Thin-layer matrix sublimation with vapor-sorption induced co-crystallization for sensitive and reproducible SAMDI-TOF MS analysis of protein biosensors

Matrix phase fractionation: Investigating the compromise between dynamic range of analyte extraction and spatial resolution in mass spectrometry imaging

RATIONALE

Matrix-assisted laser desorption ionisation with mass spectrometry imaging (MSI) has seen rapid development in recent years and as such is becoming an important technique for the mapping of biomolecules from the surface of tissues. One key area of development is the optimisation of analyte extraction by using modified matrices or mixes of common ones.

METHODS

A series of serial sections were prepared for lipid MSI by either dry coating (sublimation) or by wet spray application of several matrices. These samples were then evaluated for analyte extraction, delocalisation and dynamic range.

RESULTS

We have shown that the spraying and sublimation methods of matrix application can be used complementarily. This creates large datasets, with each preparation method applied narrowly and then interpreted as a 'fraction' of the whole. Once combined, the dynamic range is significantly increased. We have dubbed this technique 'matrix phase fractionation'.

CONCLUSIONS

We have found that, by utilising matrix phase fractionation for the detection of lipids in brain tissue, it is possible to create a significantly more comprehensive dataset than would otherwise be possible with traditional 'single-run' workflows.

High yield matrix-free ionization of biomolecules by pulse-heating ion source

Matrix-assisted laser desorption/ionization (MALDI) mass spectrometry has been widely used for biomolecular analysis. However, with conventional MALDI, it is difficult to analyse low-molecular-weight compounds because of the interference of matrix ion signals. Here, we report a matrix-free on-chip pulse-heating desorption/ionization (PHDI) method for a wide range of biomolecules ranging from low molecular-weight substances such as glycine (75.7 Da) to large species such as α-lactalbumin (14.2 kDa). Compared with the conventional MALDI, the matrix-free PHDI method affords high yields of singly charged ions with very less fragmentation and background using only one-pulse without light (laser). We believe that this new technique for matrix-free biomolecules analysis would overcome the limitations of the conventional MALDI.

Matrix Recrystallization for MALDI-MS Imaging of Maize Lipids at High-Spatial Resolution

Matrix recrystallization is optimized and applied to improve lipid ion signals in maize embryos and leaves. A systematic study was performed varying solvent and incubation time. During this study, unexpected side reactions were found when methanol was used as a recrystallization solvent, resulting in the formation of a methyl ester of phosphatidic acid. Using an optimum recrystallization condition with isopropanol, there is no apparent delocalization demonstrated with a transmission electron microscopy (TEM) pattern and maize leaf images obtained at 10 μm spatial resolution. Graphical Abstract ᅟ.

Screening of the binding of small molecules to proteins by desorption electrospray ionization mass spectrometry combined with protein microarray

The interaction between bioactive small molecule ligands and proteins is one of the important research areas in proteomics. Herein, a simple and rapid method is established to screen small ligands that bind to proteins. We designed an agarose slide to immobilize different proteins. The protein microarrays were allowed to interact with different small ligands, and after washing, the microarrays were screened by desorption electrospray ionization mass spectrometry (DESI MS). This method can be applied to screen specific protein binding ligands and was shown for seven proteins and 34 known ligands for these proteins. In addition, a high-throughput screening was achieved, with the analysis requiring approximately 4 s for one sample spot. We then applied this method to determine the binding between the important protein matrix metalloproteinase-9 (MMP-9) and 88 small compounds. The molecular docking results confirmed the MS results, demonstrating that this method is suitable for the rapid and accurate screening of ligands binding to proteins. Graphical Abstract ᅟ.

Ambient surface analysis of organic monolayers using direct analysis in real time Orbitrap mass spectrometry

A better characterization of nanometer-thick organic layers (monolayers) as used for engineering surface properties, biosensing, nanomedicine, and smart materials will widen their application. The aim of this study was to develop direct analysis in real time high-resolution mass spectrometry (DART-HRMS) into a new and complementary analytical tool for characterizing organic monolayers. To assess the scope and formulate general interpretation rules, DART-HRMS was used to analyze a diverse set of monolayers having different chemistries (amides, esters, amines, acids, alcohols, alkanes, ethers, thioethers, polymers, sugars) on five different substrates (Si, Si3N4, glass, Al2O3, Au). The substrate did not play a major role except in the case of gold, for which breaking of the weak Au-S bond that tethers the monolayer to the surface, was observed. For monolayers with stronger covalent interfacial bonds, fragmentation around terminal groups was found. For ester and amide-terminated monolayers, in situ hydrolysis during DART resulted in the detection of ions characteristic of the terminal groups (alcohol, amine, carboxylic acid). For ether and thioether-terminated layers, scission of C-O or C-S bonds also led to the release of the terminal part of the monolayer in a predictable manner. Only the spectra of alkane monolayers could not be interpreted. DART-HRMS allowed for the analysis of and distinction between monolayers containing biologically relevant mono or disaccharides. Overall, DART-HRMS is a promising surface analysis technique that combines detailed structural information on nanomaterials and ultrathin films with fast analyses under ambient conditions.

An improved sample preparation method for the sensitive detection of peptides by MALDI-MS

We describe here an optimization study of the sample preparation conditions for sensitive detection of peptides by matrix-assisted laser desorption/ionization mass spectrometry (MALDI-MS). Among many factors in the conditions, we varied the percent acetonitrile in the peptide solution, the percent acetonitrile in the matrix solution and the α-cyano-4-hydroxycinnamic acid (CHCA) concentration in the matrix solution. CHCA was chosen because it is the most frequently used matrix for analyzing peptides. The well-established dried-droplet method was employed for sample deposition. The examined range of the concentration of CHCA was from 0.01 to 10 mg/ml, and the MeCN content of the solvent for matrix/analyte was 10% to 50%. The indicator for the detection sensitivity was the S/N ratio of the peaks of peptides used. Highly increased sensitivity (100- to 1000-fold) was observed for the optimal CHCA concentration of 0.1 mg/ml in 20% MeCN/0.1% aq. trifluoroacetic acid (TFA), as compared with the conventional concentration (10 mg/ml) in 50% MeCN/0.1% aq. TFA. For example, the limit of detection of human ACTH 18-39 was 10 amol/well for the optimal condition but 10 fmol/well for the conventional condition. The optimal condition (0.1 mg/ml CHCA in 20% MeCN/0.1% aq. TFA) was verified with five model peptides and provided significant improvement in sensitivity (by two to three orders of magnitude) compared with the conventional conditions. Optimizing the CHCA concentration and solvent composition significantly improved the detection sensitivity in the analysis of peptides by MALDI-MS.

Surface preparation strategies for improved parallelization and reproducible MALDI-TOF MS ligand binding assays

Immunoassays are employed in academia and the healthcare and biotech industries for high-throughput, quantitative screens of biomolecules. We have developed monolayer-based immunoassays for MALDI-TOF MS. To improve parallelization, we adapted the workflow to photolithography-generated arrays. Our work shows Parylene-C coatings provide excellent "solvent pinning" for reagents and biofluids, enabling sensitive MS detection of immobilized components. With a unique MALDI-matrix crystallization technique we show routine interassay RSD <10% at picomolar concentrations and highlight platform compatibility for relative and label-free quantitation applications. Parylene-arrays provide high sample densities and promise screening throughputs exceeding 1000 samples/h with modern liquid-handlers and MALDI-TOF systems.

MS-based ligand binding assays with speed, sensitivity, and specificity

Immunoassays are widely used in biochemical/clinical laboratories owing to their simplicity, speed, and sensitivity. We combined self-assembled monolayer-based immunoassays with MALDI-TOF MS to show that high-fidelity surface preparations with a novel matrix deposition/crystallization technique permits quantitative analysis of monolayer-bound antigens at picomolar detection limits. Calibration curves for intact proteins are possible over a broad concentration range and improved specificity of MS-immunoassays is highlighted by simultaneous label-free quantitation of ligand-bound protein complexes.