Consistency in Geometry Among Coronary Atherosclerotic Plaques Extracted From Computed Tomography Angiography

Geometric consistency among atherosclerotic plaques in carotid arteries evaluated by multidimensional parameters

The three-dimensional (3D) geometry of carotid atherosclerotic plaques is associated with multiple cardiovascular diseases. However, it is unknown if carotid plaques of different sizes are consistent in 3D geometry, with a lack of quantitative observation. We aim to evaluate the geometric consistency of carotid plaques using the correlations between multidimensional parameters. 42 cases with asymptomatic stenosis caused by atherosclerotic plaque in the carotid artery were included. Carotid plaques and calcifications were identified on computed tomography angiography images and 3D reconstructed. Multidimensional geometric parameters (length, surface area, volume, etc.) were measured on the reconstructed 3D structures. Linear and non-linear (power function) fittings were used to investigate the relationships between multidimensional parameters. The analysis was performed based on cases and plaques, respectively. Spearman rank correlation analysis, R-squared, and p-values were used to evaluate the significance of the relationship. Significant relationship was defined as R-squared >0.25 and p < 0.05. In total, 112 atherosclerotic plaques and 74 calcifications were extracted. In plaque-based analysis, significant correlations were widely observed between paired multidimensional parameters of carotid plaques, where non-linear fitting showed higher R-squared values. Plaque volume and surface area were significantly correlated with total volume and total surface area of intra-plaque calcifications. In subject-based analysis, triglycerides and total cholesterol were significantly correlated with carotid plaque size. There is a consistency in geometry among carotid atherosclerotic plaques of different sizes. The size of a carotid plaque is associated with the patient's lipid profile.

Integrating Computational and Biological Hemodynamic Approaches to Improve Modeling of Atherosclerotic Arteries

Atherosclerosis is the primary cause of cardiovascular disease, resulting in mortality, elevated healthcare costs, diminished productivity, and reduced quality of life for individuals and their communities. This is exacerbated by the limited understanding of its underlying causes and limitations in current therapeutic interventions, highlighting the need for sophisticated models of atherosclerosis. This review critically evaluates the computational and biological models of atherosclerosis, focusing on the study of hemodynamics in atherosclerotic coronary arteries. Computational models account for the geometrical complexities and hemodynamics of the blood vessels and stenoses, but they fail to capture the complex biological processes involved in atherosclerosis. Different in vitro and in vivo biological models can capture aspects of the biological complexity of healthy and stenosed vessels, but rarely mimic the human anatomy and physiological hemodynamics, and require significantly more time, cost, and resources. Therefore, emerging strategies are examined that integrate computational and biological models, and the potential of advances in imaging, biofabrication, and machine learning is explored in developing more effective models of atherosclerosis.

Characteristics and evaluation of atherosclerotic plaques: an overview of state-of-the-art techniques

Atherosclerosis is an important cause of cerebrovascular and cardiovascular disease (CVD). Lipid infiltration, inflammation, and altered vascular stress are the critical mechanisms that cause atherosclerotic plaque formation. The hallmarks of the progression of atherosclerosis include plaque ulceration, rupture, neovascularization, and intraplaque hemorrhage, all of which are closely associated with the occurrence of CVD. Assessing the severity of atherosclerosis and plaque vulnerability is crucial for the prevention and treatment of CVD. Integrating imaging techniques for evaluating the characteristics of atherosclerotic plaques with computer simulations yields insights into plaque inflammation levels, spatial morphology, and intravascular stress distribution, resulting in a more realistic and accurate estimation of plaque state. Here, we review the characteristics and advancing techniques used to analyze intracranial and extracranial atherosclerotic plaques to provide a comprehensive understanding of atheroma.

Distinctive Morphological Patterns of Complicated Coronary Plaques in Acute Coronary Syndromes: Insights from an Optical Coherence Tomography Study

Optical coherence tomography (OCT) is an ideal imaging technique for assessing culprit coronary plaque anatomy. We investigated the morphological features and mechanisms leading to plaque complication in a single-center observational retrospective study on 70 consecutive patients with an established diagnosis of acute coronary syndrome (ACS) who underwent OCT imaging after coronary angiography. Three prominent morphological entities were identified. Type I or intimal discontinuity, which was found to be the most common mechanism leading to ACS and was seen in 35 patients (50%), was associated with thrombus (68.6%; p = 0.001), mostly affected the proximal plaque segment (60%; p = 0.009), and had no distinctive underlying plaque features. Type II, a significant stenosis with vulnerability features (inflammation in 16 patients, 84.2%; thin-cap fibroatheroma (TCFA) in 10 patients, 52.6%) and a strong association with lipid-rich plaques (94.7%; p = 0.002), was observed in 19 patients (27.1%). Type III, a protrusive calcified nodule, which was found to be the dominant morphological pattern in 16 patients (22.9%), was found in longer plaques (20.8 mm vs. 16.8 mm ID vs. 12.4 mm SS; p = 0.04) and correlated well with TCFA (93.8%; p = 0.02) and inflammation (81.3%). These results emphasize the existence of a wide spectrum of coronary morphological patterns related to ACS.

Incidental Vascular Findings in Computed Tomography Performed in the Qualification for the TAVI Procedure

Transcatheter aortic valve implantation (TAVI) or transcatheter aortic valve replacement (TAVR) is now a very widespread treatment method for symptomatic and severe aortic stenosis as an alternative for patients at intermediate or high risk of surgery or contraindications to surgery. The key role of imaging examinations before TAVI is to assess the morphology of the aortic valve, the routes of surgical access, and non-cardiac and extravascular structures. The objective of this article is to present and discuss the importance of selected accidental vascular findings in computed tomography examinations of the heart and large vessels performed in the TAVI qualification procedure: persistent left superior vena cava (SVC) with absent right SVC, right aortic arch, ectopic right coronary artery ostium, and left superior pulmonary vein draining into left brachiocephalic vein.

Geometric features of middle cerebral artery are associated with spontaneous basal ganglia intracerebral haemorrhage

BACKGROUND AND PURPOSE

Haemodynamics around the middle cerebral artery (MCA) and lenticulostriate arteries is believed to play important roles in the vascular rupture and local haemodynamics is subject to vascular geometry. Nonetheless, the relationship between the geometric features of MCA and spontaneous basal ganglia intracerebral haemorrhage (ICH) has not been investigated. To examine the relationship between the MCA geometric features and spontaneous basal ganglia ICH.

METHODS

This study was of retrospective and observational nature. The study recruited 158 consecutive hospitalised patients with consecutive CT-confirmed unilateral spontaneous basal ganglia ICH. Clinical data were extracted from electronic medical records, and imaging data were evaluated by two trained radiologists. The MCA-related geometric features were examined and their relationship with spontaneous basal ganglia ICH was analysed. Haemodynamic analyses under different MCA structural features were conducted.

RESULTS

Compared with the contralateral MCA, the ipsilateral MCA had greater M1 diameter ratio (proximal/distal) and a smaller M1/M2 angle and MCA bifurcation angle (p＜0.01). Imaging study showed differences in the MCA shape in both sides on coronal plane (p＜0.05). These MCA features were significantly correlated with the spontaneous ICH in basal ganglia. The greater M1 diameter ratio (proximal/distal), the inferior-oriented M1, the smaller M1/M2 angle and the superior-oriented M1 conditions increased the pressure, from high to low. The greater M1 diameter ratio (proximal/distal) and the inferior-oriented M1 increased the shear stress at the distal end of M1 segment.

CONCLUSIONS

The geometric features of MCA were significantly related to the spontaneous ICH in basal ganglia. The risk of haemorrhage, from high to low, included the greater M1 diameter ratio (proximal/distal), the inferior-oriented M1 (distal end), the smaller M1/M2 angle and the superior-oriented M1. Mechanistically, these vascular structural features contribute to increased vascular wall pressure and shear stress, which eventually lead to haemorrhage.