Pollinator-dependent crops significantly contribute to diets and reduce household nutrient deficiencies in sub-Saharan Africa

Recent literature highlights the potential of animal pollinator-dependent (PD) crops in enhancing food and nutrition security, although there is a lack of detailed household-level estimates. In this study, we investigate the nutrient composition, productivity, and contribution of PD and pollinator-independent (PI) crops to household nutrition in four sub-Saharan African (SSA) countries. We also evaluate the impact of reallocating resources from PI crops to PD crops on nutrient deficiencies, utilizing nationally representative panel data from three waves and over 30,000 household-year observations. Our findings reveal that PD crops exhibit higher micronutrient content per unit, albeit with lower macronutrient content compared to PI crops. PI crops have higher yield of calories per hectare while PD crops have higher vitamin A yield per hectare. However, protein and iron yield for PD and PI crops varies across countries. PI crops predominantly contribute to macronutrients and iron, while PD crops significantly contribute to vitamin A production. Our econometric results demonstrate that increasing the cultivation of PD crops relative to PI crops reduces the prevalence of nutrient deficiencies and increases crop income without compromising macronutrients production. This suggests that greater investment in PD crop production can be an integral approach to achieving nutrition security in SSA.

Evaluating the growth and cost-benefit analysis of feeding improved indigenous chicken with diets containing black soldier fly larva meal

The high cost of feed has been the major hindrance to a hindrance to the growth, sustainability, profitability, and expansion of poultry production. Black soldier fly larva (BSFL) meal is one of the most promising alternative protein sources widely accepted globally. This study evaluated the growth performance of improved indigenous chicken (IIC)-fed diets containing different inclusion levels of BSFL meals. The BSFL meal inclusion rates included 0% (Diet0), 5% (Diet1), 10% (Diet2), 15% (Diet3), and 20% (Diet4) as replacement to the expensive fish meal in chick and grower diets. Our results showed that diet significantly affected the average daily feed intake, feed conversion ratio, and average daily weight gain of the chicks. The average daily weight gain and feed conversion ratio, except average daily feed intake of the growers, was not significantly affected by diets. The gross profit margin, cost-benefit ratio, and return on investment of feeding birds with BSFL meal varied significantly. The highest cost-benefit ratio of 2.12 was recorded for birds fed on Diet4. Our findings demonstrate that insect-based feeds can successfully and cost-effectively replace fish meal up to 20% without compromising the growth performance of the birds. Therefore, BSFL meal could be incorporated as an essential part of poultry feed production for IIC, potentially reducing the total feed cost while maintaining optimal production and reducing the cost of meat and egg products.

The potential economic benefits of controlling trypanosomiasis using waterbuck repellent blend in sub-Saharan Africa

Trypanosomiasis is a significant productivity-limiting livestock disease in sub-Saharan Africa, contributing to poverty and food insecurity. In this paper, we estimate the potential economic gains from adopting Waterbuck Repellent Blend (WRB). The WRB is a new technology that pushes trypanosomiasis-transmitting tsetse fly away from animals, improving animals’ health and increasing meat and milk productivity. We estimate the benefits of WRB on the production of meat and milk using the economic surplus approach. We obtained data from an expert elicitation survey, secondary and experimental sources. Our findings show that the adoption of WRB in 5 to 50% of the animal population would generate an economic surplus of US$ 78–869 million per annum for African 18 countries. The estimated benefit-cost ratio (9:1) further justifies an investment in WRB. The technology’s potential benefits are likely to be underestimated since our estimates did not include the indirect benefits of the technology adoption, such as the increase in the quantity and quality of animals’ draught power services and human and environmental health effects. These benefits suggest that investing in WRB can contribute to nutrition security and sustainable development goals.

Proton Conductivity of Nafion/Ex-Situ Sulfonic Acid-Modified Stöber Silica Nanocomposite Membranes As a Function of Temperature, Silica Particles Size and Surface Modification

The introduction of sulfonic acid modified silica in Nafion nanocomposite membranes is a good method of improving the Nafion performance at high temperature and low relative humidity. Sulfonic acid-modified silica is bifunctional, with silica phase expected to offer an improvement in membranes hydration while sulfonic groups enhance proton conductivity. However, as discussed in this paper, this may not always be the case. Proton conductivity enhancement of Nafion nanocomposite membranes is very dependent on silica particle size, sometimes depending on experimental conditions, and by surface modification. In this study, Sulfonated Preconcentrated Nafion Stober Silica composites (SPNSS) were prepared by modification of Stober silica particles with mercaptopropyltriethoxysilane, dispersing the particles into a preconcentrated solution of Nafion, then casting the membranes. The mercapto groups were oxidized to sulfonic acids by heating the membranes in 10 wt % hydrogen peroxide for 1 h. At 80 °C and 100% relative humidity, a 20%–30% enhancement of proton conductivity was only observed when sulfonic acid modified particle less than 50 nm in diameter were used. At 120 °C, and 100% humidity, proton conductivity increased by 22%–42% with sulfonated particles with small particles showing the greatest enhancement. At 120 °C and 50% humidity, the sulfonated particles are less efficient at keeping the membranes hydrated, and the composites underperform Nafion and silica-Nafion nanocomposite membranes.

Processing, morphology, and water uptake of Nafion/ex situ Stöber silica nanocomposite membranes as a function of particle size

Because of the bicontinuous phase structure of Nafion with small hydrophilic channels, formation of composites with silica colloids to improve thermal stability, hydration, and proton conductivity should be influenced by size and surface functionality of the colloids. To test this hypothesis, we prepared batches of silica particles between 20 and 400 nm in diameter with narrow polydispersities using a modified Stöber procedure. Some particles were subsequently surface-modified using mercaptopropyltriethoxysilane. Enough particles were mixed with Nafion in alcohols to achieve 5 wt % silica in the final membranes, which were made by casting and drying. Membrane top and bottom surface and cross-section morphologies were examined with AFM and SEM to determine how the particles were dispersed. We discovered that casting the membranes from dispersions with viscosities less than 65 cPs led to larger particles floating to the top surface of the membrane where they were easily dislodged from the dry membrane. Membranes cast from more viscous solutions exhibited homogeneous distributions of particles. Water uptake was over 60% higher in nanocomposites with unmodified silica particles than for Nafion and about 15% higher than for Nafion with in situ generated silica particles, but showed no trend in water uptake correlating with particle size. Surface silated particles of all sizes appeared to have reduced water uptake relative to Nafion alone.

Strong, low-density nanocomposites by chemical vapor deposition and polymerization of cyanoacrylates on aminated silica aerogels

Strong polymer-silica aerogel composites were prepared by chemical vapor deposition of cyanoacrylate monomers onto amine-modified aerogels. Amine-modified silica aerogels were prepared by copolymerizing small amounts of (aminopropyl)triethoxysilane with tetraethoxysilane. After silation of the aminated gels with hexamethyldisilazane, they were dried as aerogels using supercritical carbon dioxide processing. The resulting aerogels had only the amine groups as initiators for the cyanoacrylate polymerizations, resulting in cyanoacrylate macromolecules that were higher in molecular weight than those observed with unmodified silica and that were covalently attached to the silica surface. Starting with aminated silica aerogels that were 0.075 g/cm(3) density, composite aerogels were made with densities up to 0.220 g/cm(3) and up to 31 times stronger (flexural strength) than the precursor aerogel and about 2.3 times stronger than an unmodified silica aerogel of the same density.