Acceptance testing and QA of interventional cardiology systems

Eye lens dose correlations with personal dose equivalent and patient exposure in paediatric interventional cardiology performed with a fluoroscopic biplane system

PURPOSE

To analyse the correlations between the eye lens dose estimates performed with dosimeters placed next to the eyes of paediatric interventional cardiologists working with a biplane system, the personal dose equivalent measured on the thorax and the patient dose.

METHODS

The eye lens dose was estimated in terms of H_p(0.07) on a monthly basis, placing optically stimulated luminescence dosimeters (OSLDs) on goggles. The H_p(0.07) personal dose equivalent was measured over aprons with whole-body OSLDs. Data on patient dose as recorded by the kerma-area product (P_KA) were collected using an automatic dose management system. The 2 paediatric cardiologists working in the facility were involved in the study, and 222 interventions in a 1-year period were evaluated. The ceiling-suspended screen was often disregarded during interventions.

RESULTS

The annual eye lens doses estimated on goggles were 4.13±0.93 and 4.98±1.28mSv. Over the aprons, the doses obtained were 10.83±0.99 and 11.97±1.44mSv. The correlation between the goggles and the apron dose was R²=0.89, with a ratio of 0.38. The correlation with the patient dose was R²=0.40, with a ratio of 1.79μSvGy^-1cm^-2. The dose per procedure obtained over the aprons was 102±16μSv, and on goggles 40±9μSv. The eye lens dose normalized to P_KA was 2.21±0.58μSvGy^-1cm^-2.

CONCLUSIONS

Measurements of personal dose equivalent over the paediatric cardiologist's apron are useful to estimate eye lens dose levels if no radiation protection devices are typically used.

Entrance surface air kerma in X-ray systems for paediatric interventional cardiology: a national survey

The aims of this work were to report the results of a national survey on entrance surface air kerma (ESAK) values for different phantom thicknesses and operation modes in paediatric interventional cardiology (IC) systems and to compare them with previous values. The national survey also offers suggested investigation levels (ILs) for ESAK in paediatric cardiac procedures. ESAK was measured on phantoms of 4-16 cm thickness of polymethyl methacrylate slabs. For low fluoroscopy mode (FM), ESAK rates ranged from 0.11 to 33.1 mGy min(-1) and for high FM from 0.34 to 61.0 mGy min(-1). For cine mode, values of ESAK per frame were from 1.9 to 78.2 µGy fr(-1). The ILs were suggested as the third quartile of the values measured. This research showed lower ESAK values than in previous research, particularly for ESAK values in cine modes. This work represents a first step towards launching a national programme in paediatric dosimetry for IC procedures.

Patient doses in paediatric interventional cardiology: impact of 3D rotational angiography

The aim of this study was to calculate the contribution of 3D rotational angiography to radiation doses received by paediatric patients in a cardiac catheterisation laboratory. The percentage increase in the median value of air kerma-area product due to cone beam CT was 33 and 16% for diagnostic and therapeutic procedures, respectively. Results are presented separately for five age groups and ten weight groups. Several methods for reducing radiation from 3D rotational angiography are suggested and patient doses are compared with previously published values.

Practical application of suspension criteria scenarios in general radiography, computed radiography,digital radiography and fluoroscopy

Radiological equipment must be assessed against criteria for acceptability to ensure that it meets the minimum standards for patient safety. This assessment is typically led by a medical physicist with input from radiology staff and the equipment supplier. Equipment that does not meet the criteria requires action and may be suspended from clinical use. European Commission report RP 91 will be revised and replaced as RP 162. It has been drawn up to aid medical physicists with the assessment process and provide guidance on suspension levels. This paper details several cases where the criteria in the proposed RP 162 were applied in general radiography, computed radiography, digital radiography and fluoroscopy. The factors considered by the medical physicist and the outcome of each case are presented. The proposed RP 162 report improves on its predecessor and provides a robust set of criteria for ensuring that patient safety within the EU medical exposures framework is optimised.

Equipment performance and radiation protection status in X-ray fluoroscopy units in Sudan

The number of fluoroscopy and fluoroscopically guided procedures has been substantially growing in developing countries at the same time advanced and sophisticated equipment are used in some hospitals. However, radiation protection requirements are not necessarily well adopted. In this study nine fluoroscopy X-ray units in Sudan were examined for compliance with international standards. The tests included: beam quality, entrance surface air kerma, image quality and radiation field measurements. Staff radiation protection tools such as lead aprons and eye glasses were also visually examined to find out whether international recommendations were fulfilled and to determine the level of staff awareness. The measured peak tube voltage deviation exceeded the recommended tolerance level in 30 % of the measurements. The results of patient doses measurements exceeded the recommended reference dose levels in 43 % of the measurements; however image quality and radiation field generally fulfilled the requirements for most units. The study revealed that a considerable number of fluoroscopy units were not performing according to the international standards and highlights the need of optimisation of radiation protection.