Simulation of Liquid Crystal Anchoring at an Amorphous Polymer Surface from Various Initial Configurations

Predicting the Conditions for Homeotropic Anchoring of Liquid Crystals at a Soft Surface. 4-n-Pentyl-4'-cyanobiphenyl on Alkylsilane Self-Assembled Monolayers

We have studied, using atomistic molecular dynamics simulations, the alignment of the nematic liquid-crystal 4-n-pentyl-4'-cyanobiphenyl (5CB) on self-assembled monolayers (SAMs) formed from octadecyl- and/or hexyltrichlorosilane (OTS and HTS) attached to glassy silica. We find a planar alignment on OTS at full coverage and an intermediate situation at partial OTS coverage because of the penetration of 5CB molecules into the monolayer, which also removes the tilt of the OTS SAM. Binary mixtures of HTS and OTS SAMs instead induce homeotropic (i.e., perpendicular) alignment. A comparison with the existing experimental literature is provided.

Simulated anchoring of a nematic liquid crystal at a polymer surface

Liquid-crystal anchoring at a polymer surface arises from interactions at several different length scales. At the molecular level, a liquid-crystal molecule may tend to align with the substrate polymer chain, while at the nanometer length scale grooves can exist that arise from the periodic repeat structure of a polymer chain or from nanometer-scale undulations due to surface stresses. On a still longer scale there is the secondary effect of grooves or surface inhomogeneities. We have performed a total of more than 900 ns of atomistic molecular dynamics simulations in order to study the relative importance of the molecular-level interaction and the topography of the polymer surface in liquid-crystal anchoring. Substrates were constructed in which grooves were induced along a direction perpendicular to the constituent molecular chains. In the results presented for the case of 32 5CB molecules on a poly(vinyl alcohol) substrate, the liquid-crystal director orientation appeared to be determined principally by the substrate chain orientation. Only for the deepest grooves did the director align along the grooves and perpendicular to the substrate molecular chain direction.

A study on interfacial tension between flexible polymer and liquid crystal

The interfacial property in polymer-liquid crystal systems is quite different from flexible polymer-polymer mixtures due to the anisotropic properties of liquid crystals. The apparent interfacial tension between a liquid crystal and a flexible polymer was measured by deformed droplet retraction method. The deformation and recovery of a single liquid crystal droplet dispersed in a poly(dimethylsiloxane) matrix were realized by a transient shear flow and observed by polarized optical microscope. The apparent interfacial tension of polymer-liquid crystal system was found to be greatly dependent on the temperature, initial droplet deformation and liquid crystal droplet size.

A novel mesophase formed by top-shaped molecules in the bulk and unsupported thin films: A molecular dynamics study

We have used molecular dynamics simulations to investigate the ordering of top-shaped molecules in bulk phases and in unsupported thin films. Each rigid anisotropic molecule was composed of 11 Lennard-Jones interaction centers (beads). In an attempt to enhance the nematic stability in preference to smectic, the three central beads were assigned a larger Lennard-Jones diameter than the tail beads, giving the molecule a shape resembling a top. The molecular model was found to exhibit an unusual bulk mesophase with long-range orientational order and with molecular center-of-mass positions arranged in parallel interdigitated layers, with layer spacing smaller than half the length of the long axis of a molecule. However, despite the toplike molecular shape, no nematic phase was observed in the pressure range studied. Unsupported films of the isotropic liquid were cooled in order to locate a triple point between the novel mesophase, vapor, and isotropic liquid. At temperatures slightly above the triple point, enhanced surface ordering of molecules was found to occur in the unsupported film. At temperatures slightly below the triple point, the preferred molecular alignment in the unsupported film was parallel to the interface, in violation of arguments that have been proposed based on the relative enthalpies of various cleavage planes for close-packed structures.

Dielectric spectroscopy of liquid crystalline dispersions

We describe dielectric spectroscopy measurements on dispersions of two thermotropic liquid crystals (5CB and 8CB) in a poly(dimethylsiloxane) matrix. 5CB exhibits nematic and isotropic phases, while 8CB exhibits smectic, nematic, and isotropic phases. The spectra of the dispersions exhibit a temperature-dependent dielectric relaxation in the interval from 100 to 1000 Hz, with relaxation times that depend strongly on whether the dispersed phase is isotropic, nematic, or smectic. The dielectric relaxation times also depend on the viscosity of the matrix fluid. These results suggest a coupling between the electric field and the mechanics of the interface that affects the spectrum of the dispersed phase and shifts the Maxwell-Wagner interfacial polarization peak.

Interfacial forces and Marangoni flow on a nematic drop retracting in an isotropic fluid

Nematic-isotropic interfaces exhibit novel dynamics due to anchoring of the liquid crystal molecules on the interface. The objective of this study is to demonstrate the consequences of such dynamics in the flow field created by an elongated nematic drop retracting in an isotropic matrix. This is accomplished by two-dimensional flow simulations using a diffuse-interface model. By exploring the coupling among bulk liquid crystal orientation, surface anchoring and the flow field, we show that the anchoring energy plays a fundamental role in the interfacial dynamics of nematic liquids. In particular, it gives rise to a dynamic interfacial tension that depends on the bulk orientation. Tangential gradient of the interfacial tension drives a Marangoni flow near the nematic-isotropic interface. Besides, the anchoring energy produces an additional normal force on the interface that, together with the interfacial tension, determines the movement of the interface. Consequently, a nematic drop with planar anchoring retracts more slowly than a Newtonian drop, while one with homeotropic anchoring retracts faster than a Newtonian drop. The numerical results are consistent with prior theories for interfacial rheology and experimental observations.

Computer simulation of a liquid-crystal anchoring transition

We present a study of the effects of confinement on a system of hard Gaussian overlap particles interacting with planar substrates through the hard-needle-wall potential. Using geometrical arguments to calculate the molecular volume absorbed at the substrates, we show that both planar and homeotropic arrangements can be obtained using this model. Monte Carlo simulations are then used to perform a systematic study of the model's behavior as a function of the system density and the hard-needle-wall interaction parameter. As well as showing the homeotropic to planar anchoring transition, the anchoring phase diagrams computed from these simulations indicate regions of bistability. This bistable behavior is examined further through the explicit simulation of field-induced two-way switching between the two arrangements.

Simulation study of the glass transition temperature in poly(methyl methacrylate)

The glass transition in syndiotactic poly (methyl methacrylate) has been studied through atomistic molecular dynamics simulations performed at temperatures in the range from 297 K to 684 K. The mean squared deviations of atoms, monomers, and molecules from their initial positions were analyzed by means of a technique that separates the effects of diffusive motion from the underlying vibrational motion. The diffusive motion shows a novel power-law variation with time, with an exponent that varies continuously from 0.5 below the glass transition temperature T(g) to 1 at high temperatures. The self part of the van Hove correlation functions for both hydrogen atoms and monomers shows structural arrest at the lowest temperature studied. A second peak in the atomic van Hove correlation is attributed to rotation of the CH3 group.