysis. Meanwhile, the ultrasound stress usually leads to accelerate electron transfer and enhance catalytic activity. Thus, piezo-photocatalysis technique is believed to be one of the effective techniques for organic pollutant degradation. In this work, a binary piezoelectric integrated piezo-photocatalytic Z-Scheme heterojunction with bismuth ferrite (BFO) and bismuth oxycarbonate (Bi2O2CO3, BOC) based on the in situ production of Bi2O2CO3 on Bi25FeO40 surface in dichloromethane, where Bi25FeO40 was employed as piezoelectric materials and Bi source, CO2 dissolved in dichloromethane was used as carbon source. Under 60 min ultrasound and visible light irradiation, the optimal BFO/BOC presented a higher piezo-photocatalytic tetracycline (TC) degradation rate (95 %) than Bi25FeO40 (30 %) and Bi2O2CO3 (17 %). Moreover, the optimal BFO/BOC illustrated higher piezo-photocatalytic TC degradation rate under ultrasound and visible light irradiation than that under visible light condition and ultrasound condition, respectively. These results strongly demonstrated the synergistically piezo-photocatalytic degradation of TC by BFO and BOC. This work not only provides a novel piezo-photocatalyst for pollutant degradation, but also provides a novel method to prepare Bi2O2CO3-based piezo-photocatalytic composite catalyst.

Nanocellulose-based polyurethane foam adsorbent for pressure-driven dye-contaminated water purification

Dye-contaminated water has caused a worldwide pollution, which is threatening aquatic organisms and human health. In this work, a pressure-driven foam adsorbent (PFA) was bioinspired from the tapestry turban for purifying the dye-contaminated water. The PFA was prepared using an one-step method from nanocellulose (NC), amino-functionalized ZIF-8 (ZIF-8-NH2), and high resilience polyurethane foam (PUF). It was applied to efficiently remove methyl orange (MO) and crystal violet (CV) dyes from dye-contaminated waste solutions. The maximum adsorption capacity of PFA for MO and CV was 225.9 mg/g (25 °C, pH = 2) and 41.6 mg/g (25 °C, pH = 10), respectively, which were acceptable as compared with the reported works. The dyes could be efficiently removed from various river water samples. After 5 cycles, the removal efficiencies of MO and CV decreased from 92.0% and 85.7% to 84.7% and 76.1%, respectively. Moreover, the PFA relied on pressure-driven force to release the purified water under a low pressure.

Photocatalytic Activity of the V2O5 Catalyst toward Selected Pharmaceuticals and Their Mixture: Influence of the Molecular Structure on the Efficiency of the Process

Due to the inability of conventional wastewater treatment procedures to remove organic pharmaceutical pollutants, active pharmaceutical components remain in wastewater and even reach tap water. In terms of pharmaceutical pollutants, the scientific community focuses on β-blockers due to their extensive (over)usage and moderately high solubility. In this study, the photocatalytic activity of V2O5 was investigated through the degradation of nadolol (NAD), pindolol (PIN), metoprolol (MET), and their mixture under ultraviolet (UV) irradiation in water. For the preparation of V2O5, facile hydrothermal synthesis was used. The structural, morphological, and surface properties and purity of synthesized V2O5 powder were investigated by scanning electron microscopy (SEM), X-ray, and Raman spectroscopy. SEM micrographs showed hexagonal-shaped platelets with well-defined morphology of materials with diameters in the range of 10−65 µm and thickness of around a few microns. X-ray diffraction identified only one crystalline phase in the sample. The Raman scattering measurements taken on the catalyst confirmed the result of XRPD. Degradation kinetics were monitored by ultra-fast liquid chromatography with diode array detection. The results showed that in individual solutions, photocatalytic degradation of MET and NAD was relatively insignificant (<10%). However, in the PIN case, the degradation was significant (64%). In the mixture, the photodegradation efficiency of MET and NAD slightly increased (15% and 13%). Conversely, it reduced the PIN to the still satisfactory value of 40%. Computational analysis based on molecular and periodic density functional theory calculations was used to complement our experimental findings. Calculations of the average local ionization energy indicate that the PIN is the most reactive of all three considered molecules in terms of removing an electron from it.

High performance visible light response of a Z-type Bi2WO6/BiOBr/RGO heterojunction photocatalyst for the degradation of norfloxacin

A Bi₂WO₆/BiOBr/RGO (BWO/BOB/RGO) composite photocatalyst with a Z-type heterojunction was prepared by a simple one-pot hydrothermal method, and the micro-morphology and physicochemical properties of the prepared samples were characterized. After reacting under visible light for 120 min, the degradation rate of 20 mg L^-1 norfloxacin (NOR) by BWO/BOB/RGO was 95.12%, and the kinetic constant of the reaction was 6.42 times higher than that of pure BiOBr. Furthermore, BWO/BOB/RGO also shows good recycling stability and universality. The characterization results show that the improvement of the photocatalytic performance of the catalyst is mainly due to the heterojunction formed between Bi₂WO₆, RGO and BiOBr, which enhances the visible light absorption ability, accelerates the photogenerated electron migration and improves the electron-hole pair separation efficiency. The introduction of Bi₂WO₆ and RGO into the catalyst also increased its specific surface area and made it have more surface-active sites. The results of radical capture experiments showed that ˙O₂^- and h⁺ played an important role in the BWO/BOB/RGO reaction system, and the intermediate products and possible degradation pathways of the system were detected and analyzed. Furthermore, the electron transfer mechanism of the Z-type heterojunction using RGO as an electron transport medium and the mechanism of photocatalytic degradation of norfloxacin were proposed.

Dye recovery with photoresponsive citric acid-modified BiOCOOH smart material: Simple synthesis, adsorption-desorption properties, and mechanisms

Dye recovery is of great significance for a circular economy and sustainable development. However, green recovery strategies without secondary pollution remain a significant challenge. To resolve this issue, a light-responsive smart material (citric acid-modified BiOCOOH (m-BOCH)) was synthesized and applied for dye recovery through adsorption in the dark, and desorption under visible light. With the modification of citric acid, the adsorption level of methylene blue (MB) on m-BOCH (43.4%) was more than six times that of pure BiOCOOH (7.1%). The desorption rate was ∼90% in 120 min under 420 nm light irradiation (there was no desorption for pure BOCH). Further, the adsorption rate was improved to 83.9% and the desorption rate remained stable at an optimal pH of 10.09. Characterization results indicated that carboxyl groups were modified onto the surface of BiOCOOH and served as adsorption sites for MB. Under visible light exposure, the connections between the carboxyl groups and BiOCOOH were damaged, which led to the desorption of MB from the surface of the m-BOCH. The recovered MB exhibited a good staining effect on hepatic stellate cells (HSC) as a fresh dye. The regeneration of m-BOCH was achieved through a moderate hydrothermal process, and the adsorption and desorption capacities were restored to 80.8% and 85.7%, respectively. This research provides a novel environmentally compatible strategy for dye recovery without secondary pollution. This is a very promising treatment technique for dye effluents, which highlights the application of smart materials resource recycling for environmental remediation.

In-situ fabrication of ionic liquids/MIL-68(In)-NH2 photocatalyst for improving visible-light photocatalytic degradation of doxycycline hydrochloride

Metal-organic framework (MOFs)-based composites have been popular in photocatalysis due to their outstanding physicochemical properties, such as large surface area, high activity and good transmission properties. Herein, a method of ionic liquids (ILs)-assisted synthesis of IL/MIL-68(In)-NH₂ composite materials were proposed, and composites were used for visible light catalytic degradation of doxycycline hydrochloride (DOXH). The effects of four kinds of ionic liquids on the structure and photocatalytic properties of the composites were explored, including diethylenetriamine acetate ([DETA][OAc]), diethylenetriamine hexafluorophosphate ([DETA][PF₆]), 1-ethyl-3-methylimidazole acetate ([EMIM][OAc]) and 1-ethyl-3-methylimidazole hexafluorophosphate ([EMIM][PF₆]). The results show that the introduction of different ionic liquids affects the grain growth of MOFs material and photocatalytic activity. Among them, IL_DAc/MIL-68(In)-NH₂ samples showed the highest photocatalytic activity. 92% removal rate of doxycycline hydrochloride and kinetic degradation constant (0.00918 min^-1) was observed under the optimal addition of IL_DAc (10 wt%), which was 4.6 times that of MIL-68(In)-NH₂. The enhancement was attributed to a combined effect of efficient adsorption at low concentration, an increase of active sites, and efficient charge transfer. In addition, the effects of pH and initial concentration were investigated. Finally, the photocatalytic mechanism of DOXH was elucidated, and the possible intermediate products and degradation pathways were discussed. Considering the excellent photostability and ultra-fast photodegradation of IL_DAc/MIL-68(In)-NH₂, this study opens up a new prospect for the preparation of ionic liquids functionalized MOFs with wide practical application value.

Hydroxyl regulating effect on surface structure of BiOBr photocatalyst toward high-efficiency degradation performance

Herein, photocatalytic degradation of levofloxacin hydrochloride (LVF) by a simple surface hydroxyl strategy on BiOBr photocatalyst was studied under simulated visible light irradiation. Interestingly, the BiOBr contained abundant hydroxyl groups following its modification with glucose, which enhanced the photocatalytic degradation of levofloxacin hydrochloride (LVF). The degradation efficiency of LVF over the optimized composite of BiOBr-5 could reach 91.67% in 20 min, which was much higher than that of pristine BiOBr (59.26%). Following, the biotoxicity of antibiotics to Escherichia coli DH5a could be eliminated after LVF photocatalytic degradation. This strategy proposed in this work can provide new ideas for tuning the surface structures of photocatalysts via specific functional groups for the highly efficient degradation and efficient removal of antibiotics in wastewater.

Doping and facet effects synergistically mediated interfacial reaction mechanism and selectivity in photocatalytic NO abatement

The surface atomic coordination and arrangement largely determine photocatalytic properties. Whereas, the intrinsic impact of surface microstructures on the reaction mechanism and pathway is still unclear. Herein, via constructing N-doped Bi₂O₂CO₃ photocatalysts with diverse exposed facets, (1 1 0) and (0 0 1) facet, we testify that the pivotal roles of crystal facet and doping effect on the intermediate production and reactivity for photocatalytic nitric oxide (NO) abatement. The photoreactivity of N-doped Bi₂O₂CO₃ is documented to be higher than that of the pure samples because of the enhanced light absorption and charge transfer. Further in situ probing experiments and theoretical calculations verify that the unique adsorption patterns and activated intermediates on the (1 1 0) facet facilitate the formation of final products and inhibit the generation of toxic NO₂ by-product in terms of thermodynamics. More importantly, we found that the selective and nonselective oxidation processes are emerged over (1 1 0) and (0 0 1) facets of Bi₂O₂CO₃, respectively.