5-HMF and carbohydrates content in stingless bee honey by CE before and after thermal treatment

Supplementation of Stingless Bee Honey from Heterotrigona itama Improves Antiobesity Parameters in High-Fat Diet Induced Obese Rat Model

Heterotrigona itama is a common stingless bee species found in Southeast Asia. Studies on the health benefits of its honey are limited in comparison with other stingless bee species. This study examines the antiobesity benefits found in stingless bee honey (SBH) from H. itama. The parameters used to measure the benefits were weight change, morphological structures, and biochemical characteristics. The research was conducted by using rats that were given a high-fat diet (HFD). In total 48 male Sprague Dawley (SD) rats were given a formulated HFD to increase the levels of obesity, the HFD was administered with a value of 0.68 g/cm2. The duration of the treatment was six weeks, and the results show that the induction obesity using the HFD was successful. Following this, the rats were then treated with SBH (at dosages of 1000 mg/kg, 750 mg/kg or 500 mg/kg), with orlistat or with a placebo. Compared with typical obesity treatment methods, the one that used the three dosages of SBH showed a higher reduction in body mass index (BMI), percentage of body weight gain, adiposity index, and relative organ weight (ROW). The levels of liver enzymes (ALT, AST, and ALP) were also significantly lower in SBH-treated groups. The levels of triglycerides and LDL-cholesterol were significantly lower, while the level of HDL-cholesterol was significantly higher in comparison with the control obese group. In terms of morphological structures, the number of adipocyte cells was reduced, and the hepatocytes found in the liver were less prone to rupturing when treated with SBH. In conclusion, the administration of SBH led to an improvement in indicators associated with obesity reduction. SBH also possesses a hepatoprotective potential which can reduce the health risks related to obesity.

Comparison of the inducible effects of licorice products with or without heat-processing and pre-treatment with honey on granulocyte colony-stimulating factor secretion in cultured enterocytes

ETHNOPHARMACOLOGICAL RELEVANCE

Licorice (the roots and rhizomes of Glycyrrhiza uralensis Fisch.) is occasionally used as crude drug following processing including roasting or honey-roasting (soaking with honey before roasting) in traditional Japanese Kampo medicine and traditional Chinese medicine (TCM).

AIM OF THE STUDY

We investigated the differences in the inducible effect of processed licorice products on granulocyte colony-stimulating factor (G-CSF) secretion in cultured intestinal epithelial cells and elucidated the active ingredients in both unprocessed and processed licorice products.

MATERIALS AND METHODS

We prepared heat-processed licorice with or without pretreatment with honey, and fractionated the extracts by Sephadex G-100. Enterocyte-like differentiated MCE301 cells were incubated in media comprising a hot water extract of licorice products for 24h, and the concentrations of G-CSF in the media were measured using enzyme-linked immunosorbent assay (ELISA).

RESULTS

Licorice extract induced G-CSF secretion in MCE301 cells, and the active ingredients of licorice were high molecular compounds. Although the roasted licorice extract exhibited the activity similar to that of the unprocessed licorice extract, honey-roasted licorice extracts exhibited a significantly higher inducible effect on G-CSF secretion in the cells than that of unprocessed or roasted licorice extracts without pretreatment with honey. This enhanced activity was dependent on the temperature and heating time.

CONCLUSIONS

The enhanced inducible effect of honey-roasted licorice on G-CSF secretion might be attributed to the combined effect of licorice-derived high molecular compounds and heated-honey-derived compounds. The results of this study can scientifically explain the objective of processing via honey-roasting in TCM theory.

A rapid method for simultaneous quantification of 13 sugars and sugar alcohols in food products by UPLC-ELSD

A novel, rapid, simultaneous analysis method for five sugars (fructose, glucose, sucrose, maltose, and lactose) and eight sugar alcohols (erythritol, xylitol, sorbitol, mannitol, inositol, maltitol, lactitol, and isomalt) was developed using UPLC-ELSD, without derivatization. The analysis conditions, including the gradient conditions, modifier concentration and column length, were optimized. Thirteen sugars and sugar alcohols were separated well and the resolution of their peaks was above 1.0. Their optimum analysis condition can be analyzed within 15min. Standard curves for sugars and sugar alcohols with concentrations of 5.0-0.1% and 2.0-0.05% are presented herein, and their correlation coefficients are found to be above 0.999 and the limit of detection (LOD) was around 0.006-0.018%. This novel analysis system can be used for foodstuffs such as candy, chewing gum, jelly, chocolate, processed chocolate products, and snacks containing 0.21-46.41% of sugars and sugar alcohols.

Thermosonication and optimization of stingless bee honey processing

The effects of thermosonication on the quality of a stingless bee honey, the Kelulut, were studied using processing temperature from 45 to 90 ℃ and processing time from 30 to 120 minutes. Physicochemical properties including water activity, moisture content, color intensity, viscosity, hydroxymethylfurfural content, total phenolic content, and radical scavenging activity were determined. Thermosonication reduced the water activity and moisture content by 7.9% and 16.6%, respectively, compared to 3.5% and 6.9% for conventional heating. For thermosonicated honey, color intensity increased by 68.2%, viscosity increased by 275.0%, total phenolic content increased by 58.1%, and radical scavenging activity increased by 63.0% when compared to its raw form. The increase of hydroxymethylfurfural to 62.46 mg/kg was still within the limits of international standards. Optimized thermosonication conditions using response surface methodology were predicted at 90 ℃ for 111 minutes. Thermosonication was revealed as an effective alternative technique for honey processing.

Determination of 5-hydroxymethylfurfural in honey, using headspace-solid-phase microextraction coupled with a polyoxometalate-coated piezoelectric quartz crystal

High concentrations of 5-hydroxymethylfurfural (HMF) in honey provide an indication of overheating under inappropriate storage conditions or aging. Conventional methods for determining HMF are cumbersome and require expensive equipment or hazardous reagents. Hence the aim of this study was to propose a new analytical tool for HMF determination in honey, using a low cost acoustic wave sensor. Volatile organic compounds (VOCs) of honey samples were extracted, using the solid phase microextraction (SPME) technique, and HMF was quantified, using a piezoelectric quartz crystal with gold electrodes coated with a layer of decamolybdodivanado phosphoric acid, sensitive to HMF. The reliability of the proposed method was confirmed after comparing the results of HMF quantification with those obtained by the conventional spectrophotometric White method, and no statistical differences were found (α=0.05).

Chemopreventive Properties and Toxicity of Kelulut Honey in Sprague Dawley Rats Induced with Azoxymethane

Ethnopharmacological Relevance. Colon cancer has been a major problem worldwide. Kelulut honey (KH) is produced by the stingless bees from Trigona species and has strong antioxidant activities that could be one of the potential chemopreventive agents from natural resources. Aim of This Study. This study investigated the chemopreventive properties and toxicity of KH in Sprague Dawley rats induced with azoxymethane (AOM). Material and Method. Twenty-four male Sprague Dawley rats aged 5 weeks were divided into 4 groups: (G1) untreated group not induced with AOM, (G2) untreated group induced with AOM, (G3) treated group induced with AOM, and (G4) treated group not induced with AOM. Injection of AOM (15 mg/kg) was via intraperitoneal route once a week for two subsequent weeks. The treatment groups were given oral administration of KH (1183 mg/kg body weight) twice daily for 8 weeks. Results. Treatment with KH significantly reduced the total number of aberrant crypt foci (ACF) and aberrant crypts (AC) and crypt multiplicity. KH was not toxic to the animals since the level of blood profile parameters, liver enzymes, and kidney functions was in normal range. Conclusions. The current finding shows that KH has chemopreventive properties in rats induced with colorectal cancer and also was found not toxic towards the animals.

Content of metals and metabolites in honey originated from the vicinity of industrial town Košice (eastern Slovakia)

Composition of three types of honey (mixed forest honey and monofloral-black locust and rapeseed honeys) originated from the vicinity of an industrial town (Košice, Slovak Republic) was compared. Higher content of minerals including toxic metals in forest honey (1358.6 ng Ni/g, 85.6 ng Pb/g, and 52.4 ng Cd/g) than in rapeseed and black locust honeys confirmed that botanical origin rather than the distance for eventual source of pollution (steel factory) affects metal deposition. Benzoic acid derivatives were typically more accumulated in forest but cinnamic acid derivatives and some flavonoids in rapeseed honey (in free and/or glycoside-bound fraction). In terms of quantity, p-hydroxybenzoic and p-coumaric acids were mainly abundant. Total phenols, thiols, and proteins were abundant in forest honey. Some metals and phenols contributed to separation of honeys based on principal component analysis (PCA). Native amount of 5-(hydroxymethyl)furfural was not related to honey type (~11 μg/g) and was elevated after strong acid hydrolysis (200-350 μg/g) but it did not interfere with the assay of phenols by Folin-Ciocalteu reagent. This is the first report of metals and metabolites in the same study, and data are discussed with available literature. We conclude that black locust (acacia) honey is the most suitable for daily use and that central European monofloral honeys contain lower amounts of toxic metals in comparison with other geographical regions.

Chemometric-assisted QuEChERS extraction method for the residual analysis of thiacloprid, spirotetramat and spirotetramat's four metabolites in pepper: Application of their dissipation patterns

Chemometric tools equipped with a Plackett-Burman (P-B) design, a central composite design (CCD) and a desirability profile were employed to optimise the QuEChERS (quick, easy, cheap, effective, rugged and safe) method for the quantification of thiacloprid, spirotetramat and spirotetramat's four metabolites in pepper. The average recoveries were in the range of 71.6-119.5%, with relative standard deviations ⩽ 12.1%. The limit of quantification for the method was less than 0.01 mg/kg. The method was applied to field samples to evaluate the residual characteristics of thiacloprid and spirotetramat. The data showed that the first+first-order model is a better fit than the first order model for the dissipation of thiacloprid and spirotetramat in pepper. The half-lives of thiacloprid and spirotetramat in pepper are 0.81 and 1.21 days, respectively. The final residues were between 0.016 mg/kg and 0.13 mg/kg for thiacloprid and 0.08 mg/kg and 0.12 mg/kg for spirotetramat.

Glucose: Detection and analysis

Glucose is an aldosic monosaccharide that is centrally entrenched in the processes of photosynthesis and respiration, serving as an energy reserve and metabolic fuel in most organisms. As both a monomer and as part of more complex structures such as polysaccharides and glucosides, glucose also plays a major role in modern food products, particularly where flavor and or structure are concerned. Over the years, many diverse methods for detecting and quantifying glucose have been developed; this review presents an overview of the most widely employed and historically significant, including copper iodometry, HPLC, GC, CZE, and enzyme based systems such as glucose meters. The relative strengths and limitations of each method are evaluated, and examples of their recent application in the realm of food chemistry are discussed.