Selective oxidation of H1-antihistamines by unactivated peroxymonosulfate (PMS): Influence of inorganic anions and organic compounds

l-Cysteine and barium titanate co-modified enteromorpha biochar as effective peroxymonosulfate activator for atrazine treatment

In this study, pyrolysis and hydrothermal methods were used for Enteromorpha biochar that was co-modified with l-cysteine and barium titanate (LBCBa). It has great environmental tolerance and can remove 93.0 % of atrazine (ATZ, 10 mg·L-1) within 60 mins of ultrasonic treatment. The enhanced hydrophilicity, electron-donating capability, and piezoelectricity of LBCBa are considered to induce excellent performance. The apparent reaction rate of the LBCBa-2/PMS/ATZ system with ultrasonic was 2.87 times that without ultrasonic. The density functional theory points out that, introducing l-cysteine to carbon edges improves the adsorption of ATZ and peroxymonosulfate (PMS), making PMS easier to activate. This work offered unique insights for fabricating effective catalysts and demonstrated the combination of hydrophilic functional groups and piezoelectricity in improving catalytic performance and stability.

Degradation of methotrexate by unactivated and solar-activated peroxymonosulfate in water: Moiety-specific reaction kinetics and transformation product-associated risks

Anticancer drugs have raised worldwide concern owing to their ubiquitous occurrence and ecological risks, necessitating the development of efficient removal strategies in water and wastewater treatment. Although peroxymonosulfate (PMS) is known to be a promising chemical in water decontamination, limited information is available regarding the removal efficiency of anticancer drugs by PMS and solar/PMS systems. This study first reports the moiety-specific reaction kinetics and mechanisms of methotrexate (MTX), an anticancer drug with widespread attention, by PMS (unactivated) and solar-activated PMS in water. It was found that MTX abatement by the direct PMS oxidation followed second-order kinetics, and the pH-dependent rate constants increased from 0.4 M-1 s-1 (pH 5.0) to 1.3 M-1 s-1 (pH 8.0), with a slight decrease to 1.1 M-1 s-1 at pH 9.0. The presence of chloride and bromide exerted no obvious influence on the removal of MTX by PMS. Furthermore, the chemical reactivity of MTX and its seven substructures with different reactive species was evaluated, and the degradation contributions of the reactive species involved were quantitatively analyzed in the solar/PMS system. The product analysis suggested similar reaction pathways of MTX by PMS and solar/PMS systems. The persistence, bioaccumulation, and toxicity of the transformation products were investigated, indicating treatment-driven risks. Notably, MTX can be removed efficiently from both municipal and hospital wastewater effluents by the solar/PMS system, suggesting its great potential in wastewater treatment applications. Overall, this study systematically evaluated the elimination of MTX by the unactivated PMS and solar/PMS treatment processes in water. The obtained findings may have implications for the mechanistic understanding and development of PMS-based processes for the degradation of such micropollutants in wastewater.

Applications of Carbon-Based Materials in Activated Peroxymonosulfate for the Degradation of Organic Pollutants: A Review

In recent years, water pollution has posed a serious threat to aquatic organisms and humans. Advanced oxidation processes (AOPs) based on activated peroxymonosulfate (PMS) show high oxidation, good selectivity, wide pH range and no secondary pollution in the removal of organic pollutants in water. Carbon-based materials are emerging green catalysts that can effectively activate persulfates to generate radical and non-radical active species to degrade organic pollutants. Compared with transition metal catalysts, carbon-based materials are widely used in SR-AOPs because of their low cost, non-toxicity, acid and alkali resistance, large specific surface area, and scalable surface charge, which can be used for selective control of specific water pollutants. This paper mainly presents several carbon-based materials used to activate PMS, including raw carbon materials and modified carbon materials (heteroatom-doped and metal-doped), analyzes and summarizes the mechanism of activating PMS by carbon-based catalysts, and discusses the influencing factors (temperature, pH, PMS concentration, catalyst concentration, inorganic anions, inorganic cations and dissolved oxygen) in the activation process. Finally, the future challenges and prospects of carbon-based materials in water pollution control are also presented.

Degradation of 1,2,3-trichloropropane by unactivated persulfate and the implications for groundwater remediation

Persulfate (PS) is widely used as an in situ chemical oxidation (ISCO) technology for groundwater and soil remediation. While conventional theory generally assumes that PS needs to be "activated" to produce reactive radicals for pollutant degradation, herein, PS without explicit activation system was discovered for the degradation of 1,2,3-TCP with the generation of reactive oxidation species (ROS). Comparison of five common ISCO oxidants (PS, peroxymonosulfate, hydrogen peroxide, potassium permanganate, and sodium percarbonate) indicated that only unactivated PS was able to degrade 1,2,3-TCP in both pure water and 12 natural water samples. 50 μM 1,2,3-TCP degradation can be continued as long as there is enough PS (50 mM). The degradation rate of 1,2,3-TCP increased 450 % when the PS concentration increased from 10 mM to 50 mM and 500 % when the temperature increased from 25 °C to 45 °C. Electron paramagnetic resonance (EPR) analyzes, hydroxyl radicals (·OH) probe reaction and radical quenching experiments confirmed the involvement of both sulfate radicals (SO₄·-) and ·OH that were responsible for 1,2,3-TCP degradation and ·OH played a more important role. HCO₃^-, Cl^- and NOM are three groundwater matrix species that are most likely to inhibit PS oxidation of 1,2,3-TCP. Compared to activated PS, unactivated PS is more promising and more practical for groundwater remediation, since it has several advantages: (1) longer lifetime and better long-term availability; (2) ability of enduring contaminant degradation; (3) applicable for low-permeability zones remediation and potential to alleviate contaminant rebound or tailing problems; (4) environmental friendly; and (5) lower cost. Overall, results of this study show that unactivated PS is a promising in situ remediation technology that may be a good candidate for the most challenging low permeable zone remediation.

Removal of Bisphenol A via peroxymonosulfate activation over graphite carbon nitride supported NiCx nanoclusters catalyst: Synergistic oxidation of high-valent nickel-oxo species and singlet oxygen

In this work, a g-C₃N₄ supported NiCx nanoclusters catalyst (NiCx-CN) was developed, and its performance in activating peroxymonosulfate (PMS) was evaluated. Mechanism investigation stated that although singlet oxygen (¹O₂) was formed in the catalytic process, its contribution to BPA elimination was weeny. Interestingly, through the experiment with dimethyl sulfoxide as the probe, it was considered that the high-valent nickel-oxo species (Ni^&+=O), generated after the interaction of NiCx-CN and PMS, was the dominating reactive oxygen species (ROS). Theoretical calculations (DFT) implied that NiCx-CN might lose electrons to generate high-valent Ni, which was consistent with the detection of Ni³⁺ on the surface of the used NiCx-CN. Besides, the prepared NiCx-CN showed advantages in resisting the interference of inorganic anions. Meanwhile, three BPA degradation routes had been proposed based on the transformation intermediates. This study will establish a new protocol for PMS activation using heterogeneous Ni-based catalysts to efficiently degrade organic pollutants via a nonradical mechanism.

Peroxymonosulfate activation by Co-doped magnetic Mn3O4 for degradation of oxytetracycline in water

Co-doped magnetic Mn₃O₄ was synthesized by the solvothermal method and adopted as an effective catalyst for the degradation of oxytetracycline (OTC) in water. Synergistic interactions between Co-Mn₃O₄ and Fe₃O₄ not only resulted in the enhanced catalytic activity through the activation of peroxymonosulfate (PMS) to degrade OTC but also made Fe₃O₄/Co-Mn₃O₄ easy to be separated and recovered from aqueous solution. 94.2% of OTC could be degraded within 60 min at an initial OTC concentration of 10 mg L^-1, catalyst dosage of 0.2 g L^-1, and PMS concentration of 10 mM. The high efficiency of OTC removal was achieved in a wider pH range of 3.0-10.0. Co (II), Co (III), Fe (II), Fe (III), Mn (II), Mn (III), and Mn (IV) on Fe₃O₄/Co-Mn₃O₄ were identified as catalytic sites based on XPS analysis. The free radical quenching experiments showed that O₂^•- radicals and ¹O₂ played the main role in the degradation process and the catalytic degradation of OTC involved both free radical and non-free radical reactions. Eventually, the intermediates of OTC degradation were examined, and the possible decomposition pathways were proposed. The excellent catalytic performances of Fe₃O₄/Co-Mn₃O₄ came from the fact that the large specific surface area could provide abundant active sites for the activation of PMS and the redistribution of inter-atomic charges accelerated the redox reactions of metal ions. The high degradation efficiency and rate constant of OTC in actual water samples indicated that Fe₃O₄/Co-Mn₃O₄ had a good practical application potential.

Degradation of norfloxacin by calcite activating peroxymonosulfate: Performance and mechanism

In this study, calcite was investigated as an activator for the norfloxacin (NOR) degradation by peroxymonosulfate (PMS). Under optimum conditions, the NOR removal percentage was 99.7% within 60 min, and the pseudo-first-order kinetics effectively described the two-stage oxidation process. The NOR removal percentage improved from 10.4% to 91.5% and the reaction rate constant elevated from 0.0010 to 0.1217 min^-1 when 0.5 g/L calcite was added compared to that without calcite addition. Furthermore, the results of radical scavenger and electron spin resonance trapping indicated that the favorable alkaline environment and a proper level of carbonate in the Calcite/PMS system facilitated the activation of PMS to generate ¹O₂ for rapid NOR degradation. Compared with NaOH, calcite was able to maintain the pH (8-9) of the reaction system stable. Besides, the content of anions with buffering capacity and organic matter in the water matrix influenced the removal percentage of NOR. Seven intermediates were identified and the NOR degradation pathways were suggested. The findings of this research provided an environmentally friendly activator for remediation of organic wastewater and deepened the understanding of the interaction between calcium carbonate and PMS.

Critical review of natural iron-based minerals used as heterogeneous catalysts in peroxide activation processes: Characteristics, applications and mechanisms

Recently, an increasing number of works have been reported about iron-based materials applied as catalysts in peroxide activation processes to degrade pollutants in water. Iron-based catalysts include synthetic and natural iron-based materials. However, some synthetic iron-based materials are difficult to scale up in the practical applications due to high cost and serious secondary environmental pollution. In contrast, natural iron-based minerals are more available and cheaper, and also hold a great promise in peroxide activation processes for pollutant degradation. In this review, we classify different natural iron-based materials into two categories: iron oxide minerals (e.g., magnetite, hematite, and goethite,), and iron sulfide minerals (e.g., pyrite and pyrrhotite,). Their overview applications in peroxide activation processes for pollutant degradation in wastewaters are systematically summarized for the first time. Moreover, the peroxide activation mechanisms induced by natural minerals, and the influences of reaction conditions in different systems are discussed. Finally, the application prospects and existing drawbacks of natural iron-based minerals in the peroxide activation processes for wastewater treatment are proposed. We believe this review can shed light on the application of natural iron-based minerals in peroxide activation processes and present better perspectives for future researches.