Persistence of Acetonitrile Bilayers at the Interface of Acetonitrile/Water Mixtures with Silica

Beyond the electrical double layer model: ion-dependent effects in nanoscale solvent organization

The nanoscale organization of electrolyte solutions at interfaces is often described well by the electrical double-layer model. However, a recent study has shown that this model breaks down in solutions of LiClO4 in acetonitrile at a silica interface, because the interface imposes a strong structuring in the solvent that in turn determines the preferred locations of cations and anions. As a surprising consequence of this organisation, the effective surface potential changes from negative at low electrolyte concentration to positive at high electrolyte concentration. Here we combine previous ion-current measurements with vibrational sum-frequency-generation spectroscopy experiments and molecular dynamics simulations to explore how the localization of ions at the acetonitrile-silica interface depends on the sizes of the anions and cations. We observe a strong, synergistic effect of the cation and anion identities that can prompt a large difference in the ability of ions to partition to the silica surface, and thereby influence the effective surface potential. Our results have implications for a wide range of applications that involve electrolyte solutions in polar aprotic solvents at nanoscale interfaces.

Intermolecular Interactions at the Silica-Liquid Interface Modulate the Fermi Resonance Coupling in Surface Methanol

The buried solid/liquid interface between hydrophilic fused silica and binary solvent mixtures of acetonitrile (MeCN) and methanol (MeOH) was studied with vibrational sum-frequency generation (vSFG) spectroscopy. Our data showed that at high relative concentrations of methanol, the Fermi resonance peak in the vSFG spectrum is greatly suppressed, and it progressively gains intensity as methanol is diluted with perdeuterated acetonitrile. This phenomenon is quantified by the Fermi resonance coupling coefficient, W, extracted using a two-level model, as well as the experimental intensity ratio, R, of the methyl Fermi resonance band to that of the symmetric stretch. At a 1.0 MeOH mole fraction, W and R values were 10 ± 10 cm^-1 and 0.01 ± 0.02, respectively, whereas at a 0.1 mole fraction, W and R increased to 46 ± 4 cm^-1 and 0.43 ± 0.16, respectively. This indicates that solvation with acetonitrile effectively tunes the Fermi coupling of methanol vibrations at the silica/liquid interface.

The joint effect of surface polarity and concentration on the structure and dynamics of acetonitrile solution: a molecular dynamics simulation study

The interfacial properties of the acetonitrile (ACN)-water-silica interface have great implications in both liquid chromatography and heterogeneous catalysis. We have performed molecular dynamics (MD) simulations of ACN and water binary solutions to give a comprehensive study of the collective effect of silica surface polarity and ACN concentration on interfacial structures and dynamics by tuning both surface charges and ACN concentration. MD simulation results indicate that many properties in the liquid-solid interface region undergo a monotonic change as the silica surface is tuned from polar to apolar due to the weakening of hydrogen bonding, while their dependence on ACN concentration is presumably governed by the preferential adsorption of water at the silica surface over ACN. However, at apolar surfaces, the interfacial structures of both water and ACN behave like the liquid-vapor interface, and this resemblance leads to an enrichment of ACN at the interface as well as accelerated dynamics, which is very different from that in the bulk solution. The organization of ACN molecules at both polar and apolar surfaces can be attributed to the amphiphilic nature of ACN, by which the micro-heterogeneity domain formed can persist both in the bulk and at the liquid-solid interface. Moreover, extending diffusion analysis to the second layer of the interface shows that the interfacial transport pathways at polar surfaces are likely very different from that of apolar surfaces. These simulation results give a full spectrum description of the ACN/water liquid-solid interface at the microscopic level and will be helpful for explaining related spectroscopic experiments and understanding the microscopic mechanisms of separation protocols in current chromatography applications.

Influence of High pH on the Organization of Acetonitrile at the Silica/Water Interface Studied by Sum Frequency Generation Spectroscopy

The acetonitrile-water mixture is one of the most commonly used solvents in hydrophilic interaction chromatography, which contains silica as the solid phase. As such, the silica/acetonitrile-water interface plays a large role in the separation of compounds. Varying the pH is one way to influence retention times, particularly of ionizable solutes, yet the influence of high pH is often unpredictable. To determine how the structure of this interface changes with pH, we utilized the surface specific technique sum frequency generation (SFG). Previous SFG studies at neutral pH have suggested the existence of acetonitrile bilayers at the aqueous silica interface even at low acetonitrile mole fractions. Here we find that the SFG signal from 2900 to 3040 cm^-1 at the silica/acetonitrile-water interface increased as we adjusted the aqueous pH from near neutral to high values. This increase in signal was attributed to a greater amount of aligned water which is consistent with an increase in silica surface charge at high pH. In contrast, complementary measurements of the silica/acetonitrile-deuterium oxide interface revealed that the acetonitrile methyl mode nearly vanished as the aqueous pH was increased. This loss of methyl mode signal is indicative of a decrease in the number density of acetonitrile molecules at the interface, as orientation analysis indicates no significant change in the net orientation of the outer leaflet of the acetonitrile bilayer over the pH range studied.

Nitriles at Silica Interfaces Resemble Supported Lipid Bilayers

Nitriles are important solvents not just for bulk reactions but also for interfacial processes such as separations, heterogeneous catalysis, and electrochemistry. Although nitriles have a polar end and a lipophilic end, the cyano group is not hydrophilic enough for these substances to be thought of as prototypical amphiphiles. This picture is now changing, as research is revealing that at a silica surface nitriles can organize into structures that, in many ways, resemble lipid bilayers. This unexpected organization may be a key component of unique interfacial behavior of nitriles that make them the solvents of choice for so many applications. The first hints of this lipid-bilayer-like (LBL) organization of nitriles at silica interfaces came from optical Kerr effect (OKE) experiments on liquid acetonitrile confined in the pores of sol-gel glasses. The orientational dynamics revealed by OKE spectroscopy suggested that the confined liquid is composed of a relatively immobile sublayer of molecules that accept hydrogen bonds from the surface silanol groups and an interdigitated, antiparallel layer that is capable of exchanging into the centers of the pores. This picture of acetonitrile has been borne out by molecular dynamics simulations and vibrational sum-frequency generation (VSFG) experiments. Remarkably, these simulations further indicate that the LBL organization is repeated with increasing disorder at least 20 Å into the liquid from a flat silica surface. Simulations and VSFG and OKE experiments indicate that extending the alkyl chain to an ethyl group leads to the formation of even more tightly packed LBL organization featuring entangled alkyl tails. When the alkyl portion of the molecule is a bulky t-butyl group, packing constraints prevent well-ordered LBL organization of the liquid. In each case, the surface-induced organization of the liquid is reflected in its interfacial dynamics. Acetonitrile/water mixtures are favored solvent systems for separations technologies such as hydrophilic interaction chromatography. Simulations had suggested that although a monolayer of water partitions to the silica surface in such mixtures, acetonitrile tends to associate with this monolayer. VSFG experiments reveal that, even at high water mole fractions, patches of well-ordered acetonitrile bilayers remain at the silica surface. Due to its ability to donate and accept hydrogen bonds, methanol also partitions to a silica surface in acetonitrile/methanol mixtures and can serve to take the place of acetonitrile in the sublayer closest to the surface. These studies reveal that liquid nitriles can exhibit an unexpected wealth of new organizational and dynamic behaviors at silica surfaces, and presumably at the surfaces of other chemically important materials as well. This behavior cannot be predicted from the bulk organization of these liquids. Our new understanding of the interfacial behavior of these liquids will have important implications for optimizing a wide range of chemical processes in nitrile solvents.

A deeper insight into an intriguing acetonitrile–water binary mixture: synergistic effect, dynamic Stokes shift, fluorescence correlation spectroscopy, and NMR studies

An insight study reveals the strong synergistic solvation behaviours from reporter dye molecules within the acetonitrile (ACN)–water (WT) binary mixture.

Binary Solvent Organization at Silica/Liquid Interfaces: Preferential Ordering in Acetonitrile-Methanol Mixtures

Nonlinear vibrational spectroscopy experiments examined solvent organization at the silica/binary solvent interface where the binary solvent consisted of methanol and acetonitrile in varying mole fractions. Data were compared with surface vibrational spectra acquired from silica surfaces exposed to a vapor phase saturated with the same binary solvent mixtures. Changes in vibrational band intensities suggest that methanol ideally adsorbs to the silica/vapor interface but acetonitrile accumulates in excess relative to vapor-phase composition. At the silica/liquid interface, acetonitrile's signal increases until a solution phase mole fraction of ∼0.85. At higher acetonitrile concentrations, acetonitrile's signal decreases dramatically until only a weak signature persists with the neat solvent. This behavior is ascribed to dipole-paired acetonitrile forming a bilayer with the first sublayer associating with surface silanol groups and a second sublayer consisting of weakly associating, antiparallel partners. On the basis of recent simulations, we propose that the second sublayer accumulates in excess.

Comparison of peak shape in hydrophilic interaction chromatography using acidic salt buffers and simple acid solutions

The retention and peak shape of neutral, basic and acidic solutes was studied on hydrophilic interaction chromatography (HILIC) stationary phases that showed both strong and weak ionic retention characteristics, using aqueous-acetonitrile mobile phases containing either formic acid (FA), ammonium formate (AF) or phosphoric acid (PA). The effect of organic solvent concentration on the results was also studied. Peak shape was good for neutrals under most mobile phase conditions. However, peak shapes for ionised solutes, particularly for basic compounds, were considerably worse in FA than AF. Even neutral compounds showed deterioration in performance with FA when the mobile phase water concentration was reduced. The poor performance in FA cannot be entirely attributed to the negative impact of ionic retention on ionised silanols on the underlying silica base materials, as results using PA at lower pH (where their ionisation is suppressed) were inferior to those in AF. Besides the moderating influence of the salt cation on ionic retention, it is likely that salt buffers improve peak shape due to the increased ionic strength of the mobile phase and its impact on the formation of the water layer on the column surface.