Simultaneously electrochemical detection of uric acid and ascorbic acid using glassy carbon electrode modified with chrysanthemum-like titanium nitride

Single-Atom Fe Nanozyme with Enhanced Oxidase-like Activity for the Colorimetric Detection of Ascorbic Acid and Glutathione

Single-atom nanozymes (SAzymes) have drawn ever-increasing attention due to their maximum atom utilization efficiency and enhanced enzyme-like activity. Herein, a facile pyrolysis strategy is reported for the synthesis of the iron-nitrogen-carbon (Fe-N-C) SAzyme using ferrocene trapped within porous zeolitic imidazolate framework-8 (ZIF-8@Fc) as a precursor. The as-prepared Fe-N-C SAzyme exhibited exceptional oxidase-mimicking activity, catalytically oxidizing 3,3',5,5'-tetramethylbenzidine (TMB) with high affinity (K_m) and fast reaction rate (V_max). Taking advantage of this property, we designed two colorimetric sensing assays based on different interaction modes between small molecules and Fe active sites. Firstly, utilizing the reduction activity of ascorbic acid (AA) toward oxidized TMB (TMBox), a colorimetric bioassay for AA detection was established, which exhibited a good linear range of detection from 0.1 to 2 μM and a detection limit as low as 0.1 μM. Additionally, based on the inhibition of nanozyme activity by the thiols of glutathione (GSH), a colorimetric biosensor for GSH detection was constructed, showing a linear response over a concentration range of 1-10 μM, with a detection limit of 1.3 μM. This work provides a promising strategy for rationally designing oxidase-like SAzymes and broadening their application in biosensing.

Vitamin C-reduced graphene oxide improves the performance and stability of multimodal neural microelectrodes

Nanocarbons are often employed as coatings for neural electrodes to enhance surface area. However, processing and integrating them into microfabrication flows requires complex and harmful chemical and heating conditions. This article presents a safe, scalable, cost-effective method to produce reduced graphene oxide (rGO) coatings using vitamin C (VC) as the reducing agent. We spray coat GO + VC mixtures onto target substrates, and then heat samples for 15 min at 150°C. The resulting rGO films have conductivities of ∼44 S cm⁻¹, and are easily integrated into an ad hoc microfabrication flow. The rGO/Au microelectrodes show ∼8x lower impedance and ∼400x higher capacitance than bare Au, resulting in significantly enhanced charge storage and injection capacity. We subsequently use rGO/Au arrays to detect dopamine in vitro, and to map cortical activity intraoperatively over rat whisker barrel cortex, demonstrating that conductive VC-rGO coatings improve the performance and stability of multimodal microelectrodes for different applications.

•

Easy, scalable, and safe reduction method to create rGO films with vitamin C

•

VC-rGO coatings improve the performance of bare gold microelectrodes in vitro

•

VC-rGO coatings enable the voltammetric detection of dopamine on the microscale

•

rGO/Au electrode arrays enable high-resolution microscale recording in vivo

Novel lanthanum vanadate-based nanocomposite for simultaneously electrochemical detection of dopamine and uric acid in fetal bovine serum

The abnormal levels of two biological molecules, dopamine (DA) and Uric acid (UA), in human body are symptoms of diseases such as Parkinson's disease and arrhythmia. A novel lanthanum vanadate and multi-walled carbon nanotubes (LaV-MWCNTs) composite modified glassy carbon electrode (GCE) was developed and utilized as an efficient electrochemical sensor for the simultaneous detection of DA and UA. LaV-MWCNTs composite was successfully fabricated by a facile ultrasonic self-assembly method and identified by means of a series of successive measurements including XPS, XRD, FT-IR and FE-SEM. The LaV-MWCNTs modified GCE shows the concentration linear ranges of DA and UA are 2-100 μΜ using DPV. The limits of detection (LODs; signal-to-noise ratio of 3, S/N = 3) of the LaV-MWCNTs modified GCE sensor for DA and UA were calculated to be 0.046 μM and 0.025 μM, respectively. The feasibility of using the LaV-MWCNTs modified GCE sensor to detect DA and UA in a typical biological fluid, fetal bovine serum, was also evaluated by the standard addition method.

Simultaneous Detection of Ascorbic Acid, Dopamine, and Uric Acid Using a Novel Electrochemical Sensor Based on Palladium Nanoparticles/Reduced Graphene Oxide Nanocomposite

A fresh strategy based on two-step electrochemical reduction for the fabrication of palladium nanoparticles/reduced oxide nanocomposite-modified glass carbon electrode (PdNPs/rGO/GCE) was established in this study. Field emission scanning electron microscopy (FESEM) images showed that spherical PdNPs were evenly distributed on the surface of rGO-modified electrode (rGO/GCE), and the introduction of PdNPs has no effect on the morphology of rGO. Electrochemical impedance spectroscopy (EIS) studies revealed that the conductivity of PdNPs/rGO/GCE was higher than that of rGO/GCE and bare GCE. The electrochemical performances of PdNPs/rGO/GCE sensor were investigated by cyclic voltammetry (CV), differential pulse voltammetry (DPV), and chronoamperometry using ascorbic acid (AA), dopamine (DA), and uric acid (UA) as analytes. At the optimized conditions, wide linear ranges of 0.5–3.5 mM (R² = 0.99), 3–15 μM (R² = 0.99) and 15–42 μM (R² = 0.99), and 0.3–1.4 mM (R² = 0.99) towards AA, DA, and UA in ternary mixture were observed, respectively. In addition to superior anti-interference capability, fast response (≤5 s), excellent reproducibility, and good long-term stability were also given by this sensor. These results suggested that PdNPs/rGO/GCE is promising for the simultaneous detection of AA, DA, and UA in practical application.

Hybrid carbon nanotubes modified glassy carbon electrode for selective, sensitive and simultaneous detection of dopamine and uric acid

Based on a hybrid carbon nanotube composite, a novel electrochemical sensor with high sensitivity and selectivity was designed for the simultaneous determination of dopamine (DA) and uric acid (UA). The hybrid carbon nanotube composite was prepared by ultrasonic assembly of carboxylated multi-walled carbon nanotube (MWCNT-COOH) and hydroxylated single-walled carbon nanotube (SWCNT-OH). And the hybrid (MWCNT-COOH/SWCNT-OH) composite was characterized by field emission scanning electron microscopy (FE-SEM) and Fourier transform infrared (FT-IR) spectroscopy. The electrochemical performances of MWCNT-COOH/SWCNT-OH composite modified glassy carbon electrode (MWCNT-COOH/SWCNT-OH/GCE) were analyzed by cyclic voltammetry (CV), electrochemical impedance spectroscopy (EIS) and differential pulse voltammetry (DPV). Under the optimum experimental conditions, the as-prepared sensor showed high sensitivity and selectivity for DA and UA. The calibration curves obtained were linear for the currents versus DA and UA concentrations in the range 2-150 μM, and limits of detection (LODs) were calculated to be 0.37 μM and 0.61 μM (signal-to-noise ratio of 3, S/N = 3), respectively. The recoveries of DA and UA in bovine serum samples at MWCNT-COOH/SWCNT-OH/GCE were in the range 96.18-105.02%, and relative standard deviations (RSDs) were 3.34-7.27%. The proposed electrochemical sensor showed good anti-interference ability, excellent reproducibility and stability, as well as high selectivity, which might provide a promising platform for determination of DA and UA.

Fluorescent and photoacoustic bifunctional probe for the detection of ascorbic acid in biological fluids, living cells and in vivo

Photoacoustic imaging (PAI) has emerged as a promising clinical technology, thanks to its high-resolution in deep tissues. However, the lack of specificity towards analytes limits further application of the PA probe in molecular imaging. To this end, we herein report a PA and fluorescence (FL) dual-modal probe for the selective detection of ascorbic acid (AA). To realize this design, cobalt oxyhydroxide (CoOOH) was adopted as a multifunctional platform (PA contrast agent, FL quencher and specific oxidant to AA) and hybridized with red-emissive carbon dots (RCDs). In the presence of AA, CoOOH is reduced to Co2+ and meanwhile releases RCDs, resulting in the decrease of PA and recovery of FL signals. We demonstrated the AA detection capabilities of the probe in complicated biological fluids (human serum and urine), living cells, and dual-modal FL/PA imaging in vivo. This work revealed the PAI capacity of CoOOH for the first time, which may inspire researchers to design other CoOOH-based PA probes and further employ RCDs in biology and the clinic.

Solution growth of 3D MnO2 mesh comprising 1D nanofibres as a novel sensor for selective and sensitive detection of biomolecules

This work is the first report describing the solution grown 3D manganese oxide nanofibrous (MnO₂ NFs) mesh and its potential for the simultaneous detection of biomolecules such as ascorbic acid and uric acid. The mesh is synthesized by a facile, one-pot, and cost-effective hydrothermal approach without using any template or structure directing compound. The morphology consists of randomly placed nanofibres possessing a diameter in the range of 10-25 nm, and length of several micron; constituting a highly porous and flexible material. The electrochemical potential was examined by recording cyclic voltammetry signals towards ascorbic acid and uric acid. The special mesh morphology offers a large surface area to promote enhanced electrochemical activity, and also provided a macroporous network that supported efficient mass transport. Additionally, the strong electronic cloud and roughness of MnO₂ NFs mesh facilitated the fast oxidation of species at very low potential. The lower detection limit was found to be 1.33 µM (S/N = 3) and 1.03 µM (S/N = 3) for ascorbic acid and uric acid, respectively. The MnO₂ NFs mesh modified electrodes can robustly differentiate both of them by giving well separate signals (Δ = 500 mV) indicating capability of the material towards selective detection. The sensor has been successfully applied to human blood and urine samples and the recoveries were found statistically significant. These results demonstrate the practical feasibility of 3D mesh to develop sensors for the accurate diagnosis of clinically important molecules.