Systematic development of extraction methods for quantitative microplastics analysis in soils using metal-doped plastics

An innovative microplastic extraction technique: The switchable calcium chloride density separation column tested for biodegradable polymers, polyethylene, and polyamide

Extracting microplastics from complex matrices poses challenges due to the potential impact of harsh chemical treatments on microplastic properties. For fate and hazard assessment reliable techniques are needed to not only quantify the particle number but also to assess the physicochemical properties of environmental microplastics with minimum changes induced by extraction. Here we present the method development for an innovative and non-destructive extraction protocol based on a switchable calcium chloride density separation column. In contrast to commonly reported extraction protocols, the presented technique is suitable for targeted microplastic property analysis (e.g., surface chemistry and texture) by keeping chemical treatments (such as oxidation and enzymatic digestion) to a minimum. By adjusting the temperature we can control the aggregate state of the highly concentrated salt solution, allowing to separate the microplastics from matrix by cutting of purified, solidified samples. Harsh chemical treatments are avoided, as well as obstruction of microplastic extraction by adsorption to matrix components when passing the tap at the bottom of traditional density separation funnels. The use of microplastics that were prelabeled with a fluorescence dye helped to solve difficulties observed during method development by visual inspection before measurement of extraction efficiency: We spiked a blank compost with low-density polyethylene (LDPE) and polyamide (PA). Additionally, UV aged LDPE was used to demonstrate applicability to more hydrophilic, more environmentally relevant microplastics. The obtained initial results show high recovery of both unaged and aged LDPE over 97 wt.-% and an efficient compost removal but a lower and less robust recovery (between 68 and 18 wt.-%) for PA particles that are more challenging to extract due to an unfortunate synergistic combination of smaller particle size and higher density. Method adaptation to other microplastic types may still be necessary. In short:•A low-cost and simple approach without oxidation to extract (pre-aged) microplastics from compost•Method development by visual observation using fluorescent labelled microplastics and method validation by spike-recovery tests.

Optimization of glass separating funnels to facilitate microplastic extraction from sediments

Recent studies on the distribution of microplastics in aquatic sediments have deployed different methods and devices for density separation of microplastics from sediments. However, instrument specific limitations have been noted, including their high cost, difficulty in handling, or/and the potential for elevated contamination risk due to their plastic composition. This study improves existing sediment microplastic separation techniques by modifying the commonly used conical shape glass separating funnels. The modification consists in connecting a silicone tube at the base of the funnel, whose opening and closure was manually controlled by a Mohr clamp. This adjustment made to the funnels have effectively mitigated critical clogging problems frequently encountered in density separation units. An experiment was conducted using sand-based sediment spiked with polyamide fragments to validate this method modification. Following a complete extraction protocol with the modification of separating funnels, the microplastic extraction efficiency from sediments was high with a 90% recovery rate. Based on these promising results, future studies should consider naturally diverse substrates, as recovery efficiency may be sediment-dependent. Two key adjustments to the glass separation funnels:•Removal of stopcocks•Use of silicone tubes and Mohr clamps to control sediment release.

The power of centrifugation: How to extract microplastics from soil with high recovery and matrix removal efficiency

Understanding the occurrence and transformation of microplastics when released into the environment is essential for risk assessment. The use of biodegradable polymers in agriculture can help to reduce microplastic accumulation in soil, since released fragments of such materials are not persistent and are further transformed into CO2 and biomass (Wohlleben et al., 2023). To be able to monitor the fragmentation and biodegradation of these materials in soil, a validated extraction protocol is needed, which does not induce changes in the chemical and particle properties, additionally it should show high recoveries and matrix removal efficiency. A density-based extraction method in the centrifuge has the potential to remove a high amount of the soil matrix and is very selective for the polymer at the same time. Here we developed an efficient and non-destructive extraction protocol for biodegradable fragments from different soils using sequential centrifugation steps with varying densities and a freezing approach for sample collection. Although the focus of the present study was on biodegradable fragments, the technique can also be used for other types of microplastics with similar or lower density than the one tested for the method validation, but additional recovery tests for the target analyte are recommended.•A density-based extraction method for microplastics from soil, validated by recovery and stability tests using biodegradable polymers•Vessel changes and harsh chemical treatments are kept to a minimum.

Studies on the transfer effect of aged polyethylene microplastics in soil-plant system

The widespread use of polyethylene (PE) agricultural films has led to a large accumulation of microplastics in soil, and the environmental effects of microplastics on soil-plants have received increasing attention. In the actual soil environment, microplastics undergo significant changes in their physicochemical properties due to aging, accompanied by complex ecological and environmental effects. However, the quantitative understanding of the environmental effects of microplastic aging in soil-plant systems is still unclear. Therefore, this study investigated the effects of aged and unaged PE microplastics on ecological functions and microplastic transfer mechanisms in soil-plant system, and confirmed the transport behavior of micrometer-sized microplastics (26 μm) within maize plants, expanding the upper size limit of existing studies on microplastic transport within plants. The accumulation of microplastics in maize was also quantitatively assessed in combination with the self-established method of Eu marked PE. The mobility ratio of microplastics from soil to roots, roots to stems, and stems to leaves was 1.07%, 0.76%, and 103.28%, respectively. This study provides a scientific understanding for the environmental effects of microplastics in soil-plants systems quantitatively.

Labelling of micro- and nanoplastics for environmental studies: state-of-the-art and future challenges

Studying microplastics and nanoplastics (MNP) in environmental matrices is extremely challenging, and recent developments in labelling techniques may hold much promise to further our knowledge in this field. Here, we reviewed MNP labelling techniques and applications to provide the first systematic and in-depth insight into MNP labelling. We classified all labelling techniques for MNP into four main types (fluorescent, metal, stable isotope and radioisotope) and discussed per type the synthesis methods, detection methods, influencing factors, and the current and future applications and challenges. Direct labelling of environmental MNP with fluorescent dyes and metals enables simple visualisation and selective detection of MNP to improve detection efficiency. However, it is still an open question how to avoid co-labelling of non-plastic (i.e. non-target, matrix) materials. Labelling of MNP that are intentionally added in the environment may allow semi-automatic detection of MNP particles with high accuracy and sensitivity during studies on e.g. transport and degradation. The detection limit of labelled MNP largely depends on particle size and the type of matrix. Fluorescent labelling allows efficient detection of microplastics, whereas metal labelling is preferred for nanoplastics research due to a potentially higher sensitivity. A major challenge for fluorescent and metal labelling is to develop techniques that do not alter the inherent MNP properties or only do so minimally, in particular the surface properties. Stable and radioactive isotope labelling (13C and 14C, but also 15N, 2H) of the polymer itself allows to preserve inherent MNP properties, but have been largely ignored. Overall, labelling of MNP holds great promise for advancing our fundamental understanding of the behaviour of plastics, notably the smallest fractions, in the environment.

A new quantitative insight: Interaction of polyethylene microplastics with soil - microbiome - crop

In this study, the interaction between primary/secondary PE MPs and soil - microbiome - crop complex system and PE MPs enrichment behavior in crops were studied by using the self-developed quantitative characterization method of Eu-MPs and in situ zymography. The results demonstrated for the first time the enrichment effect of micron-sized PE (> 10 µm) in crops, manifested as roots>leaves>stems. Primary PE MPs significantly increased soil TN, TC, SOM and β-glu activity and inhibited Phos activity. Age-PE MPs significantly reduced soil TN, TP, β-glu and Phos activities and also have significant inhibitory effects on plant height, stem diameter, and leaf dry weight of maize. Age-PE MPs significantly affected soil microbial diversity, mainly caused by bacterial genera such as UTCFX1, Sphingomonas, Subgroup-6 and Gemmatimonas. Age-PE MPs also affected some metabolism related to microbial community composition and maize growth, including Glycerolipid, Citrate cycle (TCA cycle), C5-Branched dibasic acid, Arginine and proline, Tyrosine metabolism, pentose phosphate pathway, Valine, leucine and isoleucine biosynthesis. These research results indicated that the PE MPs, which are widely present in farmland soils, can affect crop growth, soil microbial community and metabolic function after aging, thus affecting agroecosystems and terrestrial biodiversity.

The influence of complex matrices on method performance in extracting and monitoring for microplastics

Previous studies have evaluated method performance for quantifying and characterizing microplastics in clean water, but little is known about the efficacy of procedures used to extract microplastics from complex matrices. Here we provided 15 laboratories with samples representing four matrices (i.e., drinking water, fish tissue, sediment, and surface water) each spiked with a known number of microplastic particles spanning a variety of polymers, morphologies, colors, and sizes. Percent recovery (i.e., accuracy) in complex matrices was particle size dependent, with ∼60-70% recovery for particles >212 μm, but as little as 2% recovery for particles <20 μm. Extraction from sediment was most problematic, with recoveries reduced by at least one-third relative to drinking water. Though accuracy was low, the extraction procedures had no observed effect on precision or chemical identification using spectroscopy. Extraction procedures greatly increased sample processing times for all matrices with the extraction of sediment, tissue, and surface water taking approximately 16, 9, and 4 times longer than drinking water, respectively. Overall, our findings indicate that increasing accuracy and reducing sample processing times present the greatest opportunities for method improvement rather than particle identification and characterization.

Direct Measurement of Microplastics by Carbon Detection via Single Particle ICP-TOFMS in Complex Aqueous Suspensions

Multiple analytical techniques to measure microplastics (MPs) in complex environmental matrices are currently under development, and which is most suited often depends on the aim(s) of the research question and the experimental design. Here, we further broaden the suite of possible techniques which can directly detect MPs in suspension while differentiating the carbon contained in MPs from other natural particles and dissolved organic carbon (DOC). Single particle inductively coupled plasma mass spectrometry (sp-ICP-MS) is well suited to measuring particles at trace concentrations, and the use of ICP time-of-flight-MS (ICP-TOFMS) allows one to simultaneously monitor the entire elemental spectrum to assess the full elemental composition of individual particles through developing elemental fingerprints. Because carbon is not detected in a standard operation mode with icp TOF, a dedicated optimization was necessary. Subsequently, to assess the feasibility of monitoring ¹²C particle pulses for the detection of MPs in more complex natural waters, two proof-of-principle studies were performed to measure MPs in waters with environmentally relevant DOC backgrounds (≤20 mg/L) and in the presence of other carbon containing particles, here, algae. Elevated DOC concentrations did not impact the enumeration of particles in suspension, and individual MPs, single algae, and aggregates of MPs and algae were clearly distinguished. The simultaneous identification of different analytes of interest allows for multiplexed sp-ICP-TOFMS experiments utilizing elemental fingerprinting of particles and is a step forward in quantifying MPs in aqueous environmental samples.

Effect of Polymer Properties on the Biodegradation of Polyurethane Microplastics

The release of fragments from plastic products, that is, secondary microplastics, is a major concern in the context of the global plastic pollution. Currently available (thermoplastic) polyurethanes [(T)PU] are not biodegradable and therefore should be recycled. However, the ester bond in (T)PUs might be sufficiently hydrolysable to enable at least partial biodegradation of polyurethane particles. Here, we investigated biodegradation in compost of different types of (T)PU to gain insights into their fragmentation and biodegradation mechanisms. The studied (T)PUs varied regarding the chemistry of their polymer backbone (aromatic/aliphatic), hard phase content, cross-linking degree, and presence of a hydrolysis-stabilizing additive. We developed and validated an efficient and non-destructive polymer particle extraction process for partially biodegraded (T)PUs based on ultrasonication and density separation. Our results showed that biodegradation rates and extents decreased with increasing cross-linking density and hard-segment content. We found that the presence of a hydrolysis stabilizer reduced (T)PU fragmentation while not affecting the conversion of (T)PU carbon into CO2. We propose a biodegradation mechanism for (T)PUs that includes both mother particle shrinkage by surface erosion and fragmentation. The presented results help to understand structure-degradation relationships of (T)PUs and support recycling strategies.

Effect of Growth Media on the Diversity of Neocallimastigomycetes from Non-Rumen Habitats

Anaerobic fungi (AF), belonging to the phylum Neocallimastigomycota, are a pivotal component of the digestive tract microbiome of various herbivorous animals. In the last decade, the diversity of AF has rapidly expanded due to the exploration of numerous (novel) habitats. Studies aiming at understanding the role of AF require robust and reliable isolation and cultivation techniques, many of which remained unchanged for decades. Using amplicon sequencing, we compared three different media: medium with rumen fluid (RF), depleted rumen fluid (DRF), and no rumen fluid (NRF) to enrich the AF from the feces of yak, as a rumen control; and Przewalski's horse, llama, guanaco, and elephant, as a non-rumen habitats. The results revealed the selective enrichment of Piromyces and Neocallimastix from the feces of elephant and llama, respectively, in the RF medium. Similarly, the enrichment culture in DRF medium explicitly manifested Piromyces-related sequences from elephant feces. Five new clades (MM1-5) were defined from llama, guanaco, yak, and elephant feces that could as well be enriched from llama and elephant samples using non-conventional DRF and NRF media. This study presents evidence for the selective enrichment of certain genera in medium with RF and DRF from rumen as well as from non-rumen samples. NRF medium is suggested for the isolation of AF from non-rumen environments.