Specific absorption rates in simulated tissue media for a 10 x 10 cm 915-MHz waveguide applicator

Pre-clinical evaluation of a microwave planar array applicator for superficial hyperthermia

Multi-element hyperthermia applicators have an advantage over single-aperture devices in that the power deposition pattern across the applicator surface may be adjusted to improve the resultant temperature distribution. This capability can be used to compensate for irregular tumour geometry as well as heterogeneity of thermal and power absorption parameters within the tissue. This paper evaluates the first commercially available microwave system of this type designed for superficial hyperthermia. The applicator (16-element planar array, 915 MHz, 15.2 x 15.2 cm footprint) was evaluated by the following: (1) measuring absolute SAR distributions in muscle-equivalent liquid phantom with an intervening 1 cm thick layer of fat phantom by scanning a calibrated E-field sensor, and (2) power output measurements using calorimetric methods. The SAR distributions measured for each individual aperture exhibited significant irregularities and differing power deposition patterns. A priori knowledge of these different power deposition characteristics was used to provide appropriate illumination schemes which could be used as initial starting points for producing clinically useful power deposition patterns. Measurements of these composite patterns demonstrate the adjustable nature and flexibility of the heating capabilities of this applicator, which includes 50% iso-SAR coverage that can be extended to the applicator perimeter. This clearly illustrates the clinical utility and potential advantages of this system over single-aperture devices for superficial hyperthermia.

Evaluation of microwave hyperthermia applicators

Hyperthermia has been used in conjunction with radiation and chemotherapy for cancer treatment. When using electromagnetic heating, applicators are critical components in contact with or in proximity to patients and can be the determining factor for effective and safe treatment. Tissue absorption of electromagnetic energy is determined by many factors. Three cases are shown to illustrate the complexity of microwave heating: 1) The BSD MA-151 applicator has good center heating on a muscle-only phantom as shown in the operation manual. When fat slabs of 0.25, 0.5, 1, and 2 cm thick were added, two hot spots near the periphery of the applicator were evident on all fat surfaces, exposed at 631 MHz. At 915 MHz, the heating was elongated on the surface of the models with 0.25- and 2-cm fat, and two hot spots were observed on the 0.5- and 1-cm fat surfaces. 2) Heating patterns of the Clini-Therm applicators on a muscle-only phantom, as indicated in the operations guide, are elliptical with their major axes perpendicular to the electric field. However, when a bolus is used, the elliptical pattern is parallel to the E field. 3) Heating patterns in cylindrical structures were studied with inhomogeneous models of limbs. Arm and thigh models consisting of fat, bone, and muscle material were heated with Clini-Therm L, M, and MS applicators at 915 MHz. In addition to the geometric effect, the results indicated that placing the applicators with E field parallel to the long axis of cylindrical structures can minimize required power, produce less heating of fats and reduce stray radiation. In conclusion, to apply penetrating microwave or other RF fields for tissue heating, one must simulate the clinical exposure conditions as closely as possible to obtain useful heating patterns.

Therapeutic responses of spontaneous canine malignancies to combinations of radiotherapy and hyperthermia

The goals of this ongoing Phase III study of adjuvant local hyperthermia with radiotherapy were to evaluate how tumor control and normal tissue complications were related to patient and treatment variables. Canine veterinary patients with localized malignancies were stratified by histology and anatomic site and randomized into three groups. All patients received radiotherapy (60CO) in 3.5 Gy fractions given Mon-Wed-Fri to 14 treatments (49 Gy). One group received radiotherapy alone while the others also received microwave-induced hyperthermia (44 degrees C) for 30 minutes once each week. Hyperthermia followed radiotherapy and was given to one group immediately and delayed 4-5 hours in the other. Adjuvant hyperthermia resulted in a significant (p less than .05) increase in complete response rate, reduction in the frequency of non-responders, and increased persistent local control relative to radiotherapy alone. Hyperthermia increased the complete response rate regardless of histology, site, or volume and with the current sample size control was significantly (p less than .05) greater for sarcomas, tumors of the trunk and extremities, and those with volumes less than 10 cc. Quantitative clinical assessment of the acute response of skin and oral mucosa indicated that hyperthermia significantly enhanced these acute reactions, which required roughly twice the healing time observed with radiotherapy alone. Quantitative histologic scoring of changes seen between pre- and post-therapy skin biopsies indicated that a treatment induced decline in the frequency of dermal blood vessels, sebaceous glands, and hair follicles was enhanced by adjuvant hyperthermia, particularly in the late response evaluation interval. The probability of tumor control and adverse normal tissue responses correlated with several measures of thermal dose. Thermal doses in excess of 120 equivalent minutes at 43 degrees C correlated positively with increased skin reactions and negatively with the complete response rate, and these trends were usually evident during the animals' first treatment.

The modification of specific absorption rates in interstitial microwave hyperthermia via tissue-equivalent material bolus

Patterns of specific absorption rates generated by interstitial, microwave antenna arrays must be experimentally ascertained and quantified to facilitate their clinical incorporation. Phantom studies involved the use of four single-gap, coaxial antennas oriented in a 2 cm square array. These dipoles were driven in phase by a microwave generator at a frequency of 915 MHz. The inherent limitations in modifying the specific absorption rate patterns were addressed with the addition of bolus to the phantom. These additions of Guy's muscle tissue-equivalent material were made either proximal or distal to the phantom proper. Experiments conducted in the presence and absence of tissue-equivalent material bolus showed the ability to achieve broader bands of 50% power deposition in certain bolus conditions. These heating patterns were sufficiently reproducible and predictable to warrant clinical application of the bolus addition. A through-and-through method of catheter implantation allowed for bolus addition when deemed necessary. Treatments with veterinary and human patients using the bolus method to modify heating patterns yielded augmented patterns of power deposition. The effective length of the antennas that would radiate efficiently was essentially broadened via introduction of a microwave-interacting medium. As a result of the tissue equivalent material's ability to absorb microwave power, it was necessary to interpose minimally-interactive styrofoam spacers to limit heat transfer effects at the tissue-bolus interfaces.