Bubble-detector measurements of neutron radiation in the international space station: ISS-34 to ISS-37

Bubble detectors have been used to characterise the neutron dose and energy spectrum in several modules of the International Space Station (ISS) as part of an ongoing radiation survey. A series of experiments was performed during the ISS-34, ISS-35, ISS-36 and ISS-37 missions between December 2012 and October 2013. The Radi-N2 experiment, a repeat of the 2009 Radi-N investigation, included measurements in four modules of the US orbital segment: Columbus, the Japanese experiment module, the US laboratory and Node 2. The Radi-N2 dose and spectral measurements are not significantly different from the Radi-N results collected in the same ISS locations, despite the large difference in solar activity between 2009 and 2013. Parallel experiments using a second set of detectors in the Russian segment of the ISS included the first characterisation of the neutron spectrum inside the tissue-equivalent Matroshka-R phantom. These data suggest that the dose inside the phantom is ∼70% of the dose at its surface, while the spectrum inside the phantom contains a larger fraction of high-energy neutrons than the spectrum outside the phantom. The phantom results are supported by Monte Carlo simulations that provide good agreement with the empirical data.

Overview of the Liulin type instruments for space radiation measurement and their scientific results

Ionizing radiation is recognized to be one of the main health concerns for humans in the space radiation environment. Estimation of space radiation effects on health requires the accurate knowledge of the accumulated absorbed dose, which depends on the global space radiation distribution, solar cycle and local shielding generated by the 3D mass distribution of the space vehicle. This paper presents an overview of the spectrometer-dosimeters of the Liulin type, which were developed in the late 1980s and have been in use since then. Two major measurement systems have been developed by our team. The first one is based on one silicon detector and is known as a Liulin-type deposited energy spectrometer (DES) (Dachev et al., 2002, 2003), while the second one is a dosimetric telescope (DT) with two or three silicon detectors. The Liulin-type instruments were calibrated using a number of radioactive sources and particle accelerators. The main results of the calibrations are presented in the paper. In the last section of the paper some of the most significant scientific results obtained in space and on aircraft, balloon and rocket flights since 1989 are presented.

Bubble-detector measurements in the Russian segment of the International Space Station during 2009-12

Measurements using bubble detectors have been performed in order to characterise the neutron dose and energy spectrum in the Russian segment of the International Space Station (ISS). Experiments using bubble dosemeters and a bubble-detector spectrometer, a set of six detectors with different energy thresholds that is used to determine the neutron spectrum, were performed during the ISS-22 (2009) to ISS-33 (2012) missions. The spectrometric measurements are in good agreement with earlier data, exhibiting expected features of the neutron energy spectrum in space. Experiments using a hydrogenous radiation shield show that the neutron dose can be reduced by shielding, with a reduction similar to that determined in earlier measurements using bubble detectors. The bubble-detector data are compared with measurements performed on the ISS using other instruments and are correlated with potential influencing factors such as the ISS altitude and the solar activity. Surprisingly, these influences do not seem to have a strong effect on the neutron dose or energy spectrum inside the ISS.

Prospective cohort study of six hundred and sixty four revisions of loose failed acetabular implants

PURPOSE

The purpose of the study was to determine the optimal technique of revision surgery according to the deficiency of acetabular bone to ensure maximum survival of the implant and reduce the risk of complications.

METHODS

From January 1992 through May 2012, 664 revisions of failed acetabular total hip components were performed in the joint replacement department of the Moscow Central Scientific and Research Institute (CITO). The patients were divided into three major groups based on the type of the revision implant: group I--cemented polyethylene cups only, group II--acetabular cages and rings, and group III--non-cemented metal cups. In each of these groups, further subdivisions were made based on the Paprosky Classification of the acetabular defects. Failures were classified as early mechanical instability, chronic pain, and deep wound infection.

RESULTS

The most satisfactory results--91% were obtained in patients of groups I and III with relatively minor bony acetabular defects (Paprosky classification types 1, 2A and 2B). The most unsatisfactory results--25% were in the cases with greater bone loss (Paprosky classification type 3B in group I and type 2C in group III)-of the unsatisfactory results. Infection was a significant problem in all the groups, but was the highest (8%) in group II.

CONCLUSIONS

The study showed that the success of acetabular revisions was directly related to the severity of the bony defects at the time of the operation and to the reconstruction technique applied.

Measurements of the neutron dose and energy spectrum on the International Space Station during expeditions ISS-16 to ISS-21

As part of the international Matroshka-R and Radi-N experiments, bubble detectors have been used on board the ISS in order to characterise the neutron dose and the energy spectrum of neutrons. Experiments using bubble dosemeters inside a tissue-equivalent phantom were performed during the ISS-16, ISS-18 and ISS-19 expeditions. During the ISS-20 and ISS-21 missions, the bubble dosemeters were supplemented by a bubble-detector spectrometer, a set of six detectors that was used to determine the neutron energy spectrum at various locations inside the ISS. The temperature-compensated spectrometer set used is the first to be developed specifically for space applications and its development is described in this paper. Results of the dose measurements indicate that the dose received at two different depths inside the phantom is not significantly different, suggesting that bubble detectors worn by a person provide an accurate reading of the dose received inside the body. The energy spectra measured using the spectrometer are in good agreement with previous measurements and do not show a strong dependence on the precise location inside the station. To aid the understanding of the bubble-detector response to charged particles in the space environment, calculations have been performed using a Monte-Carlo code, together with data collected on the ISS. These calculations indicate that charged particles contribute <2% to the bubble count on the ISS, and can therefore be considered as negligible for bubble-detector measurements in space.

Direct measurement of the mass difference between top and antitop quarks

We present a measurement of the mass difference between t and t[over] quarks in lepton + jets final states of tt[over] events in 1 fb;{-1} of data collected with the D0 detector from Fermilab Tevatron Collider pp[over] collisions at sqrt[s] = 1.96 TeV. The measured mass difference of 3.8 +/- 3.7 GeV is consistent with the equality of t and t[over ] masses. This is the first direct measurement of a mass difference between a quark and its antiquark partner.

Heterologous expression of the Aspergillus nidulans alcR-alcA system in Aspergillus niger

The inducible and strongly expressed alcA gene encoding alcohol dehydrogenase I from Aspergillus nidulans was transferred together with the activator gene alcR, in the industrial fungus Aspergillus niger. This latter organism does not possess an inducible alc system but has an endogenously constitutive lowly expressed alcohol dehydrogenase activity. The overall induced expression of the alcA gene was of the same order in both fungi, as monitored by alcA transcription, alcohol dehydrogenase activity and heterologous expression of the reporter enzyme, beta-glucuronidase. However, important differences in the pattern of alcA regulation were observed between the two fungi. A high basal level of alcA transcription was observed in A. niger resulting in a lower ratio of alcA inducibility. This may be due to higher levels of the physiological inducer of the alc regulon, acetaldehyde, from general metabolism in A. niger which differs from that of A. nidulans.

Ethanol catabolism in Aspergillus nidulans: a model system for studying gene regulation

This article reviews our knowledge of the ethanol utilization pathway (alc system) in the hyphal fungus Aspergillus nidulans. We discuss the progress made over the past decade in elucidating the two regulatory circuits controlling ethanol catabolism at the level of transcription, specific induction, and carbon catabolite repression, and show how their interplay modulates the utilization of nutrient carbon sources. The mechanisms featuring in this regulation are presented and their modes of action are discussed: First, AlcR, the transcriptional activator, which demonstrates quite remarkable structural features and an original mode of action; second, the physiological inducer acetaldehyde, whose intracellular accumulation induces the alc genes and thereby a catabolic flux while avoiding intoxification; third, CreA, the transcriptional repressor mediating carbon catabolite repression in A. nidulans, which acts in different ways on the various alc genes; Fourth, the promoters of the structural genes for alcohol dehydrogenase (alcA) and aldehyde dehydrogenase (aldA) and the regulatory alcR gene, which exhibit exceptional strength compared to other genes of the respective classes. alc gene expression depends on the number and localization of regulatory cis-acting elements and on the particular interaction between the two regulator proteins, AlcR and CreA, binding to them. All these characteristics make the ethanol regulon a suitable system for induced expression of heterologous protein in filamentous fungi.

Unique DNA binding specificity of the binuclear zinc AlcR activator of the ethanol utilization pathway in Aspergillus nidulans

AlcR is the transcriptional activator in Aspergillus nidulans, necessary for the induction of the alc gene cluster. It belongs to the Zn2Cys6 zinc cluster protein family, but contains some striking differences compared with other proteins of this group. In this report, we show that no dimerization element is present in the entire AlcR protein which occurs in solution as a monomer and binds also to its cognate sites as a monomer. Another important feature of AlcR is its unique specificity for single sites occurring naturally as inverted or direct repeats and sharing a common motif, 5'-(T/A)GCGG-3'. Like most other Zn2Cys6 proteins, AlcR contacts directly with the CGG triplet and, in addition, the upstream adjacent guanine is required for high affinity binding. We also establish that the flanking regions outside the core play an essential role in tight binding. From our in vitro analysis, we propose an optimal AlcR-binding site which is 5'-PuNGCGG-AT rich 3'.

A single amino acid, outside the AlcR zinc binuclear cluster, is involved in DNA binding and in transcriptional regulation of the alc genes in Aspergillus nidulans

In Aspergillus nidulans, the transcriptional activator AlcR mediates specific induction of a number of alc genes. The AlcR DNA-binding domain is a zinc binuclear cluster that differs from the other members of the Zn2Cys6 family in several respects. Of these, the most remarkable is its ability to bind in vitro as a monomer to single sites, whereas only repeated sites (direct or inverted) are necessary and functional in vivo. Deletion of the first five amino acids (following the N-terminal methionine) upstream of the AlcR zinc cluster or mutation of a single residue, Arg-6, impairs the AlcR in vitro binding mainly to symmetrical sites. In vivo, the same mutations result in the inability of A. nidulans to grow on ethanol. The alc- phenotype results from a drastic decrease in activation of its own transcription and, in addition, that of the two structural genes, alcA and aldA, required for ethanol oxidation. This defect seems to be correlated to the inability of the Arg-6 AlcR mutant protein to bind to AlcR palindrome targets, which are essential in the three alc promoters. AlcR shows a unique pattern of binding and of transactivation among the Zn2Cys6 family.

In vitro recognition of specific DNA targets by AlcR, a zinc binuclear cluster activator different from the other proteins of this class

AlcR is the transactivator mediating transcriptional induction of the alc gene cluster in Aspergillus nidulans. The AlcR DNA-binding domain consists of a zinc binuclear cluster different from the other members of the Zn2Cys6 family by several features. In particular, it is able to bind to symmetric and asymmetric sites with the same affinity, with both sites being functional in A. nidulans. Here, we show that unlike the other proteins of the Zn2Cys6 binuclear cluster family, AlcR binds most probably as a monomer to its cognate targets. Two molecules of the AlcR protein can simultaneously bind in a noncooperative manner to inverted repeats. The consensus core has been determined precisely (5'-CCGCN-3'), and the AlcR-binding site in the aldA promoter has been localized. The sequence downstream of the zinc cluster is necessary for high affinity binding. Furthermore, our data show that the use of the carrier protein glutathione S-transferase in AlcR binding experiments introduces an important bias in the recognition of DNA sites due to its tertiary dimeric structure.

Gene expression from replicating plasmids in Aspergillus nidulans

Plasmids bearing the AMA1 replicator from Aspergillus nidulans are capable of extrachromosomal replication in this fungus as well as in other species. Synthetic plasmids bearing the moderately expressed argB gene and the highly expressed, inducible beta-galactosidase gene (bgaS) were introduced into fungal cells. Expression of both genes was monitored by Northern hybridization. It was demonstrated that transcription of bgaS is induced and repressed normally, irrespective of whether the gene is integrated into the chromosome or maintained on an extrachromosomal supercoiled plasmid. Transcription of the strongly expressed bgaS gene stimulates transcription of the argB gene located on the same replicating plasmid irrespective of orientation. This effect also occurs with chromosomally integrated vectors, but to a lesser extent. Episomal vectors are present in 10 copies per nucleus, and the expression level of the argB gene is approximately proportional to copy number. However, the amount of mRNA transcribed from the highly expressed bgaS gene on the multi-copy replicating plasmid does not exceed that from single-copy integrants. High levels of expression of the plasmid-borne gene do not affect plasmid mitotic stability or copy number.