Microelectronic retinal prosthesis: II. Use of high-voltage CMOS in retinal neurostimulators

Optimal design of neural stimulation current waveforms

This paper contains results on the design of electrical signals for delivering charge through electrodes to achieve neural stimulation. A generalization of the usual constant current stimulation phase to a stepped current waveform is presented. The electrode current design is then formulated as the calculation of the current step sizes to minimize the peak electrode voltage while delivering a specified charge in a given number of time steps. This design problem can be formulated as a finite linear program, or alternatively by using techniques for discrete-time linear system design.

A wireless implantable multichannel microstimulating system-on-a-chip with modular architecture

A 64-site wireless current microstimulator chip (Interestim-2B) and a prototype implant based on the same chip have been developed for neural prosthetic applications. Modular standalone architecture allows up to 32 chips to be individually addressed and operated in parallel to drive up to 2048 stimulating sites. The only off-chip components are a receiver inductive-capacitive (LC) tank, a capacitive low-pass filter for ripple rejection, and arrays of microelectrodes for interfacing with the neural tissue. The implant receives inductive power up to 50 mW and data at 2.5 Mb/s from a frequency shift keyed (FSK) 5/10 MHZ carrier to generate up to 65,800 stimulus pulses/s. Each Interestim-2B chip contains 16 current drivers with 270 microA full-scale current, 5-bit (32-steps) digital-to-analog converter (DAC) resolution, 100 M omega output impedance, and a voltage compliance that extends within 150 and 250 mV of the 5 V supply and ground rails, respectively. It can generate any arbitrary current waveform and supports a variety of monopolar and bipolar stimulation protocols. A common analog line provides access to each site potential, and exhausts residual stimulus charges for charge balancing. The chip has site potential measurement and in situ site impedance measurement capabilities, which help its users indicate defective sites or characteristic shifts in chronic stimulations. Interestim-2B chip is fabricated in the AMI 1.5 microm standard complementary metal-oxide-semiconductor (CMOS) process and measures 4.6 x 4.6 x 0.5 mm. The prototype implant size including test connectors is 19 x 14 x 6 mm, which can be shrunk down to < 0.5 CC. This paper also summarizes some of the in vitro and in vivo experiments performed using the Interestim-2B prototype implant.

Retinal neurostimulator for a multifocal vision prosthesis

A neurostimulator application-specific integrated circuit (ASIC) with scalable circuitry that can stimulate 14 channels, has been developed for an epi-retinal vision prosthesis. This ASIC was designed to allow seven identical units to be connected to control up to 98 channels, with the ability to stimulate 14 electrodes simultaneously. The neurostimulator forms part of a vision prosthesis, designed to restore vision to patients who have lost their sight due to retinal diseases such as retinitis pigmentosa and macular degeneration. For charge balance, the neurostimulator was designed to stimulate with current sources and sinks operating together, and with the ability to drive a hexagonal mosaic of electrodes to reduce the electrical crosstalk that occurs when multiple bipolar stimulation sites are active simultaneously. A hexagonal mosaic of electrodes surrounds each stimulation site and has been shown to effectively isolate each site, increasing the ability to inject localized independent charge into multiple regions simultaneously.