Development of pH- and enzyme-controlled, colon-targeted, pulsed delivery system of a poorly water-soluble drug: preparation and in vitro evaluation

Advances in Polysaccharide-Based Oral Colon-Targeted Delivery Systems: The Journey So Far and the Road Ahead

Various colon-targeted oral delivery systems have been explored so far to treat colorectal diseases, including timed-release systems, prodrugs, pH-based polymer coatings, and microflora-triggered systems. Among them, the microbially triggered system has gained attention. Among various oral colon-targeted delivery systems discussed, the polysaccharide-based colon-targeted delivery system has been found to be quite promising as polysaccharides remain unaffected by gastric as well as upper intestine milieu and are only digested by colonic bacteria upon reaching the colon. The major bottleneck associated with this delivery is that non-suitability of this system during the diseased state due to decrease in bacterial count at that time. This causes the failure of delivery system to release the drug even at colonic site as the polysaccharide matrix/coat cannot be digested properly due to lack of bacteria. The co-administration of probiotics is reported to compensate for the bacterial loss besides facilitating site-specific release. However, this research is also limited at the preclinical level. Hence, efforts are required to make this technology scalable and clinically applicable. This article entails in detail various oral colon-targeted delivery systems prepared so far, as well as the limitations and benefits of polysaccharide-based oral colon-targeted delivery systems.

Novel Developments on Stimuli-Responsive Probiotic Encapsulates: From Smart Hydrogels to Nanostructured Platforms

Biomaterials engineering and biotechnology have advanced significantly towards probiotic encapsulation with encouraging results in assuring sufficient bioactivity. However, some major challenges remain to be addressed, and these include maintaining stability in different compartments of the gastrointestinal tract (GIT), favoring adhesion only at the site of action, and increasing residence times. An alternative to addressing such challenges is to manufacture encapsulates with stimuli-responsive polymers, such that controlled release is achievable by incorporating moieties that respond to chemical and physical stimuli present along the GIT. This review highlights, therefore, such emerging delivery matrices going from a comprehensive description of addressable stimuli in each GIT compartment to novel synthesis and functionalization techniques to currently employed materials used for probiotic’s encapsulation and achieving multi-modal delivery and multi-stimuli responses. Next, we explored the routes for encapsulates design to enhance their performance in terms of degradation kinetics, adsorption, and mucus and gut microbiome interactions. Finally, we present the clinical perspectives of implementing novel probiotics and the challenges to assure scalability and cost-effectiveness, prerequisites for an eventual niche market penetration.

Effect of polymer concentration and solution pH on viscosity affecting integrity of a polysaccharide coat of compression coated tablets

Tablets, compression coated with certain polysaccharides and intended for colon delivery, retain the integrity of the coat for an initial period of about 6 h (lag period) beyond which (post-lag period) the coat is degraded by colonic enzymes to induce drug release. This work was undertaken to investigate the factors which influence the integrity of the coat during the lag period. Core tablets containing two model drugs were compression coated with various amounts of carboxymethyl locust bean gum (CMLBG). In-vitro release of drugs, erosion of coat, and steady shear viscosity of CMLBG solutions having different concentrations and solution pH were determined. The viscosity of CMLBG that depended primarily on CMLBG concentration and partly on solution pH was responsible for erosion and integrity of the coat in the lag period. Evaluation of polymer viscosity could describe the integrity of coat of a polysaccharide coated tablet in the lag period.

Optimization of tenofovir release from mucoadhesive vaginal tablets by polymer combination to prevent sexual transmission of HIV

The use of sustained-release mucoadhesive vaginal tablets of antiretroviral drugs as microbicidal formulations can be an effective strategy for reducing the sexual transmission of HIV from men to women, which is a main problem particularly in low- and middle-income countries. Different polymers (hydroxypropylmethyl cellulose (HPMC), chitosan, guar gum and Eudragit^® RS) have proven some good features for this purpose. At this work, these polymers have been combined in pairs in different proportions to enhance the advantages offered by each one individually. The in vitro release of tenofovir from the matrices, ex vivo mucoadhesive capacity (evaluated on vaginal mucosa) and the degree of swelling in simulated vaginal fluid have been assessed. A multimodal pore size distribution is observed in porosimetry studies -carried out with swelling witnesses-, due to the contribution of polymers with different swelling behaviour to the pore formation, and it is corroborated by scanning electron microscopy. X-ray diffraction technique confirms the changes in crystallinity of the formulation after swelling. We can report that the combination of HPMC and chitosan in the same formulation may be useful for the prevention of sexual transmission of HIV, since tablets can be obtained that remain adhered to the vaginal mucosa for 96h, so the drug is released in a sustained manner for 72h. When the formulation contains more chitosan than HPMC the swelling is moderate, making it more comfortable for women to apply.

Proton pump inhibitor induced collagen expression in colonocytes is associated with collagenous colitis

AIM

To elucidate the role of proton pump inhibitors (PPIs) in collagenous disease, direct effect of PPI on colonocytes was examined.

METHODS

Collagenous colitis is a common cause of non-bloody, watery diarrhea. Recently, there has been increasing focus on the use of proton PPIs as a risk factor for developing collagenous colitis. Mouse CT26 colonic cells were treated with PPI and/or PPI-induced alkaline media. Expression of fibrosis-associated genes was examined by RT-PCR. In human materials, collagen expression was examined by immunohistochemistry.

RESULTS

CT26 cells expressed a Na⁺-H⁺ exchanger gene (solute carrier family 9, member A2). Treatment with PPI and/or PPI-induced alkaline media caused growth inhibition and oxidative stress in CT26 cells. The treatment increased expression of fibrosis inducing factors, transforming growth factor β and fibroblast growth factor 2. The treatment also decreased expression of a negative regulator of collagen production, replication factor C1, resulting in increased expression of collagen types III and IV in association with lipid peroxide. In biopsy specimens from patients with collagenous colitis, type III and IV collagen were increased. Increase of type III collagen was more pronounced in PPI-associated collagenous colitis than in non-PPI-associated disease.

CONCLUSION

From these findings, the reaction of colonocytes to PPI might participate in pathogenesis of collagenous colitis.

Novel biorelevant dissolution medium as a prognostic tool for polysaccharide-based colon-targeted drug delivery system

To overcome the limitations of the conventionally used methods for evaluation of orally administered colon-targeted delivery systems, a novel dissolution method using probiotics has been recently reported. In the present study, universal suitability of this medium composed of five different probiotics is established. Different delivery systems - mini tablets, liquisolid compacts, and microspheres coated with different polysaccharides - were prepared and subjected to sequential dissolution testing in medium with and without microbiota. The results obtained from fluid thioglycollate medium (FTM)-based probiotic medium for all the polysaccharide-based formulations showed statistically similar dissolution profile to that in the rat and goat cecal content media. Hence, it can be concluded that the developed FTM-based probiotic medium, once established, may eliminate the need for further animal sacrifice in the dissolution testing of polysaccharide-based colon-targeted delivery system.

In vitro evaluation of compression-coated glycyl-L-histidyl-L-lysine-Cu(II) (GHK-Cu2+)-loaded microparticles for colonic drug delivery

Glycyl-L-histidyl-L-lysine-Cu(II) (GHK-Cu(2+))-loaded Zn-pectinate microparticles in the form of hydroxypropyl cellulose (HPC) compression-coated tablets were prepared and their in vitro behavior tested. GHK-Cu(2+) delivery to colon can be useful for the inhibition of matrix metalloproteinase, with the increasing secretion of tissue inhibitors of metalloproteinases (TIMPS),which are the major factors contributing in mucosal ulceration and inflammation in inflammatory bowel disease. The concentration of peptide was determined spectrophotometrically. The results obtained implied that surfactant ratio had a significant effect on percent production yield (1.25 to 1.75 w/w; 72.22% to 80.84%), but cross-linking agent concentration had not. The entrapment efficiency (EE) was found to be in the range of 58.25-78.37%. The drug-loading factor significantly increased the EE; however, enhancement of cross-linking agent concentration decreased it. The release of GHK-Cu(2+) from Zn-pectinate microparticles (F1-F8) in simulated intestinal fluid was strongly affected by cross-linking agent concentration and drug amount (50 mg for F1-F6; 250 mg for F7-F8), but not particularly affected by surfactant amount. Release profiles represented that the microparticles released 50-80% their drug load within 4 h. Therefore, the optimum microparticle formulation (F8) coated with a relatively hydrophobic polymer HPC to get a suitable colonic delivery system. The optimum colonic delivery tablets prepared with 700 mg HPC-SL provided the expected delayed release with a lag time of 6 h. The effects of polymer viscosity and coat weight on GHK-Cu(2+) release were found to be crucial for the optimum delay of lag time. The invention was found to be promising for colonic delivery.