An experimental design approach for the solid phase extraction of some organophosphorus pesticides from water samples with polymeric microbeads

Enhanced electrochemical sensing of methyl parathion using AgNPs@IL/GO nanocomposites in aqueous matrices

Methyl parathion (MP) is a widely used pesticide; it is recognized as being toxic to both target and non-target species, posing serious risks to environmental and human health. Monitoring and controlling MP residues is thus essential, necessitating the development of innovative sensors that are highly sensitive, selective, and reproducible. In the present study, an efficient electrochemical MP sensor is proposed based on silver nanoparticles (AgNPs) in conjunction with graphene oxide/ionic liquid (GO/IL) on screen printed electrodes (AgNPs@GO/IL@SPCE). The AgNPs were synthesized via a cost-effective wet-chemical process and characterized using UV-Vis spectroscopy and transmission electron microscopy (TEM). The modified electrodes were characterized by scanning electron microscopy (SEM) and energy-dispersive X-ray spectroscopy (EDX). The active surface area and charge transfer were examined by cyclic voltammetry (CV) and electrochemical impedance spectroscopy (EIS), respectively. The modified electrodes' electrocatalytic performance towards the reduction of MP was investigated by CV, complemented by semiempirical quantum chemistry calculations to elucidate the interaction and the electrochemical reduction mechanism of MP. The sensor demonstrates a remarkable limit of detection of 0.009 μmol L-1 within a linear range of 0.025 to 200 μmol L-1. It has an excellent analytical performance in terms of selectivity, reproducibility, and long-term stability over 60 days. The designed sensor was effectively used to inspect MP in groundwater and surface water samples, with recovery values ranging from 95.60% to 99.68%.

Deep Eutectic Solvents-Based Ultrasonic-Assisted Dispersive Liquid-Liquid Microextraction for the Determination of Organophosphorus Pesticides in Honeysuckle Dew Samples

A deep eutectic solvent (DES) with the ability to change from hydrophilic to hydrophobic was designed and synthesized and applied to the determination of organophosphorus (OPP) pesticides in honeysuckle dew samples. Choline chloride, phenol, and tetrahydrofuran (THF) were used as the hydrogen bond acceptor, hydrogen bond donor, and demulsifier, respectively. Eight OPP pesticides were extracted by DES coupled with ultrasonic-assisted extraction (UA) and then chromatographed by GC-MS. DES used as an extract solvent has the advantages of high extraction efficiency, low cost, and environmental protection. Furthermore, DES is compatible with GC-MS. The single factor experiment design and Box-Behnken design (BBD) were applied to the optimization of experimental factors, including the type and composition of extraction solvent, type of demulsifier solvent, the volume of DES and THF, pH of sample solution, and ultrasonic time. Under the optimum experimental conditions, the high degree of linearity from 0.1 to 20.0 ng mL-1 (R2 ≥ 0.9989), the limits of detection from 0.014 to 0.051 ng mL-1 (S/N = 3), and the recoveries of analytes from 81.4 to 104.4% with relative standard deviation below 8.6%. In addition, the adsorption mechanism of OPPs on DES was explored by adsorption kinetic studies. These results have demonstrated that the present method has offered an effective, accurate, and sensitive methodology for OPP pesticides in honeysuckle dew samples, and this method provides a reference for the detection of pesticide residues in traditional Chinese medicine.

Adsorption and removal of organophosphorus pesticides from Chinese cabbages and green onions by using metal organic frameworks based on the mussel-inspired adhesive interface

Based on the mussel-inspired adhesive interface (Fe3O4-g-C3N4@PDA), a novel bionic metal-organic framework (Fe3O4-g-C3N4-PDA@MIL-101) was successfully prepared. The composite featured a high specific surface area and a multi-microchannel structure, as well as strong thermochemical stability. The structural property of Fe3O4-g-C3N4-PDA@MIL-101(Fe) was characterized, and the results indicated that Fe3O4, PDA, and MIL-101(Fe) were uniformly coated on the g-C3N4 surface. The adsorption and desorption of organophosphorus pesticides with Fe3O4-g-C3N4-PDA@MIL-101(Fe) were evaluated by batch experiments. This composite showed high adsorption efficiency and selective removal of coralox, phosalone, and chlorpyrifos. Under the optimal conditions, three organophosphorus pesticides were adsorbed from Chinese cabbage and green onion samples with Fe3O4-g-C3N4-PDA@MIL-101(Fe). The analytical method exhibited high sensitivity (LOD, 0.19-2.34 μg/L; LOQ, 0.65-7.82 μg/L), excellent practicality, and good stability, suggesting that Fe3O4-g-C3N4-PDA@MIL-101 was an ideal candidate magnetic adsorbent for the removal of organophosphorus pesticides in Chinese cabbage and green onion samples.

Analytical Extraction Methods and Sorbents' Development for Simultaneous Determination of Organophosphorus Pesticides' Residues in Food and Water Samples: A Review

Extensive use of organophosphorus pesticides in agriculture leads to adverse effects to the environment and human health. Sample preparation is compulsory to enrich target analytes prior to detection as they often exist at trace levels and this step is critical as it determines the concentration of pollutants present in samples. The selection of a suitable extraction method is of great importance. The analytical performance of the extraction methods is influenced by the selection of sorbents as sorbents play a vital role in the sensitivity and selectivity of an analytical method. To date, numerous sorbent materials have been developed to cater to the needs of selective and sensitive pesticides' detection. Comprehensive details pertaining to extraction methods, developed sorbents, and analytical performance are provided. This review intended to provide a general overview on different extraction techniques and sorbents that have been developed in the last 10 years for organophosphorus pesticides' determinations in food and water samples.

Chitosan-Graphene Oxide Composite Membranes for Solid-Phase Extraction of Pesticides

Solid-phase extraction (SPE) coupled to LC/MS/MS analysis is a valid approach for the determination of organic micropollutants (OMPs) in liquid samples. To remove the greatest number of OMPs from environmental matrices, the development of innovative sorbent materials is crucial. Recently, much attention has been paid to inorganic nanosystems such as graphite-derived materials. Graphene oxide has been employed in water-purification processes, including the removal of several micropollutants such as dyes, flame retardants, or pharmaceutical products. Polysaccharides have also been widely used as convenient media for the dispersion of sorbent materials, thanks to their unique properties such as biodegradability, biocompatibility, nontoxicity, and low cost. In this work, chitosan-graphene oxide (CS_GO) composite membranes containing different amounts of GO were prepared and used as sorbents for the SPE of pesticides. To improve their dimensional stability in aqueous medium, the CS_GO membranes were surface crosslinked with glutaraldehyde. The composite systems were characterized by Fourier transform infrared spectroscopy, scanning electron microscopy, thermogravimetric analysis, swelling degree, contact angle, and mechanical measurements. As the GO content increased, a decrease in surface homogeneity, an improvement of mechanical properties, and a reduction of thermal stability of the CS-based membranes were observed. The increased dimensional stability in water, together with the presence of high GO amounts, made the prepared composite membranes more efficacious than the ones based just on CS in isolating and preconcentrating different hydrophilic/hydrophobic pollutants.

Facile synthesis of covalent organic frameworks functionalized with graphene hydrogel for effectively extracting organophosphorus pesticides from vegetables

A novel covalent organic framework material (3DGA@COFs), for use as a solid-phase dispersion sorbent, has been synthesized for extracting organophosphorus pesticides (OPs) from vegetables. The prepared 3DGA@COFs material exhibited many advantageous features, including a large specific surface area (127.95 m2/g) and high pore volume (0.0344 cm3/g), which made it an ideal sorbent for sample pretreatment. The experimental conditions affecting extraction performance (adsorbent type, adsorbent amount, reaction time, pH, ionic concentration, and eluent) were optimized systematically. The extracted analytes were detected by HPLC-MS/MS. Under optimized conditions, the proposed method exhibited a wide linear range (0.5-100 μg/L) and low limits of detection (0.01-0.14 μg/L). The recoveries (75.40%-102.13%) satisfied the requirements for a precise detection method. The proposed method was successfully used for determining malathion, triazophos, quinalphos in lettuce, tomato and cucumber samples, thus indicating the potential of using 3DGA@COFs materials for pretreating vegetable samples.

Sample bottle coated with sorbent as a novel solid-phase extraction device for rapid on-site detection of BTEX in water

Solid-phase extraction (SPE) is a popular technique for environmental sample pretreatment. However, SPE usually requires complex sample pretreatment processes, which is time-consuming and inconvenient for real-time and on-site monitoring. Herein, a solvent-free, rapid, and user-friendly SPE device was developed by coating the polydimethylsiloxane (PDMS)/divinylbenzene (DVB) sorbent on the inner wall of a sample bottle. The extraction process and desorption process were both carried out in the bottle. The analytes trapped in the sorbent were thermally desorbed and simultaneously sucked out from the bottle by an air sampling tube equipped on field-portable GC-MS. Different to previous work, the sample pretreatment process didn't require any complicated and time-consuming steps, such as centrifugation or filtration. The total analysis time for each sample was less than 25 min, which was feasible for rapid on-site detection, and thus avoided the losses and contamination of samples in conventional sample storage and transportation processes. Under optimal conditions, the proposed SPE method exhibited wide linear ranges, low detection limits (0.010-0.036 μg L^-1, which were much lower than the maximum levels restricted by the US Environmental Protection Agency and the Chinese GB3838-2002 standard), good intra-bottle repeatability (6.13-7.17%, n = 3) and satisfactory inter-bottle reproducibility (4.73-6.47%, n = 3). Finally, the method was successfully applied to the rapid detection of BTEX in the field. The recoveries of BTEX in spiked water samples ranged from 89.1% to 116.2%. This work presents a novel SPE approach for rapid on-site monitoring in water samples.

New Trend in the Extraction of Pesticides from the Environmental and Food Samples Applying Microextraction Based Green Chemistry Scenario: A Review

This review focused on the green microextraction methods used for the extraction of pesticides from the environmental and food samples. Microextraction techniques have been explored and applied in various fields of analytical chemistry since its beginning, as evinced by the numerous reviews published. The success of any technique in science and technology is measured by the simplicity, environmentally friendly, and its applications; and the microextraction technique is highly successive. Deliberations were attentive to studies where efforts have been made to validate the methods through the inter-laboratory comparison study to assess the analytical performance of microextraction techniques against conventional methods. Succinctly, developed microextraction methods are shown to impart significant benefits over conventional techniques. Provided that the analytical community continues to put forward attention and resources into the growth and validation of the microextraction technique, a promising future for microextraction is forecasted.

Supramolecular solvent-based micro-extraction of pesticides in food and environmental samples

Supramolecular solvent-based micro-extraction is a very important green technique for the isolation and pre-concentration of pesticide residues in food and environmental samples prior to their chromatographic analysis. The attractive features of supramolecular solvent-based micro-extraction include its simplicity, high pre-concentration factor, fastness, accuracy, low cost, less consumption of chemical reagents and environmental friendliness. The supramolecular solvent is generated from a ternary mixture of amphiphiles, water and a water miscible dispersion and coacervating solvent. Tehydrofuran is one of the solvents commonly used as both a dispersion solvent and a coacervating agent. This paper gives a recent comprehensive review on the application of alkanols as amphiphiles during supramolecular solvent-based micro-extraction of pesticide residues in food and environmental samples. Other researchers used long chain fatty acids as amphiphiles during pesticide analysis in food and environmental samples using supramolecular solvent-based micro-extraction, and this is discussed in this paper. The incorporation of ferrofluids in supramolecular solvents enables phase separation using a magnet instead of the time-consuming centrifugation technique. This paper also gives a detailed review of the application of ferrofluid-based supramolecular solvent micro-extraction of pesticide residues in food and environmental samples.

Customized dispersive micro-solid-phase extraction device combined with micro-desorption for the simultaneous determination of 39 multiclass pesticides in environmental water samples

A dispersive micro-solid phase extraction (d-µ-SPE) procedure was developed for the simultaneous extraction of 39 multiclass pesticides, containing a variety of chemical groups (organophosphate, organochlorine, pyrethroid, strobilurin, thiocarbamate, triazole, imidazole, and triazine), from water samples. A customized d-µ-SPE glass device was combined with a multi-tube platform vortex and a micro-desorption unit (Whatman Mini-UniPrep G2 syringeless filter), which allowed the unique simultaneous desorption, extract filtration, and injection. A simplex-centroid mixture design and Doehlert design were employed to optimize the extraction conditions. The optimized extraction conditions consisted of an extraction time of 30 min, an addition of 6.74 % of NaCl into 100 mL of water sample, and a desorption time of 24 min with 500 µL of EtAc. The procedure provided a low limit of detection (LOD), ranging from 0.51 ng L^-1 (4,4-DDE) to 22.4 ng L^-1 (dimethoate), and an enrichment factor ranging from 72.5 (dimethoate) to 200 (tebuconazole). The relative recoveries of the pesticides from spiked freshwater and seawater ranged from 74.2 % (endrin) to 123 % (molinate). The proposed procedure was applied to detect the presence of multiclass pesticides in environmental water samples. Three pesticides commonly applied in Brazil, namely, malathion, dimethoate, and lambda-cyhalothrin, were detected in concentrations ranging from <LOD to 120 ng L^-1 (dimethoate).