Excellent Stability of Ga-Doped Garnet Electrolyte against Li Metal Anode via Eliminating LiGaO2 Precipitates for Advanced All-Solid-State Batteries

Interfacial Modification of Ga-Substituted Li7La3Zr2O12 against Li Metal via a Simple Doping Method

Garnet Li7La3Zr2O12 (LLZO) is considered a promising solid electrolyte for all-solid-state lithium-ion batteries due to its outstanding performance in which Ga-doped LLZO particularly exhibits excellent ionic conductivity. However, the application of Ga-doped LLZO is limited by the interfacial instability between Ga-doped LLZO and Li metal. In this study, Ga3+- and Sb5+-codoped LLZO is prepared using a conventional solid-state reaction method, and the effects of dual-doping on the crystal structure, microstructure, conductivity of LLZO, and battery cycle stability are investigated. The results demonstrate that the introduction of an appropriate amount of Sb5+ into Ga3+-stabilized cubic-phase LLZO promotes grain contact and enhances the total ionic conductivity. The optimized Li6.3Ga0.2La3Zr1.9Sb0.1O12 solid electrolyte exhibits the highest total ionic conductivity of 4.65 × 10-4 S cm-1 at room temperature. Additionally, the introduction of Sb5+ suppresses the formation of the LiGaO2 impurity phase, thereby improving the interface stability between Ga-doped LLZO and the Li metal. The assembled Li||Ga,Sb0.1-LLZO||Li symmetric cell demonstrates stable cycling for 500 h at room temperature under a current density of 0.13 mA cm-2. The Li||Ga,Sb0.1-LLZO||LiFePO4 full cell delivers a reversible capacity of about 140 mA h g-1, exhibiting negligible decay after 50 cycles. These findings suggest that the application of Ga-doped LLZO in all-solid-state lithium-ion batteries holds great promise by simply doping Zr sites with high-valence ions.

Clarifying the Dopant Local Structure and Effect on Ionic Conductivity in Garnet Solid-State Electrolytes for Lithium-Ion Batteries

The high Li-ion conductivity and wide electrochemical stability of Li-rich garnets (Li7La3Zr2O12) make them one of the leading solid electrolyte candidates for solid-state batteries. Dopants such as Al and Ga are typically used to enable stabilization of the high Li+ ion-conductive cubic phase at room temperature. Although numerous studies exist that have characterized the electrochemical properties, structure, and lithium diffusion in Al- and Ga-LLZO, the local structure and site occupancy of dopants in these compounds are not well understood. Two broad 27Al or 69,71Ga resonances are often observed with chemical shifts consistent with tetrahedrally coordinated Al/Ga in the magic angle spinning nuclear magnetic resonance (MAS NMR) spectra of both Al- and Ga-LLZO, which have been assigned to either Al and/or Ga occupying 24d and 96h/48g sites in the LLZO lattice or the different Al/Ga configurations that arise from different arrangements of Li around these dopants. In this work, we unambiguously show that the side products γ-LiAlO2 and LiGaO2 lead to the high frequency resonances observed by NMR spectroscopy and that both Al and Ga only occupy the 24d site in the LLZO lattice. Furthermore, it was observed that the excess Li often used during synthesis leads to the formation of these side products by consuming the Al/Ga dopants. In addition, the consumption of Al/Ga dopants leads to the tetragonal phase formation commonly observed in the literature, even after careful mixing of precursors. The side-products can exist even after sintering, thereby controlling the Al/Ga content in the LLZO lattice and substantially influencing the lithium-ion conductivity in LLZO, as measured here by electrochemical impedance spectroscopy.

Review of the Developments and Difficulties in Inorganic Solid-State Electrolytes

All-solid-state lithium-ion batteries (ASSLIBs), with their exceptional attributes, have captured the attention of researchers. They offer a viable solution to the inherent flaws of traditional lithium-ion batteries. The crux of an ASSLB lies in its solid-state electrolyte (SSE) which shows higher stability and safety compared to liquid electrolyte. Additionally, it holds the promise of being compatible with Li metal anode, thereby realizing higher capacity. Inorganic SSEs have undergone tremendous developments in the last few decades; however, their practical applications still face difficulties such as the electrode-electrolyte interface, air stability, and so on. The structural composition of inorganic electrolytes is inherently linked to the advantages and difficulties they present. This article provides a comprehensive explanation of the development, structure, and Li-ion transport mechanism of representative inorganic SSEs. Moreover, corresponding difficulties such as interface issues and air stability as well as possible solutions are also discussed.