Simultaneous determination of low-molecular-weight organic acids and chlorinated acid herbicides in environmental water by a portable CE system with contactless conductivity detection

Automated Capillary Electrophoresis System Compatible with Multiple Detectors for Potential In Situ Spaceflight Missions

The in situ search for chemical signatures of life on extraterrestrial worlds requires automated hardware capable of performing detailed compositional analysis during robotic missions of exploration. The use of electrophoretic separations in this search is particularly powerful, enabling analysis of a wide range of soluble organic compounds potentially indicative of life, as well as inorganic compounds that can serve as indicators of habitability. However, to detect this broad range of compounds with a single electrophoresis instrument, a combination of different detection modes is required. For detection of any ionizable species, including organic compounds that do not participate in terrestrial biology (i.e., "unknown unknowns"), mass spectrometry (MS) is essential. Inorganic ions, or any dissolved charged species present, can be analyzed using capacitively coupled contactless conductivity detection (C⁴D). Additionally, for the trace analysis of compounds of key interest to astrobiology (particularly, amino acids), laser-induced fluorescence (LIF) detection holds unique promise, due to the fact that it has the highest demonstrated sensitivity of any form of detection. Here, we demonstrate a fully automated, portable capillary electrophoresis analyzer that is capable of all these modes of detection. The prototype system developed here addresses the three most significant challenges for doing electrophoretic separations: precise sample injection, HV isolation, and automation of all operational steps. These key challenges were successfully addressed with the use of custom-designed rotor-stator valves with optimized operational sequences incorporating gas purging steps, rinses, and HV application.

Seasonal evaluation of disinfection by-products throughout two full-scale drinking water treatment plants

Carbonyl compounds can occur alpha-hydrogens or beta-diketones substitution reactions with disinfectants contributed to halogenated by-products formation. The objective of this research was to study the occurrence and fate of carbonyl compounds as ozonation by-products at two full-scale drinking water treatment plants (DWTPs) using different disinfectants for one year. The quality of the raw water used in both plants was varied according to the season. The higher carbonyl compounds concentrations were found in raw water in spring. Up to 15 (as the sum of both DWTPs) of the 24 carbonyl compounds selected for this work were found after disinfection. The dominant carbonyl compounds were formaldehyde, glyoxal, methyl-glyoxal, fumaric, benzoic, protocatechuic and 3-hydroxybenzoic acid at both DWTPs. In the following steps in each treatment plant, the concentration patterns of these carbonyl compounds differed depending on the type of disinfectant applied. Benzaldehyde was the only aromatic aldehyde detected after oxidation with ozone in spring. As compared with DWTP 1, five new carbonyl compounds were formed (crotonaldehyde, benzaldehyde, formic, oxalic and malonic acid) disinfection by ozone, and the levels of the carbonyl compounds increased. In addition, pre-ozonation (PO) and main ozonation (OZ) increased the levels of carbonyl compounds, however coagulation/flocculation (CF), sand filtration (SF) and granular activated carbon filtration (GAC) decreased the levels of carbonyl compounds.

Determination of Inorganic Ion Profiles of Illicit Drugs by Capillary Electrophoresis

A portable capillary electrophoresis instrument with dual capacitively coupled contactless conductivity detection (C⁴ D) was used to determine the inorganic ionic profiles of three pharmaceutical samples and precursors of two illicit drugs (contemporary samples of methylone and para-methoxymethamphetamine). The LODs ranged from 0.10 μmol/L to 1.25 μmol/L for the 10 selected cations, and from 0.13 μmol/L to 1.03 μmol/L for the eight selected anions. All separations were performed in less than 6 min with migration times and peak area RSD values ranging from 2 to 7%. The results demonstrate the potential of the analysis of inorganic ionic species to aid in the identification and/or differentiation of unknown tablets, and real samples found in illicit drug manufacture scenarios. From the resulting ionic fingerprint, the unknown tablets and samples can be further classified.

Portable capillary electrophoresis instrument with contactless conductivity detection for on-site analysis of small volumes of biological fluids

A novel, easy to use and portable capillary electrophoretic instrument for injection of small volumes of biological fluids equipped with contactless conductivity detection was constructed. The instrument is lightweight (<5 kg), all necessary parts including a tablet computer are accommodated in a plastic briefcase with dimensions 20 cm × 33 cm × 17 cm (w × l × h), allows hydrodynamic injection of small sample volumes and can continuously operate for at least 10 hours. The semi-automated hydrodynamic sample injection is accomplished via a specially designed PMMA interface that is able to repeatedly inject sample aliquots from a sample volume as low as 10 μL, with repeatability of peak areas below 5%. The developed interface and the instrument were optimized for the injection of biological fluids. Practical utility was demonstrated on the determination of formate in blood serum samples from acute methanol intoxication patients and on the analysis of ionic profile (nitrosative stress markers, including nitrite and nitrate) in the exhaled breath condensate from one single exhalation.

Occurrence of carboxylic acids in different steps of two drinking-water treatment plants using different disinfectants

The occurrence of 35 aliphatic and aromatic carboxylic acids within two full scale drinking-water treatment plants was evaluated for the first time in this research. At the intake of each plant (raw water), the occurrence of carboxylic acids varied according to the quality of the water source although in both cases 13 acids were detected at average concentrations of 6.9 and 4.7 μg/L (in winter). In the following steps in each treatment plant, the concentration patterns of these compounds differed depending on the type of disinfectant applied. Thus, after disinfection by chloramination, the levels of the acids remained almost constant (average concentration, 6.3 μg/L) and four new acids were formed (butyric, 2-methylbutyric, 3-hydroxybenzoic and 2-nitrobenzoic) at low levels (1.1-5 μg/L). When ozonation/chlorination was used, the total concentration of the carboxylic acids in the raw water sample (4.7 μg/L) increased up to 6 times (average concentration, 26.3 μg/L) after disinfection and 6 new acids (mainly aromatic) were produced at high levels (3.5-100 μg/L). Seasonal variations of the carboxylic acids under study showed that in both plants, maximum levels of all the analytes were reached in the coldest months (autumn and winter), aromatic acids only being found in those seasons.

Sediment porewater extraction and analysis combining filter tube samplers and capillary electrophoresis

Careful extraction and analysis of porewater from sediment cores are critical for the investigation of small-scale biogeochemical processes. Firstly, small sample volumes and high spatial resolution are required. Secondly, several chemical species in the anaerobic porewater are sensitive to oxidation when brought in contact with ambient air. Here we present the combination of a special sampling technique and an analytical method for the porewater extraction of a varved sediment core from Lake Baldegg in central Switzerland, using MicroRhizon samplers and a portable capillary electrophoresis (CE) instrument. MicroRhizon filter tubes of 1 mm diameter and 20 mm length are suitable for fast retrieval of particle-free porewater samples directly from the sediment core. Since the time-span between sampling and analysis is less than 20 seconds, oxygen-sensitive Fe(ii) can be analyzed in one go together with Na(+), K(+), Ca(2+), Mg(2+), NH4(+), and Mn(ii) without splitting, acidification or dilution of the sample. The major inorganic cations and anions of the sediment porewater can be determined in less than 15 minutes. Detection limits are in the sub-micromolar concentration range. The capillary electrophoresis instrument used in this study requires sample volumes of only 20 μL. These remarkable small sample volumes allow the minimization of disturbance of the sediment cores and a high spatial resolution of the sediment profile, even in sediments with low water content. The equipment is inexpensive, easy to handle, fully portable and therefore suitable for environmental on-site applications.

Field enhancement sample stacking for analysis of organic acids in traditional Chinese medicine by capillary electrophoresis

A technique known as field enhancement sample stacking (FESS) and capillary electrophoresis (CE) separation has been developed to analyze and detect organic acids in the three traditional Chinese medicines (such as Portulaca oleracea L., Crataegus pinnatifida and Aloe vera L.). In FESS, a reverse electrode polarity-stacking mode (REPSM) was applied as on-line preconcentration strategy. Under the optimized condition, the baseline separation of eight organic acids (linolenic acid, lauric acid, p-coumaric acid, ascorbic acid, benzoic acid, caffeic acid, succinic acid and fumaric acid) could be achieved within 20 min. Validation parameters of this method (such as detection limits, linearity and precision) were also evaluated. The detection limits ranged from 0.4 to 60 ng/mL. The results indicated that the proposed method was effective for the separation of mixtures of organic acids. Satisfactory recoveries were also obtained in the analysis of these organic acids in the above traditional Chinese medicine samples.

Rapid and direct determination of glyphosate, glufosinate, and aminophosphonic acid by online preconcentration CE with contactless conductivity detection

Rapid and direct online preconcentration followed by CE with capacitively coupled contactless conductivity detection (CE-C(4)D) is evaluated as a new approach for the determination of glyphosate, glufosinate (GLUF), and aminophosphonic acid (AMPA) in drinking water. Two online preconcentration techniques, namely large volume sample stacking without polarity switching and field-enhanced sample injection, coupled with CE-C(4)D were successfully developed and optimized. Under optimized conditions, LODs in the range of 0.01-0.1 microM (1.7-11.1 microg/L) and sensitivity enhancements of 48- to 53-fold were achieved with the large volume sample stacking-CE-C(4)D method. By performing the field-enhanced sample injection-CE-C(4)D procedure, excellent LODs down to 0.0005-0.02 microM (0.1-2.2 microg/L) as well as sensitivity enhancements of up to 245- to 1002-fold were obtained. Both techniques showed satisfactory reproducibility with RSDs of peak height of better than 10%. The newly established approaches were successfully applied to the analysis of glyphosate, glufosinate, and aminophosphonic acid in spiked tap drinking water.

Combination of on-chip field amplification and bovine serum albumin sweeping for ultrasensitive detection of green fluorescent protein

We report a highly effective on-chip preconcentration method by combining field-amplified sample injection (FASI) and bovine serum albumin (BSA) sweeping for ultrasensitive detection of green fluorescent protein (GFP) on a simple cross-channel microchip device. With the formation of a stagnant sample/running buffer boundary by balancing the hydrodynamic flow and the electro-osmotic flow (EOF), GFP molecules can be continuously injected into the sample loading channel and stacked. We have also demonstrated that BSA is a very effective pseudo-stationary phase for sweeping concentration of proteins in comparison to the commonly used micelles. The combination of FASI and BSA sweeping yields a concentration factor of 3570 and a limit of detection of 8.4 pM for GFP. Using this method, we have separated GFP and GFP-insulin-like growth factor-I (GFP-IGF-I) fusion protein. The entire assay (GFP concentration, matrix elimination, and electrophoretic separation) can be completed within <5 min. Furthermore, we have successfully applied this method for the detection of GFP expression of E. coli cells and the GFP content in single E. coli cells.