Effect of Organic Substances on Nutrients Recovery by Struvite Electrochemical Precipitation from Synthetic Anaerobically Treated Swine Wastewater

Amino-modified upcycled biochar achieves selective chromium removal in complex aqueous matrices

Chromium pollution of groundwater sources is a growing global issue, which correlates with various anthropogenic activities. Remediation of both the Cr(VI) and Cr(III), via adsorption technologies, has been championed in recent years due to ease of use, minimal energy requirements, and the potential to serve as a highly sustainable remediation technology. In the present study, a biochar sorbent sourced from pineapple skins, allowed for the upcycling of agricultural waste into water purification technology. The biochar material was chemically modified, through a green amination method, to produce an efficient and selective adsorbent for the removal of both Cr(VI) and Cr(III) from complex aqueous matrices. From FTIR analysis it was evident that the chemical modification introduced new C-N and N-H bonds observed in the modified biochar along with a depletion of N-O and C-H bonds found in the pristine biochar. The amino modified biochar was found to spontaneously adsorb both forms of chromium at room temperature, with binding capacities of 46.5 mg/g of Cr(VI) and 27.1 mg/g of Cr(III). Interference studies, conducted in complex matrices, showed no change in adsorption capacity for Cr(VI) in matrices containing up to 3,000× the concentration of interfering ions. Finally, Cr(III) removal was synergized to 100% adsorption at interfering ions concentrations up to 330× of the analyte, which were suppressed at higher interference concentrations. Considering such performance, the amino modified biochar achieved selective removal for both forms of chromium, showing great potential for utilization in complex chromium pollution sources.

Efficient adsorption of phosphorus by macroscopic MOF/chitosan composites and preliminary investigation of subsequent phosphorus recovery through electrochemically-driven struvite precipitation

The proper management of phosphorus (P) from wastewater is crucial for sustainable development consideration. Herein, we developed a strategy which combines adsorption via tailored adsorbents and electrochemically-driven struvite precipitation (ESP) for P recovery. Novel polydopamine-modified Ce-MOF/chitosan composite beads (PDA@Ce-MOF-CS) were prepared by a facile in situ growth of Ce-MOF crystals incorporated natural polymers and PDA coating. The physicochemical properties of PDA@Ce-MOF-CS were characterized. Both batch and fixed-bed column experiments were conducted to evaluate its adsorption performances. Representatively, PDA@Ce-MOF-CS performed good selectivity for P removal and exhibited a maximum adsorption capacity of 161.13 mg P/g at pH 3 and 318 K. Meanwhile, the developed adsorbent showed great reusability after ten regeneration cycles as well as good adsorption stability. The dominant mechanism for efficient P adsorption included electrostatic attraction, surface precipitation and ligand exchange. Interestingly, PDA@Ce-MOF-CS exhibited a remarkable adsorption capacity of 92.86 mg P/g by treating real P-rich electroplating wastewater, and the desorbed P in the eluate could be effectively recovered and converted into a solid fertilizer as struvite via ESP. Overall, this work provided a new research direction for P recovery from wastewater as struvite by combined technologies with the help of macroscopic MOF architectures.

A review on recent environmental electrochemistry approaches for the consolidation of a circular economy model

Availability of raw materials in the chemical industry is related to the selection of the chemical processes in which they are used as well as to the efficiency, cost, and eventual evolution to more competitive dynamics of transformation technologies. In general terms however, any chemically transforming technology starts with the extraction, purification, design, manufacture, use, and disposal of materials. It is important to create a new paradigm towards green chemistry, sustainability, and circular economy in the chemical sciences that help to better employ, reuse, and recycle the materials used in every aspect of modern life. Electrochemistry is a growing field of knowledge that can help with these issues to reduce solid waste and the impact of chemical processes on the environment. Several electrochemical studies in the last decades have benefited the recovery of important chemical compounds and elements through electrodeposition, electrowinning, electrocoagulation, electrodialysis, and other processes. The use of living organisms and microorganisms using an electrochemical perspective (known as bioelectrochemistry), is also calling attention to "mining", through plants and microorganisms, essential chemical elements. New process design or the optimization of the current technologies is a major necessity to enhance production and minimize the use of raw materials along with less generation of wastes and secondary by-products. In this context, this contribution aims to show an up-to-date scenario of both environmental electrochemical and bioelectrochemical processes for the extraction, use, recovery and recycling of materials in a circular economy model.

Nutrient treatment of greywater in green wall systems: A critical review of removal mechanisms, performance efficiencies and system design parameters

Greywater has lower pathogen and nutrient levels than other mixed wastewaters, making it easier to treat and to reuse in nature-based wastewater treatment systems. Green walls (GWs) are one type of nature-based solutions (NBS) that are evolving in design to support on-site and low-cost greywater treatment. Greywater treatment in GWs involves interacting and complex physical, chemical, and biological processes. Design and operational considerations of such green technologies must facilitate these pivotal processes to achieve effective greywater treatment. This critical review comprehensively analyses the scientific literature on nutrient removal from greywater in GWs. It discusses nutrient removal efficiency in different GW types. Total nitrogen removal ranges from 7 to 91% in indirect green facades (IGF), 48-93% for modular living walls (MLW), and 8-26% for continuous living walls (CLW). Total phosphorus removal ranges from 7 to 67% for IGF and 2-53% for MLW. The review also discusses the specific nutrient removal mechanisms orchestrated by vegetation, substrates, and biofilms to understand their role in nitrogen and phosphorus removal within GWs. The effects of key GW design parameters on nutrient removal, including substrate characteristics, vegetation species, biodegradation, temperature, and operating parameters such as irrigation cycle and hydraulic loading rate, are assessed. Results show that greater substrate depth enhances nutrient removal efficiency in GWs by facilitating efficient filtration, straining, adsorption, and various biological processes at varying depths. Particle size and pore size are critical substrate characteristics in GWs. They can significantly impact the effectiveness of physicochemical and biological removal processes by providing sufficient pollutant contact time, active surface area, and by influencing saturation and redox conditions. Hydraulic loading rate (HLR) also impacts the contact time and redox conditions. An HLR between 50 and 60 mm/d during the vegetation growing season provides optimal nutrient removal. Furthermore, nutrient removal was higher when watering cycles were customized to specific vegetation types and their drought tolerances.

Evaluation of Different Reverse Osmosis Membranes for Textile Dyeing and Finishing Wastewater Reuse

Different commercial reverse osmosis (RO) membranes from Vontron and DuPont Filmtec were evaluated for textile dyeing and finishing wastewater (TDFW) reuse in China. All six tested RO membranes produced qualified permeate meeting TDFW reuse standards at a water recovery ratio (WRR) of 70% in single batch tests. The rapid decline of apparent specific flux at WRR over 50% was mainly ascribed to feed osmotic pressure increase caused by concentrating effects. Multiple batch tests using Vontron HOR and DuPont Filmtec BW RO membranes with comparable permeability and selectivity demonstrated the reproducibility and showed low fouling development. The occurrence of carbonate scaling on both RO membranes was identified by scanning electron microscopy and energy disperse spectroscopy. No obvious organic fouling was detected on both RO membranes by attenuated total reflectance Fourier transform infrared spectrometry. From the orthogonal tests, with an integrated RO membrane performance index (i.e., 25% rejection ratio of total organic carbon + 25% rejection ratio of conductivity + 50% flux ratio of final to initial) as a target, the optimal parameters were determined as WRR of 60%, cross-flow velocity (CFV) of 1.0 m/s, temperature (T) of 20 °C for both RO membranes, while trans-membrane pressures (TMP) of 2 and 4 MPa were optimal for Vontron HOR RO membrane and DuPont Filmtec BW RO membrane, respectively. Both RO membranes with the optimal parameters produced good permeate quality for TDFW reuse and kept a high flux ratio of final to initial, demonstrating the effectiveness of the orthogonal tests.

Combined application of microbes immobilized carbon reactor and the reactive struvite system for the management of tannery deliming wastewater

This present study investigated the removal of COD and ammoniacal nitrogen (NH₄⁺-N) from tannery deliming wastewater (TDLWW) through microbes immobilized carbon consisted a bioreactor (MICCR) and reactive struvite crystallization process. Initially, 90% of the organic content of TDLWW was removed using a MICCR reactor at 24 h retention time. Nanoporous carbon (NPC) was used as the carrier matrix for the MICCR reactor. SEM and AFM images of NPC used in the MICCR reactor identify different microorganisms on its surface. The microbial profile of NPC used in the MICCR was analyzed, and the relative abundance is phyla Firmicutes, 25.64%; Proteobacteria, 43.68%; Bacteroidetes, 6.58%; Cyanobacteria, 2.22%; Actinobacteria, 2.34% reason for organic removal. The removal of organics follows the pseudo-second-order rate kinetics with the rate constant of 1.75 × 10^-3 L COD^-1 h^-1. For the reactive struvite crystallization, MgO and Na₂HPO₄.2H₂O were taken as the precipitating agents. The optimum molar ratio for the maximum conversion of NH₄⁺-N into struvite was obtained as 1:1.4:1.4 (NH₄⁺-N:MgO:Na₂HPO₄.2H₂O). The volume of struvite precipitate was 48.5 mL/L of TDLWW, and the dry weight was 8.89 g/L. More than 93% of NH₄⁺-N was converted as the struvite fertilizer. The conversion of NH₄⁺-N into struvite follows the pseudo-first-order rate kinetics with the rate constant of 1.67 × 10^-2 min^-1. Despite the conversion of NH₄⁺-N into struvite, COD removal was observed, which confirms the conversion of organic nitrogen into struvite. The struvite was evaluated using SEM, XRD, TGA, DSC, and FT-IR spectroscopic analysis. Hence, the integrated MICCR and the reactive struvite crystallization process can be applied to manage tannery deliming wastewater.

Macro-nutrients recovery from liquid waste as a sustainable resource for production of recovered mineral fertilizer: Uncovering alternative options to sustain global food security cost-effectively

Global food security, which has emerged as one of the sustainability challenges, impacts every country. As food cannot be generated without involving nutrients, research has intensified recently to recover unused nutrients from waste streams. As a finite resource, phosphorus (P) is largely wasted. This work critically reviews the technical applicability of various water technologies to recover macro-nutrients such as P, N, and K from wastewater. Struvite precipitation, adsorption, ion exchange, and membrane filtration are applied for nutrient recovery. Technological strengths and drawbacks in their applications are evaluated and compared. Their operational conditions such as pH, dose required, initial nutrient concentration, and treatment performance are presented. Cost-effectiveness of the technologies for P or N recovery is also elaborated. It is evident from a literature survey of 310 published studies (1985-2022) that no single technique can effectively and universally recover target macro-nutrients from liquid waste. Struvite precipitation is commonly used to recover over 95 % of P from sludge digestate with its concentration ranging from 200 to 4000 mg/L. The recovered precipitate can be reused as a fertilizer due to its high content of P and N. Phosphate removal of higher than 80 % can be achieved by struvite precipitation when the molar ratio of Mg²⁺/PO₄^3- ranges between 1.1 and 1.3. The applications of artificial intelligence (AI) to collect data on critical parameters control optimization, improve treatment effectiveness, and facilitate water utilities to upscale water treatment plants. Such infrastructure in the plants could enable the recovered materials to be reused to sustain food security. As nutrient recovery is crucial in wastewater treatment, water treatment plant operators need to consider (1) the costs of nutrient recovery techniques; (2) their applicability; (3) their benefits and implications. It is essential to note that the treatment cost of P and/or N-laden wastewater depends on the process applied and local conditions.

Water Treatment Process

Water scarcity is the main factor driving the enhancement of available technologies and the development of new technologies [...].