1
|
Allali M, Dahamni MA, Ghamnia M, Boukhachem A, Boukrédimi D, Tonneau D, Fauquet C. Synthesis and Investigation of Pure and Cu-Doped NiO Nanofilms for Future Applications in Wastewater Treatment Rejected by Textile Industry. Catalysts 2022; 12:931. [DOI: 10.3390/catal12090931] [Citation(s) in RCA: 0] [Impact Index Per Article: 0] [Reference Citation Analysis] [What about the content of this article? (0)] [Abstract] [Track Full Text] [Journal Information] [Subscribe] [Scholar Register] [Indexed: 11/17/2022] Open
Abstract
Pure and Cu-doped NiO films were synthesized via a soft chemical process. They were deposited on glass substrates heated to 400 °C. Different atomic percentage ratios (2, 4, 6, 8, and 10%) of Cu-doping were used. The prepared samples were characterized by several techniques such as X-ray diffraction for crystallographic study, SEM and AFM for microstructural and morphological properties, and UV-Visible spectroscopy for optical and photocatalytical analysis. XRD results of pure and Cu-doped NiO films indicated the formation of NiO polycrystalline phases under a cubic structure with a favored orientation along the (200) plane noticed in all sprayed films. SEM images revealed the formation of NiO nanoparticles of spherical forms whose sizes increase and agglomerate with increasing Cu-doping. At 10% Cu-doping, NiO agglomeration was extended to the whole surface. AFM images showed a textured and rough surface composed of NiO nanoparticles of average size varying from 16 to 10 nm depending on Cu-doping concentration. UV-visible spectroscopy confirmed the transparency of NiO films and their semiconducting character with a band gap ranging from 3.4450 eV to 2.8648 eV. The photocatalytical properties of pure and Cu-NiO films were enhanced by Cu-doping particles as revealed by the degradation of methylene blue (MB) solution subjected to irradiation.
Collapse
|
2
|
Aroussi S, Dahamni MA, Ghamnia M, Tonneau D, Fauquet C. Characterization of Some Physical and Photocatalytic Properties of CuO Nanofilms Synthesized by a Gentle Chemical Technique. Condensed Matter 2022; 7:37. [DOI: 10.3390/condmat7020037] [Citation(s) in RCA: 2] [Impact Index Per Article: 1.0] [Reference Citation Analysis] [What about the content of this article? (0)] [Abstract] [Track Full Text] [Subscribe] [Scholar Register] [Indexed: 02/04/2023]
Abstract
Pure and Li-doped CuO nanofilms were synthesized on heated glass substrates using the spray-pyrolysis technique. The deposited pure CuO nanofilms were achieved at a precursor molarity of 0.2 M using a solution prepared from copper nitrate trihydrate (Cu(NO3)2·3H2O). Doped Li–CuO nanofilms were obtained using several doping concentrations (3, 6, 9, 12 and 15%) by adding a solution prepared from lithium nitrate (LiNO3). The pure and Li–CuO samples were investigated by different techniques. XRD revealed three dominant peaks (-111), (111) and (211), which are the properties of monoclinic CuO. The increase in Li-doping concentration showed the appearance of other peaks of low intensities detected at 2θ ranging from 49 to 68°. AFM images showed a textured and inhomogeneous surface composed of spherical grains whose size decreased with increasing Li doping. UV–visible spectroscopy showed that the CuO samples were of low transparency; the transmittance was less than 50%. The band-gap energy determined from Tauc’s equation plot increased from 2.157 to 3.728 eV with the increase in Li doping. These values correspond well to the band gap of semiconducting CuO. The photocatalytic properties were accelerated by Li doping, as revealed by the discoloration of aqueous methylene-blue (MB) solution under ultraviolet irradiation.
Collapse
|
3
|
Ben Gouider Trabelsi A, Alkallas FH, Ziouche A, Boukhachem A, Ghamnia M, Elhouichet H. Structural Defect Impact on Changing Optical Response and Raising Unpredicted Ferromagnetic Behaviour in (111) Preferentially Oriented Nanocrystalline NiO Films. Crystals 2022; 12:692. [DOI: 10.3390/cryst12050692] [Citation(s) in RCA: 2] [Impact Index Per Article: 1.0] [Reference Citation Analysis] [What about the content of this article? (0)] [Abstract] [Track Full Text] [Subscribe] [Scholar Register] [Indexed: 11/16/2022]
Abstract
NiO thin films deposed on a glass substrate, “NiO/glass”, are successfully prepared using a spray pyrolysis technique (SPT) at 460 °C and characterized via X-ray diffraction (XRD), scanning electron microscopy (SEM), energy dispersive X-ray, Atomic force microscopy (AFM), spectroscopic ellipsometry (SE), Photoluminescence (PL) and diverse electric and magnetic studies. The structural investigation shows that the synthesized films crystallized in a cubic structure with (111) preferential orientation. The NiO layers exhibit a uniform grain of regular sizes with aggregates randomly distributed across their surface. The optical properties of the NiO thin films evidenced a normal optical dispersion as well as good transparency of the NiO films. An unpredicted ferromagnetic aspect was raised due to the high oxygen presence in the synthetized material. A high thermal dependency of the conductivity, as well as a semiconductor behavior of the grown NiO material, is also demonstrated.
Collapse
|
5
|
Santos R, Martins TA, Silva GN, Conceição MVS, Nogueira IC, Longo E, Botelho G. Ag 3PO 4/NiO Composites with Enhanced Photocatalytic Activity under Visible Light. ACS Omega 2020; 5:21651-21661. [PMID: 32905253 PMCID: PMC7469368 DOI: 10.1021/acsomega.0c02456] [Citation(s) in RCA: 13] [Impact Index Per Article: 3.3] [Reference Citation Analysis] [What about the content of this article? (0)] [Affiliation(s)] [Abstract] [Track Full Text] [Subscribe] [Scholar Register] [Received: 05/25/2020] [Accepted: 07/31/2020] [Indexed: 05/05/2023]
Abstract
Black NiO powders were prepared by a hydrothermal method. Moreover, the visible light-driven Ag3PO4/NiO photocatalyst composites were successfully synthesized by in situ precipitation method. These samples were structurally characterized by X-ray diffraction and Rietveld refinement. The strong interaction between the phases and the defects in the samples was affected by the formation of the composites, as identified by Fourier transform infrared spectroscopy and Raman spectroscopy. UV-vis diffuse reflectance spectroscopy exhibited enhanced light absorption for all Ag3PO4/NiO composites, suggesting the effective interaction between the phases. Moreover, field-emission scanning electron microscopy images revealed the presence of NiO microflowers composed of nanoflakes in contact with Ag3PO4 microparticles. The composite with 5% NiO presented enhanced photocatalytic efficiency in comparison with pure Ag3PO4, degrading 96% of rhodamine B (RhB) dye in just 15 min under visible light; however, the recycling experiments confirmed that the composite with 75% NiO showed superior stability. The recombination of the electron-hole pairs was considered for the measurement of the photoluminescence of the samples. These measurements were performed to evaluate the possible causes for the difference in the photocatalytic responses of the composites. From these experimental results, possible photocatalytic mechanisms for RhB degradation over Ag3PO4/NiO composites under visible-light irradiation were proposed.
Collapse
Affiliation(s)
- Ricardo
K. Santos
- Department
of Environmental Chemistry, Federal University
of Tocantins, Gurupi, Tocantins 77402-970, Brazil
| | - Tiago A. Martins
- CDMF-UFSCar, Federal University of São Carlos, São Carlos, São
Paulo 13565-905, Brazil
| | - Gabriela N. Silva
- Department
of Environmental Chemistry, Federal University
of Tocantins, Gurupi, Tocantins 77402-970, Brazil
| | - Marcus V. S. Conceição
- Department
of Environmental Chemistry, Federal University
of Tocantins, Gurupi, Tocantins 77402-970, Brazil
| | - Içamira C. Nogueira
- Department
of Physics, Federal University of Amazonas, Manaus, Amazonas 69077-000, Brazil
| | - Elson Longo
- CDMF-UFSCar, Federal University of São Carlos, São Carlos, São
Paulo 13565-905, Brazil
| | - Gleice Botelho
- Department
of Environmental Chemistry, Federal University
of Tocantins, Gurupi, Tocantins 77402-970, Brazil
| |
Collapse
|
7
|
Zhang N, Li X, Ye J, Yang Y, Huang Y, Zhang X, Xiao M. Effect of Gellan Gum and Xanthan Gum Synergistic Interactions and Plasticizers on Physical Properties of Plant-Based Enteric Polymer Films. Polymers (Basel) 2020; 12:polym12010121. [PMID: 31948039 PMCID: PMC7023006 DOI: 10.3390/polym12010121] [Citation(s) in RCA: 17] [Impact Index Per Article: 4.3] [Reference Citation Analysis] [What about the content of this article? (0)] [Affiliation(s)] [Abstract] [Key Words] [Track Full Text] [Download PDF] [Figures] [Journal Information] [Subscribe] [Scholar Register] [Received: 12/04/2019] [Revised: 12/16/2019] [Accepted: 01/01/2020] [Indexed: 12/16/2022] Open
Abstract
The mechanical and barrier properties of plant-based enteric polymer films were enhanced by synergistic interactions between binary gum mixtures and adding plasticizers. The results indicated that the best ratio of gellan gum (GG) and xanthan gum (XG) was 7:3 by comparing tensile strength, tensile elongation, transmittance, and water vapor permeability of plant-based enteric polymer films and rheological properties of solutions. Polyethylene glycol 400 (PEG-400) was an effective plasticizer in improving plasticity and water vapor barrier property of the plant-based enteric polymer film. Rheology measurement and different characterization methods, including Fourier transform infrared spectroscopy, thermogravimetric analysis, differential scanning calorimetry, X-ray diffraction, and scanning electron microscopy, were used to explain interactions between GG and XG as well as PEG-400 and components of the film. The new mixed system, composed of GG/XG mixture with ratio of 7:3 as a novel gelling agent and PEG-400 as a plasticizer, was applied to prepare plant-based enteric hard capsules, which have potential applications in medicines and functional food preparations.
Collapse
Affiliation(s)
- Na Zhang
- College of Chemical Engineering, Huaqiao University, Jimei Road, Jimei District, Xiamen 361021, Fujian, China; (X.L.); (J.Y.); (Y.Y.); (Y.H.); (X.Z.)
- Xiamen Engineering and Technological Research Center for Comprehensive Utilization of Marine Biological Resources, Jimei Road, Jimei District, Xiamen 361021, Fujian, China
- Correspondence: (N.Z.); (M.X.)
| | - Xiaohui Li
- College of Chemical Engineering, Huaqiao University, Jimei Road, Jimei District, Xiamen 361021, Fujian, China; (X.L.); (J.Y.); (Y.Y.); (Y.H.); (X.Z.)
| | - Jing Ye
- College of Chemical Engineering, Huaqiao University, Jimei Road, Jimei District, Xiamen 361021, Fujian, China; (X.L.); (J.Y.); (Y.Y.); (Y.H.); (X.Z.)
- Xiamen Engineering and Technological Research Center for Comprehensive Utilization of Marine Biological Resources, Jimei Road, Jimei District, Xiamen 361021, Fujian, China
| | - Yucheng Yang
- College of Chemical Engineering, Huaqiao University, Jimei Road, Jimei District, Xiamen 361021, Fujian, China; (X.L.); (J.Y.); (Y.Y.); (Y.H.); (X.Z.)
- Xiamen Engineering and Technological Research Center for Comprehensive Utilization of Marine Biological Resources, Jimei Road, Jimei District, Xiamen 361021, Fujian, China
| | - Yayan Huang
- College of Chemical Engineering, Huaqiao University, Jimei Road, Jimei District, Xiamen 361021, Fujian, China; (X.L.); (J.Y.); (Y.Y.); (Y.H.); (X.Z.)
- Xiamen Engineering and Technological Research Center for Comprehensive Utilization of Marine Biological Resources, Jimei Road, Jimei District, Xiamen 361021, Fujian, China
| | - Xueqin Zhang
- College of Chemical Engineering, Huaqiao University, Jimei Road, Jimei District, Xiamen 361021, Fujian, China; (X.L.); (J.Y.); (Y.Y.); (Y.H.); (X.Z.)
- Xiamen Engineering and Technological Research Center for Comprehensive Utilization of Marine Biological Resources, Jimei Road, Jimei District, Xiamen 361021, Fujian, China
| | - Meitian Xiao
- College of Chemical Engineering, Huaqiao University, Jimei Road, Jimei District, Xiamen 361021, Fujian, China; (X.L.); (J.Y.); (Y.Y.); (Y.H.); (X.Z.)
- Xiamen Engineering and Technological Research Center for Comprehensive Utilization of Marine Biological Resources, Jimei Road, Jimei District, Xiamen 361021, Fujian, China
- Correspondence: (N.Z.); (M.X.)
| |
Collapse
|