Dispersive Liquid–Liquid Microextraction for the Preconcentration of Multiple Classes of Pesticides in Water

Determination of fipronil and its three degradates in water using stir bar sorptive extraction-thermal desorption-gas chromatography-tandem mass spectrometry

A method was developed for determination of fipronil (FIP) pesticide and its three major degradates (fipronil desulfinyl, fipronil sulfide, fipronil sulfone) in water at the levels required by the EU Commission in the Decision 2022/1307. The method combines solvent-free stir bar sorptive extraction (SBSE) with thermal desorption-gas chromatography-tandem mass spectrometry (TD-GC-MS/MS). Simple sample processing involves 16 h of stirring a 100 mL water sample with a polydimethylsiloxane-coated sorptive stir bar, followed by TD of the trapped analytes into the GC. The greenness assessment by analytical Eco-Scale approach resulted in classification of the entire analytical method as "an excellent green analysis". The obtained limits of quantification for all FIPs determined in tap, lake, MilliQ water and artificial seawater were in the range of 0.12-0.30 ng L-1. The recoveries ranged between 81.7 and 109% with relative standard deviations from 2.8 to 14%. The results show that the method is suitable for screening and monitoring the studied analytes in selected matrices.

A Simple Method for the Determination of Triazines from Seawater in Accordance with the Directive 2013/39/EU

Since the Directive 2013/39/EU included terbutryn to the list of priority substances of all water bodies, a previous method based on dispersive liquid-liquid micro-extraction (DLLME) for the determination of triazines in seawater has been modified. The main change consisted on the use of tandem mass spectrometry instead of diode array as detection technique. Due to the higher sensitivity of mass detector, sample volume was reduced and extraction solvent volume was optimized. The optimum extraction conditions were 5 mL of sample, 50 µL of 1-octanol and an agitation step instead of disperser solvent. The obtained analytical recoveries (73%-101% with relative standard deviations below 4%) meeting the requirements. The limits of quantification (between 0.016 and 0.021 µg L^-1) were more than 10 times lower than the limit set by the European Directive 2013/39/EU for terbutryn (0.34 µg L^-1). The proposed method was applied to the determination of the target compounds in seawater samples from A Coruña (Galicia, NW of Spain).

Optimized Vortex-Assisted Dispersive Liquid–Liquid Microextraction Coupled with Spectrofluorimetry for Determination of Aspirin in Human Urine: Response Surface Methodology

Background:

A Vortex-assisted dispersive liquid-liquid microextraction (VA-DLLME) method is presented for the determination of aspirin (acetylsalicylic acid) in human urine by spectrofluorimetry.

Objective:

To determine trace levels of aspirin in biologic samples by using green and low-cost method development.

Methods:

For the microextraction procedure, chloroform and acetonitrile were used as extraction and disperser solvent, respectively. The factors affecting the efficiency of extraction such as volume of chloroform, volumes of acetonitrile, ionic strength, sample pH, centrifuging time, and extraction time were investigated. Then significant variables were optimized by the response surface method using the Box- Behnken design.

Results:

Under the optimum extraction conditions, a linear calibration curve in the range of 0.1 to 130 ng mL-1 with a correlation coefficient of R2 = 0.998 was obtained. The limits of detection (LOD) and limits of quantification (LOQ) were 0.031 and 0.103 ng mL-1, respectively. The relative standard deviations (RSD) were less than 4%.

Conclusion:

Enrichment factor and recoveries were achieved for the extraction of aspirin in human urine. This method gives a rapid, simple, sensitive and environmentally friendly for the measurement of trace amount aspirin.