Topological Kagome Magnet Co3Sn2S2 Thin Flakes with High Electron Mobility and Large Anomalous Hall Effect

Ultrafast magnetization enhancement via the dynamic spin-filter effect of type-II Weyl nodes in a kagome ferromagnet

The magnetic type-II Weyl semimetal (MWSM) Co3Sn2S2 has recently been found to host a variety of remarkable phenomena including surface Fermi-arcs, giant anomalous Hall effect, and negative flat band magnetism. However, the dynamic magnetic properties remain relatively unexplored. Here, we investigate the ultrafast spin dynamics of Co3Sn2S2 crystal using time-resolved magneto-optical Kerr effect and reflectivity spectroscopies. We observe a transient magnetization behavior, consisting of spin-flipping dominated fast demagnetization, slow demagnetization due to overall half-metallic electronic structures, and an unexpected ultrafast magnetization enhancement lasting hundreds of picoseconds upon femtosecond laser excitation. By combining temperature-, pump fluence-, and pump polarization-dependent measurements, we unambiguously demonstrate the correlation between the ultrafast magnetization enhancement and the Weyl nodes. Our theoretical modelling suggests that the excited electrons are spin-polarized when relaxing, leading to the enhanced spin-up density of states near the Fermi level and the consequently unusual magnetization enhancement. Our results reveal the unique role of the Weyl properties of Co3Sn2S2 in femtosecond laser-induced spin dynamics.

Drumhead surface states promoted hydrogen evolution reactions in type-II nodal-line topological catalyst Mg3Bi2

An excellent catalyst generally meets three indicators: high electron mobility, high surface density of states and low Gibbs free energy (ΔG) [H. Luo et al. Nat. Rev. Phys., 2022, 4, 611-624]. Recent studies have confirmed that topological materials exhibit more advantages than conventional precious metals with regard to the above-mentioned indicators. Herein, based on DFT calculations and symmetry analysis, we discovered for the first time that the topological surface states of Mg3Bi2 with a Kagome lattice promote hydrogen evolution reactions (HERs). In particular, there exists a snake-like type-II nodal loop (NL), located on kz = 0 plane in Mg3Bi2. Besides, the NL forms a topologically protected drumhead surface state on the (001) surface. It was found that the ΔG (0.176 eV) value of the (001) surface is comparable to that of the precious metal Pt. Then, through hole doping and strain regulation, it was found that the catalytic activity of Mg3Bi2 is closely related to the drumhead surface state formed by NL. With the above-mentioned results, this study not only provides a promising candidate material for hydrogen electrolysis, but also deepens our understanding of the dominant factors of NL semimetals for the catalytic activity.

Observation of Termination-Dependent Topological Connectivity in a Magnetic Weyl Kagome Lattice

Engineering surfaces and interfaces of materials promises great potential in the field of heterostructures and quantum matter designers, with the opportunity to drive new many-body phases that are absent in the bulk compounds. Here, we focus on the magnetic Weyl kagome system Co3Sn2S2 and show how for the terminations of different samples the Weyl points connect differently, still preserving the bulk-boundary correspondence. Scanning tunneling microscopy has suggested such a scenario indirectly, and here, we probe the Fermiology of Co3Sn2S2 directly, by linking it to its real space surface distribution. By combining micro-ARPES and first-principles calculations, we measure the energy-momentum spectra and the Fermi surfaces of Co3Sn2S2 for different surface terminations and show the existence of topological features depending on the top-layer electronic environment. Our work helps to define a route for controlling bulk-derived topological properties by means of surface electrostatic potentials, offering a methodology for using Weyl kagome metals in responsive magnetic spintronics.

Regulation of d-Band Centers in Localized CdS Homojunctions through Facet Control for Improved Photocatalytic Water Splitting

The accelerated kinetic behaviour of charge carrier transfer and its unhindered surface reaction dynamic process involving oxygenated-intermediate activation and conversion are urgently required in photocatalytic water (H2 O) overall splitting, which has not been nevertheless resolved yet. Herein, localized CdS homojunctions with optimal collocation of high and low index facets to regulate d-band center for chemically adsorbing and activating key intermediates (*-OH and *-O) have been achieved in H2 O overall splitting into hydrogen. Density functional theory, hall effect, and in situ diffuse reflectance infrared Fourier transform spectroscopy confirm that, electrons and holes are kinetically transferred to reductive high index facet (002) and oxidative low index facet (110) of the localized CdS homojunction induced by facet Fermi level difference to dehydrogenate *-OH and couple *-O for hydrogen and oxygen evolution, respectively, along with a solar conversion into hydrogen (STH) of 2.20 % by Air Mass 1.5 Global filter irradiation. These findings contribute to solving the kinetic bottleneck issues of photocatalytic H2 O splitting, which will further enhance STH.

Firmly interlocked Janus-type metallic Ni3Sn2S2-carbon nanotube heterostructure suppresses polysulfide dissolution and Sn aggregation

Ternary transition-metal tin chalcogenides, with their diverse compositions, abundant constituents, high theoretical capacities, acceptable working potentials, excellent conductivities, and synergistic active/inactive multi-components, hold promise as anode materials for metal-ion batteries. However, abnormal aggregation of Sn nanocrystals and the shuttling of intermediate polysulfides during electrochemical tests detrimentally affect the reversibility of redox reactions and lead to rapid capacity fading within a limited number of cycles. In this study, we present the development of a robust Janus-type metallic Ni₃Sn₂S₂-carbon nanotube (NSSC) heterostructured anode for Li-ion batteries (LIBs). The synergistic effects of Ni₃Sn₂S₂ nanoparticles and a carbon network successfully generate abundant heterointerfaces with steady chemical bridges, thereby enhancing ion and electron transport, preventing the aggregation of Ni and Sn nanoparticles, mitigating the oxidation and shuttling of polysulfides, facilitating the reforming of Ni₃Sn₂S₂ nanocrystals during delithiation, creating a uniform solid-electrolyte interphase (SEI) layer, protecting the mechanical integrity of electrode materials, and ultimately enabling highly reversible lithium storage. Consequently, the NSSC hybrid exhibits an excellent initial Coulombic efficiency (ICE > 83 %) and superb cyclic performance (1218 mAh/g after 500 cycles at 0.2 A/g and 752 mAh/g after 1050 cycles at 1 A/g). This research provides practical solutions for the intrinsic challenges associated with multi-component alloying and conversion-type electrode materials in next-generation metal-ion batteries.

Inkjet printing of two-dimensional van der Waals materials: a new route towards emerging electronic device applications

Two-dimensional (2D) van der Waals (vdW) materials are considered one of the most promising candidates to realize emerging electrical applications. Although until recently, much effort has been dedicated to demonstrating high-performance single 2D vdW devices, associated with rapid progress in 2D vdW materials, demands for their large-scale practical applications have noticeably increased from a manufacturing perspective. Drop-on-demand inkjet printing can be the most feasible solution by exploiting the advantages of layered 2D contacts and advanced 2D vdW ink formulations. This review presents recent achievements in inkjet-printed 2D vdW material-based device applications. A brief introduction to 2D vdW materials and inkjet printing principles, followed by various ink formulation methods, is first presented. Then, the state-of-the-art inkjet-printed 2D vdW device applications and their remaining technical issues are highlighted. Finally, prospects and challenges to be overcome to demonstrate fully inkjet-printed, high-performance 2D vdW devices are also discussed.

Hidden Local Symmetry Breaking in a Kagome-Lattice Magnetic Weyl Semimetal

Exploring the relationship between intriguing physical properties and structural complexity is a central topic in studying modern functional materials. Co₃Sn₂S₂, a newly discovered kagome-lattice magnetic Weyl semimetal, has triggered intense interest owing to the intimate coupling between topological semimetallic states and peculiar magnetic properties. However, the origins of the magnetic phase separation and spin glass state below T_C in this ordered compound are two unresolved yet important puzzles in understanding its magnetism. Here, we report the discovery of local symmetry breaking surprisingly co-emerges with the onset of ferromagnetic order in Co₃Sn₂S₂, by a combined use of neutron total scattering and half-polarized neutron diffraction. An anisotropic distortion of the cobalt kagome lattice at the atomic/nano level is also found, with distinct distortion directions among the two Co1 and four Co2 atoms. The mismatch of local and average symmetries occurs below T_C, indicating that Co₃Sn₂S₂ evolves to an intrinsically lattice disordered system when the ferromagnetic order is established. The local symmetry breaking with intrinsic lattice disorder provides new understanding of the puzzling magnetic properties. Our density functional theory (DFT) calculation indicates that the local symmetry breaking is expected to reorient local ferromagnetic moments, unveiling the existence of the ferromagnetic instability associated with the lattice instability. Furthermore, DFT calculation unveils that the local symmetry breaking could affect the Weyl property by breaking the mirror plane. Our findings highlight the fundamentally important role that the local symmetry breaking plays in advancing our understanding on the magnetic and topological properties in Co₃Sn₂S₂, which may draw attention to explore the overlooked local symmetry breaking in Co₃Sn₂S₂, its derivatives and more broadly in other topological Dirac/Weyl semimetals and kagome-lattice magnets.

Synthesis of Weyl Semi-Metal Co3Sn2S2 by Hydrothermal Method and Its Physical Properties

In the field of condensed matter physics, as new quantum materials, topological semimetals have a special topological energy band structure and nontrivial band crossings in the energy band, which will have many excellent topological properties, such as internal insulation of topological insulators and the presence of conduction electrons on the surface; this makes topological semimetals exhibit wider application prospects in electronic devices. So far, the experimental synthesis of topological semimetals was performed using physical methods to synthesize bulk single crystals, which is not conducive to the commercial application of micro and small devices. Weyl semimetal Co3Sn2S2 with shandite structure was successfully synthesized experimentally by a green and environmentally friendly hydrothermal method. Adjusting its reaction temperature, molar atomic ratio of elements and annealing temperature, and other experimental conditions, we analyze the crystal structure and physical properties of Co3Sn2S2, with the nanocrystal size being about 200 nm. We found that the Co3Sn2S2 synthesized by the hydrothermal method has a Curie temperature at 100 K to undergo ferromagnetic transition.

Topologically Protected Wormholes in Type-III Weyl Semimetal Co3In2X2 (X = S, Se)

The observation of wormholes has proven to be difficult in the field of astrophysics. However, with the discovery of novel topological quantum materials, it is possible to observe astrophysical and particle physics effects in condensed matter physics. It is proposed in this work that wormholes can exist in a type-III Weyl phase. In addition, these wormholes are topologically protected, making them feasible to create and measure in condensed matter systems. Finally, Co3In2X2 (X = S, Se) are identified as ideal type-III Weyl semimetals and experiments are put forward to confirm the existence of a type-III Weyl phase.

Fully spin-polarized Weyl fermions and in/out-of-plane quantum anomalous Hall effects in a two-dimensional d0 ferromagnet

The quantum anomalous Hall effect (QAHE) in intrinsic ferromagnets has attracted considerable attention recently. Previously, studies of the QAHE have mostly focused on the default assumption of out-of-plane magnetization. In fact, the QAHE can also be achieved via in-plane magnetization, but such candidate materials are very scarce. Here, we find that two-dimensional (2D) YN₂ not only possesses the previously reported out-of-plane QAHE, but it also possesses a tunable in-plane QAHE. More importantly, unlike the previously reported in-plane QAHE in d/f-type ferromagnets, here we report the effect in a 2D d⁰ ferromagnet, namely YN₂, for the first time. In the ground state, a YN₂ monolayer has a half-metal band structure, and manifests six pairs of fully spin-polarized Weyl points at the Fermi level. When spin-orbit coupling is included, the YN₂ monolayer can realize multiple topological phases, determined based on the magnetization direction. Under in-plane magnetization, the YN₂ monolayer shows either the Weyl state or in-plane QAHE state. Remarkably, the Chern number (±1) and the propagating direction of QAHE edge channels can be continuously switched via shifting the direction of the in-plane magnetic field. When magnetization is applied out-of-plane, the YN₂ monolayer realizes an out-of-plane QAHE phase with a high Chern number of 3. The nontrivial edge states for all the topological phases in the YN₂ monolayer have been clearly identified. This work suggests that 2D YN₂ is an excellent candidate for investigating in-plane QAHE phases in d⁰ ferromagnets.