Cost-Effective, Single-Frequency GPS Network as a Tool for Landslide Monitoring

The constant monitoring of active landslides, particularly those located in the proximity of populated areas or touristic places, is crucial for early warning and risk-management purposes. The commonly used techniques deploy expensive instrumentation that can be hardly afforded, especially by small mountain communities in which landslide events often occur repeatedly. In recent years, the scientific community, as well as the private sector, have devoted growing effort to reducing the costs of monitoring systems. In this work, we present a monitoring network based on single-frequency Global Positioning System (GPS) sensors that have been activated to monitor an active landslide in the Carnic Alps, North-Eastern Italy. The system, which was composed of 12 single-frequency GPS stations, one seismometric station coupled with a single-frequency GPS instrument for real-time monitoring, and one permanent dual-frequency GPS station located in a stable area, provided daily reports of the landslide motion to the local authorities and administration. We show that this system is a valuable, flexible, and cost-effective tool for quick landslide characterization, and has high potential to be used as a landslide early warning system in case of emergency situations.

Testing Multi-Frequency Low-Cost GNSS Receivers for Geodetic Monitoring Purposes

Global Navigation Satellite System (GNSS) technology is widely used for geodetic monitoring purposes. However, in cases where a higher risk of receiver damage is expected, geodetic GNSS receivers may be considered too expensive to be used. As an alternative, low-cost GNSS receivers that are cheap, light, and prove to be of adequate quality over short baselines, are considered. The main goal of this research is to evaluate the positional precision of a multi-frequency low-cost instrument, namely, ZED-F9P with u-blox ANN-MB-00 antenna, and to investigate its potential for displacement detection. We determined the positional precision within static survey, and the displacement detection within dynamic survey. In both cases, two baselines were set, with the same rover point equipped with a low-cost GNSS instrument. The base point of the first baseline was observed with a geodetic GNSS instrument, whereas the second baseline was observed with a low-cost GNSS instrument. The results from static survey for both baselines showed comparable results for horizontal components; the precision was on a level of 2 mm or better. For the height component, the results show a better performance of low-cost instruments. This may be a consequence of unknown antenna calibration parameters for low-cost GNSS antenna, while statistically significant coordinates of rover points were obtained from both baselines. The difference was again more significant in the height component. For the displacement detection, a device was used that imposes controlled movements with sub-millimeter accuracy. Results, obtained on a basis of 30-min sessions, show that low-cost GNSS instruments can detect displacements from 10 mm upwards with a high level of reliability. On the other hand, low-cost instruments performed slightly worse as far as accuracy is concerned.

Continuous and Real-Time Detection of Drinking-Water Pathogens with a Low-Cost Fluorescent Optofluidic Sensor

Growing access to tap water and consequent expansion of water distribution systems has created numerous challenges to maintaining water quality between the treatment node and final consumer. Despite all efforts to develop sustainable monitoring systems, there is still a lack of low cost, continuous and real time devices that demonstrate potential for large-scale implementation in wide water distribution networks. The following work presents a study of a low-cost, optofluidic sensor, based on Trypthopan Intrinsic Fluorescence. The fluorospectrometry analysis performed (before sensor development) supports the existence of a measurable fluorescence output signal originating from the tryptophan contained within pathogenic bacteria. The sensor was mounted using a rapid prototyping technique (3D printing), and the integrated optical system was achieved with low-cost optical components. The sensor performance was evaluated with spiked laboratory samples containing E. coli and Legionella, in both continuous and non-continuous flow situations. Results have shown a linear relationship between the signal measured and pathogen concentration, with limits of detection at 1.4 × 10³ CFU/mL. The time delay between contamination and detection of the bacteria was practically null. Therefore, this study supports the potential application of tryptophan for monitoring drinking water against water pathogens.