Emerging Concern from Short-Term Textile Leaching: A Preliminary Ecotoxicological Survey

Textile dyes and their residues gained growing attention worldwide. Textile industry is a strong water consumer potentially releasing xenobiotics from washing and rinsing procedures during finishing processes. On a decentralised basis, also final consumers generate textile waste streams. Thus, a procedure simulating home washing with tap water screened cotton textiles leachates (n = 28) considering physico-chemical (COD, BOD₅, and UV absorbance) and ecotoxicological data (Daphnia magna, Pseudokirchneriella subcapitata and Lepidium sativum). Results evidenced that: (i) leachates presented low biodegradability levels; (ii) toxicity in more than half leachates presented slight acute or acute effects; (iii) the remaining leachates presented "no effect" suggesting the use of green dyes/additives, and/or well established finishing processes; (iv) no specific correlations were found between traditional physico-chemical and ecotoxicological data. Further investigations will be necessary to identify textile residues, and their potential interactions with simulated human sweat in order to evidence potential adverse effects on human health.

Detection of genetically modified maize and soybean in feed samples

Despite the controversy about genetically modified (GM) plants, they are still incrementally cultivated. In recent years, many food and feed products produced by genetic engineering technology have appeared on store shelves. Controlling the production and legal presentation of GM crops are very important for the environment and human health, especially in terms of long-term consumption. In this study, 11 kinds of feed obtained from different regions of Turkey were used for genetic analysis based on foreign gene determination. All samples were screened by conventional polymerase chain reaction (PCR) technique for widely used genetic elements; cauliflower mosaic virus 35S promoter (CaMV35S promoter), and nopaline synthase terminator (T-NOS) sequences for GM plants. After determination of GM plant-containing samples, nested PCR and conventional PCR analysis were performed to find out whether the samples contained Bt176 or GTS-40-3-2 for maize and soy, respectively. As a result of PCR-based GM plant analysis, all samples were found to be transgenic. Both 35S- and NOS-containing feed samples or potentially Bt176-containing samples, in other words, were analyzed with Bt176 insect resistant cryIAb gene-specific primers via nested PCR. Eventually, none of them were found Bt176-positive. On the other hand, when we applied conventional PCR to the same samples with the herbicide resistance CTP4-EPSPS construct-specific primers for transgenic soy variety GTS-40-3-2, we found that all samples were positive for GTS-40-3-2.

Fate of pharmaceuticals in contaminated urban wastewater effluent under ultrasonic irradiation

The application of sonolysis (US) for remediation of wastewater is an area of increasing interest. The aim of this study was to evaluate the ultrasonic (US) process on the degradation of pharmaceuticals (diclofenac (DCF), amoxicillin (AMX), carbamazepine (CBZ)) in single solutions and also in three mixtures spiked in urban wastewater effluent. Several operating conditions, such as power density (25-100 W L(-1)), initial substrate concentrations (2.5-10 mg L(-1)), initial solution pH (3-11), and air sparging were varied for the evaluation and understanding of the process. The degradation (as assessed by measuring UV absorbance), the generation of hydroxyl radicals (as assessed measuring H(2)O(2) concentration), the mineralization (in terms of TOC and COD removal), and the aerobic biodegradability (as assessed by the BOD(5)/COD ratio) were monitored during sonication. Ecotoxicity to Daphnia magna, Pseudokirchneriella subcapitata and Lepidium sativum before and after treatment was also evaluated. It was found that the pharmaceuticals conversion is enhanced at increased applied power densities, acidic conditions and in the presence of dissolved air. The reaction rate increases with increasing initial concentration of single pharmaceuticals but it remains constant in the mixtures, indicating different kinetic regimes (i.e. first and zero order respectively). Mineralization is a slow process as reaction by-products are more stable than pharmaceuticals to total oxidation; nonetheless, they are also more readily biodegradable. The toxicity of the wastewater samples before and after contamination with pharmaceuticals both in mixtures and in single substance-containing solutions was observed more severely on P. subcapitata; a fact that raises concerns in regards to the discharge of such effluents. D. magna displayed less sensitivity compared to P. subcapitata because it belongs in a lower taxonomic species than D. magna. The germination index of L. sativum in the presence of the drugs' mixture was stimulated instead of inducing any toxicity effect and this might be attributed to the fact the sample, laden with very low drug concentrations was able to act as a provider of additional nutrient elements.

Wastewater toxicity of tannin- versus chromium-based leather tanneries in Marrakesh, Morocco

The toxicity of leather tanning wastewater from a traditional tannery (TT), which is based on vegetable tannin (VT), was compared with wastewater from a tannery combining the use of chromium-based tanning (CT) with VT-based tanning operations. Wastewater samples from a TT and a CT plant as well as from five sewer sampling points were collected in Marrakesh, Morocco, and the concentrations of VT and some selected inorganics were measured. A set of bioassays were used to test wastewater toxicity in sea urchin (Paracentrotus lividus) embryos and sperm, in Daphnia magna, and in marine microalgae (Dunaliella tertiolecta). Toxicity end points included: (1) developmental defects, embryonic mortality, sperm fertilization success, and offspring damage in sea urchins; (2) D. magna immobilization; and (3) algal growth rate inhibition. Toxicity tests on TT and CT effluents (TTE and CTE) were run at dilutions ranging from 0.1% to 2% (sea urchins and algae) or up to 12% in D. magna. Parallel bioassays were run on VT extract (VTE) at nominal tannin concentrations ranging from 0.1 to 10 mg l(-1). The results showed higher toxicity of CTE compared with TTE. CTE toxicity in sea urchins and algae showed concentration-related trends, whereas TTE exerted hormetic effects at levels of 0.1% to 0.2% and toxic effects at levels >or=1%. The same trends were observed for VTE, suggesting a prevailing role of tannin in TTE-associated effects. The moderate wastewater toxicity of VT-based tanneries might prompt interest in the VT tanning process.

Fenton and photo-Fenton treatment of a synthetic tannin used in leather tannery: a multi-approach study

The aim of this work was to compare the behaviour of Fenton and photo-Fenton (UV-A, UV-C) processes to treat synthetic tannin (syntan) used in leather tannery which is one of the most polluting industries, releasing many xenobiotics. Both oxidation processes were performed at pH 3.0 and temperature 40-45 degrees C, which is the original temperature of the re-tanning process, in synthetic solutions containing 100 and 300 mg/L of COD equivalent of syntan. The efficiency of the applied oxidation processes was monitored by chemical oxygen demand (COD), oxidation redox potential (ORP) and aromaticity (UV280) and double bond (UV254) absorbance measurements. Acute toxicity test on Daphnia magna was performed to monitor toxicity in untreated and treated syntan solution. Gas chromatography-mass spectrometry (GC-MS) was applied to identify by-products of partial oxidation occurring in treated samples. The effective ratio of H2O2/FeSO4 for photo-Fenton processes was found to be feasible in terms of reagents used in the process.

Hormetic versus toxic effects of vegetable tannin in a multitest study

Tannin from mimosa trees (Acacia sp.) utilized in traditional leather tanning was tested for toxicity in sea urchin (Sphaerechinus granularis and Paracentrotus lividus) embryos and sperm, marine, and freshwater algae (Selenastrum capricornutum and Dunaliella tertiolecta), and Daphnia magna. Based on a two-step tanning procedure used in traditional tanneries, two mimosa tannin preparations, i.e., fresh tannin (FT) and used tannin (UT), were tested as suspensions. The early results in S. granularis embryos showed that UT exerted lower acute toxicity than FT, namely, 1 vs 100 mg/L, to obtain 100% mortality, respectively. Subsequent bioassays were conducted on fresh tannin water extracts (TWE) corresponding to nominal tannin concentrations ranging from 0.1 to 30 mg/L. Developmental toxicity, up to embryonic mortality was exerted by TWE at levels > 1 mg/L, S. granularis being more sensitive than P. lividus embryos/larvae. At the concentration of 0.1 mg/L, the frequencies of larval malformations were significantly lower than in controls. This positive stimulatory effect (currently termed as hormesis) was observed in extended numbers of culture replicates (up to 14) and was significant in the embryo cultures characterized by a relatively poor control quality (with < 70% viable larvae in controls), whereas this effect was not observed in good-quality cultures (with > or = 70% viable larvae in controls). Cytogenetic analysis of S. granularis embryos reared in FT or UT suspensions (1 mg/L to 1 g/L) showed mitotoxic effects (decrease in active mitoses per embryo) in FT-exposed, but not in UT-exposed embryos. Mitotic aberrations were significantly increased by 10 mg/L UT. Sperm fertilization success in both sea urchin species showed an increasing fertilization rate (FR) up to 0.3 mg/L TWE and a dose-related decrease in FR up to 30 mg/L. Again, the offspring of P. lividus sperm exposed to TWE (0.1 and 0.3 mg/L) showed a decrease in larval malformations compared to controls, whereas a dose-related increase in developmental defects was observed in the offspring of P. lividus sperm exposed to higher TWE levels (1 to 30 mg/L). Algal cell growth bioassays in two species (S. capricornutum and D. tertiolecta) also showed a maximum growth at TWE levels ranging from 0.3 to 3 mg/L and a subsequent decline up to 30 mg/L TWE. D. magna bioassays resulted in daphnid immobilization by TWE concentrations ranging from 100 to 300 mg/L. The results demonstrate that tannins utilized in traditional leather tanning industry may raise concern of environmental damage at relatively high concentrations, whereas low-level tannins may result in hormetic effects. The present study also points to the need for bioassay design that should rely on adequate criteria in control quality, allowing to detect both inhibitory and hormetic effects.

Operational strategies for a small wastewater treatment plant using OUR, microscopic analysis, and toxicity test

This study was focused on determining the optimal operational conditions of a small domestic wastewater treatment plant (SWP) with a flow rate of 1000 m3 d(-1) using oxygen uptake rate (OUR) data, microscopic analyses, and effluent toxicity testing with Daphnia magna in parallel to wastewater characterization. Chemical analyses of nine samples, taken from different points of the treatment plant over a nine months period, presented strong domestic wastewater characteristics. The plant performance for meeting discharge standards was not sufficient enough for TP parameter. Aeration capacity and sludge recycle ratio were adjusted to improve the performance of the system and to prevent any operational problems, such as bulking. Although the inflow was 100% toxic, effluent toxicity following treatment was decreased to 5%. Filamentous bacteria were in "excessive" amount. The dominant filamentous bacteria species were determined as Nostocoioda limicola II. Reevaluation of the discharge limits with respect to nutrient removal, geographic location, and receiving water quality subject to treatment effluent discharges.

A new approach to modelling substrate inhibition

Substrate inhibition, which is one of the most frequently observed phenomena in the biological treatment of industrial wastewaters, has been the subject of numerous studies. Yet there are still cases which cannot be adequately described by the existing models. In this paper, a review of substrate inhibition approaches was made. A new model is proposed that assumes a common mechanism for substrate and product inhibition. The model is a continuous function having a maximum growth rate at the critical substrate concentration, beyond which the growth rate decreases as the substrate concentration is increased. The model also predicts the maximum substrate concentration where the growth ceases. The model was tested using existing data in the literature to assess the model response and predictability of critical points. The literature datahave been selected from the studies conducted on pure and mixed cultures in batch and continuous reactors for phenol and several phenolics as well as from the studies which employed the Haldane model. A curve fitting method was used to determine the model parameters. The fit of the model to the data was satisfactory, particularly for the substrate concentrations exceeding maximum growth rate.

Effect and Control of Pollution in Catchment Area of Lake Sapanca, Turkey

/ Land-based point and diffuse pollution sources in the catchment area of Lake Sapanca, Turkey, were investigated. The present and future distribution of pollution loads were evaluated in terms of nitrogen, phosphorus, biochemical oxygen demand, and pesticides. A methodology for the estimation of pollution loads was presented; most of which were based on "unit loads." Presently domestic and industrial point sources dominate over diffuse sources including fertilizers and pesticides from agricultural use, nutrient loads from forests and meadows, urban runoff, and leachates from unregulated dumps of solid wastes. For the future, the aim of the control action is to maintain the sustainability of the water quality of the lake, at least at the second class of European Community standards. Within this framework; urgent/short-term and medium/long-term control actions will be exercised. In the urgent/short-term stage, simpler and natural ways of treatment will be employed. In the medium/long-term stage an integrated collection and treatment system will be put on operation. After completion of a proposed collection system and treatment plants to handle point sources, the control of diffuse sources will be more significant. Control of diffuse sources for the abatement of further deterioration of water quality then becomes the key issue to be emphasized in the Lake Sapanca catchment area. Diffuse sources control will be achieved by dividing the catchment area into three major protection zones. Use of pesticides and fertilizers on agricultural land and all other activities within these protection zones will be accomplished according to control plans, which will be supervised by an institution established to be responsible of all the activities within the basin.KEY WORDS: Diffuse sources; Land-based pollution; Nutrients; Pesticides; Point sources; Protection zones

Wastewater management for Istanbul: basis for treatment and disposal

A number of studies have so far been conducted to assess the magnitude of pollution generated by domestic and industrial sources in the Istanbul Metropolitan Area. They indicate that a management scheme for wastewater treatment and disposal should involve a total discharge of 15.4 m3 s(-1) with a potential pollution load of 330 tons BOD5 day(-1) for 1990. A scheme of this magnitude inevitably requires careful evaluation of receiving water characteristics, both from an oceanographic and a quality standpoint. In this paper significant water quality parameters related to the Black Sea-Bosphorus Strait-Marmara Sea System are reviewed and incorporated in the evaluation of treatment and disposal alternatives. In this context, the pollution exchange between the Mamara Sea and Bosphorus is quantified, pollutant contents of the Mamara Sea and discharges from the Istanbul Metropolitan Area are compared, and a number of scenarios are evaluated to define the optimum treatment and disposal strategy.