The role of the spectral sensitivity curve in the selection of relevant biological dosimeters for solar UV monitoring

To estimate the risk of enhanced UV-B radiation due to stratospheric ozone depletion, phage T7 and uracil thin-layer biological dosimeters have been developed, which weight the UV irradiance according to induced DNA damage. To study the molecular basis of the biological effects observed after UV irradiation, the spectral sensitivity curves of the two dosimeters and induction of the two major DNA photoproducts, cyclobutane pyrimidine dimers (CPDs) and 6-4 photoproducts ((6-4)PDs), in phage T7 have been determined for polychromatic UV sources. CPDs and (6-4)PDs are determined by lesion-specific monoclonal antibodies in an immunodotblot assay. Phage T7 and uracil biological dosimeters together with a Robertson-Berger (RB) meter have been used for monitoring environmental radiation from the polar region to the equator. The biologically effective dose (BED) established with the three different dosimeters increases according to the changes in the solar angle and ozone column, but the degree of the change differs significantly. The results can be explained based on the different spectral sensitivities of the dosimeters. A possible method for determining the trend of the increase in the biological risk due to ozone depletion is suggested.

Influence of phage proteins on formation of specific UV DNA photoproducts in phage T7

Phage T7 can be used as a biological UV dosimeter. Its reading is proportional to the inactivation rate expressed in HT7 units. To understand the influence of phage proteins on the formation of DNA UV photoproducts, cyclobutane pyrimidine dimers (CPD) and (6-4)photoproducts ((6-4)PD) were determined in T7 DNA exposed to UV radiation under different conditions: intraphage T7 DNA, isolated T7 DNA and heated phage. To investigate the effects of various wavelengths, seven different UV sources have been used. The CPD and (6-4)PD were determined by lesion-specific antibodies in an immunodot-blot assay. Both photoproducts were HT7 dose-dependently produced in all three objects by every irradiation source in the biologically relevant UV dose range (1-10 HT7). The CPD to (6-4)PD ratios increased with the increasing effective wavelength of the irradiation source and were similar in intraphage T7 DNA, isolated DNA and heated phage with all irradiation sources. However, a significant decrease in the yield of both photoproducts was detected in isolated T7 DNA and in heated phage compared to intraphage DNA, the decrease was dependent on the irradiation source. Both photoproducts were affected the same way in isolated T7 DNA and heated phage, respectively. The yield of CPD and (6-4)PD was similar in B, C-like and A conformational states of isolated T7 DNA, indicating that the conformational switch in the DNA is not the decisive factor in photoproduct formation. The most likely explanation for modulation of photoproduct frequency in intraphage T7 DNA is that the presence of bound phage proteins induces an alteration in DNA structure that can result in an increased rate of dimerization and (6-4)PD production of adjacent based in intraphage T7 DNA.

Construction of spectral sensitivity function using polychromatic UV sources

A procedure is presented for constructing the spectral sensitivity functions of biological dosimeters, using five polychromatic UV sources possessing different emission spectra. Phage T7 and uracil biological dosimeters have been used for measuring the dose rates of the lamps. Their spectral sensitivity functions consisting of two exponential terms have been constructed. The parameters of the spectral sensitivity functions have been determined by comparing the directly measured and calculated dose-rate values. The parameters of the sensitivity function are accepted as correct values when the deviation of the measured and calculated values is a minimum. Based on the deviations between the constructed and the experimentally determined spectral sensitivities with monochromatic sources, the differences between the measured and calculated results are interpreted. The importance of the correct spectral sensitivity data is demonstrated through the effectiveness spectra of a TL 01 lamp for phage T7 killing, uracil dimerization and erythema induction.

Assessment of the effects of various UV sources on inactivation and photoproduct induction in phage T7 dosimeter

The correlation between the biologically effective dose (BED) of a phage T7 biological dosimeter and the induction of cyclobutane pyrimidine dimers (CPD) and (6-4) photoproducts ((6-4)PD) in the phage DNA was determined using seven various UV sources. The BED is the inactivation rate of phage T7 expressed in HT7 units. The CPD and (6-4)PD were determined by lesion-specific monoclonal antibodies in an immunodot-blot assay. The various lamps induced these lesions at different rates; the relative induction ratios of CPD to (6-4)PD increased with increasing effective wavelength of irradiation source. The amount of total adducts per phage was compared to the BED of phage T7 dosimeter, representing the average number of UV lesions in phage. For UVC (200-280 nm radiation) and unfiltered TL01 the number of total adducts approximates the reading; however, UV sources having longer effective wavelengths produced fewer CPD and (6-4)PD. A possible explanation is that although the most relevant lesions by UVC are the CPD and (6-4)PD, at longer wavelengths other photoproducts can contribute to the lethal damage of phages. The results emphasize the need to study the biological effects of solar radiation because the lesions responsible for the lethal effect may be different from those produced by various UV sources.