Palmitic acid coating of allogeneic cancellous bone for local antibiotic treatment: A porcine impaction bone grafting model

Introduction

The worldwide rising number of joint replacements results in increasing revision surgery including a relevant portion of septic loosening accompanied by bone deficiencies. Loading of allogeneic bone with antibiotics provides high local antibiotic concentrations and might eradicate bacteria which appear resistant to systemic antibiotic application. Hydrophobic palmitic acid was shown to be a suitable carrier for antibiotics and prevents biofilm.

Methods

Cancellous bone derived from 6 to 7 months old piglets was used for a standardized in vitro impaction bone grafting model according to previous studies. The specimens were either thermodisinfected or remained native and palmitic acid with one third and two third partial weight were added and compared with control. Shear force at the interface prosthesis to cement and between cement and bone was measured. The relative micromovements were measured with 6 inductive sensors with a resolution of 0.1 μm at three different measuring heights up to a maximum movement of 150 μm between cement and bone. Taking into account the corresponding applied torque the measured values were normalized in μm/Nm. Statistical analysis was done with SPSS Statistics® Version 26.0 IBM.

Results

Smallest movement was measured for thermodisinfected cancellous bone and a not significant decrease of shear force resistance with addition of palmitic acid was found since supplementing native cancellous bone reduced shear force resistance significantly depending on the weight percentage of palmitic acid.

Conclusion

Supplementation of porcine cancellous bone with palmitic acid did not significantly reduce shear force resistance of thermodisinfected bone since adding palmitic acid to native bone decreased it significantly depending on the volume added. Palmitic acid seems to be a suitable coating for allogeneic cancellous bone to deliver high local antibiotic concentrations and thermodisinfected cancellous bone might be able to store larger volumes of palmitic acid than native bone without relevant influence on shear force resistance.

Effect of synthetic bone replacement material of different size on shear stress resistance within impacted native and thermodisinfected cancellous bone: an in vitro femoral impaction bone grafting model

Antibiotic carrier particles of variable size might influence mechanic properties within impacted thermodisinfected and native cancellous bone different. Herafill®G containing calciumsulfate and calciumcarbonate provides high local concentrations of gentamicin being important for revision surgery in infected joint replacements. Native and thermodisinfected cancellous bone derived from 6 to 7 months old piglets was used for in vitro impaction bone grafting and supplemented each with Herafill®G granules of two different sizes. Micromovement of implants related to shear force was measured in 29 specimens distributed in 6 groups. Thermodisinfected cancellous bone revealed a significant higher shear force resistance than native bone with a mean difference of 423.8 mdeg/Nm (p < 0.001) ranging within 95% confidence interval from 181.5 to 666.0 mdeg/Nm. Adding small granules to thermodisinfected bone did not reduce shear force resistance significantly since adding large granules to native bone improved it by 344.0 mdeg/Nm (p < 0.003). Shear force resistance was found higher at the distal region of the implant compared to a proximal point of measurement throughout all specimens. Less impaction impulses were necessary for thermodisinfected bone. Thermodisinfected cancellous bone might achieve a higher degree of impaction compared with native bone resulting in increased resistance against shear force since impaction was found increased distally. Supplementation of thermodisinfected bone with small granules of Herafill®G might be considered for application of local antibiotics. Large granules appeared more beneficial for supplementation of native bone. Heterogeneity of bone graft and technical aspects of the impaction procedure have to be considered regarding the reproducibility of femoral impaction bone grafting.

Influence of antibiotic pellets on pore size and shear stress resistance of impacted native and thermodisinfected cancellous bone: An in vitro femoral impaction bone grafting model

Introduction

Morphology and mechanic properties of impacted cancellous bone are affected by carrier substances which provide high local concentrations of antibiotics.

Methods

Bone chips were taken from the femoral head of 6-7 months old piglets. One half was thermodisinfected and the other remained native. Ten specimens each were mixed with Herafill® antibiotic pellets and a control group of each 10 specimens respectively was examined. The cancellous bone was impacted according to Exeter technique and the implants were cemented. The distribution of the particles and the pores were defined with three dimensional computertomographic scan and shear force resistance was measured until failure.

Results

Shear force resistance was not measured significantly less for thermodisinfected (2.7 Nm) compared with native bone (3.5 Nm) and addition of antibiotic pellets reduced shear force resistance in both groups since this was significant for the native group. The average pore volume of the native bone specimens appeared significant smaller compared to the thermodisinfected group (p = 0.011) and the pore volume showed a negative correlation with shear force resistance (p = 0.044). Pore volume around the pellets was found significantly increased and it appeared smaller for native bone. The number of pellets located next to the implant showed a negative correlation with shear force resistance (p = 0.034) and the negative correlation increased for pellets below the tip of the shaft model (p = 0.024).

Conclusion

Adding antibiotic pellets to native and thermodisinfected impacted cancellous bone increased pore volume since the area around the pellets showed increased porosity which correlated with reduced shear force resistance. Computertomographic three dimensional measurement of porosity might predict shear force resistance of impacted cancellous bone and improve impaction of bone grafting intraoperatively.

[Allogeneic bone transplantation in hip revision surgery : Indications and potential for reconstruction]

The increasing number of people having joint replacements will lead to increasing numbers of revision operations. The transplantation of allogeneic bones might reconstruct bone defects and improve long-term anchorage of the implant. A sufficient primary stability of the implanted construct is necessary to achieve osseous incorporation as well as tight contact between the implanted allogeneic and host bones. Transplantation of bone can contribute to downgrading acetabular defects and so avoid bigger reinforcement implants. An improvement of bone stock due to reconstruction of femoral bony defects might also reduce the size of the stem necessary since the indication might be limited in case of extensive bone defects. According to good longterm results of modular revision stems the Impaction-Bone-Grafting has not yet generally been established.

[PMMA augmentation of pedicle screws: results of a survey in Germany]

BACKGROUND

The anchorage of pedicle screws can be challenging in the osteoporotic spine. A promising technique are cement augumented pedicle screws. The goal of this study was to gain more information regarding application of pedicle screw augmentation in Germany.

MATERIALS AND METHODS

Participants of the National German Spine Congress 2009 were invited to participate in an internet-based anonymous survey regarding application of pedicle screw augmentation. The questionnaire was related to different aspects of materials and procedures for pedicle screw augmentation. The frequency of answers was divided according to the specialty state of the surgeons: orthopaedic and trauma surgeons vs. neurosurgeons. The Mantel-Haenszel test was applied to evaluate the differences between the groups.

RESULTS AND CONCLUSION

69 (64 %) orthopaedic and trauma surgeons and 39 (36 %) neurosurgeons participated (n = 108). Nearly 80 % of the participants use cement-augmented pedicle screws in their daily practice. Almost 2/3 of the specialists apply cannulated screws or other special screws. The Expedium (Company) screws are particularly preferred. The insertion of screws is combined with kyphoplasty or vertebroplasty in 20 % of the cases. The balloon kyphoplasty was applied most commonly. There was no statistical difference between the surgeon groups regarding the different techniques. The main indications for pedicle screw augmentation were osteoporosis, intraoperative findings as well as loosening of screws, and revision. The most frequently observed complication is cement extravasation into the spinal canal (28 %). The cost issue is considered as being important but unknown to most of the participants. It can be assumed that the use of pedicle screws in Germany is well established in spine surgery, without as yet a standard technique being established.

[Arteriovenous fistula after endoscopic dissection of the perforant vein of the lower leg with the neodymium:YAG laser in chronic venous stasis syndrome]

The endoscopic dissection of the perforating veins has been invented by Hauer in the last decade. He introduced the videoendoscopy to this surgical procedure. The avoidance of operative access through areas of trophic changes is very beneficial for reducing postoperative complications. Although postoperative thermic lesion have been reported on. Following an endoscopic laser coagulation of a Cockett perforating vein an arterio-venous fistula between the posterior tibial artery and vein developed by the mechanism mentioned. Persisting pain and the persistence of the ulcer led to several diagnostic measures including phlebography, digital subtraction angiography and CT-scan. After the fistula had been closed successfully by percutaneous embolization with four platin wires the ulcer disappeared.