Raman Analysis of E2 (High) and A1 (LO) Phonon to the Stress-Free GaN Grown on Sputtered AlN/Graphene Buffer Layer

The realization of high-speed and high-power gallium nitride (GaN)-based devices using high-quality GaN/Aluminum nitride (AlN) materials has become a hot topic. Raman spectroscopy has proven to be very useful in analyzing the characteristics of wide band gap materials, which reveals the information interaction of sample and phonon dynamics. Four GaN samples grown on different types of buffer layers were fabricated and the influence of graphene and sputtered AlN on GaN epitaxial layers were analyzed through the E2 (high) and A1 (LO) phonon. The relationship between the frequency shift of E2 (high) phonons and the biaxial stress indicated that the GaN grown on the graphene/sputtered AlN buffer layer was stress-free. Furthermore, the phonon lifetimes of A1 (LO) mode in GaN grown on graphene/sputtered AlN buffer layer suggested that carrier migration of GaN received minimal interference. Finally, the Raman spectra of graphene with the sputtered AlN interlayer has more disorder and the monolayer graphene was also more conducive to nucleation of GaN films. These results will have significant impact on the heteroepitaxy of high-quality thin GaN films embedded with a graphene/sputtered AlN buffer, and will facilitate the preparation of high-speed GaN-based optoelectronic devices.

Room-Temperature Transport Properties of Graphene with Defects Derived from Oxo-Graphene

In recent years, graphene oxide has been considered as a soluble precursor of graphene for electronic applications. However, the performance lags behind that of graphene due to lattice defects. Here, the relation between the density of defects in the range of 0.2 % and 1.5 % and the transport properties is quantitatively studied. Therefore, the related flakes of monolayers of graphene were prepared from oxo-functionalized graphene (oxo-G). The morphologic structure of oxo-G was imaged by atomic force microscopy (AFM) and scanning tunneling microscopy (STM). Field-effect mobility values were determined to range between 0.3 cm2  V-1  s-1 and 33.2 cm2  V-1  s-1 , which were inversely proportional to the density of defects. These results provide the first quantitative description of the density of defects and transport properties, which plays an important role for potential applications.

A new device concept for bacterial sensing by Raman spectroscopy and voltage-gated monolayer graphene

Electron-phonon coupling in monolayer graphene results in a modification of its Raman spectra upon charge transfer processes induced by interaction with its chemical environment or the presence of strain or defects in its structure. Modification of Raman spectra is examined in order to develop ultra-sensitive biosensing techniques for the detection, identification, differentiation and classification of bacteria associated with infectious diseases. Specifically, the electrochemical properties of top gated monolayer graphene on SiO2/Si substrates, in the absence and presence of interaction with Gram-positive bacteria (Enterococcus faecalis, Bacillus subtilis) and Gram-negative bacteria (Escherichia coli and Salmonella typhimurium), are probed by Raman spectroscopy in an applied voltage range from 0 V to 3 V. Bacteria and monolayer graphene interactions are thus electrostatically tuned. The resulting correlation of specific bacterial chemical properties and Raman spectral characteristics is reported, along with density functional theory simulations of the charge transfer mechanism. The intensities of the G and D Raman vibrational modes are modulated as a function of the applied voltage in the presence of bacteria, but remain unchanged in bare monolayer graphene. A fingerprint region is also identified in the range of 200 cm-1 to 600 cm-1, with disulfide bonds observed at 490 cm-1, associated with bacterial membrane proteins. Significantly, such observations are detected even in the absence of bacterial culturing, a time-consuming step.

The correlation between electrical conductivity and second-order Raman modes of laser-reduced graphene oxide

Second-order Raman modes correlate with the electrical properties of reduced graphene oxide measured at the nanoscale by atomic force microscopy.

Applications of 2D MXenes in energy conversion and storage systems

This article provides a comprehensive review of MXene materials and their energy-related applications.

Microstructural and associated chemical changes during the composting of a high temperature biochar: Mechanisms for nitrate, phosphate and other nutrient retention and release

Recent studies have demonstrated the importance of the nutrient status of biochar and soils prior to its inclusion in particular agricultural systems. Pre-treatment of nutrient-reactive biochar, where nutrients are loaded into pores and onto surfaces, gives improved yield outcomes compared to untreated biochar. In this study we have used a wide selection of spectroscopic and microscopic techniques to investigate the mechanisms of nutrient retention in a high temperature wood biochar, which had negative effects on Chenopodium quinoa above ground biomass yield when applied to the system without prior nutrient loading, but positive effects when applied after composting. We have compared non-composted biochar (BC) with composted biochar (BCC) to elucidate the differences which may have led to these results. The results of our investigation provide evidence for a complex series of reactions during composting, where dissolved nutrients are first taken up into biochar pores along a concentration gradient and through capillary action, followed by surface sorption and retention processes which block biochar pores and result in deposition of a nutrient-rich organomineral (plaque) layer. The lack of such pretreatment in the BC samples would render it reactive towards nutrients in a soil-fertilizer system, making it a competitor for, rather than provider of, nutrients for plant growth.

Oxidation, defunctionalization and catalyst life cycle of carbon nanotubes: a Raman spectroscopy view

Pristine, oxidized and defunctionalized carbon nanotubes (CNTs) were studied by Raman spectroscopy, X-ray diffraction, transmission electron microscopy and low temperature nitrogen adsorption. The Raman spectra of the studied samples in the range of 900-1800 cm^-1 were deconvoluted into five components to reveal the CNT oxidation mechanism. It was found that the oxidation resulted in the reduction of graphite components and ordering of both the structured and defect part of CNTs. Acid treatment also led to different types of disorders in the surface layers of CNTs. Polyene-type, polyphenylene-type and turbostratic fragments were detected as a result of partial exfoliation. Investigation of defunctionalized CNTs showed the ordering of edge carbon atoms as well as the invariability of the total amount of defects. The study of CNTs as supports for Co-based catalysts revealed a simultaneous decrease in the number of defect fragments and increase in the number of edge carbon atoms during catalyst preparation and reduction.

Photochemistry of Hydrochar: Reactive Oxygen Species Generation and Sulfadimidine Degradation

Biochar, mainly including pyrochar produced via pyrolysis of biomass at moderate temperatures of 350-700 °C and hydrochar formed by hydrothermal carbonization in a range of 150-350 °C, has received increasing attention because of its significant environmental impacts. It is known that pyrochar can generate reactive oxygen species even in the dark owing to the presence of persistent free radicals, but hydrochar is far less studied. In this study, we systematically investigate the photochemistry of hydrochar and check its effects on the sulfadimidine degradation. Different from pyrochar derived from the same biomass, hydrochar could generate much more H₂O₂ and •OH under daylight irradiation, which could enhance the sulfadimidine degradation rate six times more than that found in the dark. Raman spectroscopy, Fourier transform infrared spectroscopy, electron paramagnetic resonance, and X-ray photoelectron spectroscopy were employed to elucidate this interesting phenomenon. Characterization results revealed that the higher reactive oxygen species generation ability of hydrochar under solar light irradiation was attributed to its abundant photoactive surface oxygenated functional groups. This study clarifies the differences of pyrochar and hydrochar on organic pollutant degradation, and also sheds light on environmental effects of hydrochar.

Carbon Nanotubes Disrupt Iron Homeostasis and Induce Anemia of Inflammation through Inflammatory Pathway as a Secondary Effect Distant to Their Portal-of-Entry

Although numerous toxicological studies have been performed on carbon nanotubes (CNTs), a few studies have investigated their secondary and indirect effects beyond the primary target tissues/organs. Here, a cascade of events are investigated: the initiating event and the subsequent key events necessary for the development of phenotypes, namely CNT-induced pro-inflammatory effects on iron homeostasis and red blood cell formation, which are linked to anemia of inflammation (AI). A panel of CNTs are prepared including pristine multiwall CNTs (P-MWCNTs), aminated MWCNTs (MWCNTs-NH₂ ), polyethylene glycol MWCNTs (MWCNTs-PEG), polyethyleneimine MWCNTs (MWCNTs-PEI), and carboxylated MWCNTs (MWCNTs-COOH). It has been demonstrated that all CNT materials provoke inflammatory cytokine interleukin-6 (IL-6) production and stimulate hepcidin induction, associated with disordered iron homeostasis, irrespective of exposure routes including intratracheal, intravenous, and intraperitoneal administration. Meanwhile, PEG and COOH modifications can ameliorate the activation of IL-6-hepcidin signaling. Long-term exposure of MWCNTs results in AI and extramedullary erythropoiesis. Thus, an adverse outcome pathway is identified: MWCNT exposure leads to inflammation, hepatic hepcidin induction, and disordered iron metabolism. Together, the combined data depict the hazardous secondary toxicity of CNTs in incurring anemia through inflammatory pathway. This study will also open a new avenue for future investigations on CNT-induced indirect and secondary adverse effects.

Biological Uptake, Distribution, and Depuration of Radio-Labeled Graphene in Adult Zebrafish: Effects of Graphene Size and Natural Organic Matter

The exciting commercial application potential of graphene materials may inevitably lead to their increasing release into the environment where they may pose ecological risks. This study focused on using carbon-14-labeled few-layer graphene (FLG) to determine whether the size of graphene plays a role in its uptake, depuration, and biodistribution in adult zebrafish. After 48 h exposure to larger FLG (L-FLG) at 250 μg/L, the amount of graphene in the organism was close to 48 mg/kg fish dry mass, which was more than 170-fold greater than the body burden of those exposed to the same concentration of smaller FLG (S-FLG). The amount of uptake for both L-FLG and S-FLG increased by a factor of 2.5 and 16, respectively, when natural organic matter (NOM) was added in the exposure suspension. While the L-FLG mainly accumulated in the gut of adult zebrafish, the S-FLG was found in both the gut and liver after exposure with or without NOM. Strikingly, the S-FLG was able to pass through the intestinal wall and enter the intestinal epithelial cells and blood. The presence of NOM increased the quantity of S-FLG in these cells. Exposure to L-FLG or S-FLG also had a significantly different impact on the intestinal microbial community structure.

Crucial Role of Lateral Size for Graphene Oxide in Activating Macrophages and Stimulating Pro-inflammatory Responses in Cells and Animals

Graphene oxide (GO) is increasingly used in biomedical applications because it possesses not only the unique properties of graphene including large surface area and flexibility but also hydrophilicity and dispersibility in aqueous solutions. However, there are conflicting results on its biocompatibility and biosafety partially due to large variations in physicochemical properties of GO, and the role of these properties including lateral size in the biological or toxicological effects of GO is still unclear. In this study, we focused on the role of lateral size by preparing a panel of GO samples with differential lateral sizes using the same starting material. We found that, in comparison to its smaller counterpart, larger GO showed a stronger adsorption onto the plasma membrane with less phagocytosis, which elicited more robust interaction with toll-like receptors and more potent activation of NF-κB pathways. By contrast, smaller GO sheets were more likely taken up by cells. As a result, larger GO promoted greater M1 polarization, associated with enhanced production of inflammatory cytokines and recruitment of immune cells. The in vitro results correlated well with local and systemic inflammatory responses after GO administration into the abdominal cavity, lung, or bloodstream through the tail vein. Together, our study delineated the size-dependent M1 induction of macrophages and pro-inflammatory responses of GO in vitro and in vivo. Our data also unearthed the detailed mechanism underlying these effects: a size-dependent interaction between GO and the plasma membrane.

Vibrational modes of aminothiophenol: a TERS and DFT study

We report Tip Enhanced Raman Spectroscopy (TERS) mapping and Density Functional (DFT) calculations of aminothiophenol (ATP) grafted on a gold surface.

Fabrication of single-crystal few-layer graphene domains on copper by modified low-pressure chemical vapor deposition

Few-layer graphene domains are fabricated by modified LPCVD on Cu and the growth mechanism is schematically shown in the figure.