Cyanobacterial removal by a red soil-based flocculant and its effect on zooplankton: an experiment with deep enclosures in a tropical reservoir in China

Ferric- and calcium-loaded red soil assist colonization of submerged macrophyte for the in-situ remediation of eutrophic shallow lake: From mesocosm experiment to field enclosure application

Eutrophication and its resulting harmful algal blooms greatly reduce the ecosystem services of natural waters. The use of modified clay materials to assist the phytoremediation of eutrophic water is a promising technique. In this study, ferric chloride and calcium hydroxide were respectively loaded on red soil for algal flocculation and phosphorus inactivation. A two-by-two factorial mesocosm experiment with and without the application of ferric- and calcium- loaded red soil (FA), and with and without planting the submerged macrophyte Vallisneria natans was conducted for the in-situ repair of eutrophic water and sediment. Furthermore, field enclosure application was carried out to verify the feasibility of the technology. At the end of the mesocosm experiment, the total phosphorus, total nitrogen, and ammonia nitrogen concentrations in water were reduced by 81.8 %, 63.3 %, and 62.0 %, respectively, and orthophosphate phosphorus concentration in the sediment-water interface decreased by 90.2 % in the FA + V. natans group compared with those in the control group. The concentration and proportion of chlorophyll-a in cyanobacteria decreased by 89.8 % and 71.2 %, respectively, in the FA + V. natans group. The content of active phosphorus in V. natans decreased and that of inert phosphorus increased in the FA + V. natans group, compared with those in the V. natans alone group, thus may reducing the risk of phosphorus release after decomposing of V. natans. The sediment bacterial diversity index did not change significantly among treatments. Field enclosure application have also been successful, with chlorophyll-a concentration in the water of treated enclosure decreased from above 200 μg/L to below 10 μg/L, and phosphorus concentration in the water decreased from >0.6 mg/L to <0.02 mg/L. These results demonstrated that the FA in combination with submerged macrophyte planting had great potential for the in-situ remediation of eutrophic water, especially those with severe algal blooms.

Sustainable control of Microcystis aeruginosa, a harmful cyanobacterium, using Selaginella tamariscina extracts

Eco-friendly reagents derived from plants represent a promising strategy to mitigate the occurrence of toxic cyanobacterial blooms. The use of an amentoflavone-containing Selaginella tamariscina extract (STE) markedly decreased the number of Microcystis aeruginosa cells, thus demonstrating significant anti-cyanobacterial activity. In particular, the Microcystis-killing fraction obtained from pulverized S. tamariscina using hot-water-based extraction at temperatures of 40 °C induced cell disruption in both axenic and xenic M. aeruginosa. Liquid chromatographic analysis was also conducted to measure the concentration of amentoflavone in the STE, thus supporting the potential M. aeruginosa-specific killing effects of STE. Bacterial community analysis revealed that STE treatment led to a reduction in the relative abundance of Microcystis species while also increasing the 16S rRNA gene copy number in both xenic M. aeruginosa NIBR18 and cyanobacterial bloom samples isolated from a freshwater environment. Subsequent testing on bacteria, cyanobacteria, and algae isolated from freshwater revealed that STE was not toxic for other taxa. Furthermore, ecotoxicology assessment involving Aliivibrio fischeri, Daphnia magna, and Danio rerio found that high STE doses immobilized D. magna but did not impact the other organisms, while there was no change in the water quality. Overall, due to its effective Microcystis-killing capability and low ecotoxicity, aqueous STE represents a promising practical alternative for the management of Microcystis blooms.

Impacts of the Floc and Sink technique on the phytoplankton community: A morpho-functional approach in eutrophic reservoir water

The Floc and Sink technique promotes, through the application of coagulants and clays, the removal of phosphorus and algal biomass from the water column by flocculation and sedimentation. Although it is a promising technique for mitigating harmful cyanobacterial blooms, little is known about the impacts on other phytoplankton species as well as it is not known how species with mechanisms of resistance to sedimentation respond to the application of these products. In this study, a laboratory experiment was carried out with water from a eutrophic reservoir to assess the impact of applying aluminum-based coagulants, aluminum sulfate and polyaluminium chloride, and chitosan, alone and combined with lanthanum modified bentonite and natural bentonite on the phytoplankton community, in a functional approach based on morphology (Morphology-Based Functional Groups - MBFG, Kruk et al., 2010 and Reynolds et al., 2014), with an emphasis on the characteristics that provide resistance to sedimentation. We tested two hypotheses: phytoplankton species with adaptive mechanisms that provide buoyancy to cells are more resistant to the removal from the water column by coagulants and clays; and coagulants based on metals and modified clays are more efficient in sedimentation of microalgal cells compared to natural products, regardless of the presence of an adaptive mechanism of resistance to sedimentation. Our results showed that aluminum sulfate and polyaluminium chloride alone or combined with lanthanum modified bentonite and natural bentonite effectively sedimented the cells, regardless of the presence of buoyancy mechanisms. In contrast, the natural coagulant chitosan alone or combined with lanthanum modified bentonite and natural bentonite removed only those species that were small-celled or small colonial without specialized structures or with the presence of spines, arms and siliceous exoskeleton. In the case of species with aerotopes and flagella, the removal was not effective and still caused an increase in algal biomass due to the formation of suspended cell aggregates on the surface of the water column of the experimental units. Therefore, we concluded that the Floc and Sink technique has an impact on the phytoplankton community because it removes from the water column species that are not the target of coagulants and clays, but that are considered important sources of energy in freshwater trophic webs. This result differs according to the type of product used as well as it is related to the morphological adaptations that favor the buoyancy of cells in the water column. Species with aerotopes and flagella are more resistant to sedimentation and may make the use of products applied in the Floc and Sink technique unfeasible. Nevertheless, these results represent only an immediate effect of the technique on the phytoplankton community, thus requiring a longer time scale evaluation to determine the algae that can effectively recover water column. Therefore, we also emphasize that algae of nutritional value can recover over time and make the long-term application of the technique acceptable.

Simultaneous Removal of the Freshwater Bloom-Forming Cyanobacterium Microcystis and Cyanotoxin Microcystins via Combined Use of Algicidal Bacterial Filtrate and the Microcystin-Degrading Enzymatic Agent, MlrA

Freshwater cyanobacterial blooms (e.g., Microcystis blooms) constitute a major global environmental problem because of their risks to public health and aquatic ecological systems. Current physicochemical treatments of toxic cyanobacteria cause the significant release of cyanotoxin microcystins from damaged cells. Biological control is a promising eco-friendly technology to manage harmful cyanobacteria and cyanotoxins. Here, we demonstrated an efficient biological control strategy at the laboratory scale to simultaneously remove Microcystis and microcystins via the combined use of the algicidal bacterial filtrate and the microcystin-degrading enzymatic agent. The algicidal indigenous bacterium Paenibacillus sp. SJ-73 was isolated from the sediment of northern Lake Taihu, China, and the microcystin-degrading enzymatic agent (MlrA) was prepared via the heterologous expression of the mlrA gene in the indigenous microcystin-degrading bacterium Sphingopyxis sp. HW isolated from Lake Taihu. The single use of a fermentation filtrate (5%, v/v) of Paenibacillus sp. SJ-73 for seven days removed the unicellular Microcystis aeruginosa PCC 7806 and the native colonial Microcystis strain TH1701 in Lake Taihu by 84% and 92%, respectively, whereas the single use of MlrA removed 85% of microcystins. Used in combination, the fermentation filtrate and MlrA removed Microcystis TH1701 and microcystins by 92% and 79%, respectively. The present biological control thus provides an important technical basis for the further development of safe, efficient, and effective measures to manage Microcystis blooms and microcystins in natural waterbodies.

A possible environmental-friendly removal of Microcystis aeruginosa by using pyroligneous acid

Cyanobacteria blooms are crucial environmental issues by threatening both aquatic ecosystem and human health. A biomass by-product with antimicrobial activity, pyroligneous acid (PA) was tested for its suitability for removal of the cyanobacteria Microcystis aeruginosa (M. aeruginosa) in this work. Results show that the removal efficiency could reach up to 90% in the presence of 0.45% of PA and the inhibition to M. aeruginosa growth could extend to at least 40 days. The removal mechanism was studied. Both organic acids and phenols are functional content in M. aeruginosa removal and acetic acid is the most important one. Zeta potential analysis and morphology study show that the damage of cells dominates the flocculation and sedimentation of M. aeruginosa under low PA concentration (<0.7%), and increasing PA (≥0.7%) resulted in a trend of zeta potential to zero, thus removing any "shield" and triggering flocculation. Finally, study on the phenols residual after M. aeruginosa treatment shows that it could be close to 0 in 70 h. Therefore, this work proposes a possible method for world-wide treatment of cyanobacteria bloom and a new way for further utilization of PA.

Chitosan as a Coagulant to Remove Cyanobacteria Can Cause Microcystin Release

Chitosan has been tested as a coagulant to remove cyanobacterial nuisance. While its coagulation efficiency is well studied, little is known about its effect on the viability of the cyanobacterial cells. This study aimed to test eight strains of the most frequent bloom-forming cyanobacterium, Microcystis aeruginosa, exposed to a realistic concentration range of chitosan used in lake restoration management (0 to 8 mg chitosan L^-1). We found that after 1 h of contact with chitosan, in seven of the eight strains tested, photosystem II efficiency was decreased, and after 24 h, all the strains tested were affected. EC₅₀ values varied from 0.47 to > 8 mg chitosan L^-1 between the strains, which might be related to the amount of extracellular polymeric substances. Nucleic acid staining (Sytox-Green^®) illustrated the loss of membrane integrity in all the strains tested, and subsequent leakage of pigments was observed, as well as the release of intracellular microcystin. Our results indicate that strain variability hampers generalization about species response to chitosan exposure. Hence, when used as a coagulant to manage cyanobacterial nuisance, chitosan should be first tested on the natural site-specific biota on cyanobacteria removal efficiency, as well as on cell integrity aspects.