Geochemical reactions of Na-montmorillonite in dissolved scCO2 in relevance of modeling caprock behavior in CO2 geological storage

One of the challenges of the present century is to limit the greenhouse gas emissions for the mitigation of climate change which is possible for example by a transitional technology, CO2 geological storage. Clay minerals are considered to be responsible for the low permeability and sealing capacity of caprocks sealing off stored CO2. However, their reactions are not well understood for complex simulations. This work aims to create a kinetic geochemical model of Na-montmorillonite standard SWy-2 supported by solution and mineral composition results from batch experiments. Such experimentally validated numerical models are scarce. Four 70-hours experiments have been carried out at atmospheric conditions, and with CO2 supercritical phase at 100 bar and 80 °C. Solution samples have been taken during and after experiments and their compositions were measured by ICP-OES. The treated solid phase has been analyzed by XRD and ATR-FTIR and compared to in-parallel measured references (dried SWy-2). Kinetic geochemical modelling of the experimental conditions has been performed by software PHREEQC. Experiments and models show fast reactions under the studied conditions and increased reactivity in presence of scCO2. Solution composition results cannot be described by the change of the uncertain reactive surface area of mineral phases. By considering the clay standard’s cation exchange capacity divided proportionally among interlayer cations of Na-montmorillonite, the measured variation can be described on an order of magnitude level. It is furthermore indicated that not only the interlayer cations take part in this process but a minor proportion of other, structural ions as well, differently in the reference and scCO2 environments.

Effects of Particle Size on the Attenuated Total Reflection Spectrum of Minerals

This study focuses on particle size effect on monomineralic powders recorded using attenuated total reflection Fourier transform infrared (ATR FT-IR) spectroscopy. Six particle size fractions of quartz, feldspar, calcite, and dolomite were prepared (<2, 2-4, 4-8, 8-16, 16-32, and 32-63 µm). It is found that the width, intensity, and area of bands in the ATR FT-IR spectra of minerals have explicit dependence on the particle size. As particle size increases, the intensity and area of IR bands usually decrease while the width of bands increases. The band positions usually shifted to higher wavenumbers with decreasing particle size. Infrared spectra of minerals are the most intensive in the particle size fraction of 2-4 µm. However, if the particle size is very small (<2 µm), due to the wavelength and penetration depth of the IR light, intensity decreases. Therefore, the quantity of very fine-grained minerals may be underestimated compared to the coarser phases. A nonlinear regression analysis of the data indicated that the average coefficients and indices of the power trend line equation imply a very simplistic relationship between median particle diameter and absorbance at a given wavenumber. It is concluded that when powder samples with substantially different particle size are compared, as in regression analysis for modal predictions using ATR FT-IR, it is also important to report the grain size distribution or surface area of samples. The band area of water (3000-3620 cm^-1) is similar in each mineral fraction, except for the particles below 2 µm. It indicates that the finest particles could have disproportionately more water adsorbed on their larger surface area. Thus, these higher wavenumbers of the ATR FT-IR spectra may be more sensitive to this spectral interference if the number of particles below 2 µm is considerable. It is also concluded that at least a proportion of the moisture could be very adhesive to the particles due to the band shift towards lower wavenumbers in the IR range of 3000-3620 cm^-1.