Degradation of kanamycin from production wastewater with high-concentration organic matrices by hydrothermal treatment

Ozone Micronano-bubble-Enhanced Selective Degradation of Oxytetracycline from Production Wastewater: The Overlooked Singlet Oxygen Oxidation

The efficient and selective removal of refractory antibiotics from high-strength antibiotic production wastewater is crucial but remains a substantial challenge. In this study, a novel ozone micronano-bubble (MNB)-enhanced treatment system was constructed for antibiotic production wastewater treatment. Compared with conventional ozone, ozone MNBs exhibit excellent treatment efficiency for oxytetracycline (OTC) degradation and toxicity decrease. Notably, this study identifies the overlooked singlet oxygen (1O2) for the first time as a crucial active species in the ozone MNB system through probe and electron paramagnetic resonance methods. Subsequently, the oxidation mechanisms of OTC by ozone MNBs are systematically investigated. Owing to the high reactivity of OTC toward 1O2, ozone MNBs enhance the selective and anti-interference performance of OTC degradation in raw OTC production wastewater with complex matrixes. This study provides insights into the mechanism of ozone MNB-enhanced pollutant degradation and a new perspective for the efficient treatment of high-concentration industrial wastewater using ozone MNBs. In addition, this study presents a promising technology with scientific guidance for the treatment of antibiotic production wastewater.

Preparation of ZIF-67/C3N4 composite material and adsorption of tetracycline hydrochloride

In recent years, wastewater treatment to remove tetracycline hydrochloride (TCH) has received much attention in water treatment problems. ZIF-67/C3N4 composite adsorbent, a nanosheet structured material stacked with MOFs, was prepared by in situ growth method, which has high adsorption activity for tetracycline hydrochloride in wastewater. Comparing the effect of monomeric and composite adsorbents, Z6C2 had the best adsorption effect (206 mg·g-1), which was 77.6% higher than that of ZIF-67 (116 mg·g-1) and 10.8 times higher than that of C3N4 (19 mg·g-1). The structure of ZIF-67 stacked on C3N4 nanosheets has an excellent specific surface area and number of active sites, as well as π-π interactions, electrostatic interactions, and hydrogen bonding interactions between the adsorbent and TCH, which combine to enhance the adsorption performance. The adsorption process is accompanied by a combination of chemisorption, mass transport, and internal diffusion rate-limiting. It was shown that the adsorption process is favorable for monolayer adsorption as well as a heat absorption reaction that proceeds spontaneously. The adsorbent exhibits good stability and adsorption capacity, which may be suitable for efficient and low-cost water purification.

Enhanced hydrolytic removal of tylosin in wastewater using polymer-based solid acid catalysts converted from polystyrene

Antibiotic production wastewater usually contains high concentrations of antibiotic residues, which can cause instability and deterioration of biological wastewater treatment units and also domestication and proliferation of antibiotic-resistance bacteria. An effective pretreatment on antibiotics production wastewater is expected to selectively reduce the concentration of antibiotics and decrease the toxicity, rather than mitigate organic and other contaminants before further treatments. In this work, two polymer-based solid acids, PS-S and CPS-S bearing high concentrations of -SOH₃ groups (up to 4.57 mmol/g), were prepared and successfully used for hydrolytic mitigation of 100 mg/L tylosin within 20 min. The co-existence of high concentrations of COD and humic substances did not affect the mitigation of tylosin obviously, while more than 500 mg/L of nitrogenous compounds suppressed the hydrolytic efficiency. Recycle and reuse experiments showed that the solid acids performed well in five cycles after regeneration. Three transformation products (P1, P2 and P3) were identified using UPLC-QTOF-MS/MS. Sugar moieties including mycarse, mycaminose, and mycinose detached and released simultaneously or in order from the 16-member lactone ring through desugarization, which led to a dramatic decrease in antibacterial activity as revealed by cytotoxicity evaluations using S. aureus. Ecotoxicity estimation indicated the acute toxicities of the hydrolyzed products to model species (e.g., fish, daphnid and green algae) were classified as "not harmful". This work suggested an effective and selective method to pretreat tylosin-contained production wastewater by using polymer-based solid acids. These results will shed light on effective elimination of antibiotics pollution from pharmaceutical industries through strengthening the pretreatments.

Simultaneous determination of erythromycin and its transformation products in treated erythromycin fermentation residue and amended soil

Erythromycin fermentation residue (EFR) is a solid waste generated from the fermentation process of erythromycin A production. Some byproducts are produced during the fermentation process of erythromycin A production, and erythromycin A can also undergo hydrolysis and biodegradation reactions in the environment with the formation of transformation products. Herein, an accurate analytical method was established and validated to quantify erythromycin A, two byproducts and five hydrolysis or biodegradation products, in solid or semi-solid media of waste EFR and the amended soil. The method mainly included ultrasonic solvent extraction, solid phase extraction, and ultra-performance liquid chromatography-tandem mass spectrometry quantification. All analytes could be effectively extracted in a single process, and the recoveries ranged from 76% to 122% for different matrices. Low matrix effects and excellent precision were achieved by optimizing the mass spectrometry parameters, extraction solution, number of extractions and eluent. This method was applied to evaluate the residual analytes in EFR, treated EFR after industrial-scale hydrothermal treatment, and the subsequent soil application. Seven analytes were detected in the EFR, while six were found in the treated EFR and amended soils. The concentration of erythromycin A in EFR was 1,629 ± 100 mg/kg·TS, and the removal efficiency of hydrothermal treatment (180 °C, 60 min) was about 99.6%. Three hydrolysis products were the main residuals in treated EFR, with anhydroerythromycin A showing the highest concentration. The concentrations of the analytes in soil ranged from 2.17 ± 1.04 to 92.33 ± 20.70 μg/kg·TS, and anhydroerythromycin A contributed 65%-77% of the total concentration. Erythromycin B, a byproduct, was still detected in soil. This work provides an accurate analytical method which would be useful to evaluate the potential risk of byproducts and transformation products of erythromycin A in environment.

Comprehensive role of thermal combined ultrasonic pre-treatment in sewage sludge disposal

Thermal/ultrasonic pre-treatment of sludge has been proven to break the hydrolysis barriers of sewage sludge (SS) and improve the performance of anaerobic digestion (AD). In this study, the objective was to investigate whether the combination of two pre-treatment methods can achieve better results on the AD of SS. The results indicated that, compared with the control group and separate pre-treatment groups, the thermal combined ultrasonic pre-treatment presented more obvious solubilization of soluble proteins, polysaccharides, and other organic matters in SS. The combined method promoted the dissolution of protein-like substances more effectively, with biogas production increased by 19% and the volatile solid (VS) removal rate improved to above 50% compared with the control group. The capillary suction time is reduced by about 85%, which greatly improved the dewatering performance of SS. In addition, the combined method has advantages in degrading sulfonamide antibiotics, roxithromycin and tetracycline. Particularly, by analyzing the interaction between the degradation of different antibiotics and the composition of dissolved organic matters (DOMs), it was found that the composition of DOMs could affect the degradability of different antibiotics. Among them, the high content of tyrosine-like and tryptophan-like was conducive to the degradation of sulfamethoxazole, and the high content of fulvic acid-like and humic acid-like was conducive to the degradation of roxithromycin and tetracycline. This work evaluated the comprehensive effect of thermal combined ultrasonic pre-treatment on SS disposal and provided useful information for its engineering.

Degradation of Antibiotics in Wastewater: New Advances in Cavitational Treatments

Over the past few decades, antibiotics have been considered emerging pollutants due to their persistence in aquatic ecosystems. Even at low concentrations, these pollutants contribute to the phenomenon of antibiotic resistance, while their degradation is still a longstanding challenge for wastewater treatment. In the present literature survey, we review the recent advances in synergistic techniques for antibiotic degradation in wastewater that combine either ultrasound (US) or hydrodynamic cavitation (HC) and oxidative, photo-catalytic, and enzymatic strategies. The degradation of sulfadiazine by HC/persulfate (PS)/H2O2/α-Fe2O3, US/PS/Fe0, and sono-photocatalysis with MgO@CNT nanocomposites processes; the degradation of tetracycline by US/H2O2/Fe3O4, US/O3/goethite, and HC/photocatalysis with TiO2 (P25) sono-photocatalysis with rGO/CdWO4 protocols; and the degradation of amoxicillin by US/Oxone®/Co2+ are discussed. In general, a higher efficiency of antibiotics removal and a faster structure degradation rate are reported under US or HC conditions as compared with the corresponding silent conditions. However, the removal of ciprofloxacin hydrochloride reached only 51% with US-assisted laccase-catalysis, though it was higher than those using US or enzymatic treatment alone. Moreover, a COD removal higher than 85% in several effluents of the pharmaceutical industry (500-7500 mg/L COD) was achieved by the US/O3/CuO process.