Tungsten disulfide (WS2) is a highly active co-catalyst in Fe(III)/H2O2 Fenton-like reactions for efficient acetaminophen degradation

Non-radical activation of low additive periodate by carbon-doped boron nitride for acetaminophen degradation: Significance of high-potential metastable intermediates

Metal-free environmental-friendly and cost-effective catalysts for periodate (PI) activation are crucial to popularize their application for micropollutant removal in water. Herein, we report that carbon-doped boron nitride (C-BN) can efficiently activate PI to degrade acetaminophen under very low oxidant doses (40 μM) and over a relatively wide pH range (3-9). As expected, the significant reduction in periodate addition is likely to be due to the higher chemical utilization efficiency achieved by a non-radical oxidation pathway. This involved two main mechanisms, the electron transfer process mediated by the high-potential metastable C-BN-900-PI* complex and singlet oxygen. In this case, the CO groups and defects on the C-BN surface were identified as key active sites for PI activation. Notably, the prepared C-BN-900 had good cycling performance and the degradation efficiency is recovered after simple annealing. The existence of HCO3- and HA significantly inhibited the reaction, whereas Cl-, SO42-, and NO3- had little effect on the degradation of ACE. Overall, this study provides a new alternative method to regulate the non-radical pathway of boron nitride/periodate system.

Influence mechanism of anions on iron doping into swine bone char: Promoting non-radical oxidation of acetaminophen in a Fenton-like system

The application of iron-doped biochar in peroxymonosulfate (PMS) activation systems has gained increasing attention due to their effectiveness and environmental friendliness in addressing environmental issues. However, the behavioral mechanism of iron doping and the detailed 1O2 generation mechanism in PMS activation systems remain ambiguous. Here, we investigated the effects of three anions (Cl-, NO3-and SO42-) on the process of iron doping into bone char, leading to the synthesis of three iron-doped bone char (Fe-ClBC, Fe-NBC and Fe -SBC). These iron-doped bone char were used to catalyze PMS to degrade acetaminophen (APAP) and exhibited the following activity order: Fe-ClBC > Fe-NBC > Fe-SBC. Characterization results indicated that iron doping primarily occurred through the substitution of calcium in hydroxyapatite within BC. In the course of the impregnation, the binding of SO42- and Ca2+ hindered the exchange of iron ions, resulting in lower catalytic activity of Fe-SBC. The primary reactive oxygen species in the Fe-ClBC/PMS and Fe-NBC/PMS systems were both 1O2. 1O2 is produced through O2•- conversion and PMS self-dissociation, which involves the generation of metastable iron intermediates and electron transfer within iron species. The presence of oxygen vacancies and more carbon defects in the Fe-ClBC catalyst facilitates 1O2 generation, thereby enhancing APAP degradation within the Fe-ClBC/PMS system. This study is dedicated to in-depth exploration of the mechanisms underlying iron doping and defect materials in promoting 1O2 generation.

Congo red dye degradation using Fe-containing mineral as a reactive material derived from waste foundry dust

This study investigated the applicability of industrial waste. The high affinity of Fe-based products is widely used for industrial effluents because of their capability to oxidize contaminants. Waste foundry dust (WFD) is an Fe oxide that has been investigated as a potential reactive material that causes the generation of reactive oxidants. We aimed to investigate the physicochemical properties of WFD and the feasibility in the Fenton oxidation process. The WFD was used as a catalyst for removing Congo red (CR), to evaluate the generation of •OH and dissolution of Fe during the oxidation process. The linkage of •OH generation by WFD with eluted Fe(II) through the Fe dissolution was found. The Fenton oxidation reaction, CR degradation was affected by H2O2 concentration, initial pH, WFD dosage, initial CR concentration, and coexisting anions. The CR degradation efficiency increased with an increase in H2O2 concentration and WFD dosage. In addition, chloride and sulfate in solution promoted CR degradation, whereas carbonate had a negative effect on the Fenton oxidation process. The elution of Fe promotes CR degradation, over three reuse cycles, the degradation performance of the CR decreased from 100 to 81.1%. For the Fenton oxidation process, •OH generation is linked to Fe redox cycling, the surface passivation and Fe complexes interrupted the release of reactive oxidants, which resulted in the degradation of the CR decreased. This study proposed that WFD can serve as catalysts for the removal of CR.

Iron-doped swine bone char as hydrogen peroxide activator for efficient removal of acetaminophen in water

Bone char is a functional material obtained by calcining animal bones and is widely used for environmental remediation. In this work, iron was inserted into porcine bone-derived bone char via ion exchange to synthesize iron-doped bone char (Fe-BC) for efficient catalysis of hydrogen peroxide. This is the first time that Fe-BC has been used as a catalyst for the activation of H2O2. The effectiveness of the Fe-BC catalyst was influenced by the annealing temperature and the amount of iron doping. The results showed that the activation of H2O2 by the Fe-BC catalyst with the best catalytic performance could achieve 97.6% of APAP degradation within 30 min. Insights from electron paramagnetic resonance (EPR), free radical scavenging experiments and linear sweep voltammetry (LSV) proposed a reaction mechanism based on free radicals dominated degradation pathways (OH and O2-). Iron served as the primary active site in Fe-BC, with defect sites and oxygen-containing groups in the catalyst also contributing to the removal of pollutants. The Fe-BC/H2O2 system demonstrated resilience to interference from common anions (Cl-, NO3-, SO42- and HCO3-) in water, but was less effective against humic acid (HA). Based on the detection of intermediates produced during APAP degradation, possible degradation pathways of APAP were proposed and the toxicity of intermediates was evaluated. This work provides fresh insights into the use of heterogeneous Fenton catalysts for the removal of organic pollutants from water.

Enhanced photo-Fenton-like performance of biotemplated manganese-doped cobalt silicate catalysts

Cobalt-based catalysts are one of the preferred materials for effective activation of hydrogen peroxide, and metal element doping and active site dispersion are effective methods to enhance their catalytic activity. In this work, manganese-doped cobalt silicate@diatomite composites with enhanced photo-Fenton-like oxidation performance were prepared and used for degradation of methyl orange (MO) dyes. Experiments showed that manganese doping increased the specific surface area of the samples and decreased the band gap energy of the materials. Moreover, the samples doped with manganese elements had better photo-Fenton-like properties. The degradation of methyl orange by Co0.25MnSi@DE/H2O2-UV reached more than 95%. In addition, density-functional theory (DFT) calculations showed that the Mn-doped samples were more prone to activate H2O2 than non-manganese-doped samples, and the synergistic effect from using a bimetallic catalyst increased the photo-Fenton oxidation activity in the system. ESR spectroscopy and bursting tests indicated that the possible degradation mechanism consisted of hydroxyl radicals and superoxide radicals generated by the synergistic effect of cobalt ions and manganese under UV radiation. This study thus presents a feasible idea for the preparation of cobalt-based photo-Fenton catalysts that also provides a basis for understanding the catalytic mechanism analysis of other types of bimetallic catalysts.

Insight into iron oxychloride composite bone char for peroxymonosulfate activation: Mechanism of singlet oxygen evolution for selective degradation of organic pollutants

The activity of iron-based catalysts in advanced oxidation processes (AOPs) is limited by the redox cycle of Fe(III) and Fe(II). In this work, iron oxychloride (FeOCl) with a unique layered structure was loaded on the bone char (BC) to enhance the activation of peroxymonosulfate (PMS). Characterization of the FeOCl-BC catalyst reveals that the loading of FeOCl changed the composition and structure of BC and BC reduced the bond gap of FeOCl. Acetaminophen (APAP) as a target pollutant could be almost completely degraded at neutral pH, and the removal rate reached 0.6597 min^-1. APAP could also be selectively oxidized by FeOCl-BC/PMS system in the presence of some inorganic anions (SO₄^2-, NO₃^-, and Cl^-) and humic acid. Quenching experiments, electron paramagnetic resonance (EPR), chemical probes, and linear sweep voltammetry (LSV) confirm that the primary oxidation mechanism of the FeOCl-BC/PMS system was dominated by ¹O₂. The ¹O₂ was generated from the conversion of O₂^•- and the self-dissociation of PMS, involving the formation of metastable iron intermediates and the redox cycle of Fe(III) and Fe(II). The unique structure of FeOCl, the transport of lattice oxygen and the enrichment of electrons by carbon defects play an essential role in generating reactive species. In this work, the limitation of the redox cycle of Fe(III) and Fe(II) was broken by loading FeOCl on the surface of BC, and a new catalytic mechanism was proposed. This work provides a new perspective for the construction of efficient iron-based catalysts and the practical application of PMS-based AOPs.