Fe3O4-Zeolite Hybrid Material as Hetero-Fenton Catalyst for Enhanced Degradation of Aqueous Ofloxacin Solution

The beneficial role of nano-sized Fe3O4 entrapped in ultra-stable Y zeolite for the complete mineralization of phenol by heterogeneous photo-Fenton under solar light

Highly efficient, separable, and stable magnetic iron-based-photocatalysts produced from ultra-stable Y (USY) zeolite were applied, for the first time, to the photo-Fenton removal of phenol under solar light. USY Zeolite with a Si/Al molar ratio of 385 was impregnated under vacuum with an aqueous solution of Fe2+ ions and thermally treated (500-750 °C) in a reducing atmosphere. Three catalysts, Fe-USY500°C-2h, Fe-USY600°C-2h and Fe-USY750°C-2h, containing different amounts of reduced iron species entrapped in the zeolitic matrix, were obtained. The catalysts were thoroughly characterized by absorption spectrometry, X-ray powder diffraction with synchrotron source, followed by Rietveld analysis, X-ray photoelectron spectroscopy, N2 adsorption/desorption at -196 °C, high-resolution transmission electron microscopy and magnetic measurements at room temperature. The catalytic activity was evaluated in a recirculating batch photoreactor irradiated by solar light with online analysis of evolved CO2. Photo-Fenton results showed that the catalyst obtained by thermal treatment at 500 °C for 2 h under a reducing atmosphere (FeUSY-500°C-2h) was able to completely mineralize phenol in 120 min of irradiation time at pH = 4 owing to the presence of a higher content of entrapped nano-sized magnetite particles. The latter promotes the generation of hydroxyl radicals in a more efficient way than the Fe-USY catalysts prepared at 600 and 750 °C because of the higher Fe3O4 content in ultra-stable Y zeolite treated at 500 °C. The FeUSY-500°C-2h catalyst was recovered from the treated water through magnetic separation and reused five times without any significant worsening of phenol mineralization performances. The characterization of the FeUSY-500°C-2h after the photo-Fenton process demonstrated that it was perfectly stable during the reaction. The optimized catalyst was also effective in the mineralization of phenol in tap water. Finally, a possible photo-Fenton mechanism for phenol mineralization was assessed based on experimental tests carried out in the presence of scavenger molecules, demonstrating that hydroxyl radicals play a major role.

Heterogeneous Sono-Fenton like catalytic degradation of metronidazole by Fe3O4@HZSM-5 magnetite nanocomposite

In this research, Fe₃O₄@HZSM-5 magnetic nanocomposite was synthesized via a coprecipitation method for metronidazole (MNZ) degradation from aqueous solutions under ultrasonic irradiation which showed superb sonocatalytic activity. The synthesized magnetite nanocomposite was characterized by using field-emission scanning electron microscope-energy dispersive X-ray Spectroscopy, (FESEM-EDS), Line Scan, Dot Mapping, X-ray diffraction (XRD), vibrating sample magnetometer (VSM), and Brunauer-Emmett-Teller (BET). To investigate the sonocatalytic activity of the Fe₃O₄@HZSM-5 magnetite nanocomposite, the sonocatalytic removal conditions were optimized by evaluating the influences of operating parameters like the dosage of catalyst, reaction time, pH, the concentration of H₂O₂, MNZ concentration, and pH on the MNZ removal. The MNZ maximum removal efficiency and TOC at reaction time 40 min, catalyst dose 0.4 g/L, H₂O₂ concentration 1 mM, MNZ initial concentration 25 mg/L, and pH 7 were achieved at 98% and 81%, respectively. Additionally, the MNZ removal efficiency in the real wastewater sample under optimal conditions was obtained at 83%. The achieved results showed that using Langmuir-Hinshelwood kinetic model K_L-H = 0.40 L mg^-1, K_C = 1.38 mg/L min) can describe the kinetic removal of the process. The radical scavenger tests indicated that the major reactive oxygen species were formed by hydroxyl radicals in the Sono-Fenton-like process. Evaluation of the nanocomposite reusability showed an 85% reduction in the MNZ removal efficiency after seven cycles. Based on the results, it can be concluded that Fe₃O₄@HZSM-5 were synthesized as magnetic heterogeneous nano-catalysts to effectively degrade MNZ, and the observed stability and recyclability demonstrated that Fe₃O₄@HZSM-5 was promising for the treatment of wastewater contaminated with antibiotics.

Fenton degradation of ofloxacin antibiotic using calcium alginate beads impregnated with Fe3O4-montmorillonite composite

The primary aim of this study is to develop an economical, stable, and effective heterogeneous catalyst for wastewater remediation via the Fenton oxidation process. For this purpose, Fe₃O₄-montmorillonite alginate (FeMA) composite beads were synthesized by entrapping Fe₃O₄-montmorillonite in calcium alginate beads. The performance of the catalysts was evaluated via the Fenton degradation of ofloxacin (OFL), an antibiotic that is frequently detected in water bodies. The physiochemical properties of the FeMA composite beads were characterized using X-ray photoelectron spectroscopy (XPS), field emission scanning electron microscope/energy dispersive X-ray (FESEM/EDX), Brunauer-Emmett-Teller (BET) analysis, Fourier transform infrared (FTIR) spectroscopy, and thermogravimetric analysis (TGA). FeMA composite beads were found to have a higher surface area, higher porosity, and better thermal stability compared to pristine alginate beads. The composite beads were subsequently used for Fenton degradation of ofloxacin (OFL) in an aqueous solution. The effects of Fe₃O₄-montmorillonite loading on alginate, FeMA composite beads dosage, initial solution pH, initial OFL concentration, different oxidants, H₂O₂ dosage, reaction temperature, and inorganic salts on Fenton degradation of OFL in aqueous solution was investigated. The results revealed that the percentage of OFL degradation reached about 80 % under optimized conditions, while the total organic carbon (TOC) removal reached about 53 %. The entrapment of Fe₃O₄-montmorillonite in alginate beads results in less iron ions leaching compared to previous observation, and the efficiency remains constant over the five cycles investigated. The kinetics of the Fenton degradation process are best fitted to the pseudo-first-order kinetic model. It is therefore believed that FeMA composite beads can be a promising material for wastewater remediation via the Fenton oxidation process.

Phytofabrication of bimetallic silver-copper/biochar nanocomposite for environmental and medical applications

In the current study, a novel, green, low-cost, and sustainable path for the phyto-fabrication of Ag-Cu biochar nanocomposite (Ag-Cu/biochar) by Atriplex halimus biomass and aqueous extract is described. Surface plasmon resonance peaks were detected at 450 nm and 580 nm signifying the formation of both silver and copper nanoparticles, respectively on the biochar surface. XRD analysis confirmed the crystal structure of the phytosynthesized Ag-Cu/biochar whereas FT-IR, SEM, EDX, and XPS analyses confirmed the successful phytofabrication of the composite. Ag and Cu nanoparticles loaded on the biochar surface were almost spherically-shaped with a particle size ranging from 25 nm to 45 nm. Zeta potential of -25.5 mV showed the stability of Ag-Cu/biochar. The potential of this novel nanocomposite in the removal of doxycycline (DOX) was evident under different conditions as it reached nearly 100% under the optimum reaction conditions (DOX concentration; 50 ppm, pH; 9, a dose of Ag-Cu/biochar; 0.01 g, temperature; 25 °C, and H₂O₂ concentration; 100 mM). The promising regeneration of Ag-Cu/biochar was evident as the removal efficiency was 81% after 6 consecutive cycles. Ag-Cu/biochar was also shown an excellent antimicrobial activity against gram-negative bacteria as well a promising antioxidant activity.

Highly Efficient Photocatalyst Fabricated from the Chemical Recycling of Iron Waste and Natural Zeolite for Super Dye Degradation

In this paper, Fe2O3 and Fe2O3-zeolite nanopowders are prepared by chemical precipitation utilizing the rusted iron waste and natural zeolite. In addition to the nanomorphologies; the chemical composition, structural parameters, and optical properties are examined using many techniques. The Fe2O3-zeolite photocatalyst showed smaller sizes and higher light absorption in visible light than Fe2O3. Both Fe2O3 and Fe2O3-zeolite are used as photocatalysts for methylene blue (MB) photodegradation under solar light. The effects of the contact time, starting MB concentration, Fe2O3-zeolite dose, and pH value on photocatalytic performance are investigated. The full photocatalytic degradation of MB dye (10 mg/L) is achieved using 75 mg of Fe2O3-zeolite under visible light after 30 s, which, to the best of our knowledge, is the highest performance yet for Fe2O3-based photocatalysts. This photocatalyst has also shown remarkable stability and recyclability. The kinetics and mechanisms of the photocatalytic process are studied. Therefore, the current work can be applied industrially as a cost-effective method for eliminating the harmful MB dye from wastewater and recycling the rusted iron wires.

Greener Catalysis for Environmental Applications

Catalytic reactions account for approximately 85% of all chemical reactions, and they are particularly significant in environmental science [...]

Fenton Degradation of Ofloxacin Using a Montmorillonite–Fe3O4 Composite

In this work, FeM composites consisting of montmorillonite and variable amounts of Fe3O4 were successfully synthesized via a facile co-precipitation process. They were characterized using X-ray photoelectron spectroscopy (XPS), a field emission scanning electron microscope (FESEM), energy-dispersive X-ray spectroscopy (EDX), a transmission electron microscope (TEM), N2 adsorption–desorption, and Fourier transform infrared spectroscopy (FTIR) techniques to explain the effect of Fe3O4 content on the physicochemical properties of the Fe3O4–montmorillonite (FeM) composites. The FeM composites were subsequently used as heterogeneous Fenton catalysts to activate green oxidant (H2O2) for the subsequent degradation of ofloxacin (OFL) antibiotic. The efficiency of the FeM composites was studied by varying various parameters of Fe3O4 loading on montmorillonite, catalyst dosage, initial solution pH, initial OFL concentration, different oxidants, H2O2 dosage, reaction temperature, inorganic salts, and solar irradiation. Under the conditions of 0.75 g/L FeM-10, 5 mL/L H2O2, and natural pH, almost 81% of 50 mg/L of OFL was degraded within 120 min in the dark, while total organic carbon (TOC) reduction was about 56%. Although FeM composites could be a promising heterogeneous catalyst for the activation of H2O2 to degrade organic pollutants, including OFL antibiotic, the FeM-10 composite shows a significant drop in efficiency after five cycles, which indicates that more studies to improve this weakness should be conducted.